Santa Fe (CM - 2007-12) :: P0441 CEL Code - Evap Emission System Incorrect Purge Flow
Just received a P0441 CEL (Evap Emission System Incorrect Purge Flow). I have a 2.7l engine, 2WD. I've read other forums and it seems it's most likely the purge valve or charcoal canister.
View 7 RepliesSanta Fe (CM - 2007-12) :: CEL On With Code P0441 - EVAP Emission System Incorrect Purge Flow
I've had the check engine light come on and was told it was probably from topping up too much and that it would go off on it's own... I should say I have no issues with idle or rough starts.
I had it scanned at Auto Zone. The print out shows: "EVAP emission system incorrect purge flow probable cause
1) Faulty purge control solenoid
2) Faulty vent solenoid
3) Blocked vapor canister
Previous posts suggest if it were a blocked vapor canister I'd have trouble completely filling the tank so I am hoping it's one of the others. Almost everything I see suggests the purge control and that looks like an easy fix. My concerns are a) if it is the vent solenoid - how hard is that to get at and b) what is the part number as I can't find it listed anywhere? I want to have both on hand before I start trying to fix this. Lastly if it is the vent solenoid should I just give up and see a dealer??
Golf IV R32 :: Code P0441 - EVAC Control System / Incorrect Flow
Check engine light came on the other day. Brought the car over to autozone and this was the code that came back. P0441 EVAC Control System; Incorrect flow. Where I should start looking?
View 3 RepliesElantra XD (2001-06) :: P0441 Code Flow Fault - Changed Purge Valve
I have a 06 Elantra having a problem with a p0441 code flow fault I changed purge valve and canister purge valve I don't know what else to do what else can I do to get it to go away permanent so I can get car inspected no codes for my car can be on but only 1 i/m
View 3 RepliesLexus GS 2006-11 :: Check VSC Warning - Incorrect Purge Flow And Gross Leak
About a month ago the "Check VSC" warning came on in my 2006 GS300 AWD. This happened after the car was in the garage all night and when I started the car in the morning. The car was at the dealer for 2 days and the saved codes showed multiple errors for the evap system, but they couldn't find anything specifically wrong and the light warning went off after all the systems checked out.
A week later the warning came on again, and the codes indicated incorrect purge flow and a gross leak. After 3 days in the shop they decided that the problem was caused by a faulty gas cap, which was replaced. You guessed it! A week later the warning came on AGAIN! I'm taking the car to the shop on Thursday. I'm really getting tired of driving my car 40 miles to the dealer just to have the warning show up again in another week!
Toyota - Camry :: Evaporative Emission Control System Incorrect Purge Flow
The check engine light on my 99 Camry went on at about 180,000 miles. My mechanic checked the code and turned up an EVAPORATIVE EMISSION CONTROL SYSTEM INCORRECT PURGE FLOW He said this could be any number of things,including the need for a gas cannister or some type of valve. What does this mean? How do you determine exactly what the cause of the problem is? What are the likely fixes? Will Toyota be able to better determine the cause than my personal mechanic? What are the best options?
View 5 RepliesAccent MC (2006-11) :: 2009 - Low Purge Flow Error Code Popping Up
Not too terribly long ago I got assistance on identifying and fixing an engine misfire on my 2009 Accent. I assumed was directly connected has cropped up again - a P0497 Low Purge Flow error has come up on the car.
We recently replaced the purge flow valve, and everything seems to be running fine - there is no visible cause for the error, and I've even tried making sure I get the fuel cap as tight as possible.
The code is not popping up constantly - this is only the second time it's come up since the misfire was fixed(without obvious symptoms I always clear a code once just to make sure it wasn't a computer glitch), and the first time it popped up on it's own was the day after I fixed the misfire. Need to know what to check to find out what's wrong and, of course, how much priority I should place on fixing this issue.
Santa Fe (CM - 2007-12) :: 2008 - CEL Code P0441 / Purge Valve Location
Engine light came on a week ago, finally made it in to get the code pulled yesterday : P0441
From reading on this site, thinking its a faulty purge valve.
I have found pics of its location on an 04, but cant seem to find it on my 08 2.7L.
Accent MC (2006-11) :: Check Engine Light On / High Purge Flow
For the past couple weeks my check engine light has come on due to the code reading high purge flow sensor. I checked my gas cap, lines that run from motor to the gas tank and the purge flow that's under the intake. Can't figure out what is exactly going on. And it has 53k miles and runs just fine...
View 6 RepliesAccent MC (2006-11) :: Low Purge Flow And Misfire - Transmission Shaky At Higher Revs
I have a 2009 Hyundai Accent 4-door 1.4L auto, 123,000 miles.
Before you ask: The high mileage is because it's used for a newspaper route. We(as in, myself and my father) take great efforts to keep it in as good a shape as possible given the amount of stress this puts on it - one minor deer impact aside, I think we've done a good job.
Recently(read: a week ago), we replaced the purge flow valve due to it causing stalls and difficulty starting after refueling. After a week of apparently fine operation, as I was nearing completion of the route, a very clear cylinder misfire began. Not the worst misfire I've ever heard - the car barely seemed to struggle on initial acceleration(except in reverse, which made me slightly concerned I wasn't feeling an engine issue, but a transmission issue), and only got really shaky at higher revs.
We have an OBD-II reader at home, so when I returned I plugged it and discovered not one, but TWO error codes: P0497 -low purge flow- and P0301 -Cylinder 1 misfire- with the reader listing them in that order.
Looking up information on these two being connected has turned up little support - I've only learned that either one can be cause and effect. Needless to say given timing I strongly believe that it is highly likely that we either made a mistake installing the new valve, or that the new valve was bad from the get-go.
We'll be checking the spark plugs as soon as we are able(I am about to go to sleep and my dad has work - we tag team automotive repairs since two sets of eyes and two brains can figure things out better and an extra set of hands is always good to have ready even if only one set can actually do the job), but even if the problem isn't the spark plugs, it doesn't automatically mean it's the purge valve, either - at least as I understand things.
So with the background out of the way, my questions are thus:
1) Is the spark plugs don't fix anything, what is the quickest way to figure out which error is cause and which error is effect?
2) Are there any serious risks to continuing to run the car in this state if a fix cannot be made immediately? (being able to borrow another car is possible, but problematic - need to stick with this car if safely doable)
Ford Ranger / B-Series :: MIL P1444 Code - Faulty Purge Flow Sensor
So I had a post up saying "is MIL P1444 a urgent fix" and I got "no". On an other website though it said that it was an urgent fix. They said it was "similar to running a bad catalytic converter. You don't want to do it."
P1444:
Possible causes
- Faulty Purge Flow Sensor
- Purge Flow Sensor harness is open or shorted
- Purge Flow Sensor circuit poor electrical connection
So I located the purge flow sensor and look at the tube that connects to that,the canp solenoid, and the carbon canister. Nothing looks bad, but I did notice that the tube that connects to the carbon canister to the solenoid is not connected. The part that connects to the carbon canister dry rotted off. So I turned on my car to see if anything was coming out of that tube or air and there was nothing (not sure if that's good or bad). Also a week ago when I filled up my gas tank (before the check engine light was on) a lot of fumes were coming out of the tank while pumping.
The scanner i use also lists the secondary air system, the EVAP system, Heated catalyst, and the AC refrigenant has red X's, but they weren't continuous.
Golf IV / Jetta IV :: CEL Code P0411 Secondary Air Injection System Incorrect Flow Detected
I got 2001 vw jetta 2.0.. I keep getting check engine light,,when i scan it keep saying P0411 Secondary Air Injection System Incorrect Flow Detected. i replaced new smog air pump, and new egr valve and today i was driving car and i got check engine light, its still same code.
View 4 RepliesGolf IV / Jetta IV :: 2004 - P0411 Code / Secondary Air Injection System Incorrect Flow
2004 VR6 24v ... I had another thread about my son's car stalling after driving about 20 miles and then running good again after letting it sit for a couple of hours. Anyway I changed the Crank Position Sensor and I have been driving it work and back the last couple of days so I am starting to relax that the CPS fixed that problem. Won't be positively sure for a while as the problem took a while to occur. So far so good.
While coming to work today the car picked up the P0411 code, secondary air injection system incorrect flow. When I changed the CPS sensor i unbolted a module underneath the car by the oil filter to get better access to the CPS. I did not remove it, just unbolted it so I could push it out of the way about and inch.
After putting it all back together and driving it for several trips with no stalling this P0411 comes on. Is that module I moved the Secondary Air Pump and could I have disturbed something. I will check it when I get home. How critical is that code. I read where it works to warm a cold engine. What effect would there be driving with that code?
Accent RB (2012+) :: Check Engine Light Came On - Purge Valve Replacement
So sometime last week my check engine light came on. Took my 13 Accent to the dealership and they said the purge valve is to be replaced. Now my Accent pings when running 87 gas and I read that others (not necessarily Accent owners) who changed their purge valve noticed the pinging go away.
View 5 RepliesAccent LC (2000-05) :: CE Light Code PO734 Which Is Gear 4 Incorrect Ratio
So I got around and decided to fix my transmission my self. Any way I got the code PO734 from my CE light which is gear 4 incorrect ratio. So some people say its the solenoids that cause this issue, some say its the 4th gear clutch...
So, Is it the solenoid or it could be the clutch itself? Ive removed the 4th gear from my transmission today and it looks intact. No weird damage or physical like damage on it... I just don't know which to do since solenoid job i can do myself which will be about 5 hours minimum....
Passat (B5) :: V6 - Check Engine Light / Incorrect Flow
I know that the air injection system is supposed to kick on during a cold start, which it does, but i get the check engine code that it has "incorrect flow"...... What could this be?!
View 2 RepliesFord Escape / Hybrid :: EVAP Purge Flow Valve Sticking
Replacing part 9C915 ?
"CODE P0443 canister purge fault" diagnosed....
Found: EVAP PURGE FLOW VALVE STICKING
Recommending: "Diag, Replace sensor then retest" ....
They want to install a new 9C915 which they called in hand writing a Canister purge sensor but I've seen it called a canister purge valve on another thread by FIREME who puts 9C915 as "toward the driver's headlight assembly, near the radiator. You'll need an 8mm socket to remove it"...
3.0L DURATEC FFV V6 ENGINE
From the "newly washed ashore" who's now double posting after being flogged for trying to keep this info in a single thread rather than spreading it all over the place...
GTI 337/20th Anniversary :: 2005 GLI 1.8t - Secondary Air Injection System / Incorrect Flow Detected
Chassis Type: 9M - VW Jetta IV
Scan: 01 02 03 08 15 16 17 19 22 29 35 36 37 39 46 47 55 56 57 75 76
Address 01: Engine Labels: 06A-906-032-AWP.lbl
Part No: 06A 906 032 RN
Component: 1.8L R4/5VT G 0001
Coding: 07510
Shop #: WSC 00066
3VWSE69M14M129075 VWZ7Z0D9541648
1 Fault Found:
16795 - Secondary Air Injection System: Incorrect Flow Detected
P0411 - 35-00 - -
Readiness: 0000 0000
-------------------------------------------------------------------------------
Address 56: Radio Labels: 3B7-035-1xx-56.lbl
Part No: 3B7 035 180 G
Component: RADIO 3CP 0007
Coding: 00031
Shop #: WSC 00066
1 Fault Found:
00856 - Radio Antenna
36-00 - Open Circuit
End ---------------------------------------------------------------------
Accent MC (2006-11) :: Purge Control Valve Replacement In GLS
My 06 accent GLS has become difficult to start only after refueling, which I'm guessing is related to a bad purge control valve from what I've read. Where exactly is the valve located, and is this something that someone with relatively little automotive repair experience could do on their own? I think I've located it on the backside of the engine near the air intake.
View 2 Replies