Ford F-150 (2009-2014) :: Springing Sensation When Going Downhill And Brake Pedal Depresses
I have a 2009 F-150 Supercrew. I have noticed that when I am going down a hill and hit a bump with my foot on the brake pedal it depresses and I get a springing sensation from the pedal. It almost feels like I am depressing a spring with my foot and then it comes back to normal ???? Just yesterday I was on an off-ramp of the interstate in a sharp curve and it did it without hitting a bump ???? What is causing this or how to fix it ??
View 1 RepliesCamry :: Adjusting Parking Brake (E-Brake) Pedal On 6th Gen Toyota
I have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 RepliesToyota - Tacoma :: Engine Pause / Subtle Forward Sensation When Idling With Foot On The Brake
My 09 Tacoma 91000 miles- symptom: when idling with foot on the brake, on occasion, experiences engine pause/subtle forward sensation; otherwise drives superb. Service shop said the issue is remedied by replacing the drive shaft thereby switching out the "yoke" which is the source of the problem. Shop said this is a common problem with 09 Tacomas. Does this need immediate repair or can I drive safely?
View 19 RepliesToyota - Camry :: 2005 - Brake Pedal Almost Sinks?
We have a 2005 Toyota Camry, had it since 30K miles/2008, now has 94K miles. Since we have owned it, the brake pedal feel has not been great, kind of mushy. It is the way this generation Camry's are. It gets driven mostly on fwy, so not much brake use. At 92K miles I changed the front pads and rotors, pads still had 30% left on them. The rotors were somewhat warped. Brake fluid has been gravity flushed every 2 years since 2008, last one in 2012.
Now, the problem is when wife drives it, twice at a lengthy red light, she has noted that the brake pedal "almost" sinks. It did not go to the floor, but the level went lower. The car did not move during this events. With the newer ABS brake systems, on all my three cars, after a full stop, I can push the pedal down further, almost close to the floor. The Camry is the same way, just with a baseline of mushy pedals. My wife only drives one of the other ones (Dodge Caravan,)and has not complained about that one.
The brake fluid level is solid/steady, no leaks at the wheels either.
Now looking at whats involved, seems I can change the master cylinder myself. The question is do I need to? I don't mind paying a mechanic to do a diagnostic too, just not sure what they are going to do. I believe, just as a defensive measure, they will go ahead and change the MC (which then I might as well do it myself). I could also continue to drive it, but don't want to be stupid here.
Touareg :: Squeaking Wipers - No Smooth Motion
I replaced my wipers and it was working fine for the first two weeks. Now it seems to wipe with some resistance. It doesn't have a smooth motion going up and down. I really can't explain it perfectly what wrong, but when the wipers go up it's like something is blocking the lower part of the blade from having a smooth motion.
View 4 RepliesToyota - Camry :: Brake Pedal Is Softer Than Before So Have To Push Harder To Get Car Stopped
I have a Camry at 120K now. Front brake pads was placed at 85K and was told by the maintenance person at that time that brake rotors couldn't be resurfaced since they were close to the minimum thickness.
Braking seems still fine these days. I don't hear any high-pitched noise or feel obvious vibration/pulsation when the brake is applied. The brake pads are still within a good range of thickness as the last check was made a couple of months ago.
But the brake pedal is softer than before so that now I have push harder to get car stopped. It that a warning sign which indicates it is time to replace the brakes rotors and pads?
Toyota - Camry :: 1999 - Brake Light Comes On Sporadically / Pedal Needs To Be Pressed Down Farther
I have a 99 Toyota Camry and recently the breaklight has been coming on and off sporadically. I assumed I had done some damage to my E-break, as the other week I tried to back out with it on (cut me some slack, I just moved to PA after having only really driven in FL lol). I wasn't worried about it since I didn't notice any issues with my breaks, however the last few days I randomly have to press the pedal down almost to the floor to come to a full stop. There doesn't seem to be any consistency to this, sometimes it happens when the light is on but usually not. It does it both when I am stopped (causing me to move forward slightly till I depress it farther), sometimes when I am stopping normally, both when I'm going straight and right after turning, ect.
I checked my break fluid level and it is at the minimum line so I doubt that is the issue. I did some research and saw many saying that it was likely just air in the lines and that the system needed to be bled. But some also mentioned replacing the master cylinder so I wanted to see what response I might get on here (I don't know very much about cars myself).
Toyota - Camry :: 1993 - Jerky Motion When Making A Sharp Turn To The Right
A few months ago I had the passenger side Control Arm replaced. Over a year ago I had them both replaced with after market parts. I went into the dealer and was told the reason the parts failed so soon was because the parts were aftermarket parts and that I should have them replaced with original Toyota part. When the passenger side failed again, I had the dealer replace it with an original Toyota part.
Here's the problem: after they replaced the one side with an Toyota part I took my car and immediately when making a sharp turn to the right the vehicle making a jerking motion. It was unnerving the first time. It felt as if the vehicle might turn over. I noticed that this only happen or mostly happen when making a turn to the right.
Also, as I'm accelerating the vehicle will pull to the right the abruptly jerk to the left. What I was told by the dealer is that scene replaced the one side with a Original Part and the other side was an aftermarket part, the two not being of the same quality were what I felt he was saying that the parts were slightly different in size and would cause this problem.
Toyota - Camry :: 2002 - Jerky Motion When Driving On Freeway And Check Engine Light Came On
I have 2002 camry 4 cylinders and has 175,000 miles. I was driving on the freeway and suddenly I felt a jerky motion and check engine light came on. When I stopped at light the car began to vibrate and when started driving at low speeds it got me home. Admittedly I had put lot of hard miles on the car in past 6 months and I was lazy in getting oil changed in time. It might have been 7000 miles since oil chg. I took the car to local oil change place they did not mention anything about engine but they said my transmission oil was dark and burnt. They said I should flush and replace. I agreed and tech said he had to do second flush as oil was still dark. After second flush, he said its little bit better.
I was hoping this would solve my problem but unfortunately no. Car was still vibrating and when i drove at slow speed it was driving but as soon as I tried to accelerate the car lost power. Check engine light has been on since the incident at freeway, but now check oil light and battery sign came on. The power steering lost power. I had to park the car and restarted, as long as I drove very slowly it would drive but if I tried to accelerate where the rpm went from 1 or to next level car would loose power with warning lights on. I had recently replaced fuel pump, filter and any repair which was suggested to me. Admittedly I have not done timing chain or belt.
Dodge Neon :: 2000 - Clacking Noise At Low Rpm After Releasing Gas Pedal
2000 Dodge Neon clacking noise at low rpm after releasing gas pedal. Around the 2000 rpm range letting off the gas produces a clacking noise. I have listened to the engine with a long screwdriver at idle and revving. The noise is not always present in this condition. Although when it has come up it seams to coming from behind the engine. Does not seem to be valves, connecting rod or main bearings etc.... Only at low rpm 1200 thru 2000 rpm WHEN releasing the throttle. Clacking seams to be timed with the crankshaft as it reduces the sound as the engine reduces rpm, not at the speed of the cams. Sounds fine at idle, going through gears and at freeway rpm's.
View 1 RepliesToyota - Tacoma :: 1997 - Slight Stumbling / Hesitation Sensation
I have a '97 Toyota Tacoma, two-wheel drive. It has 154,000 miles on it. During the last three weeks, there's been a hesitation/ stumbling sensation happening occasionally in the first three gears. It doesn't happen in 4th or on the freeway. At first, I thought it felt more like a "slipping", like a clutch going bad (since I still have the original clutch).
I had my mechanic check it out, and it's fine. Here's a brief history of recent work done. Three months ago: injectors removed and cleaned out on a special machine. I replaced the cap & rotor and spark plugs. The wires were replaced last year. I replaced the fuel filter and PCV valve. I cleaned out and replenished my K&N air filter. Last week, I checked the connections where the spark plug wires connect to the cap. They seem fine.
Toyota - Sienna :: Brake Pedal Goes To The Floor And Car Does Not Slow Down
My Sienna 2005 experience intermittent complete brake failure 3 times within 18,000 miles,the brake pedal goes to the floor and it does not slow down, so I coast until I stop. However, when I release the brake pedal and then reapply the brakes, it works fine. A non-Toyota mechanic thinks it's due to malfunction of ABS. The dealership is unable to finds error codes and brakes work fine when the Sienna is in their hands. I scared that the brakes will not work the next time I reapply the brakes.
View 30 RepliesToyota - 4Runner :: Low Brake Pedal After New Pads And Bleeding?
A 2000 Toyota 4Runner was stopping fine. A mechanic informed me that the brake pads were worn down. After the pads were replaced and bled the pedal sinks lower than before and the car requires more pressure to stop. I can pump up the pedal after 3 pushes. I took it back and he has since re-bled the brakes but the pedal still sinks low.
View 15 RepliesToyota - Corolla :: Brake Pedal Squeaks When Released
My brake pedal squeaks when I release it, for the last two weeks. Does this mean I need maintenance, repair, or some oil?
View 6 RepliesToyota - Tacoma :: Brake Pedal With No Resistance In The Morning
Brake pedal goes to floor with no resistance first time I start in am. Rest of day all normal. Started when cold weather came. Fluid ok, no leaks seen.
View 3 RepliesToyota - Tacoma :: 1977 - Brake Pedal Sticking Down
My brake pedal is sticking down every time I push it in. I tried replacing the spring that was in there with a stronger one and sprayed the whole unit down with an all purpose silicon lubricant. It seemed to work a little but the problem is far from solved. It seems like it is sticking somewhere further away from the pedal. Master Cylinder maybe? I selected Tacoma because it's the closest option to my truck, but it's actually a 77 pickup/hilux.
View 4 RepliesGolf V R32 :: Front Brake Pads Makes Clacking Noise
The front pads on the R shift from one side of the caliper to the other whenever I move from forward to reverse they make a loud "clack". I thought it might be an O.E. pad issue, but I've changed the pads out to EBC's, but still no bueno. The new pads fit snuggly into the calipers and seemed to have solved the problem at first, but about 5k km's in, they're making the same noise.
I have anti-rattle springs installed, but they're not working. Is there supposed to be a pair of shims between the caliper sliders and the pads grooves that the previous owner removed for some reason? I don't think so, because that car only had 25k km on it when I purchased it; but you never know.
Passat (B5) :: 2000 4 Motion GLX Slowly Stops When Depress The Pedal
I just replaced pads and rotors on my 2000 Passat GLX. Everything went fine, i got done, pumped the pedal 10-15 times, took it for a test drive. When I depress the pedal, it goes all the way to the floor, the car pulls right, then left, and slowly stops. At this point, if I hit the brakes again, it feels normal.
I figured it just needed a few minutes, I drove it for about 45 minutes, and it never got any better. I have changed the brakes several times before and never seen anything like this before.
Celica :: 1987 Toyota Brake Pedal Is Going To The Floor When Applied
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 Replies