Subaru - Impreza :: 2005 - Knocking Noise After Timing Belt Change
I have a 2005 Standard 2.5 RS wagon - nice little car.
So with that in mind, I had a local garage (trusted...dealership in this area is notoriously crooked) replace my timing belt, tensioner, idlers, thermostat, and water-pump last week. I've had the car back for about 3 days and I just noticed today, that while the car is idling, I'm hearing a knocking noise coming from the engine somewhere (could be while I'm driving too, but maybe I just not hearing it) - I don't recall this sound before bringing it in for the work. When I rev up the engine a bit, it goes away, but when the car sits for a few minutes, it comes back.
I've already had it back in since the change for a defective tensioner, which the garage replaced free of charge. I plan on calling them first thing Monday morning to bring it in so they can have a look, but in the meantime, what this likely to be?
Subaru - Forester :: 2010 2.5X Automatic With Timing Belt Or A Timing Chain?
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesGolf IV / Jetta IV :: 2003 GTI 1.8t Timing Belt Broken?
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 RepliesHonda - Accord :: 1999 - Timing Belt Is Broken
1999 Honda Accord EX, 224K miles, 4 cylinder. Timing belt broke yesterday and ruined some exhaust valves. Also needs new radiator. Should I spend quoted approx $3500 for fixed cylinder head and valves, 30K mile check (plugs, valve adj etc), new radiator, might also include piston rings, not sure? Completely trust the mechanic. Other recent work already done is one new front wheel bearing and axle, new bearing boots on both sides, oxygen sensor, new clutch a year ago. Interior/exterior are in good shape. How many more miles am I likely to get on this engine if I have the work done? Will I likely need ball joints replaced soon? Anything else I should be considering?
View 8 RepliesPassat (B5) :: Piston Damage After Broken Timing Belt
I recently broke a timing belt on my 1999 AEB 1.8t Passat. I'm in the process of doing all of the repairs myself while working around my college and work schedule. I have yet to pull the head off, and I'm scared of what I'll find when I do. Should I expect any piston damage? I have one completely broken valve and a bunch of bent valves.
View 12 RepliesFord - Explorer :: 2007 - Timing Belt Broken
I think the timing belt broke on my 2007 4.0 6cyl that has 99k on it. Is this an interference or noninterference motor?
View 5 RepliesCamry :: 2002 Solara SLE V6 No Spark - Timing Belt Broken?
2002 Toyota Solara SLE v6 w/ 209k miles
Drove the car home from church yesterday, this morning went to start and wouldn't start..
Tested the Fuel Pump and that looks good.. Pulled a spark plug and did a spark test and I get no spark.
After reading up I get the sense it is either the Crank Angle Sensor or the Timing Belt snapped .. I don't know the last time the timing belt was changed, we got the vehicle @ 190k miles..
Does a no spark symptom sound like a timing belt that could have snapped? I believe these are non-interference engines so it should be ok..
When turning the car over the RPM gauges doesn't look like it is moving but wanted to see for a complete spark failure.
Chevrolet - Aveo :: 2004 - Timing Belt Broken / No Compression
The timing belt on my 2004 Chevy Aveo broke last week. I have it at a mechanic who got a new timing belt on to check the compression of the engine. Bad news: no compression. So far they haven't taken the head off to inspect the inside. This includes timing belt/water pump, cylinder head gasket removal and replacement, cylinder head check, some misc labor, lube, oil, and filter...
However, another mechanic is suggesting that I replace the engine instead with a used or refurbished engine with less miles. He says that it doesn't make much sense to put new parts on the top end of the engine. The engine itself has about 153k miles on it.
Volvo :: Timing Belt Tensioner Broken - Bottom Of Valves Melted
I recently bought a 97 960. i have had a s90 before in totaled it i loved the car so much i found another. i was driving and broke the timing belt tensioner which in turn lead to the breaking of 5 exhaust valves that i know of. I've taken off the head and noticed that one of the bottom of the valves had melted onto the number 5 piston head.
I called around and search but every motor is at least 1000 and i have been told anywhere from 3500-4500 to rebuild. My question would b is there an easy way to fix or should i junk it. i bought it for a 1000 it has only 140000 on it an its in almost great condition. I attached some pictures of the head and piston so u can see the damage.
Attached File(s)
2012_04_07_19.02.39.jpg ( 1.45MB )
2012_04_10_16.45.26__1_.jpg ( 1.43MB )
Nissan - Maxima :: Clunking Sound - Broken Timing Chain / Belt?
95 nissan maxima decelerated on highway, i heard a clunking sound, and then it shut off, i opened the hood and it smelled like burnt rubber. Checked all of the belts i could see..no problems. Car wouldn't start after this...and all i could hear was a clicking sound. Pulled 6 codes for the car including bad speed sensor and a misfire, as well as bad EGR...i think the timing chain/belt broke..but i can't access it.
View 3 RepliesFord - Ranger :: 1999 - Broken Timing Belt / No Start After Replacement
2.5 Litre ... Okay, I've done this on other cars, both Fords without a problem but now I'm stuck on the no start situation. I have spark and my fuel pressure is 60 psi. About to do a compression test. Only issue with replacing the belt is that no matter how many times I try removing and installing it I'm always 1/2 tooth off after rotating the engine a couple of times but that shouldn't be enough for a complete no start. Tried starting fluid. Replaced cam sensor. new plugs. checked firing order. I have spark at #1 according to my test lamp which plugs inline.
View 6 RepliesSubaru - Forester :: 2003 - When To Replace Timing Belt
I have a 2003 Subaru Forester with 44,000 miles. How will I know when to replace the timing belt? Is it more a question of miles or age?
View 7 RepliesSubaru - Forester :: Whining Noise After Timing Belt Change
We just had our timing belt changed today as well as the waterpump and fanbelts. It has a loud whining noise now and I don't know if it is even safe to drive back to the mechanic...
View 3 RepliesSubaru - Forester :: 2001 - Timing Belt Slip Out / AC Compressor Seized Up?
I have a 2001 Subaru Forester which has 165K miles. I had the timing belt changed at 105K per maintenance recommendations. I had the car in for service recently for brake pads, etc., and the dealer recommended replacing the drive belt for the AC.. which I did. 100 miles after this service, the car broke down unexpectedly. The dealer told us the AC compressor seized up... and this caused the drive belt to get caught on it and be shredded ... and with that, the sudden resistance from the drive belt on the crankshaft pulley caused the timing belt to slip out of sync and damage the interference design engine. Can that really happen? I surprised that this happened a few days after replacing a drive belt and wondered if somehow the service work done with the drive belt could have caused the problem. The dealer states the service work did not cause the problem. Is my recent service and damaged engine a coincidence as the dealer said or are they related?
View 3 RepliesSubaru - Outback :: Rough Idle And Lots Of Vibration After A Timing Belt Change
My wife and I recently bought a 2005 Subaru Outback 2.5 XT with an automatic transmission. Last week, we had the timing belt changed by a mechanic I've gone to for the past four years and trust a great deal. He changed the timing belt, drive belts, water pump, pulleys, tensioner and a few hoses, and everything seemed to go off without a hitch. After picking up the car, though, we noticed that the idle seemed much rougher than it had in the past. We can't tell if it's also rough during driving, or when the car is in park or neutral, but there is definitely considerably more vibration when the car is stopped in drive and idling--you can feel it throughout the car. I haven't noticed it until the car has warmed up.
I asked my brother, who is a mechanic in another state, if he had any thoughts, and he said it could be that the belt is off a notch, a vacuum leak or an unplugged sensor. I brought the car back to the mechanic today to see if it he could fix it, and he said that the CEL would be on if it was a vacuum leak or unplugged sensor, and that the car has an automatic idle that the belt change would not have adjusted. He asked if the vibration was getting any better, since when the battery was unplugged it would take the computer awhile to relearn the correct idle, but we've driven it a few hundred miles and it hasn't gotten any better. I left the car with him to take a look at it, but he just called and said he couldn't find anything wrong.
I want to chalk this up to us imagining something, but we both have no doubt that there has been considerably more vibration at least when the car is idling since we picked it up after the timing belt change. Is there anything else that it could be or that I should ask my mechanic?
Subaru - Impreza :: Stalling When Shifts From Higher To Lower Gear While Driving Uphill
My Subaru want to stall when it shifts from a higher to a lower gear when driving up a grade/hill. Also does the same thing when pulling out from a stop sign or traffic light. You need to pump the accelerator to get it going.
View 1 RepliesMazda :: 1998 - Timing Belt Broke While Driving
1998 Mazda B2500. Timing belt broke while driving. How likely is it that my valves are warped & how do I fix it?
View 11 RepliesAccent LC (2000-05) :: Ticking Noise While Driving Then Shut Off - Timing Belt Snapped
I bought a 02 accent base model hb 5 speed 109k miles for a winter car (have a mustang in garage.) It ran good until tonight when the timing belt snapped. I know this because while driving it made some ticking noises and then shut off and when you try to start it the noise that comes indicates no compression so the belt must've snapped and bent the valves.
View 3 RepliesHonda - Pilot :: While Driving Clicking Noise - Replace Timing Belt Tensioner?
Six months ago my 2005 Honda Pilot got a new timing belt that was incorrectly calibrated. When the Honda Dealer test drove the car, they damaged the values. They fixed the valve damage and gave me a discount on the timing belt. I considered selling the car, but decided to keep it.
Now it's six months later. When driving I hear a "clicking noise". The dealer says that the timing belt tensioner needs to be replaced and that it would be dangerous to drive it at high speed as it is now. The clicking is caused by a worn ??? tensioner.
They claim that the incorrectly calibrated timing belt could not have caused this problem with the tensioner.