Ford - F150 :: 2007 - Pronounced Vibration When Apply The Brakes
I have a 2007 F150 FX-2 which i bought new. I have about 60,000 miles on it, and every 8,000-10,000 miles i develop a pronounced vibration when i apply the brakes. When i first had this problem, at about 10,000 miles on the odometer, the dealership replaced the pads and turned the rotors, but the problem resurfaced before another 5,000 miles had passed. About 10,000 miles later the problem resurfaced, the dealership said they replaced the rotors.
The problem resurfaced again at about 37,000 miles, but the dealership claimed that since I was out of warranty. Being handy, I replaced the rotors myself, but now, about 15,000 miles later, I'm experiencing this issue again. Is this just a common problem i will have to live with? I don't tow anything, and i rarely load the bed with anything. Maybe a trip to the hardware store once a quarter and i load a motorcycle into the bed two or three times a year.
Ford 6.0L Power Stroke Diesel :: ABS Will Engage When Apply The Brake Pedal On Sharp Turn
I have an ABS issue. Coming off the free way ramp my abs will engage when I apply the brake peddle. This only happens turning right. doing the same to the left seems to feel something but not as apparent as to the right. I have no ABS light on and no code.
Last year I replaced the left front wheel hub. but didn't have any issues until this. One more thing I was getting a feeling on my brake pedal last week as if my front rotors needed to be replaced. So I did. Rotors and pads. still feel the same. could my rear rotors need replacing as well?
Ford - Taurus - Vibration :: 2003 - Wobble While Going Between 60 - 80
My 2003 Ford Taurus vibrates when I am going between 60-80. Before and after those speeds it is fine. I read an article from Tom and Ray in my local paper that instructed to do a couple things to see what it could be. I cut out the article and have never seen it again! One step was to drive on the freeway and take your foot off the gas to see if the vibration stopped. If it did, such and such was the problem, etc. I think another thing to try was put it in N.
View 4 RepliesCaprice :: New Suspension Making Clicking Noise When Apply The Brake
I recently did all new suspension on my caprice...new springs all around...new shocks all around....all new ball joints and all the tie rods brand new too and new sway bar... after installing everything i took the car to the shop and they did alignment and said they checked everything out and said i was good to go. The reason i did all new suspension in the first place was because a noise i was getting which i believed to be a bad ball joint so i just went ahead and did everything since i had to pull the control arms and what not. after everything is said and done the car is still making the same noise....its like a clicking noise which only happens when i apply the brake and the car lurches forward it sounds like a popping like something isn't tight and the car is moving forward on the frame or something....it doesn't happen in reverse and happens at all speeds sometimes one click sometimes 3 consecutive...
View 14 RepliesCamry 2012+ :: Jerking Forward When Apply Brake At Low Speed
When applying brake in a traffic at low speed, I found there is a jerking movement forward of the car. I need to apply harder so the car can stop completely. No problem at high speed on highway though.
View 14 RepliesGolf/GTI VI :: Rear Fog Light And Red Lights Appear When Apply The Hand Brake
Picked up my new VW Golf 1.6 tdi match today, am still getting used to all the functions and gadgets on board, but what a great car it is, I absolutely love it.
Basically when i apply the hand brake, the rear fog light and red (press the brake) lights appear dimly on the dashboard??? I have checked and the fog light isn't on at the rear of the car.
Also I have noticed that when I indicate right, the same red (press the brake) light and cruise control light appears on the dash and flashes the same as the indicator dash light.
Golf/GTI VII :: Wobbling Sound When Apply Or Disengage Parking Brake
I don't really know how to describe the sound but whenever I stop and set the parking brake, the car makes a funny noise that kinda sounds like wobbling. It does this when I disengage it before I take off again as well. What causes this?
View 5 RepliesSonata I45 (YF - 2011+) :: 2012 - Steering Wheel Used To Shake When Apply Brake
I have 2012 sonata and she has about 43000 miles. I replaced 4 tires at 40000 miles. Soon after, steering wheel used to shake when I apply brake. So, I got front rotors resurfaced and got new front brake pads which solved the problem of steering wheel shaking. I also got alignment right after installing brake pad.
Since last week, I realized there is a vibration coming from front of my car when driving over 30 mph to about 70 mph.The vibration is present randomly and weird thing is that the vibration stops immediately when I apply brake. What may cause this problem?
Civic - Honda :: 2007 - Grinding / Crunching Noise When Apply The Brake In Reverse
I have a 2007 Honda Civic with about 46,000 miles on it. I purchased the car "certified used" about 1 1/1 years ago. For the past several months I've been experiencing a grinding/crunching noise when I apply the brake in reverse. I've taken it to a Honda dealer and they more or less told me that it sounds like something could have been wrong with the brakes. They ended up telling me they couldn't find anything wrong and that my brakes are fine. I've called the dealer to see if they could look at it again, but now my car isn't under warranty and they'll charge me to look at it. What could be causing this noise? At this point in time it's more annoying than anything - I'm afraid if I let it go it might end up hurting something in the long run.
View 1 RepliesElantra MD (2010-15) :: Click Noise When Apply Brake To Stop From Either A Very Low Or High Speed
I think something is wrong with my brake. I only have less than 3k miles on my 2012 Elantra GLS. But now, when I apply brake to stop from either a very low speed or high speed, I always hear a clear click (only one) sound which probably comes from under the car or brake pad (front driver's side). It sounds like metals collision. When idling, applying brake does not make any sound.
View 12 RepliesPassat (B5) :: Driver Side Wheel Shakes And Rattle Noise When Slightly Apply The Brake
Ok everyone the good weather is back, so the drivers side window is down and, I am back to diagnosing an issue that I've been having for some time now. BTW were dealing with my DD 02 1.8t wagon. So all the time over any little bumps in the road or anything that i roll over that "shakes" the drivers side wheel I get this terrible rattle noise. I mean it sounds like I am a dump truck bombing down the road with a bunch of shovels in it......well not that extreme but that sort of shake noise. Anyway the noise however does not occur over any bumps when i even just slightly apply the brake. So I know that it has got to have something to do with the brake rotor or caliper or something on that wheel. Any common issues with brakes? I mean i doubt it is hurting the performance of the vehicle but it is extremely annoying and i feel like something isn't stable that should be until i apply my brakes.
View 11 RepliesNissan - Sentra :: 2000 - Hammering Noise On Front Passenger Side Wheel When Apply Brake
I have Nissan Sentra GXE year 2000 model and it has 143K miles on it. I get a hammering noise on the front passenger side wheel when I apply brake. I did replace caliper, brake master cylinder, rotors, brake pads and brake shims but no luck. The noise is like "ta ta ta ta.." and it gets louder based on speed of car. Brake pads and rotors been replaced 3 times in last 2 years to get rid of noise and been seen by 4 mechanics so far no one could find the exact problem. I also took the car to Nissan dealership they also recommend changing brake pad and rotors which I already did thrice.
View 5 RepliesFord - Taurus :: 1997 - Brake Piston Fell Out
Brake pedal was going to the floor. Plenty of fluid in Master Cylinder.
Pulled both front wheels off to find no sign of any leaks anywhere. High and dry all around.
Metal lines look like new the length of the car. No rust, no sign of any leakage. Clean and clear all around (this is a southern car).
Didn't pull the rear tires off, but just by rubber-necking with a flashlight, all dry back there, too.
So I removed the bottom bolt on both front calipers and swung them up out of the way.
Then I started pumping the brakes to see if the pistons moved.
Two rounds of about 6-7 pumps of the pedal, and nothing. No movement.
Third round, shocked to see both pistons came nearly all the way out!!!! In fact, when I touched them, they wobbled. They were hanging by a thread.
So I tried using a C-Clamp and old brake pad combo to try to push the driver's side piston back in.
But the (fairly large) C-Clamp wouldn't open quite enough, and unequal pressure was applied to the face of the piston.
Next thing I knew, the whole thing exploded with the piston falling out, and all the fluid gushing out to the ground.
Should I just pull the passenger side piston off now, too? And let that fluid also gush out? (all this fluid is pretty much original from the factory, so it's old fluid anyway.
Do I just place the piston back into the bore, refill, and bleed? The piston just sits in there loose like that with only the rubber seal holding it in??? Or are these calipers history?
What about the pads and discs? Some of the fluid got on the bottom half of the disc and one of the pads. Just wash it off with brake cleaner and let dry prior to reinstall?
'97 Taurus GL Wagon 3.0L OHV205k miles
Ford - Taurus - Wagon :: Harmful To Use Emergency Brake While Parking?
I always put on the emergency brake before putting the car in park. My husband only uses the park gear and not the emergency brake. Is this harmful to the car?
View 13 RepliesFord - Taurus :: 1999 - Brake Warning Light Came On And Staying On
I just replaced the rear calipers on my wife's Taurus wagon (old ones were siexed) and bled the brakes as normal, but now the brake warning light is on and staying on. At first I thought it was the parking break, but it seems to work fine, (Tried setting the parking break while in motion and the car slowed quickly.) Its the first time I have changed the calipers on a car. When bleeding I did so until there were no more bubbles pulling about 8 oz from each side. The reservoir did get low but I don't think it emptied. Is it possible that I went too far and now have air in the master cylinder? How would I correct this?
View 4 RepliesFord - Taurus :: Checked Back Brake Drums Now Feel Tire Wobble Around 20+ Mph
I had reason to believe that my back brakes needed replacing. While I was at it, I also attempted to swap out my front rotors, but was stopped when I was unable to remove my front brake calipers. All in all, I essentially did nothing. I checked the back brake drums and put those tires back on and then took front tires off and put them back on. I woke up today to drive to work, and and after getting about a mile down the road and going about 30-35 mph I noticed my wobble. It seemed to be coming from the front, but still hard to be sure. I know my rotors are a little warped, but I usually always experience that when braking, not when just coasting or accelerating. What to check on, or what I could have done? If it makes any difference, I am driving a 2002 Ford Taurus.
View 5 RepliesFord - Taurus :: 2002 - Brake Warning Light Is On - ABS / Traction Control System Not Working?
I have 2002 Ford Taurus SES. Currently the brake light is on and the ABS and traction control are not working. The brakes have been checked and are ok and it has been hooked up to a code reader and no codes come up. Occasionally the light will go off and the abs and traction control work for awhile.
View 1 RepliesTaurus :: Slight Vibration And Loud Groaning Sound Coming From Front Side
My 2002 Taurus has developed a slight vibration but loud groaning sound in what I think is coming from the right or left front side. It gets louder at around 40 - 60 MPH and its hard to pin point. it actually feels like it's coming from the middle of the vehicle and sounds/feels a lot like a clothes washer machine going on the spin cycle. As I turn the steering wheel slightly to the right and listening for a change of the tone of the noise is go away. What this could be? bearing? CV joint?
View 1 RepliesTaurus :: Check Brake System Message - Dimming Dash Lights
I have a 2007 Taurus and for some odd reason I get a message saying to check the brake system. Its accompanied by dimming dash lights and symptoms of a bad alternator. I'm suspecting the battery (its from 2009). Sometimes the issue goes away and when I drive and get the car above 1300 rpm it will go away until the next stop light/sign.
View 11 Replies