Ford Wiring/Electrical :: Buzzing / Headlights And Side Lights Flicker
Series 7 , 82 model, light switch drama. I think they worked fine before I had removed the dash but it has a multi plug that I never interfered with but the truck had been in water and the contacts on it were rusty and I know the unit has been submerged.
Anyway, the unit clicks and sort of buzzes and the headlights and side lights flicker and the rear LED lights barely flicker, need to watch closely. I have cleaned and used contact fluid all connections under the truck as I washed it the other day too.
Brake lights work perfectly, indicators too, just associated lights from this pull switch. The unit gets hot, not burning hot but hot enough not to hold for too long. So, thoughts ?
Need new unit ?
Touched something ?
Water ingress finally making unit fail ?
Ford Wiring/Electrical :: 1981 - Headlights / Dash Lights And Charging Light Will Flicker At Same Time
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 RepliesFord Wiring/Electrical :: Rigid Lights Flicker And Appear To Be On When Off
This AM noticed the D2 driving lights appeared to be "on" the brightness was about 10% of the norm. Went into cab and flipped the switch on and the lights lit up normally. Turned off. Looked again and lights were "on" in a dimmed way with a noticeable "flicker" Disconnected wire from power source. These are 2 months installed. Is this an internal fuse in the wiring harness or the cube shaped relay? other?
View 1 RepliesGolf IV R32 :: Interior Lights Started To Dim / Headlights Started To Flicker
so on my way home the interior lights started to dim then out of no where the abs and traction light came on as soon as i pulled up to my house the headlights started to flicker radio shut off gauges flickered off and climatronic shut off now the cars dead would this be the alternator? Car is vf stage 2 supercharged....
View 22 RepliesJeep - Electrical-wiring - Cherokee :: 1996 - Headlights Switch Off Unexpectedly
The problem is that my headlights on my 1996 Cherokee Jeep XJ switch off unexpectedly. I can get them to come back on for extended periods by fiddling with the control knob in certain ways. This is the kind where you pull out of the knob to turn the lights on, and can rotate the knob to brighten or dim the dash.
If I pull a bit harder on the knob, the lights come on; if I twist this way just so, then off they go; that sort of thing. The fuses are fine and the contacts in the fuse box are clean. High beams work great no matter what (these are controlled from the steering column). I think the problem is at the control knob.
Now, how can I keep my headlights on when I turn them on every time without having to fight the gremlins? I think my next move is to remove the bezels and so on as best I can and get in there with some proper contact cleaner to see it's just built up gunk causing havoc. If that fails, or if that's a bad idea, what's next?
Ford Wiring/Electrical :: 1986 F-150 Misses And Backfires When Headlights Turned On?
The truck has a 300 straight 6 and runs pretty good until you turn the headlights on or anything that uses current for that matter ie. Radio , Fan ect. But is worst with lights. Just got the truck last week and can't seem to figure this one out.
View 1 RepliesFord Wiring/Electrical :: 1995 F150 Stalls When Headlights Turned On
After replacing my battery cables (Pos and Ground),My Truck stalls every time I turn on the headlights. The truck stays running with the parking lights on or if no lights on at all. Could I have mixed up the 2 positive accessory wires?
View 13 RepliesFord Wiring/Electrical :: 1997 F250 - Dash Lights Flicker Off When Place The Transmission In Drive Position
I have a 1997 F250 that I am fixing up. The issue is this... The dash lights now flicker off when I place the transmission in Drive position. I can slightly move the slack in the gear selector and the lights come back on. When the transmission is in Park, the dash lights work correctly. Not sure why there is some type of switch to control the dash lights buried within the steering column?
View 2 RepliesJeep - Electrical-wiring - Wrangler :: Wipers Don't Always Work / Quit Without Warning
I have a 1999 Jeep Wrangler Sport 4.0L with a kind of serious problem. My wipers dont always work. Sometimes they work fine, sometimes they work fine to start with and then quit without warning, other times the only way to get them to turn on is to turn them on high and then go to the speed that I want to use. It has the intermittent option but I am not yet convinced that that has anything to do with my problem. They will quit working some of the time while using the delay but they also quit on low sometimes. I have been through and checked all of the plugs, and even went as far as to grease them up so I know they are making good connections. I'm at a loss, I would think if it were the motor or the switch it would just go out all together. And if it were a broken wire, wouldn't it come on and go off if I hit a bump in the road? They shut off on smooth roads so bumpy or smooth does not matter.
View 1 RepliesFord Wiring/Electrical :: 1997 - Headlights / Brake Lights Cut Off When Hit High Beam Switch?
So I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesFord Wiring/Electrical :: 2014 - Program Headlights And Running Lights Not To Come On When Open The Doors?
Wondering if there is a way to program the headlights and running lights so they DO NOT come on when I open the doors?? And to turn OFF when the switch is off??
2014 super duty lariat
Jeep - Liberty :: 2009 - Starting / Electrical Current Malfunction
I have a 2009 Jeep Liberty Sport 4X4 with 63,000 miles. There have been issues starting the car for about a year and a half.
It all started when a key was inserted into the ignition about a year and a half ago and a click would just be heard after the key was turned to the start position. Usually it started after the key was removed and inserted again. Sometimes it would take a few tries but most of the time it would start right up on the try one.
After 10 months, the battery was replaced after the vehicle had to be jump started. Shortly after, I had a Viper 5901 remote starter installed in the vehicle by a reputable store. The issue seemed to go away and thought the issue was fixed. The vehicle now was started from the remote control 90% of the time.
The issue started to become worse about 2 months ago. It would take more than 15 tries to start and to temporarily relieve the issue; it can be started on the 3rd or 4th try by rocking the vehicle. The starter was replaced two weeks ago by a reputable auto mechanic at my request. I went to a camp the day after for a week and most of the time it just sat in the hot sun except for short errands sporadically throughout the week.
I then went on a week vacation and the car sat in the driveway. I came back and the car didn’t have any power. The battery read 1.2 volts. It was jump started and then I went to work. At the end of the work day, I tried to start the vehicle and just heard the click. After rocking the vehicle, it started right up.
I was curious to why the battery was that low and so I hooked up a meter inline from the battery terminal to the disconnected red wire. Please find the results below:
-Entire top of the fuse box was removed of fuses, relays, etc. – read 0.20A empty – it sounded like the fuse box clicked when the circuit was completed. Not quite sure what was plugged in to draw that much current.
-The fuse box was reconstructed except for a few fuses – read 0.24A
-M13 fuse was connected and current increased to 0.64A (0.40A increase from previous)M13 – 20A fuse for Cabin Compartment Node (CCN)/Wireless Control Module (WCM)/Multifunction Control Switch.
-M12 fuse was connected and current increased to 1.67A (1.03A increase from previous)M12 - 30A fuse for Radio/Amplifier
-Viper fuse was connected and current increased to 1.73A (0.06A increase from previous)
I guess it come down to a few questions:
-What could be the reasoning the vehicle does not start consistently? Is it due to the battery or something else?
-What would draw a ¼ Amp without any visible connections on the top of the fuse box?
-Why would fuse M12 take so much current without a key in the ignition?
-Anything else I should look for?
Ford Wiring/Electrical :: 1984 F250 - Indicator And Warning Lights Are All Out
My indicator lights are all out. The turn signals work correctly, as do the dash lights themselves, but all of the warning lights are out. The truck sat for three years and I have just gotten it back on the road.
View 7 RepliesJeep - Liberty :: 2002 Dead - Won't Start At All - Electrical Circuit Is Short?
I have an interlock installed in my 2002 Jeep Liberty Sport. I've been having electrical problems in it ever since it was installed. Prior to it being installed the jeep wasn't mine, it was my grandfathers, and he says it really wasn't driven for a while consistently but it didn't have any electrical problems before the interlock was put in. I'm not sure if this is accurate or not because I'd never driven it prior to the installation. Either way, now I believe I have a short in the electrical somewhere in the system. I'm not sure how to proceed, other then to check the fuses. The battery IS currently dead, but it wasn't.
I was able to start the car and get it down the road, hoping the alternator would charge the battery (the lights were out, none came back on) After a little bit of driving down the road I drove back into my driveway because I was scared to drive without headlights, and shut the car off. It hasn't started back up and now none of the lights or anything are working at all. We've tried jump starting the car, thinking maybe the battery was dead or the alternator went out, but the cables just started smoking and getting really hot. I really need to know how to proceed to find this short, will I have to look at all the wires in the car? Or is it possible to just use the fuse box? My knowledge of electric in a car is very limited, though I do know the basic mechanics.
Electrical-wiring - Nissan - Batteries - Sentra - Alternators :: 1997 - Won't Start - No Click / Dashboard Warning Lights?
tonight at 1am: I put the key in and turn the ignition, no start, no click, no dashboard warning lights, no nothing. headlights don't turn on at allearlier in the afternoon - didn't check headlights, but no start, no click, no dashboard warning lights. Sliding 1 key into the ignition gave me a somewhat steady buzzing sound from the car, the kind you get to indicate something electrical is happening (I guess that's what it's for.
I wish I were mechanically inclined.) Sliding the other key into the ignition gave me a much more sporadic buzzing sound. Like metal wasn't making contact, when it should. A few hours previous in the morning - car wasn't starting as described above. Someone pushes the car back from the front so we can make way for another car, to come in and give me a jump. I put the car in neutral, and notice that the dashboard lights and buzzer is on, so on a hunch, I try to start the car in neutral and it starts right up. I drive it to the home driveway, no problem.
2 days ago, I bought the car. A 97 nissan sentra. What it could be? Again, never a clicking sound when starting the car to indicate dead battery. I'm familiar with that.
Subaru - Legacy :: Electrical Surges - Headlights Turned On Suddenly While The Car Was Turned Off
Sitting in my living room I noticed that suddenly my headlights on my 97 Subaru ob turned on. First thought was someone was stealing my pos. Knife in hand I went to investigate. No one there. The keys were in the car, in the off position. The headlights all of a sudden turned off. I noticed that the dash lights were flickering on and off. I removed the keys yet the dash lights remained on. Not wanting my battery drained I disconnected the positive cable, which obviously corrected the issue for the time being. When I was disconnecting the battery I heard a mechanical whirring noise coming from the passenger side of the car just behind the headlight. Have never heard this noise before. NOT the intake fan or the AC. Did not investigate extensively due to darkness, wind and rain.
View 11 RepliesCaprice :: Headlights Started Flicker / Car Dead / Battery Keeps Draining In Rain
I was taking my '94 Caprice to work yesterday morning in the rain, when my headlights started to flicker, then the car died. I lost everything electrical, but the starter and the change oil light, which is on constantly. When I turn the key in the ignition, nothing turns on which means no fuel pump, but car still cranks over. I have checked a lot of places for a loss of power but can't find anything. All fuses are good, fusible links are good, unless I am missing checking one somewhere. Battery keeps draining also, but I don't think it is just draining from the check oil light being on. Drains quick too. Never had this problem before.
View 9 RepliesPrius (Gen 1) :: 2002 Warning Light Came On / GPS Screen Flicker And The Car Turned Off
I have a 2002 Prius.
The other day out of nowhere the warning light came on 2 second later the GPS screen flicker and the car turned off on me. I waiting about 5 minutes and the car started up. Was told could be the main 12v battery but want more input on this. The warning light turn off on its own the next day.
Ford Wiring/Electrical :: Reverse Lights Wiring - Adding 2 LED Spot Lights
What I am trying to do it put in 2 led spot light for added backing up light. What i want to do is have them turn on when put into reverse but also have a switch i can use to turn them on when not in reverse. Just need to know what relay I need and if it even can be done.
I was also thinking of just taping into the wiring harness and adding a wire that goes to the spot lights and another wire that goes to a switch that I could turn on and supply power to the light when not in reverse (I know it will light the revers light also) but is it ok to do that?