Toyota - 4runner :: 1989 - Vibration Starts At About 45 Mph
i have a vibration that starts about 45mph."When i put it in neutral it still vibrates". I did check the universals. Rig has 195,000 miles on it. Manual trans. It must be lifted because im running 265/7516s on it. Ive been busy changing fluids and such so i have been underneath it but didnt look for lift or factory.
View 9 RepliesToyota - 4Runner :: Master Cylinder Leaking Brake Fluid
My 2003 Toyota 4 Runner with 104K miles recently started showing a brake light off and on. The brake fluid reservoir was at the minimum level and there was some residue leaking from the bottom near a silver disc. Took it to a mechanic and was told it was most likely the master cylinder leaking brake fluid. Is this normal wear and tear or is it unusual in this vintage vehicle? I do not notice any brake slippage at this point. Should I take this to the dealer and ask why this master cylinder is faulty? I thought Toyotas were long life vehicles?
View 2 RepliesToyota - Corolla :: 1989 - Leaking Inside From Above And Onto Brake Pedal?
I have an '89 Corolla with a very odd leak. There is what seems to be engine fluid dripping on to the brake pedal. My oil level is good- no apparent drop in levels and it's clean- coolant is good, brake fluid is good. The leak smells a bit like engine oil, is dark gray/ black and slippery.
Local mechanic says it sounds like a bad heater core. (The heat is working great however.) I recently replaced the distributor cap and wires/ air filter as it was misfiring like nobody's business. Running fine now
This is a second car I bought a year ago to leave on the east coast for summers. it's been really reliable- ice cold AC, great heat, great gas mileage/. Did start to over heat once this summer, but not bad.
4Runner/GX470 :: 1989 V6 - Click Coming From Passenger Side Fender Area When Turn Key Forward
89 v6 4Runner. When I turn the key forward you hear a "click" coming from the passenger side fender area. After a few turns the engine will turn over and away you go. Yesterday for the first time after a few clicks I lost all power to my instrument panel, no dash lights no gauges working and no click, nothing. Stereo, cigarette lighter still had power, even reset my dash clock so it lost all connections as well. Every few turns I would get lights back and turn the key to start and click and dead again. Eventually I bump started the engine, drove home and here I sit.
Relay box by the front fender... this is where the click is coming from, looked at a few posts from yoda tech and one person suggested cutting the no 4 line for the ignition system off the relay box and have it go directly to the pos post for the battery. This will be a closed circuit from the battery post direct to the starter relay yes?
Relay box is probably just getting old and wires are beat up. My electrical is not the best for sure. Can I just clean up the wires going to the relay box(es)?
Ford Aerostar :: 1989 - After New Radiator Running Hot?
Aero, 3.0 Shorty 1989
put a new radiator in my truck, as the original one finally had a small crack.. (I've kept it, since it is brass or copper!)
I put a new 192 T-stat in there too, (OEM temp)
but, now it seems that the van is running hotter than it did before!
when I had the original rad in there, it would never get above the R in the Normal word... now it runs at about M (high middle)
Also, when I tryed to burp it, I'd top it off, but then it would put the extra in the overflow tank, and only stays full up to the very bottom of the filler neck.
this is a plastic radiator... is that what the difference is?
I used to be able to top off the old tank, and it would be right at the top whenever I opened the cap... not so with this one>?
wondering if I should go down to like a 180 degree t-stat? gauge still stays normal - but if it's correct, it's about 50 degress difference.
4Runner/GX470 :: 1995 - Flushing Radiator And Fired Up Engine Without Coolant
I was flushing the radiator on my 1995 V6, 3 Liter, 5 speed. And absent mindedly, I fired up the engine for a minute to "flush" it out, but hadn't put the water/flush in it yet.
Now, the check engine light is on, it idles at about 2000 RPMs and spits smoke. I haven't run it more than 5 minutes total like this. I refilled the radiator, fired it up, no better. I drained that and tried again, but still no better.
Toyota - Tacoma :: 1992 - Replaced Radiator Cap And Radiator Blown
92 Toyota Pickup (22RE auto). New block, rebuilt head, new water pump at 300k about a year ago. Sounds strange I know but that's what seems to have happened. Ive never been able to get heat from the truck since Ive owned it so Ive been trying to fix that. I flushed the coolant out and replaced the tstat. I brought the car to a mechanic and he put a pressure tester on the cooling system and he said it wasn't holding any pressure. He also pulled off the heater core inlet hose with the truck running and no coolant was coming out. He thought there was a blockage somewhere but how to fix it. I figured I might as well try replacing the old radiator cap with a new one so I did. Once I did this, the first time the truck went out, it overheated and the radiator crimped upper seam (on the plastic) burst outward.So all in all...something is wrong.
View 2 RepliesFord - Mustang :: 1989 - Heater Core Leaking Antifreeze
I have a 89 ford mustang with 4 cylinder. After being stored for the winter I noticed anti-freeze leaking from drain tube below heater core (small amount). I am not looking forward to replacing the heater core in this car! Any reason this happened after the car sitting in storage all winter??? or just a coincidence??
View 7 RepliesAstro - Chevrolet :: 1989 - Leaking Red Fluid Drips From U-joint?
My 89 Astro van is leaking red fluid when parked uphill (slightly) that drips from the u-joint closest to the transmission and only from the part that is in the yoke that goes into the transmission. I dropped the drive shaft thinking wrongly that there would be a bad seal where i thought the yoke went into i thought a second piece, but it is all one piece with a collar. When parked in the garage nice and level it did not seem to leak.
View 1 RepliesFord Aerostar :: 1989 - Brakes Leaking Distribution Block
My wife's 89 Aerostar is leaking brake fluid from the back side of what is either the distribution block or combination valve. I am not sure which it is but it is the first block you run into following the lines from the master cylinder and it is right below it near the fender well.
The part has been discontinued and is too expensive anyway so I am looking for input as to what this peice is and if / how to rebuild it.
Jeep - Wrangler :: 1989 - Hydraulic Clutch Bleeder Line Leaking
I have a '89 Jeep Wrangler 2.5L with the AX5 transmission. I noticed over time I had to push the clutch pedal down more to make it work. I checked the hydraulic fluid reservoir and it was empty. I filled it but the pedal had no pressure. I looked at bleed the line protruding out from the clutch housing and noticed a fluid trail on it and inside the clutch housing. The rubber insulator at the opening was missing and suspect corrosion and any movement on the line cracked it where it connects inside. I am ready to junk this vehicle because it is rusted pretty bad, but thought I'd ask before I do.
View 3 RepliesFord - Gasoline - Mustang :: 1989 - Fuel Return Line Leaking
I have a 1989 Ford mustang 4 cylinder. The return line tofuel tank is leaking. I am wondering if I need to treat the return line as a "high Pressure line" or if I can repair with regular rubber fuel line and hose clamps.
View 4 RepliesFord Ranger / B-Series :: 1989 - Signs Of Water Leaking Through The Gasket
My 89 2.9 has gotten water in the oil. One year ago I pulled this engine to replace the crank shaft (defective Ford design 1/2 thust bearing created a nasty grove in the crank allowing it to slide back and forth1/4 inch), new bearings, oil pump, timming chain, all seals and gaskets (not head gasket). The engine had great compression so I didn't do any thing more. Now I have a leak. No oil in water. NO compression leaking off into the water jacket. No "steam" coming from the exhaust. I've replace the intake manifold gasket. It showed signs of water leaking through the gasket, actually bubbles of water trapped inside, so I hoped this was it, but I still have water in the oil. I have now removed the intake and driver side head (head gasket shows now sign of leaking). No signs of water in cylinders. Is it possible to have a warped intake manifold? I have removed it twice, and I was told that some V6's need to be slowly removed VIA de-torque the bolts. I didn't do it the first two times I removed it, today I did. I plan to remove the passenger side head tomorrow. I will take the intake down and have it tested for warping. I have read many stories on this web site of the heads getting cracks, but they all seem to be in or near the valves, I assume that allows water to be burned off as a steam engine OR compression being pumped back into the water jacket.
Is there any other source of the leak that I'm missing? Is it possibly my intake? OR should I go ahead and replace the heads?
Ford Ranger / B-Series :: 1989 - Heater Hose Leaking Around Behind The Valve Cover
Found a tee on the heater hose leaks when it warms up. Appears the PO had noticed it but put a hose over it and now is leaking around behind the valve cover. This is a hard plastic line around 5/16. No online parts show it as being available. Is there a fix for this ?
I would bet several others have had this problem as it lays right on top of the flange of the valve cover where I think it would rub a hole pretty quick.
1989 Ranger 4X4 4 cylinder....
Toyota - 4runner :: Rust On Frame
I took my 2003 4Runner to the dealer and they sent pictures to toyota. I asked that the customer service rep contact me next time he was in the area. Toyota replaced the frame with me paying a 2500.00 deductible. Now I still have the car and will wait for the recall/class action suit that someone will file to get reimbursed. I hear it was due to the frames being dipped in Alabama.
View 2 RepliesToyota - 4Runner :: 1990 Not Starting When It Is Hot Outside
I've got a friend with a 1990 Toyota 4Runner Manual transmission with ~170k miles on the clock. He's been having an issue for quite some time that he hasn't been able to be resolved. Basically he's got an issue with the vehicle erratically NOT starting when it is hot outside. The vehicle starts fine when it is cold outside, but when it is hot he erratically (only happens sometimes) get a "click" noise from the engine compartment with no engine turn over or anything. He is then at the mercy of the vehicle and sometimes just has to try multiple times or wait it out for awhile and try again. Sometimes just opening the hood, looking around a minute, closing it, and re-trying is able to get it to start, but other times not. Other times, and I quote from him, "sometimes i just get really upset and stomp on the clutch, get out of the truck and just shake/rock it, sometimes that'll do it." It happens if the engine is cold or hot, it only matters that it is hot outside, above ~90 degrees. Below is a list of stuff that has been done to try and resolve the issue, but hasn't really worked.
Steps taken:
Replace Battery
Replaced the Alternator 2 years ago
Replaced the Battery Connectors (some were corroded)
Possible Starter Replacement within the past 5 years (double checking paperwork)Rewired jumper wire from battery to starter
Seems sensor or solenoid related to me, but I'm unfamiliar with this vehicle/quirks.....
Toyota - 4Runner :: Start And Then Die After Startup
Every once in a while first thing in the morning my car will start and then die on me. It is random, but more likely to happen in damp weather and cooler weather ( cool for Florida), and when the gas is low (1/4 tank) but not consistently. I put in engine cleaner. Every mechanic I speak to says they need to see the car when it happens. This is not practical b/c it does not happen every day and only first thing in the morning.Recently, after driving 38 miles on the highway when I stop at DD for coffee and the car has been dying as I go through the drive through and the light after. Not sure if it is my imagination, but it seems to do better if I turn off the ac. The car is a '99 4Runner.
View 2 RepliesToyota - 4runner :: 2007 - Turn On And Off Itself
Last night my 2007 Toyota 4Runner started up on its own. The vehicle had been completely turned off, the keys were not in the ignition, and it doesn't even have a remote start. After a little while, the vehicle then turned itself off. It continued to turn itself on and off throughout the night. What could be wrong with my SUV?
View 10 RepliesToyota - 4runner :: CEL Periodically Turns On And Off
The CEL on my 3.0l 93 4runner intermittently turns itself off and on. I have had it to a shop and got error code 25 and error code 26. (If the numbers are wrong the codes meant lean/rich mix. The first time this happened the shop replaced the O2 sensor. When the light came back on the shop said the problem was the "mass air flow (something)". The shop ordered a new MAF and after testing the new one and the old one decided the MAF was not the problem. At this point I'm just ignoring the light and driving the vehicle. The vehicle does seem to run just fine.
View 11 Replies