Subaru - Forester :: 2009 - Continues To Skip / Misfire On Cylinder 3 And 4
My 09 Forester continues to skip although I have changed spark plugs and wires. Always reads misfire on 03 and 04.
View 2 RepliesSubaru - Forester :: 2005 - CEL Came On - Cruise Control Started Blinking?
I bought a 2005 subaru forester xt a cohple months ago and then the CEL went on and the cruise control started blinking. The car also shook horribly. Long story short, and $2,300 later, i got the "head gasket set, water pump, timing kit, oil&filter change, " etc... Fixed. Question is, I am driving to Colorado from Maine in about two weeks. How long do subarus last after such repairs? Think ill get a few years out of it? Or should I sell it and buy a more reliable car before the trip out there.
View 11 RepliesSubaru - Forester - Xt :: 2007 - CEL With Blinking Cruise Light / Fault Code P1410
At a bit over 43K miles the check engine light came on with a blinking cruise light. Dealer has confirmed that both secondary injection pumps have failed for reasons unknown. I think this is part of the pollution control system.
View 3 RepliesSubaru - Forester :: 2006 Idling Roughly And 2nd Cylinder Was Misfiring
I have 2006 Subaru Forester that is idling roughly. 90k – oil change every 3k miles. Per diagnostic codes I learned that the 2nd cylinder was misfiring. I replaced the coil, spark plugs, ignition wires, and an airflow sensor. Yet, my car still idles rough. The check engine light is solid and the cruise control is flashing. The idling problem only happens when stopped… after I get high rpms there is no shaking. I had someone disconnect the battery and reset the computer and the lights stayed off for about a week and idling was fine. Week later – the problem returned. I think this an electrical problem, but not sure if mechanical.
View 19 RepliesSubaru - Forester :: 1998 - Rough Running / One Cylinder Has No Compression
will it hurt my 98' forester to drive it when one cylinder has no compression? They tell me it needs a valve job for 2,500. They already put a mass air flow sensor in, and replaced plugs and wires. Still got the miss, but I need the vehicle.
View 2 RepliesSubaru - Forester :: 2004 - Check Engine Light On / 4th Cylinder Either Low Or No Compression
Our beloved 2004 Subaru Forester has the check engine light on. We've been told that the 4th cylinder has either low or no compression. Is this fixable/worth fixing? Would you replace the engine? The car has 183K miles on it, and runs great! It is stuttering now, due to this issue, but otherwise - runs great and is in good condition!
View 11 RepliesSubaru - Forester :: Bad Cylinder - Overfilled Oil Tank - Damaged Camshaft Seal
The day before my road trip from VA to ME I had the oil changed in my 2006/120,000 mile Subaru Forester. Soon after getting on the road I noticed a burning smell and smoke coming from my engine. I called my mechanic and he said it was dripped oil burning off. about an hour later we noticed oil dripping from the engine and when we checked the oil we noticed it was overfilled. We then took it to a nearby mechanic who said they thought the oil tank had been overfilled and may have blown out the camshaft seal and that was the cause of the drip and oil burning. They said it was a repair that would take some time, but when asked the mechanic also said we would do no harm and it wouldn't be dangerous to drive so long as we kept the oil levels up.
An hour on the road and the car started to vibrate and lose power. So we took it to yet another mechanic (same group as the prior two) the next morning and they concurred that it was likely the camshaft seal but would take several days to repair, and diagnose and repair the cause of the vibration. after a week I was told that the repair to the camshaft had indeed fixed the oil leak but that with further examination it was discovered that the pressure in one of the cylinders was 20 lbs, not the 100lb it's supposed to be. So my question is - could there be a link between the overfilled oil tank, the damaged camshaft seal, and the cylinder.
Subaru - Forester :: 2001 Misfire - Cannot Get Check Engine Light To Turn Off
I have a 2001 forester. it had a misfire which has been fixed but I can't get the "check engine" light to turn off.
View 3 RepliesSubaru - Stall - Gasoline - Forester :: 2004 - Cylinders Misfire Upon Fill Up
I have an '04 Subaru Forester which sputters and stalls after fill up. It sends error codes for cylinders 1, 3, & 4 misfiring...I only have a 4 cylinder car - This only started Friday - a few days later and I'm really getting desperate. I screw my gas cap on, we check the connections...and we've read all kinds of random solutions that spread across the board.
View 18 RepliesVenture :: Misfire Cylinder 4 With CES Blinking Under Accelerating
The fact :
- 136400 miles on a '03 Venture.
- Run on 5 cylinder for 1 minute after crank. After run fine on 6 cylinders.
- Engine coolant is leaking but I dont know where : there's no smell like a defective IMG.
I get a noticable "P0304: Misfire cylinder #4" with CES blinking under accelerating.
The cylinder #4 is the front middle one : the easiest to check and access. BTW i change plugs, wire and coil and still the same symptoms.
Fuel injector ?
Lexus GS 2006-11 :: Check Engine Light Blinking - Cylinder 3 Misfire
Just bought 2007 Gs 350 in Dec 2015 with 60k miles. The other day I filled up with gas and drove to work. On the way home check engine light started blinking, check VSC appeared on display screen and traction light came on, car ran rough, and wouldn't accelerate. Got home and searched the net.. So I removed gas cap... No change.. Then removed neg battery cable for 10 min. Fixed problem for about 10 min. Then it all happened again. Next morning took it to Lexus dealer. The rep called and said it gave misfire cylinder 3. They said they checked valve springs and they are good, exchanged coil pack with different cylinder and still misfire #3. He said has to be injector so they want to replace injector ....
View 8 RepliesSubaru - Forester :: 2005 - Noise From Compressor / Pulley Area
This is my first Subaru, and I absolutely love the vehicle; however, because of it, I'm very new to its mechanics. I bought it used from a friend, and I've been driving it for three weeks now, now this noise has come up and I want to verify what needs to be fixed before I start taking things apart. Perhaps you all know what noise this is coming from the compressor/ac idler pulley area?Here are a couple of videos.
[URL] ...
[URL] ...
In case it does somehow matter, one of my knowledgeable friends asked me if it makes more noise when I turn, and the answer is no. Also, the noise does not come through the speakers, and from what I understand, that eliminates an alternator problem.
Subaru - Forester :: 2005 - Large Evap Leaks Detected
I have a 2005 Subaru Forester with about 124,000 miles. I've had her since 2012. This year has been rough for her and every month or so there seems to be something that I need to fix.
This time, the check engine light is on, and the cruise light is flashing. Two codes came up:P0442 - Small Evap LeakP0457 - Large Evap Leak
I brought it to a local auto service shop, and they replaced the gas cap, and also cleaned the filler neck with several grits of emery cloth. They cleared the codes, and told me to drive it for a few days.
Well the check engine light came on again the other day.
Subaru - Forester :: 2005 2.5 Non Turbo Overheating - Cooling Fan Is Always Going At Full Blast
I have a 2005 Subaru Forester with 88k on it. I bought it with about 70k on and have been doing a lot of the services myself.
I change the oil religiously. I recently changed the thermostat on the car, cleaned out the reservoir and now the car has new antifreeze. The reason I did this was because cars cooling fan is always going at full blast. This only started about 6,000 miles ago. So since it was a easy job I figured change the thermostat. I am in NY and it has been very cold out, but with my 10 mile commute to work by the time I pull into the parking lot the cooling fan is very loud and the noise is very noticeable.
I recently drove up to go skiing, ( the temp outside was 9 degrees) I was on the interstate going about 70 to 77 mph because the car was going uphill and the incline was significant , I would push more on the gas pedal and I would see the thermostat on the dash going up very closely to the red mark. I pulled over a few time, the fans were at full blast.
Subaru - Forester :: 2005 - Excessive Oil Burn After Replacement Of AVCS Solenoid
I have a '05 Forester XT with 135,000 miles, I purchased the car new and have always performed regular maintenance and oil changes. The car is my baby.On a recent freeway drive I heard a "pop" followed what sounded like a shredding accessory belt. This went on for several miles with diminishing power. There was zero smoke from the exhaust. I managed to coax it into the nearest Subaru dealership. They diagnosed a bad AVCS solenoid, with P0011 error code. They charged me $2200.00 to change the solenoid and clean all the oil feed lines! While they were at it, I had them clean the banjo bolts to the turbo, as this had never been done. The engine was removed from the vehicle for them to complete the work.
Today I went to pick it up, it started right up and idled fine. When I pulled onto the highway and accelerated TONS of blue smoke billowed from the exhaust and it had zero power. Before this the car burned one quart of oil every 3,000 miles. I turned around and the car is now back at the dealership.I'm at a loss as to what to do. The car is not driveable at this point.I hate to point fingers, but what could the dealership have done to cause this excessive oil smoke? Again, the car NEVER smoked before the dealership got a hold of it.
Subaru - Outback :: 2007 Running Really Rough And Stalls Out / P0303 For Misfire In Third Cylinder
So I have been unable to figure this problem out and so had my mechanic, I am starting to think this car is cursed. I have an 07 outback with about 54000 miles on it, a few weeks ago it through a P0303 for a misfire in the third cylinder, thought nothing of it, light went off in the next couple starts and the car was running great. Had this happen a couple more times but only after the car had been out in the rain. Each time the problem went away. Now the car has sat in my garage for four days, I got out to start it and get an extremely long crank but no turn over. Try again and after 5-6 seconds car turns over but is running really rough and stalls out. Disconnected the battery checked hoses, everything looked normal, reconnected the battery and now the car is running fine.
View 3 RepliesSubaru - Legacy :: 1999 - Cylinder 2 Misfire Code As Well As Random Power Loss
I had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast.after let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 10 RepliesSubaru - Legacy :: 2005 - CEL On And Cruise Control Light Is Blinking
My 2005 Subaru Legacy 2.5i - the engine light is on and the cruise control light is blinking. This happened once before and it went away after I recapped the fuel cap. However, this time it did not work. The car is running ok.
View 4 RepliesPrius (Gen 2) :: 2005 - Misfire On Cylinder 1 And 3
Just today I acquired a 2005 Prius (trim level 1... so no options at all) in exchange for a cruddy old Ram truck and a dying Avalon. They had issues, but so does the Prius. The car has around 218K on it, I just replaced the spark plugs with NGK iridium plugs, cleaned the MAF, sort of cleaned the throttle body a little bit, and even swapped the coils around to see if the misfire would change. I also gave the car a new air filter.
View 10 Replies