Prius (Gen 3) :: Does OBD2 Scanner Consume The Power When Car Turns Off
I bought a KitBest mini Bluetooth OBD scanner on Amazon last week since my car’s engine light is away on when drives. This tool pairs with my samsung galaxy s6 perfectly, now I can get tons of information of my car. But I am not sure whether need to plug it out from obd port when the car turns off
View 15 RepliesPassat (B5) :: Car Won't Connect To Any Scanner
I tried connecting to my 99 1.8 Turbo passat with VAG COM, some tool from equu, some other tool from snap-on . All of them are unable to connect (to any module).
View 3 RepliesAccent MC (2006-11) :: Couldn't Engage Reverse When Put Shift Knob On
So I just installed my short shifter and everything works great, all the gears engage, however, when I put my shift knob on I noticed I couldn't engage reverse because it sits down too low and doesn't allow the reverse lockout to get over the rail and engage reverse. I have to loosen the knob so it sits higher and then I can engage reverse, but it moves around, so I can't leave it like this...right now my plan is to make some sort of spacer for the knob to sit on and then put loctite on it...seems like it would solve my problem. I have a Hyundai Aluminum shift knob and the short shift is OEM so I don't see what could be wrong ...
View 8 RepliesAccent MC (2006-11) :: 1.6 Motor Won't Start / No Spark - Scanner Not Linking Up
I got a 2008 accent hatch basic model. Its got the 1.6 motor with 23k miles. It will not start at the moment. Battery is good, I am getting fuel. It is not getting spark, and my scanner wont link up to it. I don't know what else to trouble shoot. I am out of warranty car is a salvage title,car ran fine until today. I am thinking the ecu fried but I don't know? All fuses good. What can i check or how do I troubleshoot?
View 6 RepliesGolf IV / Jetta IV :: 2000 - CEL On / OBD Scanner Won't Read Codes
The past week, the CEL of my Jetta 2000 was on, and a couple of days after, was off. But yesterday was relit. I take my car to Auto Zone to check codes with scanner, but was impossible read any code, the lector can't connect with computer. I thought in fuses, but the fuses are fine.
Searching on google, i found that the reason could be the aftermarket radio, but I am not sure about that, the connections are seen aparently fine. I Read in one thread that disconnecting the aftermarket radio harness is enough to can read codes from computer.
I read also that the scanner could be incompatible with VW cars, but I don't think that, because AutoZone should have a scanner compatible with most of the common cars models.
The fact is that I don't want to get in troubles with the harness of radio, I don't have tools like multimeter neither knowledge about electrical systems, i just want to know if disconnecting the radio harness is enough in order to read codes. (in case of the problem be on the K-line wire).
Grand AM :: 2000 Speedometer Stopped Working /couldn't Gear Up
I have a 2000, automatic Grand Am SE with 161,000KM in her and everything seemed to be working fine but as I was driving it today my speedometer just stopped working and when I try to get her up to second gear she kind of jerks forward.
Also, today when I was driving she couldn't gear up at all, she just went from first to second to third to fourth gear without picking up any speed. I'm pretty sure it has something to do with the transmission?
Passat (B5) :: 2000 - OBDII Scanner Won't Read For Emissions Testing
I got a Passat 2000 OBD-II scanner won't read for emissions testing. I did the test in 5 different place all the time when they ask to turn the key and the computer from emission test give a error and stop.
I have a radio aftermarket one of my friend have this problem and he have to install the original radio. So I buy the wire harness and the radio i install and still not able to do the emissions test.
My ABS light is flashing but my friend said this is not a problem he fix more than 4 car just replacing the aftermarket radio....
Saturn :: 2000 - Couldn't Drive Past 5MPH / Tranny Was Slamming Into Gears
2000 Saturn L Series Station Wagon 73,772 miles
The Check Engine Soon light was on this morning but when on highway today and at 70MPH the Service light came on and then the Reduced Power light.
Couldn't drive past 5MPH but when I turned the key off and back on the power returned but the tranny was Slamming into gears. I made it back home but where to go from here.
Prius V :: OBD2 Interface Without Android
I've found lots of good resources here about disabling the backup beep with a bluetooth OBDII device, but I don't have access to an android phone. I have a windows 7 laptop.
View 8 RepliesPhaeton :: OBD2 Port Location?
Where is the OBD2 port?
View 1 RepliesAccent LC (2000-05) :: 2000 - Misfiring Upon Acceleration And Engine Revving
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 RepliesGolf IV / Jetta IV :: 2006 - OBD2 Is Missing From Its Cut Out
I bought myself an 06 MK4 GTI and loving it!!!!!! But, now to the problem. OBD2 port is not in its designated spot. I believe the previous owner had an aftermarket radio in the vehicle and put the stock one back in before selling it. Is it possible they could have pushed on the wires and pulled the port out of its little cubby hole? If I remove the radio should I have access to the obd2 wires/port? IF so is there a trick for removing the stock headunit or do I really need the special tab tools?
View 5 RepliesToyota - Tacoma :: OBD2 Gives Same Code Twice - P0420?
My Toyota Tacoma is reporting (via an affordable OBD-II scanner) the same P0420 code: First as a regular code, then as a pending code. What could that mean?
View 6 RepliesPrius (Gen 1) :: OBD Scanner From ECROS Won't Run
I purchased a Gen I prius (non running) two years ago for a very low price and kept it in dry storage. At the time it threw a P3125 code on the ECROS scanner and would not start.
I finally have the non-running one in my own garage and am trying to get it running. The HV battery has been charged to 285 volts by a DC/DC converter I built. Last year the car would power up the ECROS OBD scanner and throw a P3125 code and I could hear the main HV Battery relay connect then disconnect. Now when trying to start it the 12 volt systems work, the OBD scanner from ECROS will not run, it has power, but no data - no OBD signal I guess, and no HV contactor noise either. I took the Vehicle ECU out from under the passenger carpet and replaced it with a good one from one of our daily drivers and still no OBD signal. I have checked all the fuses and no blown ones in any of the three fuse boxes. With the used Prius ECU in the daily driver, the OBD does work, the daily driver does not start, but no error codes.
Why does the OBD II not fire up the ECROS scanner in the broken Prius?
Touareg :: Battery Died And V6 Couldn't Start
Bought my 06 Touareg V6 two weeks ago. Well the battery died and couldn't start 10 minutes after I got her home. So the battery was replaced with a new one and it has been fine since.
Well except for the fact that I have a Gray interior and the dealer put on the lower trim panels in front of the driver's seat from a anthracite colored interior!!
Around the trim that would be taken out to replace the battery. I would like to make sure all the parts are there when I get it fixed. [URL]......
Prius (2010-12) :: 2014 - OBD2 P0300 / Random Misfire
I hookup an OBD2 tester on my Prius 2014 Plugin and saw the OBD2 P0300 - Random Misfire. I did a reset and the error still came on. I also tested my friend Prius 2014 Plugin which is factory stock and had the same error. Wonder if that is by design or not. Going to take my ride into the dealer on Friday for my 25K maintenance and have them look into that error. P0300 can be anything. Hopefully doesn't cause more problems down the run..
View 3 RepliesFord F-150 - 1997-2003 :: 2002 - Couldn't Program Key Fob?
Bought a 2002 F150. NO door button pad, and the guy lost the FOB. I bought a new FOB, but i cant get the truck to go into program mode. Suppose to turn the key on- off, 8 times and horn beeps... I never get the beep. There is a 5 digit code on the card in the glove box, so i assume it came with remote entry. How to check ? There is also a small black box about 1 inch cube attached to windhield infront of thr mirror. Has a blue LED light on it and small wireharness into roof console area. My 2001 did not have this. Is it factory for compass or part of aftermarket remote start or alarm system ? Would something like that disable my ability to program the FOB ?
View 7 RepliesFord F-150 (2009-2014) :: Couldn't Get The Wipers To Turn Off
I just bought this truck 2 weeks ago, and it's been great till yesterday coming home from church when I couldn't get the wipers to turn off. I had them on very lowest intermittent setting, and then turned them off when it stopped raining. But every few seconds the wipers are still making a pass! The truck is an XL model, so it shouldn't have the rain-sensing wipers, should it? If it does, then where is the sensor, and is there a way to disable that feature? But the goofy part is that when I got in it this morning to go to work, it was fine.
I turned the wipers on intermittent again for a little bit to get rid of residual rainfall from overnight, and they worked fine. It's worked fine all day. I thought about calling the dealer back where I bought it from to see if there was anything they would do to warranty this seeing as I just took delivery 2 weeks ago, but never did. I figured if it's not going to replicate the problem, then they're not going to be able to fix anything. They won't know what to fix if they can't physically see what it's doing. The Ford dealer I bought this truck at is about 90 minute drive, so I would probably need to take a day off work sometime this week to deal with that. Another reason why I hesitated to call them.
I'm referring to my red beast, the 2012 F-150 XL 4x4, 3.7 V6/auto. Like I said, this truck shouldn't have the rain-sensing wipers should it? Not being the XL model? If so, where is the sensor(s) located at? Because the only water I could see on the glass was off to the sides, out of the reach of the wiper blades. As I scroll through the settings on the Information Center between the gauges, I don't see anything to activate/deactivate rain-sensing wipers. Is there a way to disable that, if I have that feature? Are these trucks common for multi-function switches going bad?
I used to have a Dodge truck back in the 90's, and musta' replaced about 3 of them in that stupid truck! In the 4 years I had it!! I'm afraid of a repeat experience in which I'm chasing down electrical issues for the next 10 years.
Caravan/Voyager :: 1996 / 3.0L - Scanner Does Not Link With ECU
I'm having trouble with my 96' 3.0L, its kind of crazy its intermittent and while driving the engines surges one or twice and then dies... when I try to crank it up again cranks but don't starts if I try again it wont even crank ( no starter winding up ) what I noticed is that is I'm driving when it dies my check engine light disappears for a while and if I connect my OBD 2 reader does not link up with the ECU if I wait a while and I crank it up again its starts and the while cranking up I can hear a bang noise from the engine compartment drives side and then after a couple of minutes dies again...
View 4 Replies