Ford F-150 - 1997-2003 :: Low Beams Don't Work But High Beams Do
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 RepliesOldsmobile :: When Hit Dimmer Switch To Select High Beams, Headlights Cut Out
I have a 1941 Oldsmobile and when I hit the headlight dimmer switch to select high beams my headlights cut out . My car has all original wiring and I suspect a short at one of the terminal blocks. I am unsure how to troubleshoot this problem. I cannot select my model number below I have a model 76 Dynamic Cruiser.
View 19 RepliesFord Wiring/Electrical :: Flashers Don't Work / High And Low Beams Work
2004. Hazards and brake lights work.
View 6 RepliesOldsmobile - Cutlass :: 1992 - Spit And Sputter Sometimes?
i have 1992 v6 olds cutlass ciera. it likes to spit and sputter sometimes. no matter if it's hot or cold, up a hill or on flat, slow or stop?
View 3 RepliesOldsmobile - Cutlass :: 1992 - Shuttering And Not Wanting To Take Off
I have a 1992 Oldsmobile Cutlass Ciera 6 cyl. This car just all of a sudden started shuttering and not wanting to take off. It will if I floor it but will still shutter a little?
View 10 RepliesOldsmobile - Cutlass :: 1992 Stalls After 20 To 30 Minutes Of Driving When Stopped For A Light
Have a '92 Olds Cutlass Ciera 6 cyl 3300 engine. After 20-30 mins of driving it dies when I have to stop for a light. Depressing the brake kills the engine. Starts right up after but as soon as I put it in drive, it dies. If the car sits for 20 mins or so after problem begins it's okay. If I get to an intersection and have to stop, I put it in neutral. When I have to go again I rev the engine, let it die down some and then put it in drive (hard on the car, I know, but it's only way to get going again. Once I'm moving, I can accelerate and it's okay. What is wrong with my car?
View 3 RepliesOldsmobile - Cutlass :: 1992 - Small Roar When Turn The Steering Wheel Slightly Left At All
I have a 1992 Olds Cutlass Ciera S. Just fixed it running with a tuneup, but now I noticed that when I turn the steering wheel slightly left at all, I get a sort of small roar and it may just be me but the car seems tense. It feels and sounds like a bad power steering pump, but it turns right fine, no noise or anything. I do not think it's a wheel bearing. Could this car have rack and pinion steering and that is going bad?
View 1 RepliesPassat (B5) :: 1997 VR6 Low Beams Do Not Work
I just purchased this car and the low beams do not turn on when you turn on the lights. Right now I am driving with te DRLs at night. The high beams works perfectly. The fog lights do not work but I have not checked the bulbs (although the indicator lights on the dash works.)
Also looking for diagram of relays. I looked at the fuse panel and see a lot of empty slots. I have relays numbered 18, 21, 99, 36, 110, 53, 167 on the fuse panel. Could I be missing any?
Passat (B5) :: 1997 - Low Beams Do Not Work?
I just purchased this car and the low beams do not turn on when you turn on the lights. Right now I am drivig with te DRLs at night. The high beams works perfectly. The fog lights do not work but I have not checked the bulbs (althought the indicator lights on the dash works.) Also, any diagram of relays. I looked at the fuse panel and see a lot of empty slots. I have relays numbered 18, 21, 99, 36, 110, 53, 167 on the fuse panel. Could I be missing any?
View 1 RepliesPrius (Gen 3) :: Only High Beams Work, Others Became Dead
Just replaced my headlights within the past 4 months. Last night, I go to turn on headlights and nothing turns on, not even the parking lights. High beams work just fine. Checked fuses this morning - fuse for low beams is fine. Not sure why all 4 lights would fail at the same time. A fuse was all I could think of besides pure coincidence.
View 4 RepliesGolf V R32 :: Both Sides Low And High Beams Don't Work
My headlights don't turn on but everything else does DRL turning signals. I tested the resistance to ALL the fuses. I have two new ignitors and two new 10k light bulbs. The only way my high beams work is if i hold the lever in to bypass the resistors but like I said they don't turn on when I turn the HL switch. I just bought a new HL switch two .. the issue remains, what it could be?
View 3 RepliesSanta FE SM (2001-06) :: 2004 - Low Beams Don't Work
My low beams won't work. High beams and fog lights work just fine. We just replaced both bulbs a few months ago so the chances are pretty slim that it's a blown bulb.
I've checked the fuses and relays. I switched the low beam and high beam relays with no luck. Still no low beams.
7 Series :: 1984 BMW733i Low Beams Lights Do Not Work
I have a 1984 BMW 733i and can't figure out why the Low Beam lights do not work when the light switch is on. The Low Beams work when the High Beams are on. I've replaced the Low Beam lights and checked the fuses.
View 1 RepliesNissan - 240sx :: Headlights - Only High Beams Work
I recently got this car from a friend, and when checking all the lights I noticed that only the high beams work, not the low beams. I replaced the lamps, and checked all the fuses, but the low beams still don't work.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 - High And Low Beams Do Not Work
08 SANTA FE, NO HI OR LOW BEAMS. Daylight running lites work, fog lites work, checked all fuses, relays, and bulbs,& connectors.
View 9 RepliesSanta Fe (CM - 2007-12) :: Headlights Don't Work But High-beams Do
The normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 RepliesElantra MD (2010-15) :: No Low Beams When Headlights On But Work When Running Lights On
My limited has lost it's low beams when the switch is set to head lights but not when set to marker lamps. They still shine at a reduced output then. I've read this may be an issue with the BCM?
View 1 RepliesPrius (2004-09) :: Driver Side Bulb Does Not Work On Low Beams
Driver side bulb does not work on low beam but does work on high. Replaced the halogen bulb but problem persists. The dealership checked the fuses which were fine. No further diagnostics done as I already spent more time at the dealership than anticipated.
View 4 RepliesFord F-150 (2004-2008) :: Flashers Don't Work But High And Low Beams Does?
I'm talking about the flash to pass feature, not turn signals.
View 2 Replies