Sebring - Chrysler :: 2004 - Emergency Brake Light Comes On And It Chimes When Turn Right
If I make a right turn at anything above a snail's pace, my emergency brake light comes on and it chimes. Had the brakes checked and they are fine for now but since they are original, they will need to be replaced soon. The car has 50,000 miles. Recently had the cam sensor replaced and the dealership checked the car over.
View 6 RepliesSebring - Chrysler :: 2004 - Stuck Wheel Bearing Assembly Removal?
I'm attempting to replace a front wheel bearing and hub assembly on a 2004 Chrysler Sebring. I've removed all the hub bolts and all other more external components. I've tried hammering the assembly, reinserting the bolts partially and hammering those, a slide hammer, liquid wrench...
View 9 RepliesPassat (B5) :: Brake Light Switch Removal / Installation
Looking for tutorials? 2003 5spd v6 passat.
View 1 RepliesSebring - Chrysler :: 2005 - How To Get Brake Caliper Off
I've run into a problem while doing brakes on my friends 2005 Sebring. I can't seem to get the brake caliper off. There is a little rubber boot with a plastic cap that is where the bolts that hold the calipers in place are. How to get the bolts out to remove the caliper. In fact, it doesn't seem like there are any traditional bolt heads in the plastic cover.
View 2 RepliesSebring - Chrysler :: 2008 - Starts Intermittently / Brake Pedal Is Firm And Cannot Be Pushed Down
Let me tell you a story ‘bout my daughter’s 2008 Chrysler Sebring 2.4L…
We have owned the car since 2009. Recently the car has begun to start intermittently. Generally it starts normally. Other times it won’t. It can be driven for a month with no problem and then BAM! It won’t start. No dead battery sound, no clicking, no starter trying to engage NUTT’N!
AND… the brake pedal is firm! The brake pedal is firm and cannot be pushed down!
The car has been to the Dodge dealer several times. They have replaced the starter because a couple of teeth were missing, flashed the computer and replaced the alternator. The car started fine for a few days and then wouldn’t start again.
The Dodge boys kept the car for a week and of course, it started fine while they had it. One of the service managers told me to pull out a certain fuse to reset the computer. They also told me that they usually see these types of problems if the car was jump started wrong (the jumper cables were hooked up backwards I guess).
Sebring - Chrysler :: 2010 - Quits Running Suddenly?
I have a 2010 Chrysler Sebring that in the past month will all of a sudden quit running. Had to the dealership twice in past month. New plugs, injectors cleaned. Got car out of shop yesterday and drove 6 miles and it quit twice again. Too late to take back to dealer. They have checked it out twice on monitor and all they said was what they did to repair. It seems to me that it is a fuel problem. Maybe a fuel pump, fuel filter, or dirt in the fuel itself. Will have to take back to dealer Monday. What do you think is the problem. Not missing or ideling rough. Runs good, but will all of a sudden quit.
View 8 RepliesSebring - Chrysler :: Oil Light Comes On When Stop But Goes Off When Driving
My oil light comes on when I stop but goes off when I'm driving. I check the oil level and it was fine. What would cause this? It's a 2001 sebring 2.7L
View 6 RepliesSebring - Chrysler :: Oil Light Comes On While Coming To Stop?
Oil light comes on when I stop and goes off once I move again. Oil is full and just changed. What causes this & can I repair? I have a 01 Chy Sebring withh 100K miles on it. I bought new & have changed the oil every 3K miles since I have had it.
View 7 RepliesSebring - Chrysler :: Transmission / Airbag Light Comes On Then Turns Off Randomly
I own a 2007 Chrysler Sebring touring. I bought it used with 34,000 miles in 2009, and so far, haven't had too many real problems with it. Unfortunately, I'm rounding the ~65,000 mile mark and some weird things are finally going on. The transmission light comes on for a few days then turns off - for a few weeks one time, then it came back on for a day, and hasn't been back on for a few months. Also the Airbag light will bing on for a few seconds, turn off, then a few minutes later come back on, and this happens randomly. (It also recently threw a wheel weight it seems, but I'm familiar with how to fix that issue!)
A mechanic friend of mine told me that rather than paying money to repair this car, that I should get rid of it - he suggests Chryslers like mine become junkboxes right around 65,000 miles.
Sebring - Chrysler :: Check Engine Light Is On / RPM Too High While Driving
I have a 2004 Sebring my check engine light is on and the RMP's are really high while Im driving. What could be going on?
View 11 RepliesChrysler Sebring :: 2006 - Whine From Engine And Intermittent Battery Light
About a week or two ago, when driving home, my battery light flicked on while at a stop light. Also, as the light wen t green and I accelerated away, I noticed a kind of 'whine' from the engine, like a turbine spinning up. By the time I got home it was fine again and the light out, and has been until today, when it happened again...I noticed that it happens if I have the AC on and I'm at a stop. If I turn off the AC when waiting at traffic lights, that seems to eliminate the battery light, but I still here the whine.
View 4 RepliesChrysler - Sebring :: 2002 - Check Engine Light Came Driving Down The Highway At About 70 MPH
I drive a 2002 Chrysler Sebring convertible with about 130,000 miles on it.
I was driving down the highway in early November when the check engine light came on my car. I took it to Aamco who did some diagnosis and replaced a solenoid assembly in the transmission. The light went off and I was on my way. I never got the exact code.
About a month after that, the light came on again. This time, I got a low end code reader and scanned it myself. I got a "P0700" code, which I've read is a generic code that the transmission system sends to the computer or something. So I used my reader to erase it. However, the light came on 2 days later while I was driving down the highway at about 70 MPH.
So I went to an auto parts store to get a more detailed scan with a better tool. This one came up "P0740 Torque Converter Clutch Solenoid Circuit".
This feels weird, because the solenoid assembly was just replaced a month ago (and is still under warranty).
The car seems to drive okay. I don't notice any actual problems in shifting. The tachometer seemed to get up to about 3000 RPM on the highway. But I've seen practically new cars do that. The last time I had serious transmission problem it would rev up to about 5000 or 6000 RPM on the highway and still only getting up to about 40 MPH. That was 3 years ago and at the time I had a fairly expensive transmission repair (which included a new torque converter).
But like I said, the car seems to be driving okay. I don't drive much. Maybe 100 miles a week? And even that is mostly optional in town driving. I'm not looking to keep this car for more than another 20,000 to 25,000 miles though for the time being I cannot afford a new one.
What are the possible causes here? What are the consequences of ignoring this? Like I said, it's still driving fine and as the old saying goes "if it's not broke, don't fix it".
Sebring - Chrysler :: Check Engine Light Came On And Code Came Out As Catalytic Converter
2004 Chrysler Sebring Sedan, 4 cylinder dual-overhead cam. My check engine light came on this morning and the code came out as the catalytic converter. The car seems to be running fine, at least no recent changes. I'm debating replacing this vehicle soon, and I'm wondering if it's worth working on the catalytic converter. I recently replaced the cam shaft position sensor as well.
View 5 RepliesSebring - Chrysler :: Rough Idle And Engine Light Comes On / Codes Read Misfires On 1, 3 And 5 Cylinders
I have a 2006 Chrysler Sebring Convertible 2.7L engine. Replaced water pump and spark plugs. We triple checked the alignment on the chain and are sure the timing is fine. Car started right up. Now running rough idle and engine light comes on. Codes read misfires on 1, 3, and 5 cylinders.
View 8 RepliesLexus ES 2007-12 :: 2010 ES350 - High Mount Third Brake Light Removal?
My wife's 2010 ES 350 third brake light has an intermittent LED issue. The last 3 LEDs on the pass side flash on/off when the brake is depressed. My understanding is there may be a broken solder joint. My problem is I can't seem to get the assembly out. How the high mount assembly is mounted and how to remove it?
View 2 RepliesGTI 337/20th Anniversary :: 2004 - No Reverse Light / Lever Inside Doesn't Reach Connector From Switch?
My reverse lights are out on my GLI 2004, i bought a new reverse light switch thinking that would fix it but no.......
I then checked for power in line and by jumping it and the light go on
So Switch is goodLine as power
But as soon as it's intalled no go, light out.... it seem's like the lever inside doesn't reach the connector from the switch.
Sonata NF (2006-10) :: MAF Sensor Connector Removal
I tried to remove the MAF in 2007 Sonata Limited, and could not figure out how. I removed a cap by lifting the tabs on the sides, but the connector with the wires was still attached. I flipped over and saw another kind of tab on the bottom and seemed to be tricky to be disengaged. I did not want to go further because I broke Toyota ignitor connector not too long ago so I know some of the connectors with plastic tabs can be delicate. I want to make sure it is more clear to me before I proceed further.
View 2 RepliesChrysler - Sebring :: 2004 - Transmission Will Not Go Into Reverse
I have a 2004 Chrysler Sebring with a 2.4L dohc and automatic transmission with 115k miles. I recently had the timing belt and water pump replaced. Shop left the front 2 engine mounting bolts off and the rear one loose. Picked up car after business hours drove it that evening and kept hearing a strange metallic squeak.Returned it to the shop the next morning and as i was driving it began to smoke and stall with the temp gauge pegged. They had also left a hose to the heater core disconnected. Could the engine not being mounted to the chassis and/ or the overheating have damaged the transmission.
View 3 RepliesSebring - Chrysler :: Heater Blowing Cold Air
Got a bit of a problem with my car. Earlier this week, I got in and noticed there was heavy condensation on the inside of the windshield of my 2002 Chrysler Sebring convertible. The windows had been rolled up and the top up of course. I see this kind of condensation happen on the outside a lot in the mornings. You know, dew settling and all that. If I wait around until later in the day, it evaporates on its own.
Anyway, this time it was on the INSIDE. I wiped it clean easily enough and was on my way.
Today I noticed that my heater wasn't working. The temperature gauge goes up to about 1/3 of the way, so I know the car is warming up. I'm not sure if it normally goes up that high; I don't usually pay much attention to the temperature gauge.