Lexus GX 2004-09 :: No Acceleration After Traction Control Engages
I've noticed when driving our 06 GX this winter, that after the traction control engages on ice for example, it leaves the car with about 20% of it's normal power when you hit the gas, like it acts as a fuel shut off or something. It's been potentially dangerous if you aren't ready for it.
We have a had a lot of ice in upper Illinois this winter and I've been blind sided by what happens a few times. The worst is trying to make a left hand turn from an icy street. A lot of our side streets don't get the attention from salt trucks like the main roads do. For example, when making a turn off of an Icy side street, onto a street that has no ice. Wheels slip a bit initially, you hear the Trac kick in, then gimpy mode. After making it off the ice, the car has almost no power to accelerate, even after it's on dry pavement for as long as 10 second or so. Really dangerous when turning into a busy highway. The car just won't go. Then all of a sudden, boom and it's off again like normal. I would think that things should go back to normal on dry pavement pretty quick but the delay is pretty long.
Is this normal? Is there any way to disable the traction control in this situation? It's like the truck shuts the fuel off ( I know some Trac systems work this way). I'm definitely not one that hammers on the gas either, as soon as the tires sense a little slip it seems to go into this gimpy mode. Otherwise, everything else functions as normal.
Prius (2004-09) :: Rough Acceleration / Traction Control Light Came On Then Off
Just bought a 2004 with 240000 on it. Yesterday it started accelerating roughly. Today did the same and the traction control light came on and off several times. And just half hour ago I drove it about 10 minutes in town and the check engine light came on and stayed on.
View 19 RepliesFord Ranger / B-Series :: 2007 XLT - Cruise Control Light Blinks After Push On And Resume Buttons
My cruise control has been out for awhile and I have run the diagnostic test several times, earlier this year and now again recently. The cruise control light blinks after I push the ON and RESUME buttons, but no blink for the COAST button. I suspect there is a problem in the wiring, but I wanted to get your thoughts before I replace the switches. 2007 Ranger XLT ....
View 1 RepliesAzera HG (2011-16) :: Resume Cruise Control When Stopped By Braking?
Is there a way to resume cruise control once it is stopped by braking or hitting the cruise button? My other vehicle saves it so that it can be resumed but I don't see this option in the Azera and have to set it up again every time.
View 2 RepliesSubaru - Outback :: 2010 - Brake Warning / Traction Control / Cruise Control / Check Engine Light Came On?
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
Golf/GTI VII :: Traction Control Light Blinks And Hear Loud Bang From Front Under Hard Acceleration
Have an SE DSG w/ PP and 3300 miles.. When under hard acceleration and the traction control light blinks on I sometimes hear a loud BANG from the front - the car pulls great and goes like hell - just wondering is this the VAQ at work - sounds like the car slamming into gear.. Other than that noise the car is a total blast to drive even though it is now too cold to really play with it..
View 4 RepliesFord - Mountaineer :: 2006 - ABS AND Traction Control Lights Work In Low Traction Conditions
I need to troubleshoot a problem with the ABS & Traction control lights on a 2006 Mountaineer Premium with 126,000 miles. During the year that I have owned the vehicle this problem has occurred every time it is driven on a long trip. The previous owner never drove on longer trips so has no experience with this problem.
When you drive the vehicle around town and on shorter trips (less than an hour) there are no indications of problems. The ABS and Traction control lights come on as part of the start-up check cycle and go off. The ABS and Traction control work in low traction conditions and the lights function correctly when either one is activated.
The unusual behavior occurs on trips longer than an hour. Typically after about 1 1/2 hours at highway speed both the ABS and Traction control lights come on as well as the Wrench symbol in the message panel. It you hit "Reset" the Wrench symbol goes away but the ABS and Traction control lights stay on. The brakes work normally. I do not know if the ABS and Traction Control will work. I have never been in a low traction condition when the lights are on.
Both lights stay on until you stop the vehicle and turn off the ignition. When you restart the vehicle the ABS light is on but not the Traction Control light. When you start to drive the vehicle the ABS light goes out immediately.
After about 1/2 hour of driving both lights come on and the Wrench symbol displays in the message panel. Whenever you stop the vehicle and restart during the trip the cycle repeats. The day after you finish the long trip everything is normal for driving around town and on short trips.
Elantra MD (2010-15) :: Traction Control Light Blinking Upon Light Acceleration
Hyundai Elantra 2011... My issue occurred just yesterday on a highway at speeds above 65 mph. I initially noticed my traction control light blinking upon light acceleration but with no noticeable loss in traction.
I continued with caution. About 5 minutes later, the light now was blinking regardless of the amount of acceleration. I found I could push the accelerator to the floor with no added power and my speedometer was dropping below 55 mph.
Being a busy highway, I had to very quickly get to the side of the road as my car dropped to dangerous speeds in the middle of the highway. Had I no shoulder or outlet, I could've been in serious trouble.
The situation resolved itself with a simple shut down, restart of the vehicle. But it makes me very concerned why the error in the computer occurred in the first.
Ford - Explorer :: 2007 - Traction Control Light Flashing And Engine Will Lose All Power
2007 Explorer Limited . The traction control light will start flashing and the engine will lose all power, it slows to 30-40 mph, then goes again and the light goes out. This is intermittent and seems to happen the most when the engine is cold. This morning it wouldn't go over 20 mph and finally warmed up and went well enough to get it home. There is no check engine light or codes saved. This is my wife's driver, and it completely stopped one day and threw a check engine light. She turned it off and restarted and the light went away and the car would go again. I've read Ford had bad throttle bodies, (TPS)...
View 3 RepliesGTI 337/20th Anniversary :: Check Engine And Traction Control Came On
So a week ago i needed to change my mass air sensor due to every time it was raining it would almost stale and my check engine light was on. Now this week both my traction and engine lights are on always. When i start my car u. The morning it turns over but almost dies due to The rpms so low basically it's almost stalling if i give it gas usually it kicks it over then stays on no problem. ALSO if i reev high i hear a little grind or moan noise as well.
View 12 RepliesFord 6.7L Power Stroke Diesel :: Service Traction Control / Downhill Decent Control Fault Messages Showing Up
I have 2 messages showing up in the message center / control panel. I have taken the truck to the dealership and we cannot recreate them while the truck is at the dealership. How it can be resolved.
2013 Ford Superduty Platinum : 33,800 miles and the truck is stock
Messages : service traction control / Downhill decent control fault
This will happen just driving down the road or just after starting the truck and taking off.
It has happened towing my work trailer and also not having the trailer connected to the truck.
Camry :: 2012 - Check Engine And Traction Control Light On?
I have a 2010 camry and I am coming up on 15000 miles so i know im going to be due for another maintenance. accordingly, the "maintenance required" flasher started going off, so i thought it was all good and i should just take it to the dealership soon. well this morning when i started it up, it started flashing the "maintenance req" but once i backed out and put it in drive, the check engine light popped up as well as the traction control light (car with squiggly tire marks behind it).
View 4 RepliesPontiac - Vibe :: 2009 - Check Engine / AWD / Traction Control And VSC Off Blinking
I have 4 lights that came on simultaneously on my 2009 Pontiac Vibe. My check engine, AWD, Traction Control and my VSC Off is blinking. I had the codes read at Advance Auto and 2 codes came up and they are C1201 Engine control module performance and P0456 Evaporative emission system leak detected (very small leak).
View 6 RepliesMazda - Mazda3 :: 2009 - Check Engine And Traction Control Lights On
I've got a 2009 Mazda3 hatchback, 31,000 miles. As I'm sure you know, it's very cold in the Northeast today. It was -12F on my drive in to work! I went out to lunch with a coworker today, and it had warmed up quite a bit to about 25F. As I was driving back to work - 40mph on a dry, straight stretch of road - my check engine light and traction control/stability control light came on. They aren't flashing, just steady. The traction control light will flash if I hit a particularly bad patch of slush, but it's never lit up on a dry road before.
Right after the light came on, the automatic transmission started feeling...funny. It was shifting hard, although downshifting felt okay. My coworker even noticed before I said anything. I don't think it was the traction control - it was specifically as the automatic transmission was shifting, not at any other time. I've read through the TSBs and didn't see anything relevant, and I've already made an appointment for tomorrow at the dealer. I've only got 5,000 miles left in my warranty so I'm a little nervous - the car has been terrific so far.
I would think the traction control light would be unrelated to the transmission, so I'm a little confused. Also, just to rule out a few other things - the last time I got gas was about a week ago and I still have a third of a tank. I don't think this is a gas cap problem or frozen gas, both of which I've experienced before (in other cars).
GTI 337/20th Anniversary :: Check Engine And Traction Control Lights On - O2 Codes
I have multiple O2 codes on my '02 gti. It is giving me a check engine lights as well as the traction control light on. I received 6 codes all but one of them had to do with the O2 sensor and a short except for one that came in as the MAF. Both O2 sensors have been replaced and the codes still won't clear. I bought it in this condition, it runs really well so i wasn't to concerned about it, but the lights are starting to get annoying.
View 2 RepliesGrand Prix :: Reduced Engine Power Warning - Traction Control Lights Comes On
This has happened to me twice now, 2 weeks between occurrences:
Driving to work, about 10 minutes into the trip - traction control light comes on, "Reduced engine power" message appears on DIC, and check engine light comes on.
The car is an '08 Prix, no charger, with 51K on it. This is actually the first trouble I've had with the car since it left the dealer lot.
I pull over, turn car off. Turn back on - traction light goes out, and engine is running at full power. The check engine light remains on for about 5 starts/stops then goes away.
I haven't had the engine scanned yet. The only thread here I could find recommended replacing the throttle body. The person decided to clean the throttle body, and that was the last post.
I was thinking of removing the individual electronic components from the TB and cleaning them and the area around them in the TB. (I have the sensor-safe cleaner for TB's).
I don't think this error condition would be a warranty issue, but I'm not sure. It's a MAJOR hassle for me to get the car to the dealer.
Camry :: 2010 - Check Engine And Traction Control Lights Came On / Code P0037
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 RepliesIS F (2008-2014) :: Weird Cabin Smell / Check Engine And Traction Control Lights On
I have a11 isf with 38k on it. The other day the check engine and traction control light came on along with a weird Oder in the cabin. secondly I was short the quarts of oil.... I see no leaks.
View 2 RepliesGTI 337/20th Anniversary :: 2005 - Check Engine / Traction Control Lights Came On - Throw 13 Codes?
Alright i have a 05 1.8t GLI I just installed a 42 draft designs full 3inch turboback, and a eurojet turbo inlet hose, after I put the stuff on my check engine light came on which I thought was gonna happen and is normal but my traction control light came on as well, the cars running better then ever and pulling harder then ever, but when i hooked it up to the computer I'm throwing 18 codes? Ive triple check to make sure everythings tight and in the right spot? What could be wrong?
View 5 Replies