Oldsmobile - Leaks - Cutlassciera :: 1994 V6 Idles Rough And Usually Stalls If Put It In Gear When Start The Engine
I have a 94 Oldsmobile Cutlass Ciera, (3.1L V6 GM3100 engine). When I start the engine it idles very rough and usually stalls if I put it in gear. Eventually once it warms up I can drive it, but when I do drive it's extremely sluggish on accelerations and acts like its about to die. At constant speeds it runs mostly ok. We figured it was a vacuum leak, but we've tried every test we can think of to find it and talked to a couple mechanics and tried their tests and it passed all of them. Supposing it isn't a vacuum leak, then what it might be?
View 4 RepliesNissan - Maxima :: 1996 Keeps Stalling And Idle Rough
My car has suddenly started stalling a lot. I can get it to start right up if I put the clutch to the floor and it will idle fine until I start coming up of the clutch even while it in neutral. At times it will idle in neutral then start to idle rough and stall. I can drive it in reverse but can't drive it forward except in first if i keep the clutch at a certain point and not release it all the way. However when I try other gears sometimes it's like it does't want to go stalls. What it might be?
View 1 RepliesOldsmobile - Cutlassciera :: 1990 V6 Won't Go Until Warm It Up
Olds Cutlass Ciera, 1990, v-6 engineI warmed-up the engine for about 12 minutes this morning (after 8:30 a.m.), its maximum speed was 20 MPH at 30 RPM when I climbed up the hill to Agri Center from Bonita Lakes area on HW 19. I was afraid to exceed 30 RPM, so I stopped near the top of the hill for about a few minutes. After that, the road is down hill. The engine became vigorous and went beyond 60 MPH at 20 RPM.
View 5 RepliesChevrolet - S-10 :: 1996 - Running A Bit Rough / Irregular Idle / Cylinder 1 Misfire
My 1996 S10 2.2 liter pickup has been having some 'issues'. Truck has been kind to me over the years, but now is running a bit rough. It has an irreguler idle and continues to run this way through all speeds. The blinking code reads "cylinder 1 misfire". I did all the basics. I changed the plugs and wires, ignition coils and fuel filter. Here is where is gets tricky, after changing the fuel filter, it ran great again. Then it started to run rough again later that day. I thought I somehow clogged up the new filter, so I removed the new one for inspection. Realizing there was nothing wrong with it, I reinstalled. Truck ran great again. Went out to drive it to work a couple hours later and it started fine, then after about 10 seconds of running, it went back to the rough idle.
View 19 RepliesOldsmobile - Cutlassciera :: 1985 - Engine Not Turning Over / Dash Lights Came On
I have a 1985 Cutlass Ciera Brougham with a 2.5L four. Got in it one day and when I turned the key nothing happened except the dash lights came on. No clicking or buzzing, no engine turning over, nothing... Pulled the starter and had it tested, it passed. Then again it is only about a year old. I then jumped the poles on the starter and the engine came to life. Replaced the ignition switch ( the electrical part ) still have the same problem. Turn the key and nothing happens except the dash lights.
View 8 RepliesOldsmobile - Cutlassciera :: 1993 - Hard To Start / If Idling Low Will Stall Sometimes
The 93 Cutlass Ciera 3.3 6 cyl. is hard to start..takes like 3 tries to start it...even after changing..oxygen sensor, MAF sensor, coil pack, fuel filter, air filter, good plug wires, crank position sensor, fuel pump, sending unit....if idling low will stall sometimes. Mechanic said it's slow getting spark up just when starting it..not sure why..
View 1 RepliesOldsmobile - Cutlassciera :: 1989 - Smokes White / Noisy Lifter And Stalls In Gear
I have owned this 1989 Cutlas Ciera for nine months. I bought it for commuting, because my truck is a gas guzzler. Two weeks ago, the Ciera began tick tick ticking. It sounded like it was coming from the lifters. I tried the easy fix first, a little auto elixir, which I have never had much faith in, but figured I would try. I put half a bottle of Sea Foam in the oil. The exhaust smoked white for a few minutes and over the next 20 or so miles the ticking quieted some. 100 miles later, the oil was very dirty, and seemed thinned, so I changed the oil.
And, being that I had just topped off the tank, I added the remaining Sea Foam to the fuel, as the bottle informed me could clean fuel injectors. When I next started the Ciera, the lifter tick seemed louder, white smoke poured out of the exhaust and does not seem like it will stop smoking, and the car now stalls in gear. I'm not sure where to start: head gasket, adjust lifters, cam timing belt, could some of these symptoms be caused by the Sea Foam? It may be more economical to junk this car if repairs are costly, but I may be able to do the work myself if parts are responsible and repairs are only moderately difficult.
Oldsmobile - Cutlass :: 1996 - Fuel Pump Running But Car Will Not Turn On
I been working on this car for several weeks now. I have change,
1. The starter.
2. New Battery, New Plugs, New Crankshaft sensor.
I even change the belt tensioner because is was going bad (Broken). In fact I can hear the full pump running. After doing all this the car still not turn on. there is full in the full injector.
Focus :: 2000 Focus SE Running Rough Idle Then Stalling
my 2000 focus se, 2.0L SPI, with 82k began to recently run rough at idle then progressed to stalling at longer lengths of idle. The condition starts once the engine warms after 2-5 minutes. I 1st tried gas treatment. I replaced the ignition coil as suggested in the other threads, but it has not improved the problem. I had the fuel pump recall-replaced 2 years ago. I would guess that a bad fuel pump would exhibit loss of power at all engine speeds? Before I proceed to replace plug wires and plugs.
View 14 RepliesOldsmobile - Intrigue :: Random Misfiring / Running Rough And Short On Power
My '99 Olds Intrigue was running rough & short on power. Autozone read a trouble code "random misfiring" (PM3000 I think it was). As suggested, I changed the plugs/wires and checked resistance on all three coils with no luck. Here's the real spooky thing: while driving down the street a couple days ago, the pipe between the catalytic converter & muffler separated, scaring me and sending all the children getting off the school bus scrambling for cover. There was no noise or odor prior to the 'drop out' - is there any chance that the one problems (a catalytic malfunction, or small leak in the area for instance) could be related to the misfiring? A mechanic - before the pipe plummeted - had suggested it might be an injector problem or the intake manifold but I figured that an injector problem would trigger a code.
View 1 RepliesIntrigue :: 1998 Oldsmobile Rough Idle / Driver Side Windows Do Not Go Up Or Down
I recently bought an '98 Oldsmobile Intrigue, I do not know much of anything more than how to check fluids and were to put them when low, So here's the issues that I have come across.
Roughish idle. when stopped and in drive it has a rough idle but not bad yet.
Driver Side windows do not go up or down. The driver window is stuck with a 1/4 inch gap I keep weather proof tape over it. the back window slides up and down but not with the button also held up by tape. I can hear the motor running when I press the button but no luck.
A/C motor works but no air blows out of the vents.
Driver side back up lights don't work and Driver side front blinker or parking light does not work.
Security light recently come on and can't get it to go off whenever the car is started and it is a steady light no flash or blink.
I already know there is a small leak in the radiator and even with the issues it has I love the lil car and want to fix it up to proper working order. So, what I can possibly do?
Oldsmobile - Engines - Cutlass :: 1990 Quit Running At A Stoplight Or At Any Idle Speed / Hard To Restart
A friend has a '90 olds Ciera with the 3800 engine. The engine will quit running at a stoplight or almost any idle speed and then will be hard to start. May have to wait a few minutes before it restarts.
View 1 RepliesGolf IV / Jetta IV :: 2003 GLI 24v VR6 Running Rough And Stalling Out
I have been beatingy head against the wall for the last month with this car. It started out by just running really rough and stalling out. Found out that I had a bad clamp on the air intake that attaches to the throttle body. Replace that after I already replaced the MAF. Everything was great till couple days later then the car just crank crank crank no fire....
I cleaned the grounds pulled the plugs and coils, had perfect spark. Put everything back come to find out after going thru my Bentley manuals I jumped around the fuel pump relay fuel pump kicked on perfect started great! Replaced the fuel pump relay BAM! Ran great!!!! For 2 days..... After that right when I pulled into the drive way the car would not start.... So I tried everything again.... To no avail..... Check the codes again, now I'm throwing these codes which yes I did cross reference in my Bentley manual.
P1117- O2 sensor heater circuit bank 1 sensor 2 short to ground
P1198- O2 sensor heater circuit bank 1 sensor 2 electrical malfunction
P1472- EVAP emission control LDP circuit short to ground
P1516- Intake manifold changeover valve circuit open
And the dreaded same code I've had the whole time........
P0102- Mass or volume air flow circuit low input.
I have also tried tracking down any bad wires, and testing resistance...
Kia - Sephia :: Stalling Out And Running Very Rough - Catalytic Converter Replacement?
I was told that my 1997 kia Sephia needed a new catalytic converter by a very reliable shop. My car had been stalling out and running very rough. They did replace the distributor cap which seems to have increase the overall performance and that same day i had a smog check and passed with flying colors! Why would I still need to replace my converter if I passed smog. My car has only 36k on it.
View 19 RepliesChevrolet - Equinox :: 2010 - Running Rough And Stalling When Idling
I have a 2010 Equinox with about 52000 miles on it. At about 48,000 I took it in for the 50G maintenance. The car ran with a fluttery sound that I did not really notice until it was brought to my attention. Recently the car began running rough and stalling when idling. there were no warning or indicator lights lit. I had OnStar run a remote diagnostic and they said there were no codes. The day after the diagnostic the check engine light went on , while at the same tie the rough idle and stalling went away.
I brought the car in for service at the dealer. They said that the car had several codes indicating low oil and the car was down 2 quarts but there was no leak. They also said the noise I heard was the timing belt. The noise is gone after the service and the car is running smoothly. Coincidentally, or not, I got a notice from GM saying they were changing the oil monitoring software on the 2010 Equinox to recommend me frequent oil changes.
1) What could cause the car to loose 2 quarts of oil over less than 6000 mile? Is this normal or an Equinox problem.
2) Would low oil cause the timing belt to make a noise.
3) Do I have a lemon and am I being ripped off y the dealer?
Santa FE SM (2001-06) :: Stalling And Running Rough - Codes P1166 And P1167
My 03 Sante Fe is running a little rough and is stalling. My Mechanic said this P code was going to run me $1300. I'm not very mechanical , but this just seems very high. He said that aftermarket sensors would not work and only Hundai parts for the fix.........
2003 Sante Fe, LX, 3.7 l engine
Toyota - Corolla :: 2004 - Stalling / Running Rough And Hesitate On Acceleration
I'm having issues with my 2004 Toyota Corolla with 118K. Every few weeks, the car will go through a phase where it will stall out, run rough and hesitate on acceleration. Oftentimes it is accompanied with the rotten egg smell coming from the catalytic converter. When I decelerate to a stop light, the car will stall. When I start it back up, I have to rev the engine to 2000 rpm in neutral to keep it from re-stalling. Once I get up to about 10-15 mph, the car will jerk and sputter, and at 40mph, the jerking motion gets worse. If the car doesn't stall it'll run rough and have the rotten egg smell. I'm assuming the smell is from unburnt gas.
I find it happens more often when I don't let the car warm up for a few minutes. I've taken it to my mechanic, and i've gone through 2 MAF sensors, cleaned the throttle body. I changed the iridium plugs at 102K and am on top of maintenance with filters, oil and such. Of course when I bring it to the mechanic, the problems don't show up, and we are kinda blind to what could be causing the issue. Also, if I park it for a day or two after the issue occurs, the problems go away. What to look for?
Ford Ranger / B-Series :: 1985 - Running Rough - Bogging Out And Stalling
I am fairly new to this stuff but I just got a 85 Ranger 4x4 and its running pretty rough it will be fine then all of a sudden it will bog right out and want to stall so I have to keep my foot planted on the gas and it pops and spudders and eventually runs normal again? Its a 2.8 V6 carb...
View 14 RepliesSuburban :: 1996 K2500 Running Rough / Getting No Codes
My '96 K2500 w/7.4 is running rough.
I've replaced: cap, rotor, fuel pressure reg, injectors (Bosch Design 2's), plugs, wires.
Had it timed today and it still runs rough. Really rough sometimes. I'm getting no codes.
In the morning when the engine is cool, I'm going to pull the pugs and check them, and verify the plug wires are installed correctly.