Ford F-150 (2004-2008) :: Antifreeze Smell In The Cab - Windshield Haze Of A Leaking Heater Core?
I have a 08 f-150 with a 5.4. Started smelling anti-freeze in the cab, with that classic windshield haze of a leaking heater core. I don't have anything on the floor, nor is the engine heating up. Temp gauge is where it always is. This doesn't smell all the time.I just drove 4 1/2 hrs. with no problems. Other than the heater core ?
View 2 RepliesPassat (B5) :: 2002 - Leaking Heater Core / Faint Smell Of Antifreeze
I have an 02 passat with about 85K and the other day my windows would not clear up and a faint smell of antifreeze. also when temp control is in cool and you move the temp control to warm steam comes out of vents. I need to know if i could change this myself and if any procedure on how to do it.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Replaced Heater Core Still Smelling Antifreeze?
replaced heater core because when pulling a trailer it would admit steam out the defrost vents and the smell of antifreeze, what it could be?
View 8 RepliesGolf IV / Jetta IV :: Smell Of Antifreeze Coming From Vents - Heater Core?
My car had the smell of antifreeze coming from the vents, but it goes away when I use the "recirculating" button. Do u think it's the heater core? I hope not though. Also how much is the coolant suppose to be filled up too? Mine filled up a lot more then half the reservoir.
View 2 RepliesFord - Gasoline - Mustang :: 1989 - Fuel Return Line Leaking
I have a 1989 Ford mustang 4 cylinder. The return line tofuel tank is leaking. I am wondering if I need to treat the return line as a "high Pressure line" or if I can repair with regular rubber fuel line and hose clamps.
View 4 RepliesFord - Focus :: 2000 - Heater Core Started Leaking
Coworker's 2000 Focus's heater core started leaking on his 50m commute this morning. He is ready to donate the car at this point. Any stop leak product (i.e. Bars) that would stop the leak without clogging the cooling system.
View 5 RepliesDodge - Dakota :: 2002 - AC Drain Plugged / Heater Core Leaking
I purchased a 2002 Dakota and have had a hard time ridding it. I thought that the heater core was leaking and getting the passenger side floor wet, but it's the overflow for the evaporator under the dash. The drain must be plugged. Will I have to remove the dash to pull the heater unit down far enough to clean it. I don't think I can do much from under the hood...too tight.
View 4 RepliesSanta FE SM (2001-06) :: Heater Core Leaking Coolant And It Dripped All The Way Down To Original ECU
The problem started when his heater core was leaking coolant and it dripped all the way down to his original ECU. Car stopped working. Then he went to a Hyundai dealer to fix the problem but they said he had to buy a brand new one. First ECU didn't work. Returned it and bought one more expensive. Dad told me it worked but he didn't by pass the heater core so coolant dripped again. So now I'm on my third ECU but it doesn't work. I've read online that some older cars have plug-and-play type of ECUs that aren't restricted to the VINs. His car is a 2004 Hyundai Santa Fe GLS FWD 4dr 3.5L.
View 5 RepliesFord - Windstar :: 2002 - Pipe Where Heater Hose Hooks On The Manifold Is Leaking Antifreeze
On the manifold there is a metal/steel pipe that the heater hose hooks to. That pipe is leaking anitifreeze. It has a small hole in it. Is this pipe replaceable or is it part of the manifold.
View 19 RepliesFord Ranger / B-Series :: 1989 - Heater Hose Leaking Around Behind The Valve Cover
Found a tee on the heater hose leaks when it warms up. Appears the PO had noticed it but put a hose over it and now is leaking around behind the valve cover. This is a hard plastic line around 5/16. No online parts show it as being available. Is there a fix for this ?
I would bet several others have had this problem as it lays right on top of the flange of the valve cover where I think it would rub a hole pretty quick.
1989 Ranger 4X4 4 cylinder....
Nissan - Quest :: 2004 - Heater Leaking Antifreeze Under Hood
2004 Nissan Quest... Leaking from right side of solenoid valve.
Should I replace valve or fix gasket? Where would it be leaking? From solenoid valve or heater coil? Lose 1 liter a week.
Silverado :: Plastic Coupling Between Core And Hose Remove From Heater Core?
Plastic coupling between core and hose, is there a specialty to needed to remove from heater core?
View 1 RepliesFord - Mustang :: 1989 GT Starts Without Key
I noticed something strange the other day that my 89 GT can be started without the key ! Everything works as it should but you do not have to put the key in the ignition lock switch. I did have the ignition switch replaced many years ago when Ford had the recall due to a possible fire.. I believe the switch that was replaced is located down under the base of the steering column and activated with a rod from the column key lock.. Is it hard to replace this column lock switch ?
I would rather do it myself instead of paying a locksmith to do it..I do have an anti-start security system on it and when you enable it it locks out the ignition. To start it you have to enter a certain 5 number code for it to crank. I had this car since new and only 117k on the clock and runs like new. Where can I obtain a replacement "key lock assembly " ? This is the original key lock on the column..Just worn out I guess . Only thing I replaced on this car was a new clutch due to a bad throw out bearing making noise at 80k and a water pump and serpentine belt at 90k and a noisy fuel pump. Still has the original prone to failure ignition control module.
Ford - Mustang :: 1989 - Idle Is At 2000 RPM When Pull To A Stop Light
I posted a few weeks ago about a problem I fixed with the MAF ( leak after the MAF ). 89 GT 111k miles, ( car restored to showroom condition ) Last week I pull to a stop light and idle is at 2000 RPM. Shut engine off and restarted and all was well, and idle back to about 800. I know something was wrong before hand as the car was pulling without my foot of the throttle. This happened again when I pulled into my driveway so let it run like this and when I pulled the plug on the IAC and idle dropped to about 600.
I took the IAC off the TB and cleaned it which did not look too bad. Installed IAC but left it disconnected and set up the idle on the TB according to the shop manual to 750 RPM. Shut engine off connected the IAC and followed the instructions in the manual to reset the ECU by disconnecting the battery for a few minutes, letting it idle for 2 minutes shut engine off then restart.
Well it was good for 2 days then started the same thing, 2000 rpm at idle..for the time being I have the IAC disconnected and set the idle up on the TB to about 850 RPM.
I have been driving the car like this for 4 days now and no running problems what so ever. Funny thing is no check engine light and no stored codes during this entire episode..Had my friend with an earlier OBD scan for codes and clean.
I hate shot gunning parts by replacing the IAC. Does it hurt running the car with the IAC disconnected or should I foot the bill and get a new one ? and hope that is the problem..or could something else be causing this ?
I checked for any vacuum leaks using my propane torch no change in idle. IAC problem on 89 Mustang GT 5.0 manual trans.?
Ford A/C :: 2000 F150 - Heater Core Went Out
I have a 2000 F-150 5.4L 4x4. I am currently deployed and my wife has the truck. Just yesterday she told me my heater core went out again the only way she knows this is its the 4th time in just over a year. What would cause a heater core to go out so many times in a short period? What should I have my wife do? I do not want to get rid of my truck and I wont be back for another few months.
View 2 RepliesFord A/C :: 2005 - Front Heater Core Always On
2005 Ford E Series heater core is "always on"?
That is, coolant always circulate through the core, there is no "valve" that turns it on or off.
The HOT / COLD dial opens and closes a door (vacuum operated) that allow air to enter the heater core area?
Ford F-150 - 1997-2003 :: Bypass Heater Core On The Fly
My commute into the office was more difficult than usual because of the fumes pouring out of the vents. I have a 1997 F-150 5.4 V8. should I remove both in and out hoses from the firewall and connect them with a plastic fitting not to risk breaking the aluminum fittings on the motor?(There is an advanced a mile away) OR is it possible for me to remove the in hose from the firewall and remove the out hose from the motor, and run the in hose directly into the motor. Are the fittings the same and can I do that with limited time and tools?
View 8 RepliesFord - F150 :: 2001 - Reversing Flow To Heater Core
The heater on my 2001 ford F150 is not heating. The blower is working, the inlet hose is hot, the outlet hose is cold. Removal of hoses confirms that there is very limited flow through the heater core. I flushed it but got only minimal improvement. However when I back flush (reversing the flow through the core) the flow is great. Here's the question: Can I reverse the flow through the heater core on a permanent basis? It seems this would give the needed flow of hot fluid through the core to allow heating. Is there a problem with doing this?
View 14 RepliesFord - F150 :: 2002 - Replaced 4 Heater Core In A Year?
Ford dealership is having problems with heater core repair. 2002 Ford F150 Supercrew. Problem is antifreeze (or early on just smell) in the cabin. 4 heater core replacements in 2 years. A hose (?) replaced. Electrolysis kit replaced. 4th heater core replacment finished yesterday. I know that I need to let the dripped antifreeze work out of the system, but I am smelling mild antifreeze this AM. Usually gets worse over 2-3 days then I have to take it in. What might be being missed here?
View 5 Replies