Buick - Lucerne :: Car Bounced More Than Once - Air Compressor Runs For 5 Seconds?

I just put new rear air shocks on my Buick Lucerne. I noticed the back in my car bounced more than once when I tested them. After starting the car I hear the air compressor run for about five seconds. This seems to have no effect on my new shocks. The old shocks had holes in the bladder. What tests can I perform to figure out what's wrong?

View 8 Replies

Buick - Lucerne :: Air Conditioner Draining Into Back Of Car

We have a 2008 Buick Lucerne. Now that the weather has become humid, we have been using the air conditioner more. We noticed that the carpet was wet on the rear passenger floor. Shortly after that, we noticed it on the driver rear floor. The dealer repair guys are puzzled and say it can't be the air conditioner as it would get the front passenger floor wet and not the back. They blamed on a luggage rack or sun roof (which we do not have!) or on the rain or car wash. We haven't been through the car wash and it hasn't rained here in over 3 weeks. What would cause this to occur and how do we fix it?

View 4 Replies

Buick - Lucerne :: 2006 - Can't Open Rear Door

I've seen posts about this problem online, but no one has listed a good fix. There seem to be LOTS of '06 Lucernes with back doors that won't open. It is not a child door lock issue as the customer has no kids needing such protection, and the door should open from the outside anyway.

I need to remove the inner door panel, but can't figure out how to do that with the door closed. Once the door panel is off, I can probably see what's going on inside, and maybe fix it.

View 18 Replies

Buick - Lucerne :: 2007 - Horn Relay Location?

Where is the horn relay for a 2007 Buick Lucerne?

View 3 Replies

Buick - Lucerne :: 2006 - How To Stop Any Corrosion From Occurring

I have a 2006 Buick Lucerne. The wheels were losing chrome and were oxidizing. I just bought some new "Koenig Unknown" wheels for it. I took it to the local shop to have the new wheels put on And one of the tires had some bad scuffing on the sidewall. The mechanic said it was too much damage on the tire and that he could not mount it on the new rim. So, I took it home and did it myself.

The duct tape that I used under on the flat bar was not sufficient and I ended up putting some rather deep nicks on the edge of the new rim. Though you cannot see it them unless you look very close, I know that these digs can be sources of corrosion. The lip of the rims are a polished mirror-like aluminum finish. I am sure they have some clearcoat on them and that is what I have damaged. How I can fix them to prevent any corrosion from happening.

View 8 Replies

Buick - Lucerne :: 2006 - Shakes When It Rattles And Rolls

2006 Buick Lucerne... I have been experiencing this for about 12 months… But now I have new tires that have been balanced twice by two separate shops. I'm still getting a wobble from the right front at about 65 miles an hour. The original tire on the right front has outside wear about half way around the tire. It seems very strange… Half of the outside of the tire is down to the cord the other half has some tread remaining… It's like something is shaking it up and down…

View 11 Replies

Buick - Lucerne :: 2007 - Won't Start - Alternator / Battery?

My wife's 2007 Buick Lucerne wouldn't start the other day after sitting maybe 20 minutes with the headlights on. She had to call AAA for a jump start. It starts fine now. I took it to an autoparts store, the battery shows 90% life left. Brought it home, charged in 10 minutes using my car charger. My question is, what could cause the car not to start so easily? I am skeptical the battery was the culprit. How can I check the alternator, etc? Any other thoughts?

View 9 Replies

Buick - Lucerne :: Hyper Turn Signal Starts Blinking On And Off Very Quickly

My wife's 2007 Buick Lucerne's directional signal is acting odd... When you turn it to the left-hand blinker, the pace is not the normal factory pace. After two or three cycle it then starts blinking on and off VERY quickly, like those blinkers you see on junkers periodically. The right blinker is normal pace as are the hazards lights. I am looking for potential causes before I bring it in for repair. I can't say anything trigger it, other than I noticed it after a car wash. Electrical problems are not my thing.

View 5 Replies

Buick - Lucerne :: 2006 - Squeaking Noise From Steering Wheel / Column

I bought a one-owner, 50,000 mile Buick Lucerne in February. Yesterday I heard a squeaking noise from the steering wheel/column and it is there today. Does this mean I need to lubricate or replace the lower seal on the steering shaft?

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2005 - Low Oil Pressure Showed Up?

its a 2005 f350 with the 6.0 diesel.I recently had my oil cooler replaced after my oil temps hit 254 while towing through the mountains.I had the oil changed at the first town i hit then had my oil cooler replaced the next day.I got my truck back and came all the way home n had no problems.I didnt drive it again untill today and now my dash says low oil pressure but the truck still runs.

View 14 Replies

Passat (B5) :: AC Compressor Will Not Engage

The AC in my 2004 V6 4-matic wagon has not worked since the dealer had it in their shop last. Coincidentally, neither does the outside temp display on the dash. I tried one of those recharge kits with the cans but the pressure guage registers 90 PSI when I hook it up, more than enough according to the instructions. So it seems the system is charged and it looks like the compressor will not engage. Could the temperature problem and the AC be related? Manual says it only kicks in when the outside temp is hot enough so I figure how will it know if its hot enough if the temp probe is not working? (unless there is another probe somewhere) ...

View 7 Replies

Saturn - Vue :: A/C Compressor - Clutch Will Not Engage

My daughter has a 2003 Saturn Vue 2.2 and it seems that the clutch if froze up... I have checked Freon level with a gauge that I use to top of Freon and seems ok... the vehicle has 170,000 thousand miles... are these compressors prone to failure and is there a "Quick Fix" without replacing compressor, orphis tube and dryer?

View 3 Replies

LS / MKZ :: 2003 - Getting Power At AC Compressor But It Will Not Engage

So my 2003 LS AC is not working. I had the Unit fully charged. and it started working. A few days later it stopped working. Checked Freon, and it is fully charged. I get power at the compressor but it will not engage. I ran the DATC Self test and got a 24 26 code back. What this code is? Why the ac clutch will not engage?

View 3 Replies

Volvo :: AC Compressor Clutch Will Not Engage - Fan Stuck

if the fan doesn't work, could this make the AC compressor clutch not engage? I think the fan is burned out because it doesn't spin at all, and only moves with a lot of effort. If the fan circuit is open, will this cause the Compressor to not work as well? the car is a 1991 740 GL. 2.3L engine, non turbo.

View 3 Replies

Ford A/C :: 2000 - Compressor Won't Always Engage Especially When Accelerating

I have a problem with my AC that is driving me mad. The compressor won't always engage, especially when accelerating. I browsed the forums and came upon this link; SpringerPop's Compressor Clutch Air Gap , very useful. With the AC on, when the compressor didn't engage, I just hit the clutch plate with a wood pole and the compressor immediately turned on.

So its definitely not pressure related and as far as I know, the relay and wiring are working or else it wouldn't even turn on. It works well for a few minutes (very well) and then it just stops working. Anyway, I read the instructions on that page. The thing is... when I put the keys in ON and turn the AC on... the clutch still doesn't engage, making it impossible for me to get the plate out to get the shim out.

Model: Ford Explorer 2000 SOHC....

View 8 Replies

Ford A/C :: Clutch Does Not Engage And Compressor Is Not Running

So clutch doesn't engage and compressor is not running. I have 12-13v at the low pressure switch and the same at the high. When I jump the low pressure I don't get any voltage at all at the plug that controls the relay for the clutch.

Where I'm confused is:

Is this a low pressure problem - gauge is reading 60psi on the accumulator
Or
Is this electrical somewhere?

View 7 Replies

Ford A/C :: 1994 - Compressor Clutch Will Not Engage

I just picked up a '94 7.3 IDI Turbo, and I can't figure out what ails the AC. It appears that there should be enough refrigerant (according to my recharge kit), but the compressor clutch will not engage. I have checked the fuses, and all are fine. All other HVAC functions are normal. Is there a way to test the compressor?

View 5 Replies

Lexus IS 2014+ :: AC Compressor Takes More Than 1 Minute To Engage

I noticed that if i don't use my car for more than 3 days, it take my A/C compressor more than a minute to engage. Once it engages, every is ok. A/C is cold and everything is back to normal. Is that a safety feature for our compressor?

View 14 Replies

Golf IV / Jetta IV :: Intermittent AC - Compressor Would Engage Then Disengage

I have an 02' 2.0 Jetta Wagon, and the A/C is having some issues. Since I know close to nothing about A/C systems, I took it in to a few places to have it looked at. I've had the whole system Evac'd and recharged, and have had the low pressure fitting replaced (apparently there was a slight leak there), and the system is still not working.

The A/C worked fine when I first purchased the car a few months ago. Shortly after my 800 mile trek from Oregon, back to home, the A/C started to only work intermittently. The compressor would engage, then disengage, repeat...It seemed like a bad idea to keep trying to use it in its sad state so I stopped using it altogether. As I said, I had the system emptied and recharged, but it still only works intermittently. It sort of follows a pattern where upon start up it works longer, and switches on and off at shorter intervals, until it doesn't engage at all.

There are no strange noises from the compressor, and when it was hooked up to the machine, it proved to be performing its function well.

View 5 Replies