Jeep - Cherokee :: Oil Light Comes On Intermittently And Goes Off When Accelerating
My oil light keeps coming on when slowing down or at a stop light and goes off when accelerating. We changed the sensor and it still does it. We checked the oil pressure and oil pressure is good. We just replaced the heads due to a cracked head. The light was coming on before changing the heads and still comes on. Why this happens and what is wrong with the car. I am afraid to drive it. There is oil in it and it reads full.
View 7 RepliesJeep - Cherokee :: 2001 - Engine Shut Off / Idles Rough?
After I start up and drive my jeep around town and then shut the engin off. Then I get back inside the jeep, start it up the engin idels rough. Some times the engin light comes on. I had a coil pack installed and still the same symptoms. What do you think?
View 2 RepliesJeep - Cherokee :: 2001 - Starting After Crank For 20 To 30 Seconds And Idling Rough
Pretty soon this thing's gonna have ALL new parts and STILL running rough! The Jeep has about 40K on a Jasper motor, 175K on everything else. I was experiencing starting issues (crank for 20-30 seconds), and noticed a P0171 code on my odometer (O2 sensor?) so off to my mechanic. He replaced two O2 sensors, no change. New code read MAP sensor, replaced, no change.
Finally, changed Fuel Pump in tank (Fuel filter was changed 2 months ago), still no change. I tried starting it tonight by turning the key 5-10 sec. to prime gas, started but still rough at idle. Runs strong above idle 1500-2000RPM. Mechanic can't check fuel pressure at rails? for some reason. My next thoughts were spark plugs and vacuum lines...
Jeep - Cherokee :: 2009 - Engine Is Running Rough / CEL Code Is P0152
I have a 2009 Jeep Grand Cherokee. Engine is running rough. Check engine light comes on. Code is P0152. The code is defined as high voltage on the front o2 sensor (bank 2). I hooked up the scanner again and checked the voltages. Both O2 sensors on bank 2 are never making it above 0.1V. That seems to contradict what the DTC is telling me. Is that somehow related to the fact that it is not going into closed loop? I'm a little confused.
View 8 RepliesJeep - Cherokee :: 1990 - Rough Idling In Drive With Brake Applied
I am about to begin servicing my new/old jeep. I am unfamiliar with fuel inj.
it is beginning to run a bit rough idling in drive with brake applied. It is beginning to start less easily, turning over longer before firing...
Jeep - Cherokee :: 2015 - Engine Is Very Noisy At Idle?
2015 Jeep Cherokee 2.4 engine. Engine is very noisy at idle. Not noticeable when driving. It has variable valve timing or valve lift. I also has a big black hat on the engine, I wonder if that is supposed to quiet the engine some, if so it isn't working.
View 19 RepliesJeep - Engines - Cherokee :: Idle Whistle When Engine Is Cold
For three years now my 2001 Jeep Grand Cherokee Laredo will whistle. Usually when the engine is cold. When the vehicle is idling in the driveway or at stoplights, whenever I take my foot off the accelerator it will whistle too. The only time it won't whistle is when the gas pedal is being pressed. I've had it to a number of different shops to be serviced but once the car is inside or the engine is warmed it will never whistle for the mechanic looking at the vehicle. I've been told that it could be related to the IAC motor.
View 3 RepliesCherokee :: 1996 Jeep Grand 4L Stalls At Idle And At Highway Speed
1996 Jeep Grand Cherokee 4L
Problem "Stalls at idle and at hwy speed" sometimes starts right up and sometime will not start. Sometimes it will lose acceleration but engine will still be running and you can punch the gas and it will go again.
It has been in the shop for most of the last 2 months. Driven in 3 times and hauled in twice.
Low mileage 70,000 - has been great until now - serviced regularly.
Did get new fuel pump only about 10,000 miles ago do to starting problem but in that case it just did not start.
Independent shop replaced distributor cap, rotor, coil, fuel filter. No codes and couldn't duplicate problem.
Jeep dealer replaced fuel pump (they said wiring problem), O2 sensor, engine module no help, they asked us to pick up car because it ran fine. It stalled within 2 miles of shop.
We replaced gas cap just in case.
Limped back to shop to replace crank sensor as it was suggested several places. Ran fine for about 45 minutes then back to old tricks. Relays have been checked. Still at shop trying to trace problem. At least nobody is saying they can't duplicate problem as it now stalls all the time.
Jeep - Cherokee :: Low / Fluctuating Oil Pressure Gauge And Spiking Temps At Idle
I have a 1998 Jeep Cherokee L6 4.0 Liter automatic with 223,000 miles.
The oil pressure usually runs around 1/8-1/4 when driving around town and now I am getting temperature spikes. I had the coolant and water pump replaced last fall when I was having similar idling issues then. My coolant isn't a perfect green color--it is a little bit grey, but it is full. I cleaned the entire throttle body last January, cleaned the IAC today, and redid the NSS this week (not that this probably matters, just being thorough in my explanation).
It seems to happen worst on hot days (of course) when idling in traffic for a few minutes and makes the air conditioned air run warmer than it should.
Is this a busted radiator? The mechanic said I did not have a leak when I had him check last week.
Jeep - Cherokee :: 2001 - Very Bumpy Initial Idle / Car Shake Back And Forth
I have a 2001 Jeep Cherokee Sport edition, automatic transmission, about 100k miles. Recently, when I turn on the engine -- sometimes -- it is very loud, and the car really shakes back and forth (in place) with the engine. It almost feels like the car is going to die. It feels like a very bad idle. If I wait, nothing changes. If I turn the car off, wait, and turn it back on, nothing changes. If I hit the gas, it continues, but decreases very quickly and by the time I hit a stop sign or red light (let's say 100 yards away), the car is more or less fine; no more fear that it's going to die, although there's still some noise that seems like it's coming from somewhere between the transmission and engine. I had the starter replaced last June (when it went kaput) and replaced the idle control valve a couple of months ago (the car kept dying when I came to a complete stop). I mainly drive it to/from work, about 50 miles each way, going 45-80 mph on a hilly freeway, and there have been no problems while driving.
View 2 RepliesElectrical-wiring - Gasoline :: 1998 Jeep Cherokee Runs Rough / Gas Smell From Exhaust When Idling
1998 Jeep Cherokee sport ... My mechanic tells me that my #1 fuel injector is always spraying and that that is why the jeep runs rough. This is after he already told me that my injectors were clogged and needed to be replaced (which he did). When the car is idling for a while, the exhaust really begins to smell like gas, so this seems to make some sense to me, unlike his previous diagnosis. But now he is telling me that I need to replace the computer to fix this problem.
View 8 RepliesJeep - Cherokee :: Engine Continued To Idle Roughly / Pressing Accelerator Did Not Result In Any Increase In Speed
I was driving my 90 Jeep Cherokee (automatic transmission) last night on the freeway when I suddenly lost power. The engine continued to idle (but roughly) but pressing the accelerator did not result in any increase in engine speed or vehicle speed. The car came to a stop on the off-ramp but I was able to restart it and limp along at idle speed for another few blocks until it came to a stop.
I suspected I may have run out of gas, despite the fuel indicator showing a quarter of a tank but after adding 2 gallons of gas to the tank it wouldn't start. It sounded like it wanted to but it wouldn't start.
Jeep - Grandcherokee :: 2004 Starts Intermittently / Rev High At Idle Sometimes
My Jeep does not always start. All the dash lights come on, but when I turn the key to start the engine, they all go off. The lights stay off, and the engine will not start. The ignition won't even click... it's similar to a dead battery. When I turn the key back to its original position (when first inserting), all the gauges spike and the needles jump really high for a split second. When the door is open the gauges keep jumping (spiking). After waiting for 30 minutes, the engine will start fine like nothing was wrong (except the fluctuation in idle). It would rev high at idle sometimes, and sometimes it would idle low... so low in fact the jeep stalls. I have read about the symptoms of crank/camshaft sensors and relay, but I wanted to make sure from people that know more than I or have faced this particular problem.
View 5 RepliesJeep - Grandcherokee :: Engine Occasionally Run Rough At Idle / Low Rpm Before Stalling
I've got a 1998 Jeep Grand Cherokee, 6 cyl. engine, ~145k miles. A few weeks ago, I noticed the engine would occasionally run rough at idle, dropping down to a low rpm (~500 rpm, but erratic) for a few seconds before stalling. This usually happens when in park or stopped at a stoplight, but it's occasionally happened at low speed while coasting to a stop (never while accelerating, or while traveling above 20 mph or so). Generally, the car will restart right away, though sometimes I have wait a few seconds to a minute (I was a real popular guy at that intersection).
At first, no codes came up, so I changed the plugs and wires (I was due anyway). That didn't work. (The plugs, while worn, looked normal to me-no residue). I've since had a P0351 code pop up. Before I throw parts at this code (ignition coil, I believe), is there anything else I should be looking into?
Jeep - Wrangler :: 2004 - Hard Start - Rough Idle - Getting P0505 Code?
My 2004 Rubicon has been having some idling issues. It idles kind of rough (+- 200 RPM) and is hard to start. I tried to start it recently and after 4 cranks, it started then the CEL came on, and has been on ever since. I have recently moved from Washington state to Houston Texas, and the problem starterd here in Texas. I checked the code and am getting a P0505 code. I had a mechanic replace the IAC valve, Checked for vacuum leaks, and cleaned the throttle body. The mechanic says the output from the main computer appears to have burned out, and needs to replace the main computer(for $1000). The mechanic can clear the CEL, but after turning the jeep off then back on it reappears. The mechanic says he verified the computer was the problem by installing a known good computer and it cleared the problem. Does this sound right to you? If my computer is bad, wouldn't my whole operation be affected?
View 4 RepliesFord - Windstar :: 2000 - Rough Idle Intermittently?
I have 2000 ford windstar with 3.8 engine. I have been reading up on the idle problems with these vans. However, most responses are in regard to the engine stalling and/or it trips a code. My does not do this. Sometimes the idle is rough and other times everything is smooth. I am thinking it may be an egr valve or dpfe valve.
View 5 RepliesFord F-150 (2004-2008) :: Rough Idle Intermittently?
Ok, so I just replaced the entire timing set (phasers, chains, sprocket, tensioners ect) on my 2004 f150 5.4l about a month ago. I also extracted ALL 8 spark plugs and replaced those with the Champion 1 piece plugs. In addition, I replaced the intake manifold because I did this job when it was 20 degrees outside and I found a crack. Soooo, all that being said I put the whole truck back together and it runs like New. Until about a month later. When the engine gets hot, maybe after about a 30 minute drive or so, it has a really really rough idle until I give it a little bit of gas. Then it clears up. It has only done it 3 times since I put the engine back together. It might go 2 weeks and not do it. No codes. What I could be? EGR? MAS air? Only other thing I can think to say is if you get on it out on the highway, after about 3k rpms it seems like the power drops off quite a bit. Like the engine isn't getting enough fuel. I guess it could be just me, but it just doesnt seem right.. I guess I could try to unplug the MAS air flow sensor...
View 14 RepliesFord - Explorer :: 2004 - Rough Idle Like Missing And Die Intermittently
I have a weird intermittent problem. Sometimes when I start my explorer it will idle down and die immediately, I restart and it will idle about 400-600 really rough, sounds like it is missing. When I drive it it is jerky and the acceleration is sluggish but after I get it up to about 20 mph it clears out and then drives and idles fine until I shut it down. Plus these things only happen about every third time (on average) that I drive it. Lastly it's not giving me any codes. What this could be?
View 2 RepliesFord 6.0L Power Stroke Diesel :: Intermittently Running Rough At Idle - Code P0269
So my truck is intermittently running rough at idle for the most part and sometimes slightly loses a little power while driving down the roads. Seems to run worse as it warms up. When it runs rough it sounds like a cylinder is missing. The truck is throwing code P0269 for Cylinder 3 Contribution/Balance. Smoking isn't horrible coming out of exhaust but it's there and it comes out at a constant rate. The injector has been replaced by the previous owner recently. It has an egr delete, new turbo, ficm, ficm harness, HPOP, and stand pipes.
When I put the starter solenoid wire to the battery you can hear the engine skip. I did a compression test on cylinder 3, put oil in the cylinder and did the test again to find that I still didn't have compression. Assuming that this was an issue in the head I had my doubts that it was a bent valve and it could have been a bent pushrod.
Sure enough I found the intake pushrod for cylinder 3 was bent slightly so I replaced the pushrod. I started the truck again and seemed fine at first but just like before it started to run worse as it warmed up.
I was able to drive it to the gas station real quick to fill it up on fuel and drove back home which is a short drive, but the truck was running worse and worse and it eventually died on me. I attempted to start and had to jump start from my other truck and the 6.0 would not start. I ended up frying the starter trying to start it so I'm taking a break from it for now.... Ended up pushing the truck home.
The only thing I can figure is that I don't have oil pressure in the oil rail which is why it died but I don't understand why the truck still ran rough and pulled up with the same P0269 code....