Infiniti - G35 :: Fixing SES P0430 Code?
I recently purchased a used, high mileage 2004 Infiniti G35x (AWD) 145K miles from a reputable new car dealer here in my town. The car was impeccably maintained and clean inside and out. Just a week or two after the purchase my SES light came on revealing engine Code: P0430 (catalyst efficiency below threshold bank 2) pointing to a new catalytic converter in my future. Infiniti recommends premium unleaded for this vehicle. I found out my son filled her up with mid-grade unleaded. Is there any chance this could have triggered the SES light to come on? (Previous owner states he always used premium unleaded in the vehicle since ownership.) I also double checked the gas cap to make sure it was on tight. I find it extremely odd that the SES light would come on so shortly after the purchase. I mean what are the odds? Don't dealers run a diagnostic scan of their trade-ins to check history and for potential problems prior to selling their used cars? I test drove this car numerous times without any indication of a problem and right on the heels of the purchase it passed state emissions... now just a few days later, the SES light comes on. Why wouldn't emissions pick that up? I have reset the SES light (code) and filled her up with premium unleaded. Now it's a waiting game to see if the light comes on again. If the light reappears, I plan on taking it back to the dealer to work out some kind of "reasonable solution" to repair costs. I'll find out just how willing he is to stand behind his cars. I realize that this is a high mileage car, and I hardly expect perfection, but I didn't see this coming. What to do... what to do... By the way, I checked all the fluid levels ... no discoloration in the oil (fresh, golden brown)... no discoloration in the coolant... transmission fluid, good... all other levels are good. Car runs fine, no rough idle in cold...
View 11 RepliesSubaru :: 2006 - Fixing CEL Code P0304?
2006 Subaru Forester X 2.5L AT non-turbo
I changed the oil and oil filter; replaced the air filter (Fram), and replaced the alternator and a/c belts. I also got a full tank of gas at Sam's Club, I was nearly empty. I've gotten gas plenty of times there, before.
Next day, the CEL comes on. It's a P0304 code. (Cruise control light is flashing, too.) Engine stumbles and runs rough when cold; idles fine when warm, runs OK, but not the same, when warm. CEL is steady, which is "not bad" but I can make it flash if I hit the accelerator while the engine is cold. Resetting the computer by disconnecting the hot battery terminal didn't work; CEL came on again two days later and symptoms remained.
I buy some MAF cleaner (CRC) and use it; MAF was pretty dirty on the upstream side, actually.
I'm going to change the plugs and wires (they need it, anyway) and I've ordered a new ignition coil, which I'll also switch out.
I've also ordered the gasket for the throttle body, which I'll take apart and clean once that comes in. Last step is to order replacement O2 sensors.
I'm 99% certain there's nothing wrong with the engine, in terms of rings, valves, pistons, etc. I think I'm covering all the bases in addressing this myself. I'm on a limited budget so I'm doing all the labor myself and ordering non-OEM parts on-line, after researching to make sure the parts have a good reputations, fit, etc. (Yes, that's all a big FU to Subaru service for being over-priced but besides being relatively poor I also enjoy doing this stuff.)
Toyota - Camry :: Fixing Code PO401
is my Toyota camry going to stall cause it has po401 code and I think it has an muffler or exaust leak can the cause po401 code.
View 3 RepliesTouareg :: 2007 - Fixing Code PO306?
My Touareg (2007) was running great until this morning when the MIL (malfunction indicator lamp) came on. Checked with a mechanic who got a reading of PO306 which he explained was the #6 cylinder problem. All VW dealers are closed for service by now but I must drive back to work in St Louis tomorrow? Is it OK for me to drive with that MIL on?
View 7 RepliesCamry :: 2002 - CEL Came On - Fixing Code P1135
My 2002 camry 4cyl auto, jap built, with near 190k miles, check engine light just came on, P1135, has not replace any sensor since I own at 125k, 7 years ago, did noticed last 3 to 6 months, mileage drop to 25 or 26mpg average, used to be around 30+mpg, I thought it was change season for gasoline mix.
View 3 RepliesCaravan/Voyager :: Fixing ABS Error Code 50FE
I'm using an innova 3100/abs tester and that's the code it throws back. The company is zero support, claiming it is an internal Dodge code that they have no info for.
The code is : 50FE
Is that any use to me, or did I buy this tester for nothing..?
GTI 337/20th Anniversary :: Fixing Engine Code P0704?
Check engine light just came on. I scanned the car and the code PO704 came up.
"Clutch switch input circuit malfunction."
If I replace my clutch switch, will this solve the problem? I got the part number #1jo 927 189f i just want to make sure its that switch that's bad.
Golf/GTI VI :: 2011 - Fixing Code 009220 / P2404?
I'm owner of a VW GTI 2011 Stage 2 APR
Chip Stage 2, APR Intake
Today I got a Check Engine light, I plugged my scanner and read: P2404/009220 EVAP Leak Detection Pump Sense Circuit: Implausible Signal. But I realize that I have 2 tube near the motor that doesn't have anything on it.
Prius (2001-03) :: 2002 - Fixing Code P3030?
I picked up a 2002 Prius with 164k, still on original battery. It giving code P3030 which evidently relates to a high voltage line snapped on the bus bar.
View 4 RepliesPassat - Volkswagen :: 2003 - Fixing Code P3081 / AC Not Working
I own a 2003 Volkswagen Passat Wagon 2.8L SFI DOHC 6cyl. I have a code P3081 I have replaced the temp sensor and the reserve coolant tank I am going for the thermostat next. I cannot get rid of this code. Also since the code started when my wife drives short distances and turns off the car it won't start again for about 15 min unless it is jumped started. To top it all off she came home yesterday and said she turned on the a/c and it worked for about 10 min and then made a lot of noise and quit working.
View 2 RepliesCorolla :: 1999 - Fixing Misfiring Code P0303 On Cylinder 3?
The issue with 99 Corolla CE with 147,000 miles....
I have a misfiring P0303 Code - Cylinder #3 Misfire. Here is what has been done in an effort to remedy the misfire. A major tune up, new spark plugs, new fuel injectors, new spark plug wiring, new coil packs, The car runs ok once warmed up but in the morning the engine vibrates until warm and also shivers a little while the car is stopped at a stop light. I have dropped it off at the mechanics a couple of times now to no avail. Once the code is reset it will not display the CEL for a couple of days but the symptoms still remains. The CEL comes back on within 2-3 days with the same code. Really frustrating! Well, at least this time CEL in not flashing like before it comes on and stays on.
Golf IV / Jetta IV :: Fixing Code P1136 - Vacuum Leak?
As title states, I scanned my gti and got P0420 (nothing new here) and P1136. I did some searching and looks like vacuum leak can cause this, however I also read that it'll affect my idle. I replaced MAF 2 years ago with a brand new OEM one, my idle is NOT rough, at all.
View 1 RepliesFord - Bronco :: 1988 - Keeps Turning Over When Tried Shutting Car Off
I have a 1988 FORD BRONCO, full size, that has a peculiar problem. I tried starting the car and it turned over, but when I tried shutting it off it kept turning over. I had to disconnect the battery to stop it. I replaced the solenoid being careful to route the wiring connections the same way. I tried starting it and it shut off using the key switch the first time, but when I tried starting it again it wouldn't shut off so I had to disconnect the battery. What might be the problem? The ignition switch??
View 3 RepliesFord - Bronco :: 1994 - Has No Spark - ECC / PCM Mode?
So three weeks ago, yes 3 weeks, my loathed Bronco decided not to start. It has been sitting at my office parking lot since then. Every day at lunch and after work I spend some quality time with it, attempting to coax it back to life. Here is what I've done so far...Installed a new ignition coil (gets 12+ volts with key in 'run,' and ±10.5 v. when cranking), a new distributor, (with PIP) cap & rotor, new remote mounted ignition control module. All voltages and resistances throughout the ignition system are good according to the Hayes repair manual but there is no spark being sent to the distributor. I've also done an ECC self test and got no response at all. Does this mean the ECC/PCM is bad? My butt is in so much pain with me having to ride a bicycle everywhere. (Riding in the rain while carrying an umbrella is no fun!).If I don't figure this out soon I suppose I'll give the Vehicle Donation Program a call.
View 9 RepliesFord - Bronco - Transmissions :: Shifting Drive Selector Is Off By One
The drive selector on my 2000 Ford Explorer Automatic 4.0L will not allow selection of low gear. The selections are shifted to the right so the last one, low gear will not select. When in park, P, it shows R. When in drive, D, it shows as 2 and when in 2 it shows as 1. Then it will not allow to shift in to 1.The settings are off by 1 knotch. what's up with that? It runs fine but cant get to low.
View 5 RepliesFord Bronco :: 1988 - Motor Keeps Turning Over Even When Turn The Key Off
I have a 1988 full size Ford Bronco that when I start it the motor keeps turning over even when I turn the key off. I installed a new solenoid thinking that would do the trick and it worked correctly the first time, but the second time it kept turning over until I unhooked the battery. What is the problem? Is it the ignition key?
View 12 RepliesFord - Bronco :: 1996 - High Idle While Coasting
I bought a 96 Bronco 5 speed manual last year in pretty good shape.Everything works well, but the idle speed at coasting is hovering around 1500rpm until the vehicle slow down to 30mph at which point the rpm drop to about 700 (where it should be).It only happens while coasting.When truck is parked, the idle is fine and steady; I revved it up to 3000rpm for a while to see if I could replicate the behavior, but no, as soon as I release the accelerator, the rpm's drop nicely to 700.While driving though, if I switch to neutral, the rpm will go up for a second, and than sloooowly drop to around 1500 and stay there until I slow down to 30mph. Spark plugs, distributor cap and rotor, wires, TPS, ICM, and MAF are new. Could it be ECM?
View 6 RepliesFord Ranger / B-Series :: Bronco II A/C Cuts Off While Driving
The panel goes off and the fan quits blowing. Sometimes it works, cools great, then just cuts off...
1989 Bronco II 2.9 4x4 auto 164k miles... I have been on TRS, BroncoII Corral, and even FSB searching.
This is the first attempt at reaching out because i have found that here at FTE the folks that chime in know their stuff, or know where i can find out for myself.
Ford Aerostar :: Axle Swap - 66-77 Bronco 9 Will Work?
I was thinking the other day, wonder if a 66-77 bronco 9" axle would work, width wise, on an Aero? Obviously, you'd have to grind off all the mounting brackets and add the Aero ones. Mostly just building the "ultimate Aero" in my mind,
View 5 Replies