Ford Excursion :: Heat Is Blowing Through Dash Vents With Controls Off
Heat is blowing through my dash vents in front of the windshield with the controls OFF!
View 14 RepliesFord F-150 (2009-2014) :: Dual Temp Controls / Passenger Side Does Not Cool Or Heat Properly
2010 fx4 duel temp controls...
My driver side works great (heat and AC). My passenger side does not cool or heat properly. Not sure about the back.
From what I have read this is most likely the upper door actuator...Which is what I was hoping because the lower one is such a nightmare. Am I on the right track here?
Ford - Windstar :: 2000 Stopped Putting Out Heat To Any Front Vents
Ford - no front heat - 2000 Windstar - actuator
My Dad's 2000 Ford Windstar van stopped putting out heat to any front vents. I was able to hear a rhythmic thumping sound when the heat control slider was placed in the hot position. I looked for info on line, and found many posts that said the actuator was probably the issue. I also went back and asked my Dad if before the thumping sound he had heard anything else, and he confirmed he had heard some gear grinding noises, which others have reported as the actuator is starting to grind and slip its internal gears. If the actuator is not working correctly, it won't hold the heater duct door in the open position, which means you can't get any hot air.
Ford F-150 - 1997-2003 :: Max Heat Blowing Through Vents When Temp Set On Cold
2001 F150 5.4 4wd - AC not working but when I turn the temperature dial to the blue side and turn on the fan, super hot air comes out of the vents or wherever I direct the fan to blow (Floor, defrost, etc) I know it shouldn't blow ice cold especially since my AC doesn't work but.....shouldn't I feel a temp change coming from the vents when I move temp dial from the red area to the blue? It's max heat wherever I have it set.
View 6 RepliesFord - Windstar :: OBD DLC Not Working Correctly
The vehicle in question is a 2001 Windstar. The OBD Data Link Connection is not working properly. When I plug in my scanner it DOES power up and will read the ABS info, but will not read anything else.
The scanner is new, and a pretty good one for a DIYer, and I've tried it in other vehicles. I've also tried another reader that also didn't work on this van. So I don't think it's the scanner.
My Haynes manual has no info on how to wire a DLC or how to repair/replace one. How can I fix this?
Ford F-150 - 1997-2003 :: Heat Started Blowing Cold / Temp Gauge Showing Lower Then Overheated
Was driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 RepliesCamry :: 2008 - Turn Temp Knob To Hot But No Heat Is Coming
I have an 08 camry v6, from time to time i've noticed when i turn the temp knob from cool to hot it would blow cool. Now it's happening all the time no heat at all just blows cool air when heat is on in all modes.
View 2 RepliesWindstar :: 2001 Ford - Select Tail Lights Will Not Function
2001 Ford Windstar, select tail lights will not function. All lights serviced by Fuse #7 have ceased to function (left rear turn lamp, right backup lamp, right stop lamp, right rear park lamp, right license lamp, left license lamp, and left backup lamp). Checked all bulbs and replaced any that were questionable but to no avail.
View 2 RepliesFord - Windstar :: 2003 - Grinding Front Brakes On Occasion When Coming To A Stop
My 2003 windstar SEL needed new brakes and to have the rotors turned... instead I opted to buy new discs and pads online ... To my surprise the new discs were about a 16th of an inch thinner than the old.... I changed discs and pads and was happy for a few days, but now on occasion when coming to a stop the front brakes grind terribly....the next time i stop everything is fine...visa versa...dscs feel true (no pulsing) I DID APPLY BRAKE QUIET TO THE BACKS OF PADS....
View 2 RepliesLexus LS 2007+ :: Only Driver Window Function From Main Door Controls
Hopefully this isn't a big issue, but I got in my car this morning and tried lowering the windows and only the driver window would function from the driver controls. The windows work fine with their own door control, but not from the driver's seat.
View 8 RepliesLexus LS 2007+ :: 2008 LS460 Radio Controls No Longer Function
Radio controls no longer function. Only the volume and the seek buttons work. Have to use controls on the steering wheel to make any changes.
View 2 RepliesFord Super Duty (1999-2016) :: Front AC Is Blowing Ambient Temp Air
Took the Ex in today because the front AC is blowing ambient temp air. I had them re-charge the system and they tell me no leaks were found but the air never blew cool. Took it in today and they just suggested the following.
AC Manifold P&A LAB 3.0 5C72 190850 DA
68oz R134 P&A LAB 1.0
AC Oil/Dye Kit P&A
Have you ever had to do this kind of work? Is this an easy task to do?
Toyota - Matrix :: 2005 - Temp Gauge Won't Reading Correctly?
I have a 2005 Toyota Matrix with 250k on it. It has run like a champ so far, with the only problem being an ECM recall last year. I have noticed a few problems recently; the heat blows cold air for quite awhile, and the temperature gauge, while not reading hot, sort of fluctuates between normal and a little warm. When the ECM was being replaced, the dealer said the serpentine belt was overdue for replacement, and I know he's probably right about that. He also said the water pump needed replacing, although I have never seen any signs of leaking. This car has been a champ, and I'd like to try and get another 100k out of it if possible. I'm pretty handy around a car, I've replaced an alternator and radiator before, and I'm working on a limited budget, so if any of this is doable by me, I'm up for it.
View 11 RepliesGolf IV / Jetta IV :: 2004 - Overheating / Fans Stopped Working Correctly And Fuses Kept Blowing
I have a 2004 volkswagen jetta, and it has started overheating. At first my problem was the thermostat. After that was changed out the fans stopped working correctly. It kept blowing fuses in s180 slot.
I read somewhere in another post that this is due to the fact the resistor in the low speed fan go bad, and for your car's radiator fan to go from zero to high speed, causes the fuse to blow. Also I read that when the fans start up it draws the most current, and then after it's running the current is considerably less.
This is my solution, I went to napa, and got a circuit breaker for a car, and Yes, to my surprise they make them. I picked up several a 10amp, 15 amp, 20 amp, and a 30 amp. First, I tried the 30 amp circuit breaker and it didn't trip the circuit, but when I put a regular fuse in the slot, it did trip the circuit, when I did the fan test at the thermostat switch. Next, I put the 25 amp in there and neither did it trip the circuit. When I put the 10 amp in the s180 slot, it tripped the circuit, just as the regular 30 amp fuses do. So that confirmed that the amps that were being drawn from the fans were not enough to trip a 30 amp circuit breaker.
What I did next, is I took a 20 amp circuit breaker and put that in the s180 slot. Then I hooked up vag com on my laptop to check and see how it performed with the 20 amp circuit, and these are the results.
Car Temperature in celsius
at 111 degrees the gauge was moving past the halfway point
at 115 degrees the gauge was one notch past halfway going towards the red zone
at 120 degrees the gauge was two notches past halfway going towards the red zone
at 122 degrees the fans kicked on high speed for about 30 seconds, and knocked the
temperature down to 105 degrees.
In conclusion, if the high speed on the fans work, you don't have to take those out and go and buy an expensive new fan set. Just stick a 20 amp circuit breaker in the slot, and keep using the fans that you have.
Part no: 782-3154................ Name: Circuit Breaker, 20 Amp; Blade
Note: I take NO responsibility for any damage you do to your vehicle from any information you obtained from this post. Do this at your own risk! I am not a mechanical expert but this is my solution to the overheating problems.
Ford - Windstar :: AC Blowing Hot When Idling
I have a 2002 Ford Windstar and the A/C has started blowing hot when i idle but it blows cold when I am driving. I had the compressor replaced back in February and the pressure is normal so it doesn't look like it has a system leak. If I am at a traffic light, I can put the van in neutral and press the gas and it will start blowing cold again. Since I just spent $1300 a few months ago when my compressor seized, I really hope it is not an expensive fix.
View 6 RepliesWindstar :: 2004 - Mileage Not Showing / Heat Blows On Driver Side
I have a 2004 Windstar that is nor behaving well. It seems to run ok for the time i have had it. Mileage not showing, error code for cam shaft sensor (It has been replaced), passenger window works intermittently, no display on stereo, Heat blows on drivers side while the AC blows on passenger side, Electric doors work sometimes.
Like i say, it drives ok but won't pass emissions and too many erratic problems to sell it. My independent mechanic thinks its the computer and said take it to ford. Cant afford for them to waste hours shooting down individual problems if they are all related.
Ford - Windstar :: 2000 - Temp Sensors Or Sending Unit?
My question is about a 2000 ford windstar with 3.8 engine. Does this vehicle have a coolant temp sensor and sending unit or just a sensor?
View 7 RepliesWindstar :: 2001 - Rear Auxiliary Unit Not Blowing Hot Or Cold Air
2001 Ford Windstar rear auxiliary unit will not blow hot or cold air. The front system works fine with very cold or very hot air as needed.The system has been in this state for the past four years.Last month I had a local shop evacuate the refrigerant and then I replaced the following A/C components (compressor, front orifice tube, rear expansion valve, receiver dryer, and condenser). The shop then recharged the system and the front blows ice cold air...amazing! Unfortunately the rear system just doesn't want to blow any air, hot or cold. To date I have completed the following checks:
Relays
- Front cabin relays #3 and #6 were swapped with no change to front system.
- Rear unit relays make a clicking sound when either front or rear control panels set blower motor speed.
-- I swapped out with front and rear cabin blower motor relays with no change to front blower motor.
Engine Compartment - Both 40A fuses were checked (117 & 120).They are supposed to be 40A fuses but my box had 50A in both places.It had been like this for years with both systems working fine up until the rear unit ceased working.(NOTE: maybe this is coincidence but when I changed these from 50A to 40A my son noticed that some of the rear tail lights stopped working. in fact all of them associated with fuse #7 located in the passenger cabin.)
Fuses - all related fuses were checked and are fine.As noted above the distribution box fuses were changed from 50A to 40A with no detrimental effect on the front system working.
Front Control Panel
- Heat and air work fine (blower and temp controls)
- Front control panel appears to change rear unit temperature setting but only one of blend door actuators adjust when changing temperature setting
-- The one closest to the blower motor does not function.The one that directs air to floor or ceiling functions properly.
-- Shouldn't they move together based on the temp setting?
- Front control panel blower motor settings only result in hearing a clicking noise for each setting.
- Setting front control panel to REAR CTRL allows rear control panel to function.
Rear Control Panel
- Temperature settings - same result as front control panel with blend door actuators.
- Blower motor settings - same result as front control panel.
Rear Auxiliary Unit
- Expansion valve makes a hissing sound on A/C or Defrost settings.
- Blower motor was removed and benched tested for operation.
-- Electrical connection looks fine and seats snug.
Camry :: 2002 LE - All HVAC Function Stopped Working From Standpoint Of Air Blowing
My buddy has a 2002 Camry LE(?), without Automatic Climate Control. He had experienced the flashing A/C light like many others, but his solution to the problem was to direct-wire the compressor to the battery. Seemed to work fine, and the compressor still works. Fast-forward to two weeks ago. All HVAC function stopped working from the standpoint of air blowing. No outside air. No A/C. No heat. AND no rear defroster. He replaced the Magnetic Clutch relay tonight thinking it might have something to do with the problem, but that did not solve it. We checked the blower motor, and it only has 0.01V going to it when the air is on. We're getting no sound of anything going on in the cabin.
View 14 Replies