Honda - Accord :: 1999 - Struts Replaced And Front End Creaks Loudly (when Warm)

We recently had the struts replaced on our '99 Honda Accord (about 2 months ago I think), and since then, or maybe shortly after then, we get very loud unhappy creaking sounds from the front end. If the car has been sitting all night, it usually does not creak right away, and the sound is the worst after we have been driving for a while. It is most evident when turning or going over bumps at low speeds.

View 7 Replies

Ford - Fusion :: 2006 - Need New Engine At 110K?

I have a 2006 Ford Fusion with a 2.3 L engine and 110k miles that needs a new engine according to the dealer. The car was well taken care of with regular oil changes etc. My local mechanic says the supply of used engines for the Fusion is limited because of their extremely high failure rate. He is a one man shop that has done 6 Fusion replacement overs the past 2 weeks alone yet when I called Ford they claim there has not been unusual numbers of engine failures reported. In spite of this, the Ford dealer mechanic refers to it as a throw away engine.

View 19 Replies

Ford - Fusion :: 2006 - Blower And AC Keeps Turning On And Off

The blower and A/C on my 2006 Ford Fusion keeps turning on and off. The system has manual knobs and is not computerized. It turns on just for a few seconds and then turns off. The knob that controls the turning on and off of the system is in the off position when this happens. What could be causing this?

View 1 Replies

Ford - Fusion :: 2006 - Leak In Crankshaft Seal

I have a 2006 Ford Fusion SE (2.3L 4-cyl.) 5-speed Manual, with 280,000 miles on it. It's been a great car with very little repairs, etc. I've noticed a little oil on the driveway - nothing big, but certainly consistent. At my last oil change, they told me I had a leak in the crankshaft seal and that I should take it to an engine shop. I'm not a 'do it yourself' kind of person when it comes to big repairs. I'd love to keep the car going another year... If I don't fix it, should I avoid oil changes? The leak doesn't seem bad and it doesn't drive any different.

View 4 Replies

Ford - Fusion :: 2006 - Hard Starting In Cold Weather

My 2006 Ford Fusion SE V6 has trouble starting in cold weather. Once it starts, it's fine throughout the day, but once it sits a long time, like overnight, it has trouble starting in the morning. If it had a carburetor, I'd say the choke wasn't working. The dealership couldn't figure it out a few years back. I even tried a new battery and that didn't work. Is there a sensor that detects cold weather and increases fuel flow or chokes off air flow for richer starting mixture that could be failing?

View 12 Replies

Sonata NF (2006-10) :: Passenger Side Creaks When Driving After Cold Starts

Okay. So the past two days I went out to start my car to let it sit for a minute or two. When I went back out I heard a strange noise coming from the passenger side towards the front of the engine. So I got in the car and went to drive out. I shifted into gear and went to pull out and when I turned the steering wheel my battery light came on and the steering wheel got hard. Only lasted for about a second. Then while driving I noticed the passenger side creeks when I hit a bump. Also after driving and parking I noticed my car jumps around slightly at idle

I'll get a video of the noise tomorrow morning...

Also, I do have a custom cold air intake I built myself, and a custom built exhaust.

View 8 Replies

Ford - Fusion :: 2012 V6 - MPG So Inconsistent?

I have a 2012 Ford Fusion with a V6 and record my mileage & fuel info every time I fill up. For the first 45,000 miles I was getting 26mpg consistently every time I filled up, around 45,00 miles it started hopping around. Some fills I get as low as 20mpg others I get up to 33mpg. Over several fill-ups it is averaging close to 27mpg for the past year, but the volatility concerns me. I haven't seen something like this on past vehicles and not sure what it could be.

View 19 Replies

Ford - Fusion :: 2010 V6 Stalling At Highway Speeds?

My daughter's 2010 v6 Fusion has stalled twice (without warning) in the last month at 65+ mph. The dealer reported that since no fault codes were set, there were no repairs they could make to correct this very dangerous situation from recurring. What repairs were made to correct the problem. The car has only 23k miles and has been well maintained at the dealer.

View 3 Replies

Ford - Fusion :: 2007 - Low Coolant Temperature OBD Code

I have an '07 Ford Fusion with 94,000 miles. The check engine light came on a couple of days ago, so I took it to a shop to have them pull the codes on it. The code that came up said the coolant was not reaching the proper temperature, and the mechanic told me the thermostat should probably be replaced.Two questions:

1. Should I go ahead and get it done, or wait and see if the check engine light comes back on? I usually only drive the vehicle about 10 miles a day, and it's all city driving.

2. What kind of cost should I be looking at? He said it would be a system flush, replacing the coolant and thermostat (which they would get from a dealer).

View 4 Replies

Ford - Fusion :: 2007 - Brakes Are Squishy After The Car Is Jarred

My daughter has a 2007 Ford Fusion with brake issues. Brakes are squishy after the car is "jarred" (i.e. hits a bump or pothole). The brakes go almost all the way to the floor and return to normal after a driving for a while. All the work described below has been performed by Ford dealers (at great expense): Master Cylinder replaced, all brake pads replaced. Brakes have been bled numerous times. When we bring it in they bleed it and say it's fine, next "bump" and the problem comes back. We're really at our wits end, the car is, at many times, scary to drive.

View 12 Replies

Ford - Fusion :: 2013 - Thermostat Won't Work While Going Uphill?

My cars thermostat runs normal all the time unless I go up hill. I drive into the mountains to work every day. It runs about 80% hot until I crest the mountain and then immediately cools back down to normal. Since its winter no air conditioning running but heat is on at times. Only 37000 miles on car. Automatic transmission.

View 7 Replies

Ford - Fusion :: 2010 - Power Steering Failure

The power steering fails. Turning the engine off and restarting reactivates the power steering.....

View 1 Replies

Ford - Fusion :: Engine / Transmission Warning Lights Came On

A few weeks ago my 2008 Ford Fusion engine/transmission warning lights came on. I took my car to a local Ford dealer and they told me that my Bosch battery (made by Excide) leaked acid all over some electronic components. The leak came from the negative post terminal. There is spacing where the post goes into the battery. They first thought they could do the repairs under warranty, but since the battery caused the problem they could not get it approved. I now have Excide involved. I took pictures of the battery and engine compartment to show them the damage.

I put in a claim and now they are telling me that they want the battery shipped to them so that they can do some testing on it -- which could take 3 weeks. I'm not sure if I should allow them to have the battery. Once it out of my possession, I have nothing to challenge them on. However, I do understand why they want to look at it. I might not have a choice. Any thoughts? I'd prefer they send one of their reps to the dealer to look at the battery and the damage it caused. The rep can then report his findings back to the corporate office. I just can't believe the damage the acid caused. I never saw it coming. There were no signs. The car was sitting for 2 weeks in my garage while I was on vacation.

View 12 Replies

Ford - Fusion :: Check Fuel Inlet Light Went On

The check fuel inlet light went on. Should we be concerned? What does this mean?

View 9 Replies

Ford - Fusion :: 2010 - Stumble When Stopped In Gear?

I've noticed in the past couple of days that when my Fusion is fully warmed up and stopped at a traffic light I'll feel a short rocking forward-backward. Almost like a bunch of guys are pushing on the car from behind. Sometimes, if it is really bad, I'll even seen the RPMs dip a little bit.

I was thinking that it might be motor mounts causing the sensation. But what would be making the engine dip idle RPM?

Additional info: 138k miles on it and transmission fluid was last changed at about 80k. Plugs changed at 100k. New air filter installed a couple weeks ago.

View 3 Replies

Ford Super Duty (1999-2016) :: 2005 F350 Squeaks And Creaks

2005 F350 4x4... I just installed some Bilstein 5100 on all 4 corners. Stock truck. No lift.

Now every bump I go over the truck squeaks and creaks like crazy. It's embarrassing. Sounds like bushings? Truck was fine before with the stock Ranchos.

I torqued rear to 46ftlbs and front to 76ftlbs. I tightened the top nut until the bushings compressed 1/4" each.

No instructions came with them. Do I need to lube something?

This was a last minute install before a road trip and they ride great but I'm hoping the noise is something I can take care of.

View 7 Replies

Ford A/C :: 2006 F150 - Warm Air Blowing While Idling?

Having problems with the A/C on F150 2006 or newer. It blows warm air while idling. I have taken mine to 2 different dealerships had Ford engineers down and no one can seem to find the problem. I love Ford vehicles but I can't handle this in the these hot summers.

View 10 Replies

Ford Fusion :: 2007 AWD - Strange Humming Sound While Driving

I have a 2007 Ford Fusion AWD and noticed a humming noise as I was driving last night. It started when I got near 50mph and seemed to stop or get so quiet as to be not noticeable when I got to 40 or put the breaks on. What this might be?

View 2 Replies

Ford - Fusion :: 2010 - Service Power Steering Now Indication On IPC

First, I should say that my Fusion has an EPAS (Electronic Power Assist Steering) which means that there is no hydraulic pump but rather an electric motor which provides the assistance to the steering system.

In January I had the "Service Power Steering Now" indication on the IPC (Instrument Panel Cluster) as well and an AdvanTrac (Ford's traction control system) light. Also, the power steering was not operational even after restarting the car and disconnecting the battery. I did some reading online and found that corrosion on the battery cable can cause this issue. It turns out that my battery cable had actually cracked in one place from excessive corrosion and was beyond repair. So, I ordered a new harness and changed the entire cable. Even after the cable was replaced the fault didn't clear and the power steering was not available which makes driving quite the workout.

I took the car to the Ford dealership to have the computer reset. The first several mechanics didn't know what to do. Eventually, someone pulled an old grey bearded man resembling Santa Claus from the back who was able to hook up a laptop and reset the computer. When I restarted the car the faults were gone and the power steering worked!

It is now August. Yesterday the exact same thing happened, loss of power steering the the above faults returned. I took a peak at the battery terminal and it is corroded over again! This time it didn't crack, so a good cleaning should suffice. I spent several hours cleaning the terminals with battery cleaner and a wire brush mounted on a Dremel tool. I took the car back to the Ford dealership and got a lot of disbelief from the guys at the shop. Of course, Santa had gone back north for the winter not to return for several weeks. After much debate, I agreed to leave the car for diagnostics ($85).

Ford called back and wants to replace the entire steering gear which has the EPAS motor mounted to it for $1800. I'm pretty sure that they just need to reset the computer (a 3 minute job) so I'm having a hard time agreeing to drop that kind of cash. So, the questions are as follows:

Was my initial fix a good fix? Why don't these faults clear automatically when the problem is cleared (assuming my battery fix was correct)? How do I go about getting my computer reset? -Do shops other than the dealership have the ability to do this? -How much does the equipment cost to do this myself/what would I need?

View 11 Replies