Kia - Sorento :: 2006 - RPMs Go Up To 4000 And Stay For A While
2006 Kia Sorento Auto Transmission, Appx. 106k miles. My wife's car so I don't drive this very often. However, on the last trip, I noticed that it would stay in a particular gear longer than (I think) it should. The RPM's will go up to maybe 4000 or so and stay there for a while even if I let my foot off the gas before finally kicking into overdrive or the next gear and back to a comfortable cruise. I notice this mostly happened when I was going highway speeds and either passing someone or going up a hill. I can't think of the last time the transmission fluid was changed, so I'm thinking that may not be a bad place to start...
View 3 RepliesImpala - Chevrolet :: Sputter And Jerk When Start To Accelerate Past 25 Mph And Get Around 2000 Rpms
I have a 2002 Chevy Impala driving it in the city of Chicago. It's recently had the oil changed, and the transmission fluid flushed and filter replaced. This car was mine before I went off to school, and I meticulously maintained it for three years, and then my step sister inherited it. She drove it for two years, and then it sat in the driveway for a year and a half. It's got about 175,000 miles on it.
Problem: Every time I start to accelerate past 25mph and get around 2000rpms, the car starts to give out, sputter and jerk. It starts to drop off right when it should be shifting to second gear. When on the highway, even if I floor the gas peddle, it won't accelerate normally, but instead just crawls slowly to higher speeds.
It will eventually reach the higher speeds, but it takes about 5-10 minutes for it climb up from 25mph. I don't know enough about this level of car trouble to make a diagnosis myself, and would like an estimate of the cost for repairs. Also the car is getting around 19mpg on the highway, which I need to improve if I'm going to survive the $4.50/gal of Chicago gas. I'm hoping that fixing this problem will take care of that as well.
Malibu - Chevrolet :: Motor Sounded Kind Of Noisy And RPMs Went Up And Down / CEL On
My 2005 Chevy Malibu (97,000 miles) started sounding like the motor was going to die tonight as I was idling. When I started to drive again, the motor sounded kind of noisy and the RPM's went up and down (from 1 to 2 and back down again), and the engine light came on. The temperature gauge showed that the car was running a little hotter than usual, but not much. The gas was about half full, I have had no problems with the gas gauge. I change my oil regularly. No message came on my message panel. I can turn off the engine and start it up again just fine, but the engine still sounds bad and the light still comes on.
View 3 RepliesBmw - 320i :: 1981 Will Not Rev Past 4000 Rpm
My car starts get 62psi out of fuel pump but will not rev past 4000rpm. What might be wrong.
View 5 RepliesChevrolet - Malibu :: 2006 - Misfiring And CEL Started Blinking When Accelerating From Stop Up To 30 - 40 Mph
About a week ago, my wife's Malibu (~130,000 mi) started exhibiting symptoms I would associate with a problem with the ignition system. It was idling rough, it felt like it was misfiring, and the check engine light started blinking when I was accelerating from stop up to 30-40 mph.
The timing was all weird because of the holiday, and so I didn't take it to get the engine codes pulled right away because I figured Id take care of it this week (we were traveling over the weekend).
My wife just called and said her car won't start at all. The car will try to turn over and she didn't describe anything consistent with a dead battery.
If I can't get it somewhere to get the codes pulled, what might be wrong? To summarize, it started idling roughly and maybe misfiring about a week ago, it sat for four or five days, and now it won't start.
Chevrolet - Malibu :: 2006 - Electric Power Steering Tight And Kind Of Jerky
My Wife has a 2006 Chevy Malibu Maxx Lt, we recently had a series of factory safety recalls performed. Now we have a message coming up saying "POWER STEERING" and the steering wheel is tight and kind of jerky. We didn't have this much trouble before we had the recalls done.
View 10 RepliesGolf V R32 :: When Pressed Throttle While In Neutral Car Will Not Rev Over 4000 RPMs?
So I drive a 2008 R32/U.S. spec and I was in neutral when I pressed the throttle and it would not rev over 4000 rpms and was wondering why??
View 24 RepliesSaturn - Sl :: High Revs - 3500 To 4000 Rpms
I have a '96 Saturn SL with a 1.9 SOHC. I recently removed the engine and transmission to change the clutch. I also changed the timing chain guides, the valve cover gasket, the timing chain gasket, oil pan gasket, front and rear crank seals and motor mounts. After I put it back in, it revs to 3500-4000 rpms and is very rich (so rich it smokes). I replaced the throttle position sensor since it had a crack at the plug and to see if that was the problem. I have looked at everything again and nothing is jumping out at me.
View 10 RepliesPassat (B6) :: Sudden Boost Loss At 4000 RPMs
I just installed a boost gauge and drove the car a little and this is the readings I get. It starts off with 20 inHg and to normal street driving it goes up to 0 and down. However when I pushed it a little, the maximum reading I got was 11-13PSI (High RMP-almost redline). I am a noob in this boost department so Is this readings really accurate or is there something wrong? Recently i had some transmission work done. And since then the gas pedal feels heavier. I was convinced that it is from the new bushings but I feel like this is boost related. Because at 4000 RPM sometimes It suddenly looses the boost (Kick).
View 5 RepliesGolf IV / Jetta IV :: Engine Whine At Above 4000 RPMs
I've had a weird problem pop up within the past few weeks. My engine seems to have a noticeable whine above 4000 RPMs. It sounds almost like a supercharger whine, but my engine is completely stock. Possible problems I found online include exhaust leak, vacuum leak or tensioner issue for the belts.
Another issue I have had is that whenever shifting into second gear, I have some difficulty getting it into second gear. It makes a scraping sound as though the clutch is not disengaged all the way. On occasion, I have also had the shifter kind of pop second gear out when continuing onto third or even feel like it is rejecting second gear sometimes. A friend of mine told me that the scraping sound is normal and, "that's just how manuals are." Doesn't seem normal to me especially since it is every time I shift to second gear.
GTI 337/20th Anniversary :: Strong Noise When Hit 4000 RPMs In All Gears
I am hearing a rumbling noise when I hit 4000 rpms on all gears worst in 2nd and 3rd.... I just recently replaced the timing belt, TBA Done, valve cover gasket, and passenger side axle (through raxles). Anyways I started hearing noise after those repairs, my mechanic has gone through all the work recently done and cant find the problem..... We replaced the tranny mount thinking it was that, but no luck.... I have not lost boost, and noise starts 4000k and goes away at 4700k No codes are flashing.
View 5 RepliesCamry 2012+ :: High Pitch Whirl When Heavily Accelerating At About 4000 RPMs
Is this normal for the Camry? When you're flooring the car besides the typical roar I hear like a small high pitch noise, it's gone once I let go of the gas. I tested it & start to hear it at about 4000RPMs I believe. Recorded it on video but you can't hear it at all on video.
View 14 RepliesLincoln - Markvii :: While Driving Speed Dropped To 40mph And RPMs Rise To 4000
I have a 1990 Lincoln Mark VII, black on black, basically one owner, excellent condition... except one problem. While driving the car my speed dropped to 40mph, while my RPMs rose to 4000. Upon checking I found the plastic clip, which holds the linkage from the transmission to the accelerator had snapped. I replaced the part and still have the same problem...is my transmission smoked or is there an adjustment?
View 4 RepliesGolf IV / Jetta IV :: MK4 VR6 12v - Acceleration Ticking / Clicking Noise Stops At Exactly 4000 Rpms
My VR6 is making a ticking sound when i accelerate, between 2800-3100, then it dies down a little and then gets loudest at about 3600-4000. The noise stops at exactly 4000rpms every time. Here is a sound clip of what the noise sounds like... you can hear it best in the last 15 seconds or so in the video. Maybe its the timing chains...
[URL] .....
Ford - Escape :: 2005 - Dies At 4000 RPMs / High Temp Engine
My hybrid has been a great car, owned 3 years. Now have problem: runs great but if going higher speed 65 and pulls hill needing to kick in to 4000rpms it dies right away says high temp engine but does not smell hot or need water. Let it sit for 15 minutes (even though will start right away but might keep dying unless sits). Will run fine unless hits higher rpms then dies again. 2005 Ford Escape Hybrid...
View 5 RepliesFord - Focus :: 2002 Cylinder 2 Misfire / Stumbles On Acceleration Between 2000 And 4000 RPMs
I've got a misfire problem with my Focus. It started about a month ago and did not trip a code until last week. It stumbles on acceleration between 2,000 and 4,000 rpms. It is only a slight stumble and although noticeable, it does not impede driveability much. Last week I was able to get it to finally trip an OBD code. P302 - Cylinder 2 misfire. I changed the plugs and wires with no effect. I thought I had it narrowed down to the coil or injector until my wife noticed a new wrinkle.
Under normal driving conditions the misfire is annoying, but my wife found that if she turns on the A/C, it is undriveable and will not accelerate past 30 mph without some patience and a neck brace for the bucking. My first thought was the A/C compressor was freezing up. I turned off the A/C and left the blower on and it would not stop missing. I turn off the blower and it smooths right out to the annoyance I described first.
Right now I drive the car without A/C and blower whenever I accelerate. If I'm going a steady speed, all is well and I can run the blower and A/C.
Ford Ranger / B-Series :: Started Revving Real High (about 4000 RPMs) And Getting No Power (20 MPH)
Two days ago, I was driving on a North GA steep, windy, mountain road in my 2002 v6 4.0 Ranger. All of a sudden, i started revving real high (about 4000rpms) and getting no power (20mph). I pulled over immediately and transmission fluid was pouring, by the quart, out of my truck. I didnt get to look exactly where it was coming from, since i backed away once i saw a small flame coming from the leak. i then called a tow truck (assuming it was a seal or a hose break) and had it towed to my house.
I started investigating the possible problems and didn't really see anything noticeable under the truck (not that I was expecting to). So what I did was put three quarts of transmission fluid in the dipstick hole and put in gear to see if I could spot a leak. nothing. then I drove it around the block to get it warmed up and put a little pressure on the transmission by driving up a semi-steep hill to see if that would spark the leak again. still no sign of the a leak.
And finally, when I went to go check the dipstick after my test drive, it read to be above the cross hatched area, hence being overfull. What my next step should be?
Kia - Rio :: 2005 - RPMs Won't Go Past 2500
I drive a 2005 Kia Rio with 48,000 miles. Every once in awhile (particularly after a bit of driving when everything is warmed up) the RPM won't go past 2,500. I'll put it in 1st gear, accelerate till 2,500, but as soon as it gets there, the engine gets groggy, the car slows down, and I have to quickly switch to 2nd and repeat the cycle on every gear. Flooring it makes it worse.
Obviously the fastest I can possibly go with this happening is about 50mph on 5th (just below 2,500). This has happened three times and it has fixed itself every time so far.
A possible clue may be that the check engine light frequently comes on, and its always the same culprit: this "flow meter" sensor. I've had it replaced three times now, but it still always trips the engine light. I now just ignore the check engine light.
GTI 337/20th Anniversary :: RPMs Don't Go Past 5500
So about a week ago i got on the onramp to get on the freeway and stepped on the throttle as usual to get up to speed, but now for some odd reason the rpm's dont go past 5,500. Not sure whats wrong. I stay on the throttle but it pretty much stops and levels out at right around 5,500.. i must say i am pretty clueless. i just past 80k not long ago, and everything seemed to be going fine.
View 3 Replies