Prius (2010-12) :: Sunroof Rubber Edge Fading / Cracking Unevenly
Model Year 2010 Prius, rubber along the front edge of the sunroof glass looks dry/cracking, but only on the left side of the car. Don't think it has anything to do with the location it is parked in, as that and the orientation changes daily.
View 4 RepliesPrius (2010-12) :: Sunroof Glass Edge Rubber Rippling / Tearing
Gen3 2010, 15 months on the road, 62 000 km. While washing the car today I noticed that the rubber edge bonded to the sunroof glass is buckling/rippling/tearing. Cosmetic only, as far as I can tell - damage/wear doesn't permeate far enough down to cause a problem, I don't think.
View 2 RepliesDodge - Caravan :: Intermittent Brake Noise Like Rubber Rubbing Against Rubber?
I have an intermittent brake noise, which sounds like rubber rubbing against rubber. There is no discernable effect on the brakes, pulling, etc. My mechanic can find noting wrong with the brakes.
View 5 RepliesTouareg :: Oil Pressure Gauge Keep Hanging On 0 Until Driven For A While
I've been noticing recently that my oil pressure gauge has been hanging on "0" until I drive it for awhile, then it will go up to a normal level of around 180-200. It used to register the pressure quicker. The oil level is fine. In fact, I just had my 5K (at 6K) service a month ago.Again I ask, is this normal?
View 2 RepliesGolf VI R :: Cable Hanging Loose In A Loop Under The Car
After driving in heavy snow I noticed a cable hanging loose in a loop under the car in the mid section. What could this be ?
View 24 RepliesGolf IV R32 :: Little High Pitch Noise When RPM Hanging In Between 1K And 2K
My friend and I both have the MK4 R32. He had a bunch of stuff replaced in the engine. (a bunch of plastic parts that are super expense, the timing chain, something related to the guide, basically the plastics that holds the engine cushion/absorb) Anyways, his engine sounds great and quiet at the same time with a little high pitch noise when the RPM is hanging in between 1K and 2K.
Our cars were in the garage and I did the same thing and it sounded NOT quiet, a lot more noise than his. There was an obvious difference in noise coming from the engine with the hood open. I do have cams and a light weight pulley. Can that have an affect on the engine noise? If I am not making sense, then i should probably video record the sound or take it to the dealership for a check up. Also, I am at 93K.
Ford F-150 (2004-2008) :: Little Nub Hanging Of The Tailgate
What's up with the little nub hanging off the tailgate?
View 5 RepliesMontana :: Connector Hanging Off On Front End Around Radiator Area?
I just noticed a connector hanging off at the front of the van, around the radiator area. It's a blue connector with a yellow, green/black wire (see attached pics). Everything on the van seems to work fine, no alarms or dash message indicating there's a problem. I looked everywhere for a place to connect it, but couldn't find anywhere.
View 5 RepliesGolf IV / Jetta IV :: Wires Torn And Hanging From The Underside
After a bit of a crunch to the underside, i've noticed some circular metal covering broke back and some wires are torn and exposed just behind the front passenger wheel on the bottom.
View 5 RepliesGen 2 Prius :: 2006 - Driver Side Mirror Hanging Off
Came out from work today to find the driver side mirror hanging down. It is broken at the plastic swivel hinge where it swings in and out from the driver side door (should have swung it in!).
Currently I have it taped. It still works except that the whole mirror doesn't swing in and out. Dealer wants an arm and a leg to fix. Any tips on how to get in fixed a little more reasonably.
Prius (2010-12) :: Oil Change Door Broken And Hanging Down
2010 prius. Oil change door broken at front and hanging down, just scooping up the wind...
View 19 RepliesFord Excursion :: V10 - Hanging Idle / High RPMs
Not really sure if the V-10 is supposed to be this way or not. I've had quite a few of the 4.6 and 5.4, both the 2v and 3v variant. Never had them do it.
Basically, my V-10 doesn't idle down easily. I can do a neutral rev and it will hang out from 1,000 to 1,500 rpm for maybe 2-3 seconds, then drop to normal idle revs.
While in gear and slowing to a stop, it feels like the motor is fighting the brakes and I have to press harder to stop. It also comes off the transmission when going 35-40 mph and letting off the gas. Causes a weird lurch if I have to get back on the gas.
Not dangerous or anything of that sort, but very very annoying. And I feel it's costing me some MPG's since I drive 99% city and have lots of stops. Probably 1-2 MPG at max. Back in my 2v Mustang days I remember some of the guys were modifying the 4.6 2v IAC because of similar complaints. I'm trying to dig up that mod, but it's been a few years.
I plan on cleaning the IAC this week when I get the time
Lexus RX 2004-09 :: RX330 Making Odd Sounds - Something Hanging From Bottom Of SUV
I was driving yesterday and noticed the car making odd sounds. Turned it off and on again and noises completely stopped. Got up this morning and noticed something hanging from the bottom of my SUV near the front of the car. What it is?
View 2 RepliesGen 2 Prius (Audio/Electronics) :: Aux Input Cable Hanging In The Middle Of The Car
I would like to keep my ipod up in eye line view so that I am not looking down to change songs... I was going to buy the pro clip for the driver view, but realized I would just have a cable hanging in the middle of the car...
View 3 RepliesElantra XD (2001-06) :: Rear Parking Brake Cable Hanging
I noticed the rear parking cable's one end hanging. Not sure how to connect it. Appears a part is missing.
View 7 RepliesPassat - Volkswagen :: 1999 - Scraping Noise Under Car / Something Hanging Loose?
I've recently ran into some issues with my Passat. The other day while driving I noticed a scraping noise under my car. I got out and saw two bracket looking things were hanging down. As far as I know, nothing has changed to the driving but I want to know if it is something really serious. They are on opposite sides of each other, each about a foot length from the front tires (toward the middle) and one appears to be more bent than the other, probably due to scraping.
View 7 RepliesFord Ranger / B-Series :: Drive Shaft Was Hanging From The Rear End
I purchased a 1990 Ranger 4x4 with a v6 from auction. Took it to local shop to have them check it for me. Found out that it has a 3.0 in it and mechanic believes it is from a taurus. Truck actually runs extremely well. Has a few codes due to the ECM is for an automatic trans. Now the problem. I was on the highway-in 5th gear. Terrible noise the nothing. When I got it pulled over. The drive shaft was hanging from the rear end. It had been twisted like a straw. The transmission side had the yoke only, and the tail housing was cracked. It rolls and the drive shaft at the rear end turns. I figured the trans locked up. I don't know what trans to look for---is a 90 2.9 5 speed the same on a 3.0 ??
View 6 RepliesFord F-150 - 1997-2003 :: Factory Tach Needle Hanging Up
I've got a 97 f150 with 4.6l and my factory tach needle hangs up. Sometimes doesn't move at all and I can tap on the tach and it will work ok. Then I check it and it is stuck in the 2000 to 3000 rpm range. Can I take it apart and clean it or won't .....
View 2 RepliesGolf/GTI VI :: Rain Sensor Part Bumpy, Rear Mirror Was Hanging
A month ago, when I got into my car I saw that my rear view mirror was hanging freely with the tension of the rain sensor cables. My windshield was changed last winter. The thing is insurance company didn't change it with the original factory version. So I think they removed the rain sensor from the old one and tried to stick it to the new one. And the whether was so hot at that time so the glue just came off. The only part of the mirror that didn't came off was a black sticker kind of thing with a hole for the rain sensor in the middle of it. Then I tried to stick it back using super glue. Well it worked for a month but yesterday my mirror fell of again. So I cleaned the residue of the super glue from windshield using acetone and left it like that.
I'm thinking of taking the car to service now. Oh and btw the rain sensor part is a bit bumpy right now. I mean it doesn't stay in a fixed position. It stays a little bit in front of the hole it should stay in so gluing the mirror back is possible only if I apply the glue to the rain sensor.