Doors - Chevrolet - Blazer :: Alternately Blowing Hot Then Cold With Creaking Noise During Transitions
Auto facts: 2000 Blazer, Mileage: 196,000 Engine: V6, 4.3L Transmission: Automatic Drivetrain: 4WD, Single climate control
Recently had my AC compressor assembly replaced, renewed accumulator/receiver drier, orifice tube, recharge, etc. The AC was cooling well below par after the repairs. Then is started alternately blowing hot (12 sec), cool (3 sec), etc. with a "spooky" creaking noise coming from within the middle dash during each transition (blend door?).
The mechanic charged the system again and agrees there is a refrigerant leak "somewhere" to account for the marginal cooling capability but the dye put into the system before the repair is not showing up anywhere that he can see (so far, having it checked again today). So, are these 2 separate issues? What are the steps of diagnosis and repair possibilities?
Chevrolet - Blazer :: 1998 / V6 - Long Turnover Start / Really Rough Idle And Loss Of Power
What would cause my truck to have a long turnover start, a really rough idle, and a loss of power after idling at a stop light for about a minute?
This problem gets worse as the truck warms up. It feels as if I'm not getting power from all 6 cylinders but this goes away after about 20 feet of acceleration. The truck has never not started. It just has to turn over for about 5 to 10 seconds before it fires up. I changed the spark plugs and wires thinking it was that and then i tried the fuel filter and it wasn't that either.
Chevrolet - Blazer :: 1999 Turns Over But Does Not Start
Vehicle turns over, but does not start. I do not hear the fuel pump when the vehicle is switched on. Fuel pump was replaced back in December 2010.
View 1 RepliesChevrolet - Blazer :: 2000 - Knocking Noise For 15 To 20 Seconds After Start Up
2000 Blazer 4wd, automatic, 122000 miles
In the last couple of weeks, if the Blazer isn't driven for 3 or more days, there is a slight knocking noise for 15 to 20 seconds after start up. Oil level and pressure are fine. I'm guessing it's the lifters.....
Chevrolet - Blazer :: Running Rough - What Is Normal Idle
I have a 1998 chevy blazer about 134000 miles v6 4.3 4wd.. This last two weeks my blazer been running rough. I like to know what is normal idle for that blazer. When at idle its 500- 550 rpm when in drive its 500rpm.
View 16 RepliesS-10 :: 1994 Chev Blazer - Hot Exhaust / Rough Idle And Black Smoke Out Of Tail Pipe
I have a 1994 chev Blazer S 10. that has thesy troubles. when it warms up it runs high and hot exhaust and ruff idle. with a hot cat. Replaced EGR carbon build up at times.replaced fuel pump, and all the senors under the hood. Still runs the same.
View 3 RepliesBelts - Chevrolet - Noises - Blazer :: Loud Slapping Sound When Cold
'91 Blazer, S10, 2wd, 300,000 mi ....when weather cold, and car cold, I hear a loud slapping sound that I thought was a fan belt, but checked and they are ok...when car warms up, or when weather warm, I don't hear the slapping..... sounds like belt against plastic,,,,???
View 7 Replies1992 Blazer 4.3 S10 - Rough Idle Cold
I've got an "on- and off-going" problem with my '92 S10 Blazer.
Car specs:
Year 1992
Blazer S10 4.3 Tbi
4- doors 4WD
Mileage 200k miles
Symptoms:
As cold, every now and then it will start right up, but the idle is wery rough, and seems like its running on less than 6 cylinders. When giving gas, it revs up, but runs roughly and still seems to be running on less than 6. Won't stall though.
When engine warms up after a couple of minutes, the idle gets smooth and no issues what ever when driving.
So just to be clear, this issue is so far only happening when staring cold.
Parts (new off course) changed recently (less than 500miles on them):
Distributor
Spark plugs + wires
Alternator
Battery
IAC valve
Fuel filter
This symptom came up now and then before changing any parts. I am quite handy with cars (pure amateur though), but can't really afford solving the proble by changing loads of parts with no effect..
Chevrolet :: 1996 Blazer Won't Start In The Rain
Why will the 96 Blazer not start in the rain? Replaced almost all electric components from key cylinder to plugs. It is grounded somewhere when wet.
View 3 RepliesChevrolet - Blazer :: 1997 - A Lot Of Cranking At First Start In The Day
my 97 chevy blazer has a lot of cranking first start in the day. I changed the rotor and distributor cap but I don't smell any fuel then all fo asudden it will start. I am wondering is it a fuel relay problem, a fuel filter, or some sort of sensor. when it does start it is very smooth running no shaking or hesitation full of power for the rest of the day starts and stops erands . is it worth buying a plug in code gadget and will this problem show up as a code.
View 4 RepliesChevrolet - Blazer - Transmissions :: 2000 - Won't Start In 1st Gear?
2000 Chevy Blazer 4.3 (automatic) - When I bought it used, it shifted fine, has no issues other than the transfer case wouldn't engage every time. A few months later my overhead console display lights went out, then all the dash lights such as engine, 4x4, the gauges started lighting up and acting weird randomly, then a week later the truck started shifting funny.
Now 90% of the time, the truck won't start in 1st gear, it starts in 2nd, then while accelerating up to 30-35mph it will shift up way too soon and bog down, then shit back down to 2nd, then shift up again, and continue until it hits 30-35, then it fails to shift into overdrive. Also when coming to a stop, it kicks down a gear (into 2nd I assume) pretty hard and clanks pretty loud around 2mph just before a complete stop.
Weird thing is every once in awhile, it will go away and shift normal but the engine light is usually lit up during normal shifting.Could it be the ECM causing all these weird things?
Chevrolet - Blazer :: 1998 V6 Won't Start Back Up If Turned Off
I have a 1998 chevy blazer v6 about 127000 miles on it. When I go and start up car the car starts right up. If I turn car off it won't start back up so i give it a little gas it starts right back up. There is no check engine light...
View 7 RepliesGmc - Envoy :: Louder Exhaust Noise Than Normal When Start The Truck In Cold Weather
I have a 2003 GMC Envoy with 76000 miles on it. I heard a louder exhaust noise than normal when I start the truck in cold weather. I had it checked and was told that the exhaust system was OK but that the noise was because the motor mounts needed replacing. I have never heard of this before. Before I spend this money I wanted to see what your reply was to this question. Is it common for motor mounts to have to be replaced on this type vehicle with this mileage and age?
View 2 RepliesChevrolet - Blazer :: 1998 - Starter Will Spin But Won't Start Engine
I have a 1998 chevy blazer and I cant get it to start. I removed the starter and turned the key and can see the starter popping out and spinning, but when I put it back into the flywheel all I get is clicking noise(like if the battery is dead) I had it on jumper cables so I don't think its the battery?
View 12 RepliesChevrolet - Blazer :: 1976 - Constant Grinding Noise
My 1976 Chevy Blazer K5, runs and drives excellent. But when I take it up into the mountains 4 wheeling, there is a problem. Any time that one or the other of the front tires goes up on a hill and there is any twist to the frame, I get this constant grinding noise. If I stop and put it in park, it still grinds and wont stop until the front tires on the same plane. What could this be?
View 1 RepliesChevrolet - Blazer :: Rubbing Noise Emanating From The Right From While Driving
My 4WD light does not come on but the warning light to service it does which leads me to believe the 2WD is not engaged. I have a 2001 Chevy Blazer. Also the seems to be a "rubbing" noise emanating from the right from while driving.
View 1 RepliesChevrolet - Blazer :: Knocking Noise - Oil Pressure Drop From 40 To 10
1997 chevy balzer 4.3 6cyc. Oil pressure drop from 40 to 10 and making a knocking sound no loss in power. About 3 weeks ago had oil change and new oil lines and gaskets put on because i had some leaks no noise or problems then just was losing oil then this happened first of all does this sound like a main bearing gave away second should i go back to where i had this work done and complain could they have done something to cause this they are very good and honest mechanics and a reliable auto repair mechanic company the blazer has 180,000 miles or do you think it just because of the mileage it was bound to happen i hate to blame something on someone if was just a coincidence but does this sound like the main bearing?
View 1 RepliesChevrolet - Blazer :: Noise Appears Around 30 Mph / Increased Slightly At Higher Speeds?
I "think" I may have a bad wheel bearing. Problem is, which one is it? The code reader I own does not read for ABS. The noise appears around 30 mph. It increased slightly, at higher speeds. I tried jacking each side of the truck up and checking for play and noise. There is no play. The only thing I can say is that the passenger side wheel seems heavy to spin. But spins.
The drivers side wheel spins slightly more free, but has a faint sound like the brake shoe is touching the rotor. I drove it and tried turning left and right. The noise does not seem to get worse or better when turning either direction. I called my local Auto Zone, and they only told me to do what I have already done. So I am at a loss. What else can I do? My Blazer is a 2000, 4X4, Automatic.
Chevrolet - Blazer :: Wheel Bearing Making Noise After Tire Replacement
Immediately after I had four new tires installed on a 2000 Blazer 4wd, the front wheel bearings started making noise. At the time I thought the noise was from the new tires. A few thousand miles later my mechanic told me I needed two reman hub assemblies (sealed bearings) for ~$350 apiece plus labor.
Is there anything that the tire shop (independent not chain) could have done (accidentally or otherwise) to damage the bearings during the tire installation? I have to get 4 tires for my 93 Chevrolet Caprice and don't wish to repeat the experience.
Whoops, forgot to mention this happened at 56k miles when the truck was five years old. Is it possible that the bearings were borderline and the process of mounting the wheels put them over the edge? For instance, someone being a little over enthusiastic with an impact wrench.