IS F (2008-2014) :: Check VSC / ABS Off / Traction Control Off / AFS Lights Came On?
So yesterday at night i take the isf for a boot, everything is going great and then i rip it off the lights, as soon as i do the traction starts acting weird and so do the rpms for a few seconds, rights after that the light show started. Check vsc, abs off, traction control off, afs off. all came on at once. i didn't turn anything off.
View 6 RepliesIS F (2008-2014) :: Traction Control Lights Stay On During Driving
My traction control lights is on and stays on during driving. Any reason for this?
View 9 RepliesMazda - Mazda3 :: 2009 - Check Engine And Traction Control Lights On
I've got a 2009 Mazda3 hatchback, 31,000 miles. As I'm sure you know, it's very cold in the Northeast today. It was -12F on my drive in to work! I went out to lunch with a coworker today, and it had warmed up quite a bit to about 25F. As I was driving back to work - 40mph on a dry, straight stretch of road - my check engine light and traction control/stability control light came on. They aren't flashing, just steady. The traction control light will flash if I hit a particularly bad patch of slush, but it's never lit up on a dry road before.
Right after the light came on, the automatic transmission started feeling...funny. It was shifting hard, although downshifting felt okay. My coworker even noticed before I said anything. I don't think it was the traction control - it was specifically as the automatic transmission was shifting, not at any other time. I've read through the TSBs and didn't see anything relevant, and I've already made an appointment for tomorrow at the dealer. I've only got 5,000 miles left in my warranty so I'm a little nervous - the car has been terrific so far.
I would think the traction control light would be unrelated to the transmission, so I'm a little confused. Also, just to rule out a few other things - the last time I got gas was about a week ago and I still have a third of a tank. I don't think this is a gas cap problem or frozen gas, both of which I've experienced before (in other cars).
GTI 337/20th Anniversary :: Check Engine And Traction Control Lights On - O2 Codes
I have multiple O2 codes on my '02 gti. It is giving me a check engine lights as well as the traction control light on. I received 6 codes all but one of them had to do with the O2 sensor and a short except for one that came in as the MAF. Both O2 sensors have been replaced and the codes still won't clear. I bought it in this condition, it runs really well so i wasn't to concerned about it, but the lights are starting to get annoying.
View 2 RepliesCamry :: 2010 - Check Engine And Traction Control Lights Came On / Code P0037
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 RepliesGTI 337/20th Anniversary :: 2005 - Check Engine / Traction Control Lights Came On - Throw 13 Codes?
Alright i have a 05 1.8t GLI I just installed a 42 draft designs full 3inch turboback, and a eurojet turbo inlet hose, after I put the stuff on my check engine light came on which I thought was gonna happen and is normal but my traction control light came on as well, the cars running better then ever and pulling harder then ever, but when i hooked it up to the computer I'm throwing 18 codes? Ive triple check to make sure everythings tight and in the right spot? What could be wrong?
View 5 RepliesPontiac - Vibe :: 2009 - Check Engine / Vehicle Stability / Traction Control System Lights Came On
I have a 2009 Pontiac Vibe with 43,000 miles. Recently the check engine light, the vehicle stability control light and the traction control system light all came on simultaneously. Since then they have all come on or all gone off several times. Usually once they come on, they stay on for the remainder of the trip. Sometimes they will still be on when I next start the car, sometimes they will be off. What might be causing this?
View 17 RepliesSuzuki - XL7 :: 2008 - Dinging Alarm Sound Inside Cabin / Traction And Stability Control Warning
I own a 2008 Suzuki XL7, purchased new from the dealership in 2008. Recently, the vehicle sounds a dinging alarm inside the cab of the vehicle & the dash lights up w/ "Service Traction Control" & "Service Stability Control" warnings. These warnings appear sporadically - not at startup - but sporadically while I am driving, and in no specific time pattern. We have had the brakes checked, diagnostics run at a mechanic shop, purchased new tires, and changed the fuses. We have googled Suzuki websites & found that other people are having this problem, but no one seems to have a solution.
View 1 RepliesSubaru - Outback :: 2010 - Brake Warning / Traction Control / Cruise Control / Check Engine Light Came On?
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
IS F (2008-2014) :: Traction Control Light Stay Lit / Will Not Turn Off
Why my traction control light stays on? just installed sikky headers. The light will not turn off no matter how long i hold the traction button. Could it be a sensor? No VSC or CEL only traction control light...
View 8 RepliesFord F-150 (2009-2014) :: ABS Light Staying On - Check Brake System And Traction Control Symbol Alternating Back And Forth
2009 F-150 FX4 5.8 .... Had a couple days of 20's temps, started truck last night and I have the brakes symbol and ABS light staying on, with the message "Check brake system" and the traction control symbol alternating back and forth. On a 16 mile trip, they all went out just once, for about ten seconds when I restarted at the gas station. Then came back on. Brake job done within the last two years by previous owner at the dealership.
View 2 RepliesGTI 337/20th Anniversary :: Check Engine And Traction Control Came On
So a week ago i needed to change my mass air sensor due to every time it was raining it would almost stale and my check engine light was on. Now this week both my traction and engine lights are on always. When i start my car u. The morning it turns over but almost dies due to The rpms so low basically it's almost stalling if i give it gas usually it kicks it over then stays on no problem. ALSO if i reev high i hear a little grind or moan noise as well.
View 12 RepliesCamry :: 2012 - Check Engine And Traction Control Light On?
I have a 2010 camry and I am coming up on 15000 miles so i know im going to be due for another maintenance. accordingly, the "maintenance required" flasher started going off, so i thought it was all good and i should just take it to the dealership soon. well this morning when i started it up, it started flashing the "maintenance req" but once i backed out and put it in drive, the check engine light popped up as well as the traction control light (car with squiggly tire marks behind it).
View 4 RepliesFord Ranger / B-Series :: 1998 - Weird Idle At Stops - No Check Engine Lights
I’ve got a 1998 Ranger with 166,000 miles and it’s starting this weird idle at stops where the engine drops about 150 RPM’s and then fluctuates. The problem is intermittent and no pattern as to cold or warm engine. I changed the plugs and wires at 100,000 and the plugs again at 150,000, so the wires have 66,000 and the plugs 16,000. I really don't want to shotgun the plugs, wires and coil pack. I understand that vacuum might have something to do with my problem?
View 14 RepliesPontiac - Vibe :: 2009 - Check Engine / AWD / Traction Control And VSC Off Blinking
I have 4 lights that came on simultaneously on my 2009 Pontiac Vibe. My check engine, AWD, Traction Control and my VSC Off is blinking. I had the codes read at Advance Auto and 2 codes came up and they are C1201 Engine control module performance and P0456 Evaporative emission system leak detected (very small leak).
View 6 RepliesLexus GS 2006-11 :: Check VSC On Dash Traction Control Light And Check Engine Light Is On
I was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 RepliesFord - Mountaineer :: 2006 - ABS AND Traction Control Lights Work In Low Traction Conditions
I need to troubleshoot a problem with the ABS & Traction control lights on a 2006 Mountaineer Premium with 126,000 miles. During the year that I have owned the vehicle this problem has occurred every time it is driven on a long trip. The previous owner never drove on longer trips so has no experience with this problem.
When you drive the vehicle around town and on shorter trips (less than an hour) there are no indications of problems. The ABS and Traction control lights come on as part of the start-up check cycle and go off. The ABS and Traction control work in low traction conditions and the lights function correctly when either one is activated.
The unusual behavior occurs on trips longer than an hour. Typically after about 1 1/2 hours at highway speed both the ABS and Traction control lights come on as well as the Wrench symbol in the message panel. It you hit "Reset" the Wrench symbol goes away but the ABS and Traction control lights stay on. The brakes work normally. I do not know if the ABS and Traction Control will work. I have never been in a low traction condition when the lights are on.
Both lights stay on until you stop the vehicle and turn off the ignition. When you restart the vehicle the ABS light is on but not the Traction Control light. When you start to drive the vehicle the ABS light goes out immediately.
After about 1/2 hour of driving both lights come on and the Wrench symbol displays in the message panel. Whenever you stop the vehicle and restart during the trip the cycle repeats. The day after you finish the long trip everything is normal for driving around town and on short trips.
Scion - Xb :: VSC - Traction And Check Engine Lights Turned On
One day my VSC, Traction and check engine lights came on. Nothing seems wrong with the car. Took it to a mechanic, they said many things popped up on their computer (emissions, etc, including replacing computer). The car has 48k on it, the warranty ran out at 39k.
View 15 RepliesLexus RC F 2015+ :: Check Engine And Traction Off Lights Are On
I've struggled all day in my tiny inspection pit fitting the catback, un-resonated A'pexi system which looks and sounds fab. Problem is the engine light and trc off light are now on?
I don't know why given the cats are still there? Have I upset the lambda sensors somehow? How to clear it? Can the fault codes be cleared a certain way?