Accent LC (2000-05) :: GLS Key Won't Turn - Steering Wheel Is Loose
Girlfriend went to start her car on a nice cold day, and said it wouldn't turn over. so after taking her to work, i tried to see what the issue was . . . and the key wont move. the steering wheel is loose, i used the transmission override to move the stick back and forth a few times. still no go.
Did the hammer tap on the key, and used electronics cleaner on the switch in case something was stuck.
Oddity was, the door ajar chimes come on without the key inserted. So am I chasing electrical gremlins or what? the car is a base model without keyless entry.
Accent LC (2000-05) :: 2001 GL Transmission Shifting Hard Into Drive
I have a 2001 hyundai accent GL the transmission has started shifting hard when it shifts into drive. It shifts fine and smooth from first to second but when it shifts into drive it hits drive hard and sometimes it acts like it doesn't want to shift and if you let up on the gas it will go ahead and shift, but when it shifts to overdrive it seems fine but hits hard when it down shifts back to drive. Also I have noticed a couple times when it goes to shift into drive the engine seems like it revs up some but when you let off the gas it goes ahead and shifts.
View 3 RepliesSanta FE SM (2001-06) :: Vibration On Steering Wheel When Turn Hard Right Or Left
I've got a nasty groan and vibration on the steering wheel coming from my Steering Pump when I turn hard right or left. There seems like a little bit of oil around the pump and some traces of shiny metal (tiny sparkles) near the spline so I'm pretty sure the pump and pulley needs replacing.
View 1 RepliesCivic - Honda :: 2001 - Power Steering Intermittently Cuts Out And Wheel Becomes Really Hard To Turn
The power steering on my 2001 Honda Civic intermittently cuts out and the wheel becomes really hard to turn. The belt is tight and the fluid level is correct.
The weird thing about it, is it only happens in cold weather. Everything was fine all summer, but now that the weather has turned colder the problem has reappeared. Same thing happened last year. . .
Accent LC (2000-05) :: 2001 GL Won't Turn Over / Buzzing Noise Coming From Beside Cold Air Intake
I have an 01 Accent GL 1.6L. It will not turn over. Battery, terminals, and wires are all new. Alternator is also good. There is a buzzing noise coming from beside the cold air intake. I'm not sure what part that is. The part that is buzzing is where the cam position sensor is connected to. It also has wires that run into the firewall.
View 21 RepliesLexus ES 2013+ :: How To Turn Off Directions In 2014 Nav
Only have had the car for a couple of weeks. One problem that I have is that I don't know how to turn off the nav once the address has been entered and navigation started. My family changes their mind all the time and wants to go some some other destination in the middle of a trip. Unless a new destination is put in the nav keeps directing to the previous destination. How does one just simply turn it off?
View 1 RepliesAccent LC (2000-05) :: Suddenly Died When Making U-Turn / Vacuum Noise When Turn The Key
I have a 2001 accent 5-spd. I was on my way to work and I was making a u-turn when the car suddenly died. I tried to start it back up but it didn't even sound like it was turning over. I tried to bump start it or do a rolling start and nothing. I had to go to work. When I returned to it 8 hours later I again tried to start it and nothing. When I turn the key it makes a "whirring" or "humming" noise, kind of like a vacuum noise. When I had someone else try to turn it, I noticed the belt was turning, but the engine wouldn't crank or make any attempt to turn over. Just the belt was spinning and no engine crank. What could this be?? Could it be the crank position sensor?
View 1 RepliesSanta FE SM (2001-06) :: Noise While Turning Sharp In Both Directions - Tranny Fluid Leaking
Noise started a day earlier, drove slow and listened to the noise while turning sharp in both directions. Was noisy at full turns and mostly quiet going straight. At higher speeds a slight wine could be heard.
It was a clunking, grinding noise with a little steering bind and pulling. I assumed it was cv joints but but after jacking up the front end to inspect, I have tranny fluid leaking from between transfer case and tranny.
Last thing I expected was tranny, It shifts fine and just started leaking, NOW what am I facing.
Accent LC (2000-05) :: Hard Time Getting Uphill
This isn't my car, but It is my grandparents and I drive it often to my doctors 80 miles away, and to meetings 100 miles away. Both directions are very hilly and one of the road has 3 mile inclines. 2005 Hatch, Automatic.
Fresh spark plugs, oil change, oil filter, air filter. 95k miles.
Gas mileage is ok, but it has a really hard time getting up hill. I will be almost pedal to the floor going up the hill for 3 miles at 3k RPM.
Is this something I should be turning OD off for? I checked the manual and OD wasn't mentioned in the glossary.
Nissan - Frontier :: 2000 - Clang / Clunk Sound When Turn The Wheel And Drive Making U-turn
Every day I make a u-turn around the median in order to get to our driveway...which means I turn the steering wheel all the way to the left. As I turn the wheel and drive, there is a clannnngKK sound on the driver's side from somewhere near the front. I wondered if there is something getting hung up/caught "under there" but have no real working knowledge (obviously) of my truck's anatomy. It only makes this noise when I make this u turn. I've not heard it any other time.
View 1 RepliesAccent LC (2000-05) :: Hard Shifting Between Gears And Wouldn't Go Over 45
That said my wife bought a 2001 Accent 1.6L Auto while I was overseas and it's been a great car, about 8 days ago it just crapped out. The reverse went out on her so we took it to get the codes read and on the way it went in limp mode, started hard shifting between gears and wouldn't go over 45 she says. Took it in to the stealership today and they said that the trans is shot as well as showing codes for P1527, P0732, and P0734. I know what the two slippage codes are and I can prolly just replace the speed sensors and that will be fixed but I'm not sure about the reverse and P1527.
View 4 RepliesAccent LC (2000-05) :: Hard To Start When Filling Up The Tank
I have a hyundai accent, 2002, I have the typical hard to start when filling up the tank. My understanding is there are 2 Fuel Vapor Purge Valves, one in the rear next to the charcoal canister, the other is in the engine compartment attached to the intake manifold - is that correct?
Which purge valve is the culprit to the hard start after fueling the car? Why can I only find the rear purge valve when looking for parts - is the one up front a dealer only part?
Accent LC (2000-05) :: Tranny Slip From 3rd To 4th Gear Around 45 Mph When Get On Gas Too Hard
I recently bought a 2002 Accent with the 1.6 auto 133000 miles. I have been reading the postS around here about the crappy transmission. My car seems to have some life in the tranny still but it has slipped from 3rd to 4th gear around 45 mph when i get on the gas too hard. Its also a little sluggish to start off. My question is should i change the fluid out knowing i have a slipping issue? The reason i ask is that last time i changed the fluid and filter on a Jeep that was slipping i ended up having to rebuid it. Is that a real possibility if i change the fluid in this Hyundai?
View 3 RepliesAccent LC (2000-05) :: Trans Shifts Hard Into Second And Won't Go Into Overdrive When First Started
I have the p0734 and p0732 codes. Thing is it shifts hard into second and wont go into overdrive when first started. After about ten minutes of drive time you shut it off and turn it back on and the thing shifts perfectly. No hard shifts and overdrive works then check engine light turns off. The pulse generators have been replaced when i purchased car. It is an 02 accent with 90,000 miles.
View 3 RepliesAccent LC (2000-05) :: 2002 - Hesitation Under Hard Acceleration On Lower RPM
I have a 2002 Hyundai Accent with a 1.5L SOHC and manual transmission, with 207,000 trouble-free miles on it.
I have recently noticed a hesitation under acceleration. It happens most frequently under hard acceleration under lower RPM, if I'm close to lugging the engine. The engine "hiccups," almost like it is missing a cylinder. It will hiccup 2-3 times until engine RPM's increase, then smooths out.
What the cause may be? Last changes: Plugs at 175K; Plug wires @ 160K, Fuel filter @ 100K, Timing belts at 60K, 120K, 182k. K&N air filter cleaned at 50K intervals, last time @ 200K.
Accent LC (2000-05) :: Need To Push Clutch Really Hard To Allow The Gear To Engage?
2001 Accent 1.5 GL 165K miles.
The clutch doesn't engage until it's on the floor. I have to push real hard to allow the gear to engage. It then shifts... sometimes smoothly, sometimes it takes a hard push of the gear shifter, or it grinds until getting into gear.
I've changed the master cylinder twice in about 3 years but those times the pedal had no spring and just fell to the floor and stayed. Now, the pedal has spring (I push it to the floor and it springs back) so I assume the MC is ok. I even bled it with fresh fluid.
I'm not sure if the tranny fluid has ever been changed. Would changing the fluid fix this problem or does it sound like I need a new clutch? I'm guessing it needs a new clutch (or corresponding parts) since I've had two MC's go bad in a few years.
The pedal, even when it's shifting smoothly is pretty non-responsive and still engages a little mushy (comparing it to my 2012 Elantra 6sp).
Accent LC (2000-05) :: 2004 - No Reverse / Shifts Hard Into Drive
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 RepliesAccent LC (2000-05) :: 2002 - Hard Shifting Into 2nd Gear (Automatic)
The Accent has been working great recently until the other day when I got in to go to work and now it suddenly shifts very hard into 2nd. And sometimes 3rd.
This problem seems to come and go. Sometimes it will shift smoothly. Other times it will have to reach super high rpm and I will have to let off the gas and slowly accelerate to get it to shift. This seems to happen throughout all the gears and it does not make any difference if overdrive is turned on or off. Also reverse works just fine.
I checked the fluid and it is at the proper level. It does seem to be a little dirty (not burnt) so I am planning on changing the transmission fluid, but something tells me that is not going to solve this issue. It seems like an electrical issue to me. What it could be?
There are no codes at all on the car. Don't know if it matters but the car just turned over to 100k miles. I've been reading on here about all the problems the automatic trannys have in this car but 100k seems a bit early to have any serious transmission problems.
Accent LC (2000-05) :: 2004 - Clutch Lost All Resistance / Hard To Get Into Reverse
I'm not very mechanical when it comes to cars. I have never had any clutch issue with my car. I arrived to work yesterday fine. When I started to leave it was incredibly hard to get into reverse and I had to force shifting after I left and the clutch had also lost all resistance and I could easily push it all the way to the ground. What could be a cause of the clutch always working perfect including the last time you drove it, and then 8 hours later you start up and it has done a 180. The fluid level is fine. I would presume if my clutch had went I have have slowly noticed it going.
View 1 Replies