Volvo :: 1992 960 Automatic Wagon Hesitates Then Clunks Into Gear - High RPMs
My 1992 960 automatic wagon with 326K miles has started to kind of lurch into low gear, especially from a stop or a rolling stop where I am not giving any gas but not using the brake. Then when I do give it some gas, it doesn't do anything at first, then it clunks into motion, and it seems to me the rpms are pretty high (3K). Once it gets going it seems fine, and it upshifts and downshifts as expected (well, occasionally it clunks changing gears at highway speeds, but it has done that for a long time). Yesterday during stop-and-go traffic (more than 100 miles worth) I was so stressed out wondering if it was going to completely die.
The winter mode arrow indicators have been stuck On for years, by the way, but it has never acted as if it thought it really was in winter mode (where you start up in third). They didn't think it was worth fixing, as it would have been very expensive and wasn't really affecting anything. I don't think my current issue could be that, though -- surely it wouldn't be clunking into gear then?
Volvo :: 92 940 GL - Gear Doesn't Want To Shift Into The Next
I have an automatic 1992 940 GL and it has been almost a year since the head gasket blew in the car. The gaskets and everything have been replaced as well as the fuel filter, transmission pulley, and timing belt. The car seems to run fine except for a small problem with the gears. When driving it's like it doesn't want to shift into the next gear unless you let off the gas a little bit which then it shifts over fine and it does this for all for gears. It has also recently started back to stalling out at a stop light or stop sign but very rarely.
View 1 RepliesVolvo :: 1990 240 Will Not Shift Into 4th Gear
My beautiful 1990 Volvo 240 will not shift into 4th gear! It is an automatic. The OD light will go on and off and I can hear it click when I turn it on. I just noticed that when getting on the highway it seemed as if the RPM was a little too high so I started paying more attention to which gear it was in and noticed today that it stays in 3rd gear.
I have already replaced the fuse #11. With the OD seemingly working fine, should I mess with the relay?
Volvo - V70 :: 2000 - Gear Shift Box Cracked?
I got into my 2000 V70 Turbo and noticed that someone had cracked the gear shift box. I didn't know what to think so I checked to see if they messed with the gear shift (automatic transmission) and thus were trying to steal the car by moving the gear shift into neutral and pushing my baby away. Nope. Gear shift looked ok. I put my key in and the car was totally dead. I popped the hood, looked about, then looked at my main fuse box. Someone pulled my air pump relay fuse. Oh boy! I went back to the gear shift to see if they messed with my emergency brake. I can't tell. So, I called the police and filed a police report. Here's my question: By pulling the Air pump relay--is someone trying to kill my ABS brakes and then when I'm cruising down the highway I have no ABS and my emergency brake is gone? Very scary thought here. Is my thinking clear, or is there another reason to remove the air pump relay and break into my gear shift box?
View 19 RepliesVolvo - 240 :: 1998 - Transmission Does Not Shift Into Overdrive (4th Gear)
My 1988 Volvo 240 DL a/t 200000 miles does not shift into overdrive (4th gear ). Is there a relay between the switch and the solenoid?. Is it okay to drive over 40mph.
View 1 RepliesVolvo :: Gear Shift Got Stuck In Neutral - Control Rod Loose From Transmission Lever
Volvo Automatic 1992 240 - So, just started to back out of the garage and, all of a sudden, my gear shift got stuck in neutral and then started shifting without engaging the transmission at all. Pushed it back into the space and, taking a look underneath, I realize the control rod's completely detached from the lever in the transmission.
I can re-attach it, but it just comes loose again when I shift. It seems like something should be in there to hold the control rod in place with the transmission lever, but I don't know what because I can't seem to find any documentation on what everything should look like down there.
Attaching a couple shots, one with a circle around the area that's coming un-attached since the angle's a bit off.
Attached File(s)
IMG_8972.jpg ( 1.09MB )
IMG_8978.jpg ( 938.64K )
Volvo :: 1992 - Speakers Are Blown
I own a 1992 Volvo 240 and most of my speakers are blown. I want to get new speakers (all 4 of them) but I don't want some old salvaged Volvo 240 speakers. I want to buy some nice new speakers. I'm new when it comes to anything involving changing something in a car, so what speakers will fit and easily take place of those speakers where I won't have to do any unnecessary cutting or modify in order to get them to fit (I don't want holes also).
View 19 RepliesVolvo - 240 :: 1992 - Idle Very Fast
Car has begun to idle very fast ( comes and goes ) ( 1992 240 ) ....
View 2 RepliesVolvo :: 1992 240 - Sputtering / Stalling And Not Starting Well
1992 240. A couple days ago, the car started fine, but immediately started running erratically, feeling like it was about to stall out at lower speeds and then, whenever I gave it a lot of gas, it would stall out or nearly stall out.
Then, after about 5 minutes of driving and then stopping the car, it took about 15-20 seconds of turning over to start. After 10-15 minutes of driving, all seemed fine and it started totally fine after that a little later that day. Next day, same issue takes a lot to start, stalls when I press down on the gas a lot/suddenly from low gear.
Not sure if it has anything to do with it, but we live in Los Angeles and it's just now started to get "cold", with our first chilly day same day this started happening, on Monday.
Not sure if it's the air intake or a fuel injection issue....
Volvo :: 1992 Stalls When Hot / Restarts After About 20 Minutes
Have swapped the following parts from my 92 240 into my 93 240 without any change in my stalling issue:
AMM, coil, ignition module, fuel relay, spun all fuses and checked hose between throttle body and AMM for holes.
Was super hot in NM today and after driving the car about 1/2 an hour it stalled and would not restart until it cooled off for about 20 minutes.
It doesn't seem to matter what level the fuel tank is. Stalled the other day when it was full.
Volvo :: 1992 - Bulb Out Dashboard Indicator Came On
My "bulb out" dashboard indicator came on and after checking all lights I could not find a burnt out bulb. I took the car to the local dealer and they told me the "bulb failure relay" was bad and needed replacing. I decided to try and replace it myself but so far I'm not doing to good.
I found this picture on another website and also read that the realy is permantly mounted to the relay board. Also, when I looked at pictures of the replacement relay they lok nothing like the original.
So now I'm wondering how the heck do you take the old relay out and get the new one in that doesn't at all look like the original?
Attached File(s) : RelayPanel760960A.gif ( 31.06K )
Volvo - 740 :: 1992 - Grinding And Vibration When Slowing Down From 15 - 0 Mph
I own a 1992 Volvo 740 wagon, non-turbo. Super solid car up until a month ago when it developed a grinding sound and vibration when slowing down from 15-0 mph. There is no noise or pulsating at any other speed when I apply the brakes. This happens with tranny in N or D. I replaced the front rotors and pads about a month before this started happening.
I suspected the rear brakes so I also replaced the rotors and pads but I was still getting that grinding/ vibration. The next thing was to replace the hub/bearing assembly, I only did the drivers side because I banged it up pretty bad when replacing the rotors. This also had no effect on the grinding. I also noticed that when driving at moderate to fast speed I hear a humming noise, almost like big truck tires make. This is especially noticeable when letting off the gas and coasting. Could this be a tranny issue?
Volvo :: 1992 - Shivering After Running For 20 Minutes At Speed Between 90 To 110 Km/h
1992 Volvo 240 ... I'm having car jerking problem after running for about 20 minutes at speed between 90 -110 kph. Car stabilizes again when the speed comes back to 90kph. There is no problem initially when running beyond 120kph when the engine first started up. The problem only starts after a short while.
View 1 RepliesVolvo :: 1992 - Won't Start - Change The Crank Sensor?
Cranks strong, I have fuel to the rail, 12V at the injectors and spark. Have changed crank sensor and 2 relays?
View 3 RepliesVolvo :: 1992 - Engine Sputtered And Turned Off When Car Go Through A Puddle
I just got caught in the rain, literally, a freeway ramp was partially flooded, saw other cars go through a "puddle" and with safety distance proceeded. About 9 feet away from the edge of this water accumulation my engine sputtered and turned off on me and I recall seeing some, but not much white smoke coming out of the hood. I didn't leave the car as when I look right next to me I saw only water, about 1/2 the height of my tire surrounding me. AAA came pretty fast and pulled me out of that wet mess and mentioned it could be just as simple as overheating. It's about 2 hours later and I tried my engine but all it does is struggling to turn on. I turned it off immediately. I checked my coolant level - empty as it can get, and also my dipstick in the oil seems to be not right. Transmission fluid is fine though. Could those two fluids be the problem to why my engine is not starting? Or could it be that something got too wet? Once I turn the key in the 1 position shows electricity is fine and all lights come on with Overdrive and SRS going off after a short while. 1992 Volvo 240 ...
View 4 RepliesVolvo - 240 :: 1992 - Loud Clunk When Flooring The Gas Pedal
When I 'hit the gas' I hear a loud clunk or short scratching noise (definitely metal) before the engine starts revving up. I've researched the issue a bit but found no concrete answers. Motor mounts, timing, transmission issue? No one thing seems to cause it as far as I can tell.
I got my '92 Volvo 240 Non-Turboalmost a year ago and haven't really thought much of the noise, but I'm coming up on a 500mi trip to Northern California. I want to make sure it's in tip-top shape before I leave. [IMG]
Volvo :: 1992 850 Estate (wagon) Making Noise When Driving
I have a 1992 850 Estate (wagon) which has been making a funny noise when driving. I cannot locate it. The noise only happens when driving, I have never herd it when stationary. Most often when cold but not exclusively. I have examined all the items attached to the engine driven by the serpentine belt all run smoothly. The belt was changed just after I bought it.
I have checked the wheel arches to see if the tyres rub but no. The suspension is fairly new with new anti-roll bar links fitted for last MOT. The noise sounds like a dry bearing and is a combination of a rub and a screech, there is no loss of coolant but I suspect the water pump or one of the tensioning rollers to be at fault. The last owner told me that the belt had been changed a few months before I bought the car (off Ebay) but he did not say anything about the rollers or water pump and I did not ask.
One other point is that when I bought the car I had to add a full 5 litres of oil to the sump due to their being no oil on the dip stick. Since then the engine has run well (good engineering) but this noise is happening and as I have said it is driving me nuts.
Attached File(s)
volvo_011.JPG ( 588.86K )
volvo_008.JPG ( 530.3K )
Volvo :: 1992 960 Sedan - Child Seats Anchor Points?
We are considering the purchase of a 1992 Volvo 960 sedan. We have two young daughters who both need to be using child seats. I cannot work out where the anchor points are for fitting the seats.
View 1 RepliesVolvo :: 1992 240 Wagon Intermittently Stalling / Missing - Loss Of Power
My 1992 240 wagon (injection) is intermittently stalling, and missing. The lambda light is on the dash. Last year it was doing something similar, but not as bad, and I took it to Volvo and they cleaned the throttle body and said it should be ok, and it was for a while, but now it's worse. Ignition parts are mostly new, I doubt it's that. When it stalls it nearly always starts straight away. When it's missing badly but not stalling, pressing the acc peddle does nothing, until it eventually catches on and revs properly.
I also find that when I have a full tank it's not so bad. When the tank was nearly empty it was particularly bad - it's winter and I was suspecting there was condensation in the tank.
Is there a 'backyard' way of getting the error codes? This could be a good start.