Golf IV / Jetta IV :: Clutch Chatter When Starting Off In First And Slippage In 5th Gear
I installed a new clutch, pressure plate, and flywheel at 154,000 and I'm now just over 155,000. I drove it very conservatively for at least 1,000 miles, and had no issues whatsoever.
Now, after sitting for a day, starting off in first gear, I'll get some clutch chatter. Outside of first starting out in 1st, every other gear is solid. And the 1st gear chatter tends to get better as the car is driven longer.
Secondly, it happened today, I'm getting what I thought I experienced before as clutch slippage in 5th gear: I'll lose acceleration as if the clutch is slipping, but the revs won't spike even if I tap the throttle. If I come off for a second and go back on, everything is fine. It doesn't make sense that's it's slipping as it's brand news.
It also seems to happen when it's been rainy or wet, but that could be all in my head.
Golf/GTI VI :: Clutch Engagement Failure Or Slippage
I have experienced what I believe is clutch engagement failure or clutch slippage on three occasions over the last 2000 miles on my DSG equipped 2011 GTI. Twice from a complete stop the engine rev to 3000 rpm but the car did not move. I let off the gas then tried again and the car accelerated normally. Once, again when accelerating from a complete stop the car moved relatively slowly while the engine revved, the clutch then seemed to fully grab and the car accelerated normally. I plan to get the car into the dealer in the next couple of weeks but I fully expected that the service staff will not be able to replicate the problem since it occurs infrequently.
View 15 RepliesGolf VI R :: Clutch Slippage / Failing Flywheel
I have a stage 1+ tune, fuel pump, and intake. I ran into some clutch slippage and I decided to purchase an aftermarket clutch that was designed to mate with the OEM dual mass flywheel. I went this route because I had a single mass on my GTI and it was loud. I figured this would be a good solution to avoid the noise and be able to hold the added torque.
I broke it in as the instructions stated. After break in I gave it some throttle and I notice that there is severe slipping occurring. I have the clutch and flywheel pulled back out and sent back to the clutch manufacturer (they requested to see the flywheel despite it being the OEM one). The manufacturer states that the clutch is fine but the OEM flywheel is failing. They refurbish the clutch and ship it back to me with the flywheel. I take the flywheel to the dealer and explain that I suspect the flywheel is failing and divulge that I have some light modifications. The dealer shows me paperwork that they had behind the counter that says that any transmission issues on cars A, B, C, and D require an immediate contact to their VW rep and an opening of some type of file on the failure (forget what they called it). What's on the top of the list? The Golf R of course. They go on to tell me that they need the car to start this process and they will do nothing with the removed flywheel that I brought to them.
So at this point, my car is in pieces at the shop that I use and I've been without it for going on a month. I will also, obviously, end up having to pay double the labor for the install. I am also going to be out some more money to come up with a viable solution as I still don't have a functional flywheel. So what do I do?
I could purchase another OEM flywheel for about $800. My concern here is the OEM flywheel busting up again and being in exactly the same spot that I am in now. I could purchase a new aftermarket clutch and flywheel combo and scrap the hope of avoiding the noise and sell the refurbished clutch I have to try to recoup some of the losses. Not sure what other options I have, if any.
Needless to say, I am feeling pretty unhappy about this whole thing. I've landed in a place where I am going to end up shelling out twice as much cash as I should have to get a clutch in my car. Burning a couple of grand to get absolutely no benefit stings more than a little.
Golf/GTI VII :: 2016 - Stage 1 Low Output Clutch Slippage
Went APR low output stage 1 on my 2016 GTI PP 6MT W/ Less then 5k miles on it. Clutch immediately started slipping in high torque situations.
View 4 RepliesTiguan :: Slight Slippage From The Clutch
Just installed APR stage 1 software around 1000 miles ago. The power increase is great, though the last couple days i noticed a slight like slippage from the clutch. I dont do any burnouts. Just open it up,( full thottle) here and there. Always let the car reach operating temp before i start driving. I am afraid that the stock clutch is going to go on me. By the way the car only has 2600 miles on the odo...
View 3 RepliesSonata I45 (LF 2015+) :: Transmission Rough / Shifting Lag Or Slippage Only In First Gear
I around 1200 miles. The car would get going when i give it gas but it feels as if their was shifting lag or slipage. Only in first gear. Doesn't happen all the tho..usually happens on rolling stops... is this normal?
View 6 RepliesGolf IV R32 :: Clutch Would Not Go Into Gear
Just bought my first r 32 recently , had previously owned a 20th anniversary GTI, anyway guy i bought the car from mentioned the awd system was not working , recently was driving and clutch would not go into gear in addition to the haldex or awd not functioning . The clutch also kinda "stuck" to the floor .. Also I noticed some fluid on the undercarriage the day I brought it home . I'm pretty sure the car was beat on but there aren't many available up this way , and honestly I know I'm prob gonna spend some to get her road worthy again , Also felt like the car was operating in rwd for some reason and traction control light is on.
View 3 RepliesGolf VI R :: New Clutch - 1st Gear Stuck
Car: 2012 Mk6 Golf R
Mileage: 43,000 km
Software: UM stage 2 loaded
Related mods:
- diesel geek short shifter
- Emmanuel design, Sachs SRE stage 2 SMf clutch kit
- Tyrol sport deadest rigid collar kit (probably not related)
Background info:
Clutch installed at 40k km.
0-500km stop and go traffic
500-505km punched it bc a 350Z pissed me off*
506-1200km highway and not very aggressive twisters
1200-3000km hwy and city mix
First 0-500km I babied the clutch. No issue
501-505km I punched it a bit hard. Felt great. No issue
506-1200km hwy there, no issue. Closer to the 1200km mark the issue surfaced
1200-3000km was able to repeat the issue and adjusted diesel geek ss and re-bled the clutch in attempt to resolve it
Issue:
- from dead stop, 1st gear gets locked in at 2-4k rpm
- either I rev up beyond 4k, drop below 2k rpm to unlock it
- if I man handle n yank it out of 1st, gears grind
- only happens when the car is fully warmed up and fully running at optimal temperature for at least 10-15 minutes
- diesel geek ss readjustment
- re-bled the clutch (no topping off the clutch lines)
Issue was improved, however, I'm experiencing this locking issue again. Less frequent and less predictable. Attempted to replicate the issue, only happens if it's stop and go traffic-jam speed. Was unable to focus on an rpm range.
Golf IV R32 :: 02m Clutch Does Not Slip In Any Gear
So long story short, my clutch is not disengaging all of the way, but only sometimes.... I have replaced clutch, flywheel, slave cylinder, new stainless steel clutch line and new clutch master cylinder all within this month. The same issue has been occurring prior to replacing all of this and also after replacing all of this. I've bled the system (with a power bleeder) more times than you can count on both of your hands so there is no way there is air in the system.
More details : The clutch doesn't slip in any gear. Stop and go traffic in first gear is really the only time I notice it not disengaging. I can't pull it out of 1st gear when it happens so I have to shut the car off to get it out of first gear. When it's stuck in first gear with the clutch pushed in (on a flat surface) and I let off of the brake the car creeps forward. Not at full speed like if I were to release the clutch pedal all the way but its still semi engaged enough to make the car move.
Replacing everything theoretically should have fixed all issues, but it hasn't. The only thing I didnt replace was this piece of the factory clutch line.
Tomorrow I am going to take the stainless steel clutch line and run it straight to the clutch master cylinder bypassing that weird silver box and hope that fixes it. As a side question what does that silver box do anyways?
Golf/GTI VI :: Clutch Was Slipping When Hit Third Gear
So I have a stage 2 endurance clutch and light weight flywheel on my car. I had not really gotten on it of late until yesterday. I was getting on the highway and really got on it. When I hit third gear it felt like my clutch was slipping. I have only had it on the car for like six months and about 10,000 miles. It could be worn out all ready? And after the incident yesterday I pushed the clutch in and held it to let it cool down a bit after it did it held fine even in higher Rpms didn't feel like any kind of slipping. Pulled very strong. This morning after having all night to cool off (and I mite just still be freaked out a bit) but it seemed to feel different, like a possible slip at 3,000 Rpms but again I mite just be freaking out about nothing. What does a master cylinder or slave cylinder going out feel like?
View 1 RepliesGolf VI R :: Clutch Clicking While Shifting Between 1st, 2nd And 3rd Gear
Last couple morning here in Michigan we've seen temps in the low to mid 30's. The last two mornings when I shift between 1, 2 & 3 I'm hearing a clicking noise coming from the clutch when engaging the gear. After a few minutes, once it warms up, the clicking goes away.
I am @ stage 1+ W/VWR intake, but I'm not expecting clutch troubles from that.
Golf/GTI VI :: Clutch Slipped A Bit On Highway In 6th Gear
I have a 2010 GTI and I got the APR 93 octane chip about 6000 miles ago. The other day I pushed the gas to pass a car on the highway in 6th gear and it sounded like my clutch slipped a bit. It made me quite nervous as the car only has 10,000 miles on it. I'm hoping maybe it just got glazed over a bit.
All of my other cars had manual transmission so it's not my driving skills and I don't beat on my car either. My last 2002 GTI had 150,000 miles on it when I sold it and 140,000 of those were chipped. Never once did that clutch slip.
Golf IV R32 :: Clutch Pedal Went To The Floor When Get It Into Gear
So my clutch has been acting up lately. When it sits for a few hours the clutch engagement point seemed to creep down but over the course of 35 minutes of driving would work its way back up again. Today it was unusually low and wouldn't let me get it into gear. I tried pumping it a few times and realized it wasn't coming back up all the way, I pulled it up and then tried again and it just dropped right to the floor where it now sits. Fortunately I was at work and can hang here until my ride arrives, and will just wait until late tomorrow night to drive it to my shop without stopping...
My guess is I need a new clutch master cylinder. I have plenty of fluid in there although its a bit old so I'll be changing that when I change the cylinder. Could it be the slave cylinder? If so is it a bear to change that? (do I need to drop the trans?)
Golf/GTI VI :: Drop In Clutch - 5th Gear Slipping
So I got my stage one flash yesterday and I noticed 5th gear slipping already. I don't plan on getting a k04 upgrade, maybe stage 2 down the road. so I am looking into the drop in clutches, preferably this one [URL] .... I am just trying to find out some reviews from people who are currently running drop in clutches and the issues that they have come across.
View 8 RepliesGolf IV / Jetta IV :: VR6 Could Not Go In Gear When Release The Clutch
I drive a 24v vr6 GTI in 6-speed I was coming home and as I turned and got on the gas a little and all of a sudden there was a pop and my car couldn't go in gear when I release the clutch. Luckily I was close to home and basically cruised in neutral. I jacked it up and found that my axle is twisted. Now I was aware the boots were torn before so I'm assuming the axle got screwed up but my other concern is, why won't my car go in gear? Here's the photo of inner CV. I'm hoping it's just an axle and not the clutch.
View 8 RepliesGolf IV R32 :: Clutch Whining Sound In First Gear
When I drive my car and its still cold in a first gear i let it go from clutch there is this whining sound... It sounds like its coming form suspension not sure
View 3 RepliesGolf/GTI VI :: Clutch Slipping When In 5th Gear And RPM Increasing
So I was driving my car and notice when I was in 5th gear the rpm was at 3 and was increasing to 4 then when back to 3 or 3500 rpm. I tired it again but with a little more gas to it and got the same results. Wondering if this is signs of clutch slipping or another cause.
View 5 RepliesGolf VI R :: 2012 - Clutch Slipping In 5th Gear?
I have a 2012 Golf R 6 Speed manual, Just noticed that my clutch was Slipping in fifth gear when I give it gas. What clutch kit is recommended. It is the first time I have a VW and dont really know what will work better on it. Mods are Full catless downpipe and exhaust, Injen air intake and Revo stage 2 tune, ST Coilovers and NICHE Bronze wheels. Podi boost gauge and AEM wideband. I put down 285hp and 310TQ at Dyno jet 2 weeks ago I was kind of suprise expected a bit more but maybe the clutch was going bad already.
View 1 RepliesGolf/GTI VII :: Squeak Like Noise When Clutch Engages In 2nd And 3rd Gear
Currently driving a GTI mk7 autobahn 6MT, this is my first manual transmission i have owned.. and have a question about a squeak like noise i hear when the clutch engages in gear 2 and 3.
This does not happen all the time, however i noticed that some / most of the time when i slowly let the clutch out in gear 2 and 3, right after the clutch engages and i let it out the rest of the way, it makes a squeak kinda sound.. almost like springs contract / retracting, i can also slightly feel it in the pedal.
Question is ...is this some what normal? i have never owned a MT car, and cant remember if such a thing happened while driving friends / family MT in the past..