Ford Brakes/Suspension :: 1997 F150 - Converting Drum Brakes To Rear Disc Brakes?
I have a 1997 F150, 4X4. My mechanic says its time for new brakes and was curious if it would be worth possibly converting from drum brakes to disc brakes??
My mechanic has quoted me $300 to do the rear brakes, would it be worth the extra money to convert??? I really don't care for drum brakes. I have done a search on the internet and every time it brings up the issue with the parking brake.
Camry :: Rear Drum Won't Go Back On - Brakes Are Too Far Out
I didn't put the rear drum on while adjusting the rear brakes, now the drum wont go back on because the brakes are too far out. How do I get my drum back on! This is on a 2002 Camry LE
View 6 RepliesFord Ranger / B-Series :: Rear Drum Brakes Not Working
Received the truck, 1989 Ranger XLT long bed single cab from my mom. It had been used by my younger brothers for some years, and then sat at mom's for a couple years.
It needed new front brakes badly, so replaced rotors, and pads. No unexpected problems there.
Looked at replacing the rear. Both adjuster cables were initially broken, so they obviously weren't adjusting, or braking. Replaced with a hardware kit, and shoes, and drums. Its the 9" drums, BTW.
Still not actually braking. I can tell this, when at a stop sign in the winter, with the brake pedal held down, and the backs will still spin, with the tranny in D. Even on gravel or grass, this'll happen.
One shop told me this is because the axle seals are leaking. THey've never leaked badly, and the axle fluid isn't low, by and shade of the imagination. Also, this theory falls apart, when the parking brake works just fine, right? Its just hydraulically that they don't work.
I've since replaced the wheel cylinders, the brake line from the frame to the rear axle, and the master cylinder. No change. Bleeding them doesn't seem to be a problem; i.e. no lack of or little fluid witnessed, it seem fine.
Also have bypassed the RABS valve for about a year or so, and its made no difference. Last fall I pulled the drums off, and manually adjusted them, and it didn't seem much better either.
Ford F-150 - 1997-2003 :: Rear Drum Brakes Locking Up
I'm having a problem with my rear drum brakes locking up when I press the brake pedal. I've had this problem before, but ignored it because it wasn't too bad. It would just release after taking my foot off the brake pedal.
1998 F-150 XLT supercab 4x4 front discs, rear drums 4.6L v8 175k miles
I cleaned my master cylinder and bled all brake lines so they have fresh fluid. Now that my brakes work way better, my rears just lock up. I put new brake cylinders on, still locking up. I went to a junkyard today and replaced the proportional check valve, brakes still locking up.
Could I maybe have did something wrong when cleaning the master cylinder? I'm sure I put it back together correctly. Anything else i should look at? bad lines maybe?
Ford F-150 - 1997-2003 :: Rear Brakes Drum To Disc Conversion
Changing rear drum brakes to discs? I've done it with my 94 explorer, and i was wondering if the axles are the same, just swap the hardware like the explorers are.
View 14 RepliesFord F-150 - 1997-2003 :: 2002 - Rear Axle Drum To Disc Brakes
I got a 2002 f150, right now it has a 9.75 with disc brakes. But it exploded. I can only find a 9.75 with drums in the wrecking yard. Can I just swap my disc brakes on to the axle with drums?
View 1 RepliesFord Super Duty (1999-2016) :: Driver Side Rear Brakes Making Popping Noise - Bad Rotors / Rear Wheel Bearings?
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
Hyundai :: New Rear Brakes Making A Grinding Noise Around 15 - 25 Mph
My car came back from the shop yesterday with new brakes and pads and seems to be making some odd noises, both at low speeds and while breaking. I called the shop this morning and they said that this sound was normal for awhile but to come back in a week if it persists. Is this sound advice, or should I be driving my car right back to the shop?
2005 Hyundai Tucson 122,000 miles
Ford Brakes/Suspension :: 1997 F250 - Passenger Side Rear Drum Brake Was Full Of Oil
Recently purchased my first Ford truck, a 97 F250 w/7.3L diesel. I discovered the passenger rear drum brake was full of oil. Cleaned it up and put it back together to do some research.
I see how the hub comes off and there are two bearings in it an an oil seal. The bearings are lubed in wheel bearing grease. Does differential oil circulate through the bearings too?
It doesn't look like a difficult job. Do the seals go bad often or could this be due to a clogged differential vent? Truck has only 100k miles. Any gotchas I should be aware of?
Kia - Sportage :: 2009 - Rear Brakes Making Grinding Noise
I have 23, 400 miles on my Kia Sportage 2009 and just found out I need to replace both of my rear brakes.They were making grinding noise. Is this a defect? Seems like low mileage to have to replace them?Also my front brakes are down to 50%. Is this a known KIA issue?
View 4 RepliesElantra XD (2001-06) :: Rear Brakes Making Noise While Coming To Last 10 Mph To Stop
Any fix for the rear brake noise I am getting on a 2001 Elantra. I pulled the drums off and inspected the drums and shoes all looks fine. Then I adjusted the brakes cleaned everything and still get noise. It occurs as the vehicle is coming to a stop last 10mph to stop.
View 13 RepliesAccent LC (2000-05) :: Rear Brake Drum Cylinder Removal?
I must replace my driver's side rear brake drum cylinder but I am unable to fit any socket or wrench on the backing plate bolts holding on the brake cylinder. They are rusted and never been touched I think; how does one remove the bolts holding on the brake cylinder without stripping them? There is basically no room for leverage and the walls of a socket are too thick.
View 3 RepliesToyota - Camry :: 2010 - Making Squealing Noise While Backing Up - New Rear Brakes?
Our 2010 Toyota Camry makes a squealing noise as we back out of our garage.Does this mean we new rear brakes?
View 15 RepliesFord Brakes/Suspension :: Consistent Squeaking Coming From Back Drum Brakes When Pedal Is Applied
After putting my Ford Ranger in park and pressing down on the E-break to get the news-paper or mail. I've noticed that there is a consistent squeaking coming from the back drum brakes when the brake pedal is applied. But only for a certain period of time; then the squeaking stops.
View 8 RepliesFord Super Duty (1999-2016) :: 2001 - Rear Drum Braking Noise?
I have an '01 F250/4X4--How can you tell if your rear drum brakes are bad? Do they make a noise?
View 8 RepliesFord Excursion :: 2000 - Popping Noise Coming From Rear End When Apply The Brakes
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 RepliesFord Super Duty (1999-2016) :: 2000 - Rear Brakes With More Power Than Front Brakes
I use a bottle hanging like an I.V. drip to flush the Brake Fluid in all my cars. I can pump all the old fluid out, as well as the air. My Superduty 7.3 has a good solid brake pedal after the flush. It seems to me the rear brakes handle 60% of the stopping load. Its been like this for so long I'm not sure if it's ever been different. i then go to a gravel or wet road and test the rear abs, and it seems o work, but definitely has a squirrely feel. I did some strong pavement stops with speed, and it stops, no skidding. Is that the way it should be?
View 14 RepliesC/K :: Restoring 1970 Chevy C10 - Drum Brakes Not Coming Off
I've begun restoring my grandpas 1970 Chevy c/10 but I can't seem to get the brake drums to budge. I tried several cans of lubricant and even beat on one with a sledge hammer till the outside broke off. But the front face of the drum still won't come off. How to remove them?
View 14 RepliesCorolla / Matrix 2009-13 :: How To Change Drum Brakes To Disc
I bought a 2012 Corolla S and I feel that the rear brakes are a little cheap. Has swapping brakes but how?
View 3 Replies