Accent LC (2000-05) :: Gearbox Stiff And Jamming
I own an Accent 2000 model Manual Transmission. When the motor gets hot , the gear lever become increasingly hard to move and eventually locks. i.e., after say 10 minutes.
If I stop the car, turn the motor off, the gear lever moves freely. Start the car up again and the gears seem to work for a while.. then it locks up again.
This happened about 2 months ago.... seemed to fix up for a while.. now its back permanently. I changed the trans oil.. it made no difference..
The cable to the trans seems ok.. When the motor is 'off' it never jams. BUT i am not using the clutch then !! Could it be clutch.??
Accent LC (2000-05) :: Gear Stick Is Floppy - No Resistance In Gearbox
l got a problem with my 01 hyundia accent I have no gears at all,the gear stick is floppy. I have looked at the linkage from the stick to the gear box it's all ok but as it enters the box it has no resistance. The clutch is about 1year old.
View 2 RepliesAccent LC (2000-05) :: 1.5L Engine Started Making Strange Noise That Sounds Like Sewing Machine
I own hyundai 2000, 1.5L. About 5 days ago the engine started making strange noise that sounds like sewing machine.
I went to my garage and they said that its the hydraulic valve lifters and that I should replace all of them(12 total).
My question is, what can happened if I wont replace them? can I postpone the replacing for a few months or it can cause damage?
By the way, I heard that the noise from hydraulic valve lifters can start due to bad oil, I had 20W50 so I changed today the oil to 15W40(manufacturer recommendation) and the oil filter and still got the noises.
Accent LC (2000-05) :: Pulsating Grinding / Whining Noise Coming From Engine
So I had all of my belts changed including timing belt and tensioner pulley as well as an oil change. After, I noticed a weird pulsating grinding/wining noise coming from the engine bay. It only can be heard once the car is warmed up. (It is much louder in real life.).
Car Noise - YouTube
Accent LC (2000-05) :: Manual Transmission Whine - Louder When Decelerating?
I have a 2002 Accent with a manual transmission with just over 100K. It has for some time had a low whine, which is getting worse. Not wheel bearings. The whine increases with speed, and seems a little louder when decelerating. Makes the sound in every gear and when in neutral (coasting at speed). Brought it into a mechanic and he thought bearings in the transmission (though I don't know why it would make the same sound when in neutral . . .). Shifts through all of the gears fine, no other odd sounds. Can't find any information out there that sounds like my situation.
View 4 RepliesAccent LC (2000-05) :: Sounds Like Marbles In The Front Wheel
I have been getting noise that sounds like marbles in the front wheel area. It doesn't happen right away, but after about 20-30 minutes of continuous driving you can hear it. It is louder the faster the car goes, and when you stop it the sound slows down and stops. There is no difference in the way she drives / handles with or without the noise, but I know she hasn't made that noise in the past.
View 8 RepliesAccent LC (2000-05) :: Vibration Sounds Like A Plastic Trim In The Dash
Here goes, I just took ownership in the last month of a Hyundai Accent GS(2000). Car's been going great, but I have now found an annoying issue with a vibration coming through the dash. When I'm accelerating in all gears (and esp up hill when the car is under pressure), a Vibration starts in the dash and stays until I am roughly over 3000 revs. I'm in Ireland, so the car is Right Hand Drive. The Vibration sounds like it is coming from behind the speedo clocks near to windscreen.
So far, I have removed the Center Console and Stereo and the Vibration stays there. I've reached in behind the console and cant find any vibration there. I have also driven with the speedo clocks removed and putting my hand into the space trying to find the vibration.....but no joy.
The vibration itself sounds like a plastic trim in the dash (or behind the dash), but it has my stomped! Can it be something in the engine causing it? Engine ticks over fine, not lumpy in anyway.
Accent LC (2000-05) :: 2002 GL - Strange Clicking Or Ratcheting Sounds
2002 accent gl. 96000 miles...strange clicking or ratcheting sounds that I thought were drivers side 1/2 shafts going bad...replaced it, still has the sound...replaced left shock-strut was bad as well. sounds like differential noise, almost like a baseball card hitting bicycle spokes! previous owner told me this sound has been there for over 1 year and he put both 1/2 shafts in as well, sound is still there. Trans was a little low on fluid(automatic/overdrive). tried driving car with o/d off, manually shifting and driving through all the gears, sound is still there.
View 3 RepliesAccent MC (2006-11) :: Gearbox Lever Lights Went Out
My automatic gearbox lever lights went out, the ones that say P R N D 2 L no longer light up, im not sure if its a fuse or something but I can't find the fuse for it anyways.
View 5 RepliesAccent LC (2000-05) :: Humming Which Sounds Like Knobby Mud Tires / Bad Wheel Bearing On Front Driver Side
I just purchased a 2000 Hyundai Accent. I was told it has a bad wheel bearing on the front driver's side. I am assuming that would be the clicking sound that associates with speed. I was told the cv joints or axles were replaced but have a leak. I couldn't see a filler hole or one to check from. I also don't see fluid under the car from parked. Also, there is a humming which sounds like knobby mud tires. The humming disappears during hard right turns.
View 6 RepliesAccent LC (2000-05) :: Grinding Noise While Driving
So I have a 2000 Hyundai Accent, 1.5L with an automatic transmission. I'm hearing a grinding noise when I'm driving. It gets faster as the car goes faster, but the engine RPM has no effect only the speed of the car.
I got new tires, changed the CV axle shaft on both sides, and I also changed the front struts as I was told that one of the struts was bad the last time I took the car for an alignment. None of that has had any effect on the grinding noise.
Then I jacked the car up on both sides and let the wheels spin, and the grinding noise is present that way as well. Then I jacked up just one side at a time. When the driver's side wheel is spinning, the noise is audible, but not when just the passenger side is spinning.
I then disconnected the brake caliper from the driver's side and held it up with a tie wrap to keep it out of the way. The noise is still audible when the wheel is spinning, so it's not the pads or a clip or anything like that.
So now I'm down to a couple of ideas.
1) Wheel bearings
2) Something is hosed in the differential or transmission. I'm guessing that the differential is more likely, as the transmission should effect both sides the same, right?
I'm going to check the wheel bearings now, though to me it seems unlikely to be the problem.
Accent LC (2000-05) :: 2003 - Grinding When Shift From 1st To 2nd Gear
Why my car is grinding gear when I shift from 1st to 2nd, & yes the clutch is fully depleted and still grinds when I shift.
View 4 RepliesAccent LC (2000-05) :: Repeated Click Or Grinding Sound When Turning
This started a few months ago. At first it only happened when making a hard right turn, its a repeated click or grinding noise. Over time it has gotten worse, and now happens when turning either direction, and its worse the faster the car is going. Turing into the parking space at our apartment is fine... turning from one street to another going to work is not. Various things I looked up suggested the cv joint, but when I went to parts stores websites to look up prices all it gave me was cv boot kits in the results. Is this whats actually wrong, and is it something easily fixed for a DIY person?
View 7 RepliesAccent LC (2000-05) :: 2002 - Gear Grinding And Leaking Slave Cylinder
When changing gears my accent grinds as if its not engaging properly? I checked my slave cylinder and the rubber was filled with silver looking fluid could me replacing the S/C fix the issue? I don't think its synchro issue i tried double clutching and still no difference. the grind sounds the exact same as it does when you accidentally release your clutch when changing gears and it hasn't engaged properly. I also changed my manual gear box oil.
View 2 RepliesAccent LC (2000-05) :: 2001 - Died At Stop Light / Grinding Noise
2001 1.5 Accent. It has not been starting consistently for the last few weeks. Ive had to use the jump box on it a few times and that worked.
The other day (cold day!) it died at the stoplight after driving for about 20 mins. It made a grinding crunch sound from under the hood as it died. After several attempts on jump box it fired up and ran again for about 15 seconds and died and made sound again.
This repeated itself a few times before I got it towed home.
I removed alternator and it tested good (PASS) at two parts stores...testing 3 times each.
Battery has about 14 volts at the posts without having charged it after event.
What would cause the car to die and make the awful sound? And why would it appear to need a jump start?
I was thinking alternator but.....
Accent LC (2000-05) :: Grinding Noise Coming From Driver Side - CV Or Bearing?
Noise sounds like its coming from driver's side. It's not terrible until you hit 30-40km/h, after that its quite loud. No whistling sounds, which i was told to listen for if it were a wheel bearing (although I ma not convinced is the only sound a warn bearing makes).
The sound sometimes goes away when I am on a bend turning left (taking the weight off the drivers side wheel).
Accent LC (2000-05) :: Grinding / Squealing Noise When Braking After First Start In Morning
Recently I've noticed more that when we first start the hyundai in the morning or after sitting a while and we use the brakes it grinds/ squeals a little and then doesn't after about 2 or 3 miles. Is this something to get checked out or should I spray something on my brakes to lubricate?
My next step that I though of was to get a simple automatic car wash cause it's been a bad winter in Rhode Island and the street shave been flooded with rock salt. I figure that might cause some friction under the pads.
Accent LC (2000-05) :: Light Grinding Noise When Let The Clutch Out / Pedal Super Hard
Yesterday I was driving home and my clutch started acting up. To start I was unable to press the pedal. The pedal was super hard, then let up but didn't feel right.
I removed the slave and the pedal went down fine. Both the master and the slave have no leaking and fluid levels are good. I haven't been able to have a buddy look at the levels when I press the clutch, but....
Here is a little more, the car shifts fine with the car off, it goes into all the gears, but with the car on it will not shift into gear. Also there is a light grinding noise when I let the clutch out..
I ordered a clutch kit already, but don't want to pull the trans if I don't have to, I would love to hear the issue is with the master or slave.....
2005 Hyundai accent with 138,000 miles
Accent LC (2000-05) :: Brake System - Front Right Wheel Started To Make Grinding Noise
I own a 2005 Hyundai Accent 1.3 SOHC and a while ago the front right wheel started to make a grinding noise, problem was related to the brake system..
So far I've tried replacing the rotor (disc), repaired the caliper (using a rebuild kit), replaced hoses (both), and event the master cylinder.... and the problem persists, it actually came to the point that after driving a while the front wheels will get stuck.
I've followed all the directions from the service manual and it still got the problem...