Touareg :: 2006 - Runs Rough After Cold Winter Starting / Choke Stuck Closed
I have had my 06 for 4 months now. I started to get a cold running problem now that the temperature is falling below 40. When I start it in the morning I wait till the idle comes down before driving. I start driving and it runs rough as if it had a choke stuck closed. I spoke with the dealer and he told me to run lower octane in the winter. That has not worked.
View 7 RepliesFord A/C :: 1979 F150 - Air Out Of The Vents Is Only Dropping 20 Degrees Max
I have a 1979 Ford F150 1/2 ton P/U XLT, 4WD 6.6L 2BL OHV 8cyl that I'm trying to put A/C back in. The truck had factory air, but the evaporator is the only original part in this setup (along with the controls inside the cab on the dashboard).
The new compressor is working. All the pressures look good (the low side is around 35 to 40). But we're finding that the air out of the vents is only dropping 20 degrees max. We've checked to see if the blend door was not working and it was getting heat from the heater core. We blocked off the heater core completely with the same results. It just doesn't seem to be getting cool enough. The large fittings on the firewall should be cold (maybe 40 degrees), but it's only cooling to about 79 degrees, about a 15 degree drop.
We cannot see into the evaporator box to see if there is an expansion valve in the system, but we did not put an expansion valve in with the new system we put on.
Ford Transmission :: 1979 F150 - 4 To 5 Speed Trans Swap?
I am looking to change out my manual transmission in my 79 f150. I want to put a 5 speed in it but still keep my manual clutch. I have a 300 engine that I also want to keep, can I just put a late 80's early 90's 5 speed transmission in it and keep my original bell housing?
View 5 RepliesFord Transmission :: 1979 F150 4x4 - Slight Clanking Noise In Front
I used my truck in 4x to pull a couple of little stumps. Nothing major, just put it in 4l more or less to keep from tearing up the yard. Noticed a couple of weird things today. For a minute had a good pull to the right. Just felt "weIrd" in front end. For lack of a better explanation. Jacked up and checked for play, nothing unusual. Took off the tire and checked other stuff and couldn't find anything. Lubed up joints etc and drove later. I'm hearing a slight " clanking" noise in front. I know it's got something to do with the 4wd but I don't know where to start.
View 3 RepliesFord Transmission :: 1979 F150 - Lost Reverse And Won't Stay In High Gear
79 F150 400/C6 2wd. Loss of reverse and it doesn't want to stay in high.
Strange thing happened today. I took my truck on it's longest test drive since rebuilding the transmission. It was about 25 miles. I got to the junk yard just fine and it was running just fine when I left. I went through a drive through to grab a burger and headed home. That's when it started acting funny. It shifted fine 1st to 2nd, then 2nd to 3rd, but it wouldn't stay in 3rd. It would shift into high, but the slightest bit of throttle and it would shift back into 2nd and eventually got so bad that it just stayed in 2nd, so I had to return to the town I was leaving.
I drove to an autoparts store nearby. I decided to move where I was parked and when I put it into reverse, nothing was there. It rolled back. I drove it to the new spot and called for a tow truck. Weird thing is that reverse worked just 10 minutes earlier when I left the junk yard. When I got it home 2 hours later, it backed up under it's own power. I let it cool down completely and took it for a test drive and it drove perfectly. I have a few theories or questions:
Kickdown rod: Can it be in such a position that it could take away reverse? I would assume that if the spring wasn't returning it all the way forward that it wouldn't have shifted from 1st to 2nd properly. I ask this because I am not using the Holley spring mount and I'm wondering if the wrong spring set up allows the kickdown to be partially activated.
Fluid: What fluid are you suppose to use after a rebuild and what fluid can't you use. Mercon V says it supercedes earlier fluids, but is that wrong?
Am I wrong to assume that if fluid was the problem that I would have had problems with 1st and 2nd?
Cooling: What are signs of hot fluid other than smelling it. Once again, assuming I would have problems with all gears if fluid was too hot.
My guess is that something is sticking in the valve body, but before I drop the pan and pull out the valve body, I want to make sure all other avenues are exhausted.
Ford Brakes/Suspension :: 1979 F150 - Disk Brake Caliper Replacement / Evaluation
I have a '79 F150 4wd and was wondering what would indicate a caliper needing replacement. I'm already going to replace everything on my rear brakes, they are completely trashed. However, the fronts seem OK, NO indications of leaks or seizing both sides of the rotors appear to be evenly "used" I guess. The inner pads do seem to be thicker than the outer pads is this normal? Anything I should be specifically looking for before I have the rotors turned and put a new set of pads on?
View 5 RepliesFord - Explorer :: 1995 - Rough Idle / Stall And Choke A Little When Cold
My truck is a 1995 Explorer 4.0 150,000 miles, 5 speed.
Problem - Rough idle : when cold it's worse and will stall and choke a little. When warmed up it just has a rough idle but will not stall and stays at a pretty constant RPM. It's very tolerable when warmed up but still not right. It drives fine once off idle. No black smoke that I can see. Power may be just a little off but I would not bet on it. MPG seems about normal but haven't been on a long enough trip since problem started to tell for sure. Also longer than normal cranking on occasion.
Diagnostics so far : Fuel pressure is at 32 PSI, vacuum off regulator it's at 40 PSI. Not sure about key on only as I don't trust the autozone loaner gauges. You have to fiddle with it each time before it will read. Leak down after 30 minutes was about 4 PSI
No Check engine light ever. KOEO test shows no hard or on demand codes, I get the 111 pass. From CM I get 336 and 45.
336 is EGR related and my looks pretty rusty. I put a vacuum pump on it while running and the EGR held vacuum but had no effect at all on idle, I was expecting it to get worse as I opened the EGR so it may be stuck.
Searched high and low for vacuum leaks by ear, visual and with starting fluid all turned up nothing.
Actions so far : Replaced plugs, wires, IAC, and fuel filter. Cleaned MAF sensor and throttle body plus ran lucas fuel injector cleaner through it.
Next steps : I've got the EGR but it's so rusty I am sure I'll break the tube it bolts to plus I don't know it that alone will cause the rough idle. Will the DPFE sensor and/or EVR create a rough idle yet not turn on the CEL?
Thought about changing the fuel pump and/or regulator but the numbers are not terrible. Agree?
Thought about changing the intake gaskets but don't see any leaks.
Ford Fuel System :: 1979 F150 - Fuel Pump Leaking From Side?
I've had a fuel leak near the pump of my 79 F150 with a 400 for some time. I didn't know exactly where it was coiming from, but fuel was being sprayed on to the oil filter from something near the pump. I assumed it was the steel line, and that it had rusted through or cracked, and was going to replace it when I had a chance. I was poking around today though, and realized that the fuel was not leaking from the line, but from a hole in the side of the mechanical pump.
For someone who knows what these pumps look like, there is a horizontal cylindrical bump out near the top of the pump, on the side of the pump that is away from the engine. The fuel is spraying in a mist out of one side of that. To me, it always seemed to be a screw channel, but I didn't think the pump was 2 halves put together? Need to know more about my pump, what that bumped out section is, or why/how fuel could be spraying out of it.
Volvo - V70 :: 2001/ 24T Vehicle Runs Smooth When Cold / Runs Rough With Delayed Acceleration On Warm Up
My 2001 V70 24T runs smooth when cold as it warms up it runs rough with delayed acceleration reaction ....
View 1 RepliesFord Wiring/Electrical :: 1996 F150 - AC Runs And Then Cuts Out / Compressor Not Turning
Have and intermittent condition with my 1996 F-150 4.9. AC runs and then cuts out (compressor not turning). I lose 12v to both side of high side switch. I tried to troubleshoot using a schematic in Haynes Foprd Pickups and Bronco for 92 and later F-Series/Bronco, but the color code for the wiring doesn't match up.
On my truck, there is 2 wires from the low side pressure switch which mates to a socket with only 1 wire. I have 12 volts at switch terminal on dash control, and it seems that I have an broken wire behind the dash, as I can get it to operate again when I move the harness around. Where can I get a schematic of this part of the circuit?
Rough - Mazda - 626 :: 1999 - Rough Idling But Runs Fine At Higher RPM
This problem has been getting worse over the last 2 years. When the car starts it idles fine at about 1000 RPM. As soon as it warms up, it starts to idle rough, between 500 and 750 RPM. It almost quits running. As soon as you give the car some gas it runs just fine. About 3 weeks ago I got a "Engine Lean" check engine light error. I reset the system and have not gotten the error again. Since then I have: changed the MAF cleaned the EGR (made sure it closes completely and ohm out the coils in the actuator) changed the O2 meter on the exhaust manifold cleaned out the throttle body Ohmed out the air idle controller. What I should check next. I was planning to check the fuel pressure in case it is a fuel system problem. It is a 1999 ....
View 5 RepliesFord Fuel System :: 1987 F150 Fuel Pump Runs After Key Is Off?
Why the frame mounted fuel pump might run after the key is turned off? Then when you turn the key on it may or not run. If it does run it keeps running. shouldn't this shut off after pressurizing the line? is their a pressure switch in the pump that's failing? This has the 3 pump system...
View 4 RepliesFord F-150 (2004-2008) :: Runs Rough At 60 Mph?
Before and after this speed it runs fine, so what could it be. The check engine light is now on all the time.
View 2 RepliesFord - F150 :: 1992 - Running Rough At Around 30 To 40 / 60 And 70 MPH
My 92 f150 has been running rough at around 30 to 40 mph and around 60 and 70. It has a 5.9 v8. I have recently replaced the plugs, plug wires, dis cap, and fuel filter without it solving this problem at all. Someone said this could be my transmission or throttle body.
View 8 RepliesFord - Explorer :: 2005 Wouldn't Start / Just Clicked And Lights Flashed
I have a 2005 Ford Explorer and a few days ago it wouldn't start, it just clicked and the lights flashed. I put it on a charger overnight and it started right up. I took it to Autozone and he tested the starter, alternator and battery and said everything was green. It was fine until yesterday when I started it up and it ran a self test and gave me:
Ignition Key B
Serial # 00075194
Part # 4L2T-10849-CK
Diagnostic Trouble Code : 9318,9352 and D900
I looked through my manuals and can't find anything with codes. My friend says batteries don't last long in Florida, I have only been here a year from Michigan. I bought the truck in 2008 and have never replaced the battery. The guy at Autozone was reluctant to sell me a battery because he didn't think I needed one. I have never had any problems with this vehicle.
Ford :: Engine Will Rev Up But Runs Very Rough And Lacks Power When Driven
I have a 1994 Ford F-150 pickup with a 4.9 litre fuel injected inline six. Truck ran fine and took me to my destination but after sitting for 4 hours the truck would not start. Engine would turn over normally and could hear fuel pump running (didn't seem to stop) but truck would not start.
I changed fuel filter but truck would still not start. I removed air filter assembly and poured starting fluid in the air intake and engine started but idled roughly. Engine will rev up but runs very rough and lacks power when driven. Also the check engine light stays on.
Ford - Focus :: 2003 Runs Rough At Random Times
My son drives a 2003 Ford Focus with 183,000 miles on it. At random times when he starts the car, the engine runs very rough at idle speed but when he drives away, it runs fine until he slows for a stop sign/turn, etc. and the engine is at idle speed again. When this happens, the engine runs so roughly, that he loses vacuum to the brakes and his brakes stiffen dangerously. The car may not do this at all for a couple of weeks of driving, and when it doesn't do it, it runs beautifully.
Also, it only runs like this if it does it from start-up; it never idles roughly in the middle of a drive in which the car started normally. I have changed the spark plugs and wires, PCV valve, fuel filter, and air filter, but it still goes through this about once a week. I bought the car used just a few months ago and it had just had the valve cover gasket changed because the valve cover was leaking.
Ford Ranger / B-Series :: 2008 - Runs Rough With No Power
I just changed the plugs and wires on my 2008 Ranger 3L. Now it runs rough with no power. It was fine before I did the work but I thought I should change the plugs at 215000KM. I used Ford wires but unfortunately I used Bosh platinum plugs and now think I will change to Ford plugs. Do you think the Bosch plugs would be that bad for the Ranger? What is the belt tensioner torx size? I had to move the A/C compressor over to get the #4 plug but had a very hard time trying to loosen the belt.
View 7 RepliesFord - Lincoln :: 2004 - Rough Idol But Runs Smooth When Gas Is Given?
My 2004 Lincoln navigator is very rough at idle but runs smooth when I give it gas. Someone said my VCT may be stuck or bad. I looked at Youtube videos of VCT replacement but in all the videos the VCT's are up front in the valve covers. On the Navigator they aren't there. Where the heck they might be located?
View 2 Replies