Ford Ranger / B-Series :: ABS Engaging When Slow Down To A Stop While Turning Left
I noticed that my ABS was engaging when I would slow down to a stop while turning left. I pulled the fuse for the ABS just to make sure that's what was causing the pulsating brake, and it was. Anyway, if it's an ABS sensor problem, would it be the front passenger side sensor if it's only happening when I turn left? Is there a way to test this. Would a scanner detect it? It hasn't been throwing a code or anything. Just the ABS engaging while braking and turning to the left when it shouldn't be.
View 6 RepliesAccent MC (2006-11) :: Stop Light Switch Sticking So Brake Lights Wouldn't Work Properly
I am the owner of a 2009 Accent L (Canadian model) sedan. I have had this car from brand new and I have had two warranty issues with this car in the last 6 months. First at approx.36000 miles (60000Km) the stop light switch started sticking, so the brake lights wouldn't work properly. The second issue was the turn signal/ headlight combo switch malfunctioned and started to smoke. The dealer replaced these under warranty after some hassles.
View 1 RepliesFord Ranger / B-Series :: Dome Light Automatically Turning Itself Off?
How to keep the freaking dome light from automatically turning itself off?? I understand it's a battery life saving function but I find it ANNOYING and would like to stop it.
View 6 RepliesFord Ranger / B-Series :: 2001 - Oil Pan Gasket Sticking Out In The Front
My son and I were doing a transmission flush and while we had it on the lift, I noticed the oil pan gasket was sticking out in the front quite a ways. I assume its time for a new one. Is there anything I need to know having never dropped the pan on this truck? Is this a common issue?
View 14 RepliesFord Ranger / B-Series :: Front Brake Caliper Seems To Be Sticking?
Yesterday, I noticed that my right front brake caliper seemed to be sticking. This morning I jacked up the front end, and could barely turn the right front wheel when it was off the ground. So, I have concluded that that caliper is sticking. So, here is the question(s): what is the best way to repair this (new caliper, rebuilt caliper, or rebuild it myself), do I need to do both sides the same or can I just do the one that is acting up, and should I expect to pay. I have some mechanical ability, but that Haynes manual doesn't make too much sense to me. Getting it professionally repaired is extremely inconvenient, I need to be back at school (300 miles away) Tuesday evening, and probably couldn't get it in to get it done before then.
View 12 RepliesFord F-150 (2009-2014) :: 2012 - Brakes Sticking After Coming To A Full Stop
From everything I have read I can't seem to figure out exactly what the fix is for what feels like brakes sticking after coming to a full stop, then accelerating? I will describe as a clunking and kicking feel, as if power to the rear end is being delayed then kicking in.
From all the posts and replies it seems like a differential issue. Exactly what the issue is and the correct fix? 2012 purchased used with less than 5K miles in 2013, problem has slowly been getting worse over time.
Ford Ranger / B-Series :: 1998 - Ticking Noise Under The Hood As If Lifters Sticking
1998 ranger 5spd... I have 117k miles on this little ranger and I recently took it on a little trip and since that trip it has a ticking noise under the hood as if the lifters were sticking. I believe it has hydrolic lifters in it. I put some sea foam in it 200 miles ago and changed the oil about 50 miles ago. I used Valvoline full synthetic and it seems like it has lessened the tick and it drives a lot smoother, in my opinion. Is there any thing else I can do to relieve that ticking? It is more noticeable when the engine first starts and is louder if i push down harder on the gas. It is not preset if i do not put that much pressure on the gas.
View 6 RepliesFord Super Duty (1999-2016) :: 2004 - RPMs Will Stop Then Pick Up And Stop - No Codes?
i have an 04 f250 5.4 4x4 250k miles+ ...the truck has been acting weird lately. I has 0 power...i went to pass an 18 wheeler today at about 15 mph and gave it about half throttle...well it held first gear till about 5 grand then slammed into 2nd...It just has 0 umph ... it wont even consistanly pick up speed at half throttle or over..the rpms will stop ...then pick up...then stop...it always accelerated smoothly....it is bogging really bad...it was downshifting into 3rd today on little overpass hills that it NEVER does that on...something is telling me torque converter BTW no codes and no flashing overdrive light
View 14 RepliesFord Ranger / B-Series :: Uneven Front Brake Wear / Caliper Sticking Slightly
2000 Ranger, see my sig.
Just had to swap out the pads on my truck yesterday. The pedal was pretty mushy and I was getting shaking in the steering wheel when the brakes got warm. Shaking wasn't all the time, only after they had been used quite a bit - say after city use and the brakes had to be applied suddenly. So I popped off the tires and swapped out the pads and replaced the brake fluid - flushed it.
On the driver side front, the pads barely had any real wear and the anti-rattle clip was all messed up. It was installed properly, but it looked like the pads had smashed into it. The rotor appeared to be warped, or at least out of round - but just barely. You could see it wobble slightly in one spot if you spun the hub with the caliper removed. The caliper itself was sticking slightly.
I didn't see any evidence of damage, the brakes flushed just fine although the fluid was incredibly dirty (because I haven't done it in a long while). On the passenger side front, the pads were worn down to the level I would have expected given the mileage. The wear was even.
My question ultimately is this - is the out of round hub the culprit here? Might there be something else going on like a caliper problem? Ultimately I plan on having the rotors surfaced - one of them certainly needs it and with new pads I might as well do it anyway.
GTI 337/20th Anniversary :: Rough Idle - RPMs Go Up And Down At Stop Light
Have a jazz blue chipped tuned with giac.. It does this random times.. When I come to a red light on idle the rpms go up and down just a bet but never stalls. The car vibrates and the engine shakes a bit. Engine is stable when car is on and off. Idk if its motor mounts or what?
View 10 RepliesFord Ranger / B-Series :: Barely Accelerating From A Stop Light At 2k RPM - Horrible Gas Mileage
I got my b2500/ranger a couple of months ago and I've had very poor gas mileage. I replaced the air filter, changed the plugs, no luck. The truck has 169,000 miles. I haven't checked my exact gas mileage but from what i am seeing its horrible. I filled it up last night, not completely full but really close the full marker. In the morning i drove to school (7 miles) drove home, so 14 miles. Then i had to go back out by my school to pay back a friend. All in all about 28 miles. This cost me a little more than a quarter of a tank. The 2.5l has a 16 gallon fuel tank, so if my calculations are correct im getting about 8 miles to the gallon. I also took it the consideration that it was a half gallon from full.
And it wasn't just past below a quarter to full it was 3/4 of the way to a quarter from full. I know that i didn't test the mpgs "properly" but i think its close enough to draw a conclusion from. And keep in mind its not a 4.0, its a 2.5! Although i do think the engines size contributes to the mpgs because it takes ALOT to accelerate in this truck. At 2k rpm im barely accelerating from a stop light. And on the highway my engine stays a 2500 rpm doing 60-65. I am really hoping I can fix this because I don't want to drive around in a civic. Plus I need a truck for scrapping which is how I pay for gas as i am 17 and jobs are scarce. Also I know about cleaning the MAF butit has tamper proof torx on it which i do not have the tools to remove. I think it could also be the o2 sensors.
Ford Ranger / B-Series :: 1984 - Stalling When Approaching A Stop Sign Or Light
It's an oldie, 1984, but so far still kicking. 6 cyl 2.8, carb. I took a little couple hundred mile trip a few weeks ago. Rolled back into town no problems.
A few days later I took a ride and the ranger would stall when approaching a stop sign or light. I would hold the pedal down a little to keep it running but it sounded like it wanted to die if I didn't feather the pedal to rev a bit.
I drove a few days later, as I was going down the neighborhood road(25 mph), it acted like it wanted to just die. I mashed the pedal and it had no effect. It didn't stall and eventually I could rev the engine to continue.
It continues to do the same, then will all of a sudden take off like there was never a problem. If/when it does stall again, it can be hard to start until it does start and off I go again like there was never a problem. Other times, it will idle.
Another note: Sometimes when I go to start the engine it will stutter, intermittently turnover. It has done the same thing while actually driving, kind of a jerking deal.
Fuel filter, fuel pump, electrical? I'm going to first check/replace the fuel filter tomorrow.
Ford Ranger / B-Series :: 2010 - Single Knock When Accelerating From A Stop Light
I have a 2010 Ford Ranger Sport. RWD with the 4.0L. Currently Sitting at 46,000 Miles.
Where I am located, it is very cold. Downwards of 5 Degrees F. I just started noticing a strange sound in my truck. When accelerating from a stop light I hear a single knock, and to my ear it sound as if it was coming from the rear. First thing I did was check the U-Joint, but there is zero play and it is very tight.
After driving quite a lot and unable to diagnose the problem, I part and got out of my truck, only to hear that same noise when I stepped out of the truck. (I am not fat 195b lol). So I sat back down and I heard it again. Did this a few times and consistently heard it. I got into the bed of my truck and started to jump around and got the same knock.
I shook the exhaust pipe to see if it was making the noise, but it wasn't, which makes sense considering while driving over bumps I could not hear anything. I am totally lost as to what this could be....I want to add that I CANNOT feel any difference driving. Feels great.
My ideas on problems are as follows;
-Spare tire
-bushing
-loose bold
-leaf spring (maybe a hanger)
-The cold creating noise like always.
Integra :: At Stop Light If Hit Brakes A Few Times RPMs Drop And Start Going Up And Down
Basically i have an integra here used to be a gsr with a type R engine. Basic bolt on's and 8lbs flywheel, 6 puck racing clutch. Here are the problems, i hate fixing other shops messes but here we go. When sitting at a stop light if we hit the brakes a few times every time we do it the rpm's drop and start going up and down, some times when the car is just sitting there idleing it does it. Had the same problem on a del sol with a gsr engine and b16a2 head on it done from the same shop. Also when its cold the owner complains that it will take him like 1/2 hour to start it. I was thinking that the grounding wasn't good enough. The check engine light is on as well, but how to get the ecu codes out of this ecu.
View 14 RepliesLS / MKZ :: RPMs Quickly Dipped Twice Then Went Right Back To Normal Idle At Stop Light - P0456
I've got a P0456 code on my 02 LS v6. I came to a stop at a light, RPMs quickly dipped twice from 800 to 400(ish) then went right back to normal idle (800-1000) and the CEL lit up. It seems to be running fine other than the RPM drops after coming to a stop.
I checked the gas cap, everything seems OK there. Checked the hoses coming into/out of Evap valve (well, assuming this diagram actually points me to the evap valve: [URL] .... and there were no major/detectable cracks. Any other hoses/fittings that I should check?
Civic - Honda :: Engine Keeps Quitting When Either Stopped At A Stop Light Idling Or RPMs Really Low
I am desperately seeking info about my 1998 Honda Civic. My engine keeps quitting on me when I am either stopped at a stop light idling or the rpm's are really low. This seems to happen at random with no warning or check engine light. I keep my tank more than half full with gas so I don't believe this could be it. I have been to my mechanic and they said it could be a multitude of things wrong with it so it doesn't make sense to put money into the car if it won't necessarily fix it. I am desperate to figure something out so it can get fixed because I have to drive to work everyday and I'm sick of feeling anxious while driving all the time!
View 5 Replies94 Jeep Grand Cherokee Laredo Shuts Off At Stop Light - Revs At Just Barely Above 0 RPMS
I have a 94 Jeep Grand Cherokee Laredo and when I first got it, it revved too high well now it revs too low, when im at a stop light it revs at just barely above 0 RPMS and the engine will cut off. it just ate shutting off yesterday. I took my car back to the dealership to get it fixed and they said "there's nothing wrong with it" well now I just passed my warranty and it starts shutting off on me.
View 2 RepliesFord Ranger / B-Series :: 1993 - Check Engine Light Comes On And Truck Will Not Start / Fuel Pump Runs Non-stop
Sometimes the check engine light comes on and truck will not start,the fuel pump runs non-stop.. when check engine light goes off,the fuel pump runs for a few seconds and stops,truck will start.... driving down the road check engine light will come on and truck runs bad....
View 2 RepliesSonata I45 (YF - 2011+) :: Front Right Brake Sticking In Stop And Go Traffic
My Sonata suddenly started having front right brake sticking issue. It will happen only after an extended distance of frequent drive & stop. Something like Houston daily ride. So, after the traffic jam mysteriously clear and you can get some speed, starting at 40MPH a high grinding noise from the front (Ceramic brake pads) and the car feels very heavy. The sticking phenomenon will disappear if you wait a little with avoiding using the brakes.
I am going to check it today. So far I know that the sliding pins are not the issue. I recently cleaned them and lubricated them. The front right brake will get hot while the left are just in normal temperature. The brake pedal is getting higher while the sticking is about to happen and happening.
My first guess is the Flexible brake hose. Or maybe a bad caliper. I think if the master cylinder was the issue, I might have more than one sticking brake wheel. I don't know how common it is to have a bad ABS unit causing this issue. It feels really like a build up pressure caused by a valve effect of interior deteriorated brake hose.