Monte Carlo :: 2003 SS - Intake Manifold Gasket Replacement
I took my Monte in for the annual Missouri Safety Inspection. Note: I had no known problems with my 2003 Monte SS 117K Miles. After the inspection, which passed, I was informed of a variety of problems: Intake Manifold Gasket Replacement, Valve Cover Gasket w/Intake replacement, Thermostat w/Intake Removal, Fuel Injector O-Rings w/Intake Removal.
My question is should I have all of this done? It's not cheap..roughly 1000 bucks. I know very little about this and I don't want to just tell my mechanic to do it without some research. Are these common problems with Monte's of this age/mileage and just part of the cost of owning this car. I am the original owner and have avoiding costly repairs/maintenance..it's been a great car.
Ford F-150 - 1997-2003 :: 1998 - Intake Gasket Leaking - Replacement?
I have a 98 f150 4.6 4x4 with 175.000 miles, I suspected the intake gasket is leaking, I'v never done this before. What is involved with this type of repair? Will the intake gasket leak bad enough to leak antifreeze on the floor? Is it okay to continue to drive with this problem? Bad weather is on the way.
View 7 RepliesFord - Explorer :: 2003 - Vacuum Leak And CEL On - Air Intake Gasket Replacement
I have a 2003 Explorer with the 4.0 K motor. It has a vacuum leak and the check engine light will come on from time to time. My work buddy has a high end computer and it showed that the driver side bank was running lean. The computer showed the O2 sensors to be working fine, and I replaced the PCV valve. All other vacuum line appear to be in good condition and I tried the spray test with the break cleaner with the motor running. This is leading me to believe the air intake gaskets where due for replacement. Here is my problem, I can not get the last bolt out of the plenum. The one on the driver side up against the fire wall. I tried to remove the cowl in order to get a straight shot at it but I can not get the seem seal to break free.
View 4 RepliesFord F-150 - 1997-2003 :: Coolant In Cyl 5 After Removing Bad Intake - Head Gasket?
I have a 03 5.4 F150 SCrew... The intake was leaking on the passenger side (water outlet tube meets plastic).
Putting in the Dorman replacement and noticed that the front cylinder drivers side (#5) had a decent amount of coolant in it.. None of the others did. I've drained the coolant already and was wondering should I just put this back together and see?
The water outlet crossing has a hole right next to this cylinder and I can't see any cracks and not sure if the gaskets were leaking under it.
Seems like if the head gasket was blown I would see it in more cylinders? It never smoked or run bad before I got this leak... Drove it maybe 10 miles with it leaking out onto Cyl#1. Ran fine, never missed.
I just don't want to put this back together if the head gasket is blown but I don't know what to do.
Grand AM :: 2000 GA 3.4L SE (base) Sedan With Intake Manifold Coolant Leakage
I have a 2000 Pontiac Grand Am SE sedan (base model) with a 3.4L engine at 142Kmi that was just diagnosed with an intake manifold coolant leak by an independent shop.
I've done some googling and found that this is a known problem with this engine (including a class action suit). So far the leak is just external; no coolant in the oil and no oil in the coolant.
Bonneville :: Coolant From Lower Ports Throttle Body - Gasket?
Took off throttle body on 3800 series1 S/C and coolant is leaking from both bottom ports from mounting area on motor. Is this normal ? Intake area into S/C was dry but very much build up. The 2 ports just end at bottom back of throttle body and are sealed by the gasket. Coolant comes out steadily from those 2 holes. Is this an intake problem, gaskets ?
View 1 RepliesPrius (Gen 2) :: Engine Coolant Pump Replacement Due To Leakage?
I'm sitting at my Toyota dealer where I bought the car 3 weeks ago. My car is in because it needs to have the engine coolant pump replaced due to a leak. Is this a common fix for the gen 2 Prius? Fortunately this is getting covered under warranty.
View 4 RepliesFord F-150 - 1997-2003 :: 4.2L V6 - Intake Manifold Gasket Leak?
I've got a 1997 F150 with the 4.2L V6. Before I got it last summer I did some research, but apparently missed the issue with the intake manifold gasket leaks on these early engines. It seems to be a very slow leak, but obviously I want to get it fixed. I called Ford to see if it had had the recall work done on it, but all they could tell me is that there wasn't an open recall on my truck (with the exception of the recent fuel tank strap recall). Their system apparently only goes back 10 years, so they couldn't even see the freakin' recall. So, I've got a few questions:
1) I know I didn't post much info, but does this seem like an intake manifold leak?
2) Are there any special tools needed to change out the gasket myself?
3) Can you all recommend any replacement gaskets? I found a few different manufacturers of gaskets, but I'm sure some are better than others.
4) Can this issue cause the computer to throw the loose gas cap code (P0455 if I recall correctly).
5) Would it be worth it to just get a new truck? I really wanted a diesel in the first place, but I also hate to give up on a nice truck with only 115,000 miles.
Ford F-150 - 1997-2003 :: Blown Head Or Intake Gasket?
My 97 f150 5.4 started missing on 5,6 it had antifreeze on top of the spark plugs but i cant figure out where its coming from my truck has been loosing coolant and it seems like the system is holding pressure because every time i take the cap off the radiator overfill i can hear it hissing then i see the antifreeze level plummet there's no visible leaks that i have seen when the truck is running an missing it steams out the exhaust but when its no missing it doesn't seem to be there's no milky oil or anything the thermostat doesn't seem to be leaking either the truck has over heated a couple times due to the antifreeze disappearing or the temp wont move at all then it shoots all the way to hot and cools down within seconds to normal i just put a new thermostat in. Also it sometimes misses on 4 and my exhaust smells like straight gas i put 4 gallons in it got 29 miles out of it .
View 10 RepliesFord Super Duty (1999-2016) :: Coolant Leaking From EGR Unit - Gasket Replacement
Having some coolant leaking from the EGR unit in my 2011 super duty.. Dealer says it's a 14 dollar part, but labor is a few hours to replace.. Not sure I see how that can be, but I wanted to ask on Here to see how long this should take..
View 1 RepliesFord F-150 - 1997-2003 :: Blown Intake Manifold Gasket / Battery Light Comes On
just got finished putting her back together from a blown intake manifold gasket and run for a few miles to get rid of any cob webs and then my battery light comes on. just replaced the battery last week. and I tested the alternator and it charging at 14.5 volts bat reads when disconnected 12.9 volts so I am not sure why my battery light will come on.
View 14 RepliesFord F-150 - 1997-2003 :: Truck Running Rough / Intake Manifold Gasket Blown
I have been having some issues with my 97 ford f150 4.6 liter, started out running rough, then hydrolocked with no serious damage, blown intake manifold gasket, fixed that, alternator over charging do to bad voltage regulator, fixed that. and airbag code 52, still working on that, as well as failure to connect when trying to do diagnostic scan. now I am wondering if the engine diagnostic is still even working. still running good just a very slight vibration when warms up. I am not getting any code. or my check engine light is not showing any codes. What I want to do is force a code. What would be the safest way to force a code or force engine light to give a code?
View 6 RepliesFord F-150 - 1997-2003 :: F350 - Exhaust Manifold And Two Of Lower Intake Bolts Broken
I have a 97 f350 crew cab xl stock everything. 351 windsor in it I do believe. as of right now He is broken down pulled apart in my garage. Due to a much requested headgasket replacement. In any event long story short I got him all apart to discover that there was someone in it before me & had broken the infamous exhaust manifold bolts (5) and two of the lower intake bolts, (of course I've tried the correct route in removing these broken bolts/studs but again the year of the truck (1997) & its bone stock no way their moving...
So of course I tried the next best thing (on a budget) which is to drill them out, but I went to far into the exhaust manifold bolt holes, And now I believe that I've ruined the heads is this so? If so who knows where i can get a decent set of bolt on heads ready to go. yes this is my daily driver & since He's been down I've been going deeper in dept.
Windstar :: Oil Leakage Between Engine And Transmission
I noticed leakage of transmission oil leaking between the engine and the transmission of my windstar 2000 280 K miles. No driving issue, no flashing OD light. I am keeping the level.
View 5 RepliesExplorer :: 2003 With 4.0 Engine - Coolant Loss And Smell But No Leakage
I have an 03 Explorer with the 4.0 engine. There is a strong smell of coolant and the reservoir does go down slightly once a week or so. There is No Leak whatsoever that I see, I have checked under the hood, under the vehicle, under the dash, everywhere...nothing. Where is the coolant going? This seems to be a common problem, I work at a quick lube and almost all of these explorers are low on coolant when they come in.
View 2 RepliesFord - Windstar :: 2003 - Driver Side Window Not Working - Motor Replacement
Drivers window not working .. I pulled panel and checked voltage at motor when switch was activated 12.8 volts on this vehicle. Is just the motor changed or the whole window mechanism. If so, what are the steps ...
View 2 RepliesHyundai :: Air Intake Leakage Caused CEL To Come On
My check engine light came on and I had it checked at Advanced Auto and it said it had to do with my air intake so I checked if it was leaking and the hose closest to the engine has a big rip in it so I taped it for now.
2003 Hyundai Tiburon
Ford F-150 - 1997-2003 :: 2001 5.4L - Intake Manifold And Gaskets Replacement
I am about to replace the intake manifold and gaskets. I know all of that process, but first question is if there is anything i should do whilst in there. Second question; what can I do with my intake to get more power? Mainly just kind of wondering before I get my parts ordered.
View 4 RepliesFord F-150 - 1997-2003 :: Coolant Leak On The Upper Intake?
I have a 1998 Ford f150 4.6 2x4 i have a coolant leak on the upper intake. It comes out on the back left of the intake through a metal pipe. Well where the metal pipe is (pressed in) to the intake. Now i talk to the guy at ford dealership in the parts he said it is called the (heater pipe). He also told me that the part is 21 dollars but I have to press it in and if that does stop the leak he said I would have to buy a new intake. Now here is the problem I can not find any info regarding this heater pipe. I don't know how to remove it properly, why it is leaking. I can't find it in the handbooks that i have read so far.
View 14 Replies