Civic - Honda :: 1997 - Cylinder Head And Gasket Replacement
I have a 1997 Honda Civic that I was given by an elderly neighbor's daughter after the elderly lady went to the grocery and ended up 100 miles away when she could not figure out how to get home. The car was smogged at the beginning of the year but when I got it ran very rough and the temp went nearly to overheating on the drive home when I was stuck in stop and go traffic.I found the radiator fluid level low and an oily residue inside the radiator water bottle. I took it to a mechanic to check it out and was told it had a blown head gasket and maybe worse.
I am thinking of buying a rebuilt cylinder head and replacing it myself but I am not sure how to diagnose if any other damage could have been caused to the engine. It's hard to know but I am guessing that the engine was damaged during the 100 mile road trip due to low coolant level. It turns out short term memory loss was the diagnosis for my elderly neighbor. I filled the coolant level and ran the engine for a bit and the temp stayed normal but the rough running remains. The oil dip stick shows no signs of coolant in the oil and the coolant looks bright green when I looked in the radiator after topping it up with some water.
Any way to detect if I could be facing bigger issues like failed bearings? I am OK to do the head replacement but an engine replacement starts to get into the realm of what it would cost to get another car of the same age.
Civic - Honda :: 1999 - Leaking Oil / Head Cover Gasket Replacement
How much should it cost to have it replaced? car seems to be running just fine but leaking oil.
View 6 RepliesCivic - Honda :: 1999 - Start To Run Hot At Low Speeds - Possible Head Gasket?
I was recently given a 1999 Honda Civic Lx for free from a family member and its been my day to day vehicle for months. I wont lie, aside from keeping oil, gas, and all of the standard stuff like it I haven't put very much work into it since I got it. Recently I noticed the car would start to run hot at low speeds and while sitting at traffic lights, stop signs, etc. When this would happen I would just throw some water in the radiator cap and the problem would be solved. For a few days at least. Today I was driving and did not notice that the temperature was getting pretty high. Not into the red, but getting close.
When I saw this I immediately started looking for some where to pull over to put some water in. Before I could get stopped I heard a loud popping noise and the sound of water pouring out from somewhere underneath the car. The second this happened the temperature gauge went down for a few mins but then rapidly shot back up. I got stopped and started putting water in, though I assumed the damage had been done. Sure enough the water eventually started coming out of the bottom of the car. Seems like its coming out of the little crevices in the engine and not the hose or the radiator. Im assuming (or hoping, maybe) this is a blown head gasket and not something more serious. The car is now parked and not going anywhere until repairs are made.
Civic - Honda - Radiators :: 1997 - Possible Head Gasket Leak?
Recently had a new water pump and radiator put in my car. Not so sure if they are "new" but anyway.
The car does not seem to use coolant it has only slowly flowed back into the reserve tank over time spilling over a little.
Civic - Honda :: 2005 - Overheating At Random Times Because Of Head Gasket
My 2005 Civic is overheating at random times. My mechanic couldn't find the problem so I took it to the dealer and they replaced the thermostat and a fan switch. That didn't work so now they tell me I have a blown head gasket ($1,458)... but there's no water in the oil and no gray smoke. They say the coolant leaks into the block until there's not enough circulating and it overheats. Then, when it cools, the coolant goes back into the reservoir and that's why it never seems to be low on coolant. I've seen other Civic overheating letters (including a 2005 that sounded like my exact problem) but I never saw an update about what fixed the problem.
View 12 RepliesCivic - Honda :: Leaking Head Gasket Causing Engine To Overheat?
I have a 2003 Honda Civic with 140k miles. It has a leaking head gasket which is causing the engine to overheat when driving slower without airflow to cool the engine.
I would love to drive the car to 200k+ miles but if this is the first of many pricey fixes I want to cut my losses.
Lincoln - Towncar :: 1996 - Lifters Rattles / Head Gasket Blown Away
4.6 engine had blown head gasket. right side. Pulled heads had checked for cracks and resurfaced. Reinstalled heads, but I still have a problem with oil pressure on right side. Chain doesnt seem to tighten and lifters rattle.There is good base oil pressure.
View 16 RepliesPontiac - Montana :: 2002 - Head Gasket Replacement
I have a 2002 pontiac montana that needs the head gasket replace. Mileage is 152,000 miles with a v6 engine. I would like to get at least another 75,000 miles once the repair is done. Is it worth doing as alternative is to scrap the van and buy a new vehicle...
View 3 RepliesSubaru - Forester :: 2007 - Head Gasket Replacement
I have a 2007 Subaru Forester X Sport Model. I just passed 86,000 miles - much of that open road driving. My head gaskets need to be replaced. This seems somewhat early. I recently switched from using regular motor oil to a synthetic blend that the dealership suggested. Is there any history suggesting that switching lubricants might cause the head gaskets to deteriorate?
View 10 RepliesAcura - Integra :: 1996 - Overheats And Coolant Slowly Disappears - Head Gasket?
I'm looking at a cousins 1996 integra that has some issues. It's a hand me down vehicle that has little maintenance. Probably regular oil changes and that's it. It has been overheated once in the past and uses coolant now. Coolant slowly disappears and she adds coolant to rad when it starts to get too hot. So likely, more overheat episodes. What are the chances just changing the head gasket will resolve the coolant loss?
View 7 RepliesGeo - Prizm :: 1995 - Starter Just Clicking After Head Gasket Replacement
I recently replaced the head gasket on a 95 Geo Prizm. Now when I tried to start it, all I get is the starter clicking. I tried tapping the starter solenoid, to no effect. The only electrical that I messed with during the head gasket replacement was to disconnect the battery.
View 4 RepliesFord - Explorer :: No Response From Starter After Head Gasket Replacement
Vehicle 2007 Ford Explorer Sport Trac with 4.6L
Ok, just did a head gasket replacement. Everything is now hooked back up. Now when we try to restart the car, we get lights, but nothing from the starter. Also the OBDII code puller can't communicate with the car. Also the security light flashes very fast when you try to start.
Ford 6.0L Power Stroke Diesel :: Head Gasket Replacement?
So, I blew my head gasket and have been looking for what to replace it with. From what I've seen, just an OEM gasket would be best.? I'm also putting ARP studs in it, unless there's another brand I should put in it.
View 3 RepliesFord - Mountaineer :: 2005 - Blown Head Gasket - Replacement?
I need walked through the take down to replace the head gasket on an 05 mountaineer with a 4.0. I've never worked on one of these so I don't even know. I havent even seen the engine to know where to start.
View 3 RepliesCamry :: 2007 Toyota 2.4 Simply Not Starting After Head Gasket Replacement
A 2007 Toyota Camry 2.4 was brought into the shop I work at smoking badly and running terrible. The car had been run hot because the radiator was busted and it blew the head gasket. So I pulled the head and sent if off to the machine shop to have it checked. They said it was badly warped across three cylinder and they resurfaced it.
Now I have everything re assembled, but it simply will not start. All the timing marks on the timing chain line up where they should be. All four coils are firing. Injectors wires pulse noid lights. A few times it has hit and sputtered like it was trying to start but never successfully does.
Golf IV / Jetta IV :: 2004 - Again Producing Smoke - 2nd Head Gasket Replacement?
I'll start by saying that I have a 2004 GTI 1.8t. Picked the car up from a local junkyard around 2 months ago for a grand. They were unsure why it was running rough, so I took a chance and picked it up. Got it back to the house and the timing chain tensioner was shot. Ordered a new one up. Went to a friends house and he noticed it was producing some white smoke from the tail pipe and suggest I take a look into my head gasket. Replaced the head gasket about 2 weeks ago. Got everything buttoned back up and it smoked even worse.
Being my first head gasket change I accepted the fact that I may not have been thorough enough in my replacement and stripped her back down once again. Made sure I was extremely focused and replaced the head gasket again. I just got her back together and she is still smoking.
I know for a fact that coolant is getting into my pistons and causing my spark plugs to foul out. Too much moisture in the cylinder.
Camry :: Overflow For The Radiator Started Gurgling / Head Gasket Replacement
On my car which never overheated but one day the overflow for the radiator started gurgling and I turned off the car fast and brought to our mechanic and he advised that it was head gasket after changing hoses and water pump. when I first realized the gurgling and shut off the car and never ran it again did i save the engine and replacing the head gasket is a good thing. also did I save the head from warping by my actions?
View 13 RepliesFord - Explorer :: 2007 - Head Gasket Replacement - Remove Motor?
2007 Sports Trac .. Does the motor need to be removed to replace head gaskets? 4.0 sohc
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - Head Gasket Replacement
I'm going to be doing head gaskets on my 2006 F350 6.0. I know I need the head bolt tool and head lifting fixture. I have the tool to release the injector wiring plug from the head. Are there any other specialty tools I need? I saw in Hot Rod magazine a few months ago there was a new head gasket for the 6.0. Unfortunately I don't have the magazine anymore. I can't remember the brand of gasket. I know everyone in the past has said use OEM Ford head gaskets. Lastly, can I do the head gasket job and put studs in without pulling the cab or HVAC box?
View 7 Replies