Ford Escape / Hybrid :: 2003 4WD - Front Driver Side Axle Leak
I have a 2003 Escape Limited 4WD with approx 163K on the clock. It developed a tranny leak from the front driver's side axle. The seal is new and in good shape as I just replaced the axle and seal a few weeks ago. (I checked the shaft size and surface finish of the axle and it is in spec.)
I just removed the axle tonight and discovered that the problem seems to be the bushing just inboard of the seal in the tranny. The axle has movement up and down when inserted. (Not good!) This is allowing the fluid to leak from the seal.
Here are my questions. Is this a simple DIY fix using a slide hammer type of puller (or similar), or is it time to take it to a tranny shop. I can not seem to find a replacement part listed anywhere.
Also, with this much mileage, should I have the tranny reworked as a precaution if this repair requires dis-assembly or should I just address the leak and think about dumping it? I would prefer to keep it as my kids are now driving age and this is primarily their vehicle. (It has been a great little truck!)
Sonata NF (2006-10) :: Transmission Fluid Leak From Passenger Side Axle Seal
I have a 2006 sonata 3.3 with auto trans I'm having trouble with fluid leaking from the passenger side axle seal. I have already replaced the seal with a Hyundai seal and it is still leaking. Not as bad as before but it leaks onto the exhaust and smells really bad. The transmission is not overfull...
View 2 RepliesFord Transmission :: 1979 F250 - Rear Axle Seal Leak
This is a photo of my '79 F250 4x4 rear axle (Dana 60 full floater) this seal will leak in a few miles ..what I need is the part number of a replacement seal made like the one in the lower photo ..it seems that Ford no longer has this seal.
Notice the increased distance from the bearing to the sealing lip in this photo ..the sealing lip on the new seal in the upper photo lies almost on the bearing, this one just barely engages the seal surface on the axle stub. I can machine the bearing pocket deeper to cause the seal to move farther onto the sealing surface, but that would also cause the bearings to be closer together, and may cause problems there.
Elantra XD (2001-06) :: Driver Side CV Axle Seal Started Leaking
So I have a 2004 Hyundai Elantra 5 speed. The driver side cv axle seal started leaking a few months ago and I finally got around to repairing it. Everything went relatively smooth until I got to replacing the seal...
The problem is, it will NOT fit over the cv axle. It just won't. When the seal is installed, not matter how much force I put on the axle it will not go in. Also, I even pulled the seal back out and tried to put it onto the axle out of the car and there is no way it is going on. This is the third seal (done the rounds to through the big name parts stores) and no go.
Now, some quick car back story, I generally do all of my own repairs, but over the winter in the midst of a family tragedy I had a friend (professional mechanic with a shop) do a bunch of work to the car. He replaced the boot and joint that goes into the transmission (he did not replace the entire cv axle assembly for some reason). What I am beginning to think is that he replaced it with the wrong part.
Now, what I am wondering, is this even possible? Is it possible that it could fit and work perfectly yet be wrong? This also appears to be what broke the original seal. The inner portion of the seal was totally blown out in a circle, but perfectly, like it was crushed or cut out, and I am wondering if this happened due to having extreme force applied to it (possibly when he reinstalled it?)
That, or is it just extremely difficult / next to impossible to get these seals on? Even with both parts out of the car, stretching and pushing down on the seal (oiled it up as well to see if that would work) with all my might yields no results.
The leak was not there for the first month or so that I got the car back and then showed up. I have put about 5k miles on the car since I got it back. With Monday quickly approaching, I am wondering if I should just blow the crap out of my budget and pick up a new cv axle? I could at least have them pull one and let me see if the seal fits, I suppose.
Chevrolet - Montecarlo :: 2000 - Driver Side Axle Seal Leaks Fluid Only After A Drive
I have a 2000 Chevy Monte Carlo that has me stumped as to why it leaks. The driver side axle seal leaks fluid only after a drive. I have replaced the axle twice and seal 6 times and it still leaks. I am stumped on this one. Unless I got a bad axle twice that the diameter of the sealing surface is too small but didn't seem like it as the seal hugs the shaft.
View 4 RepliesGolf IV R32 :: Vacuum Leak On The Driver Side Seal
I have a vacuum leak on the driver side seal on the changeover rod in the intake manifold. It was replaced recently at the dealer and now has another hole in it. I was told this is caused by oil in the lines and my pcv valve is bad.
View 1 RepliesFord - Escape :: Fluid Leak Under The Oil Pan On Driver Side
Tonight when I was on my way in from taking the trash out, I happened to notice a puddle under my 04 Ford Escape. The car has been sitting in its parking spot for about a week (cold and mostly sunny weather, but some light rain, frost, and ice recently) so I figured it was just a bit of moisture from melting frost...worry wort that I am, though, I decided to investigate. It looked like it was in the area of my oil pan so I thought the size of the puddle warranted an investigation. I moved the car back a bit and tried to soak up whatever it was with a paper towel (soaked moisture up, but colorless).
I checked the oil levels (puddle was the size of a it small frisbee, so I have to imagine that if it were oil, I would notice a change in the levels) and saw no change since I last checked about a month ago. While I was trying to look like I know what I am doing, I noticed a new oil drop on the pavement - under the oil pan on the drivers side. I have replaced the pan gasket within the last 2 years and know that the car has a timing cover leak, but that has been fairly limited to the passenger's side.
The oil pan looked dirty, and showed SOME evidence of an small oil leak, but the other spot I noticed worried me a bit more: behind the oil pan (looks like it is almost center of the front axel) there is a fluid leak of some kind. Whatever the fluid is, it looks to be clear and has a slight hint of an odor (not sweet, not oily...sort of like stale water). When I turned the car on to back it up, I had the defrosters running. All in all, I would say they were on a total of 45 seconds, but the "water" is still dripping several hours later.
Ford F-150 - 1997-2003 :: Rear Axle Leak - Seal And Bearing Replacement?
Looking for a video, pictures, or steps that are in depth on how to replace my rear seals and bearings? They are leaking very badly and would like to see some other ways to get it done.
View 3 RepliesFord Super Duty (1999-2016) :: Right Front Axle Seal Continues To Leak?
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 10 RepliesFord Transmission :: Driver Side Axle Shaft Replacement / Bearing Retainer Is Starting To Slide Off
I have a 73 F100 with a 9" rear end. I need to replace the drivers side axle shaft as the bearing retainer is starting to slide off and I'm not willing to take a chance a new bearing and retainer will do it again. They are 31 spline axles and have the ball bearings not the tapered rollers.
What year trucks can I find a replacement axle shaft? Any other thing I should be aware of in finding a replacement?
Ford Transmission :: 1995 F150 - Rear Axle Seal Replacement
How do you replace the rear axle seal in a 1995 F150?
View 14 RepliesMazda - 323 :: Driver Side Front Axle Stuck In Transmission
My mechanic told me that something was wrong with the driver's side front axle of my 1990 Mazda 323, which has been a dream car for 21 years. He got a new axle to put in but could not get the old one out. Now it is at another mechanic's, and he also can't remove the old axle. He says there is a pin on the end and it is stuck inside the transmission (a 5-speed manual transmission). He has broken the axle trying to remove it, and now it cannot be driven.
View 19 RepliesFord Super Duty (1999-2016) :: 2015 F350 - Rear Axle Pinion Seal Leak
I was looking underneath the truck yesterday and saw that the rear end pinion seal was leaking. Looked like it had been for a while. Truck has 35,850 miles on it. Unscrewed the fill plug and a lot of pressure is released. So I'm assuming the breather is clogged somewhere along the line. I have an appointment at the dealer on Friday to see whats wrong. What is supposed to be at the end of the breather tube? Mine has a barbed 45ish degree fitting on the end of it. Its a SRW by the way.
View 5 RepliesFord Excursion :: Driver Rear Axle Seal Leaking Coating The EBrakes In Gear Oil
While diagnosing an issue with my ebrakes I found the drivers rear axle seal was leaking coating the ebrakes in gear oil, replaced the seal. Decided to pull the differential fill plug and check to make sure it was full - drained a good bit out pulling the hub to replace the seal. To my horror this is what I find when I pull the plug. First photo is as it came out on the magnet - second is after a clean up. What is it? I am almost afraid to drop the cover....
View 14 RepliesElantra XD (2001-06) :: Transmission Fluid Leak - Dripping Down Onto Passenger Side Half Axle
I have recently replaced the clutch, clutch master cylinder, clutch slave cylinder, Strut tower mounts and brakes on my 2002 Hyundai Elantra 5 speed. Everything is working properly but now I have a transmission fluid leak. I can not locate the exact location. It appears that it is dripping down onto the passenger side half axle where it connects at the transmission.
View 2 RepliesFord Excursion :: 2005 - Rear Axle Seal Leaking On Passenger Side
2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
Ford Excursion :: Passenger Side U-Joint Is Shot And Axle Wiggles Around In The Dust Seal
Picture if you will...Removed tire, caliper and rotor. Removed hub, and knuckle containing the stub shaft/spindle with it's yoke for the U joint. You are now looking at the end of the axle tube, with the axle shaft in it, one end connected to the differential carrier, the other end has the yoke for the U joint on it. Just inboard of the yoke, is a seal. Apparently it's called a "dust seal" is there a bearing behind this, or is the first bearing all the way in at the differential? When I was doing my brakes, I noticed the passenger side u-joint is shot, and the axle wiggles around in the dust seal. Figured I'd replace the seal while I was doing the U joint. Also, how do I get the axle shaft out? Just pull, or do I have to remove a C clip from the inboard end? What is the right National part number for the seal? I have a 6/2000 Excursion.
View 2 RepliesLexus ES 2013+ :: Axle Seal Leaking Transmission Fluid?
I get my oil change at the Toyota dealership instead of Lexus and save quite a bit of money for my 2013 ES350. At the 30k service, Toyota technician said he noticed transmission fluid leaking at the axle seal." I was gonna show Lexus this at some point, or maybe get an oil change there at the 40k service.
View 3 RepliesCamry :: 2003 - Transmission Fluid Leaking After Replacing CV Axle And Seal?
I have replaced my cv axle and seal, and now I have transmission fluid leaking from the axle seal. What could be the cause of this? The seal is brand new as is the cv axle. Could it be that it the seal isn't seated correctly? What could possibly went wrong to cause this?
View 3 Replies