Touareg :: Grinding / Scrubbing When Turning At Low Speeds
Brought my Treg in for service today for a host of things:
Grinding/Scrubbing when turning at low speeds. TPM Pull to the right/Alignment/Uneven tire wear.
Limited remote range
Drivers side whistling noise when fan speed at 3-4 bars and windows are closed
Service Advisor tells me the Transmission Control Module is the cause of the scrubbing/grinding at low speeds. I have seen the posts with respect to the Stepper motors.
Touareg :: 2006 V8 - Grinding Noise Specially While Foot On Gas At Cruising Speeds
I have an 06 Touareg V8 with AWD, auto tranny. No leveling suspension. And when I drive it specially while my foot is on the gas at cruising speeds there's a grinding noise coming from under the car. When I step off the gas it is gone or when I am accelerating hard I can't hear it. What could it be? It's driving me and my ocd insane!! I think it is drivetrain related (differential, wheel bearing, etc.) but not the transmission as I can still hear it while coasting in neutral.
View 3 RepliesTouareg :: V6 - Loud Vibration On Roof At Certain Speeds (40 - 45 / 80 Mph)
V6 Touareg, Sunroof, roof racks (locked together at rear.) At certain speeds (40-45mph) there is a loud vibration on the roof. If the sunroof is opened or raised, the vibration stops. Nothing visible on the roof or sunroof which would suggest the cause of the noise.
View 4 RepliesPassat (B6) :: Metal Grinding Noise At Low Speeds?
Ok so 11 days into ownership and only slightly over 800 miles the car started to act funny. First the common DVD nav issue (no disk in drive message).
Second issue is a strange metal on metal rubbing noise when turning at low speeds (i.e. in parking lots). When I make a big turn (either direction) it sounds like either the brake calipers aren't releasing fully and is causing the pad and disk to rub, or something else is rubbing.
This actually happened once yesterday on the highway as well. going 75mph, a very loud metal on metal rubbing noise.
Seems to only happen when temps outside are below 40. It warmed up yesterday afternoon and the noise went away, but after it got cold again last night, the noise came back.
Passat (B7) :: Grinding Noise When Turning Right At Low Speeds
I have a 2013 Passat TDi SE with about 64000 miles on it and 20 rims. I noticed a grinding noise when turning right at low speeds. It was a very slight noise at first, but has gotten louder over the past 1-2 months. The grinding noise sounds like it's coming from the back of the car and only at fairly tight turning radii, with speeds 10 - 20 mph (think going up the levels of a parking garage). What could this be????
Other things to note:
No other noises, vibrations accompany the sound.
I do get the steering rack creek when turning lock-to-lock, but this sound is definitely not that sound.
I mentioned I have 20 wheels thinking that might have something to do with it. They don't rub at all going in a straight line, however.
Sound is only present when turning right.
Camry :: 2003 - Awful Grinding Noise At Low Speeds
I'm going to start tearing into my wife's car this weekend because the bearings are making an awful grinding noise at low speeds, so I feel like this needs to be done soon.
I bought from rockauto new hubs and bearings, but looking at them, it seems like the bearing goes over the outside of a shaft on the hub. Other that than, I'm not really sure how it all goes together until I look.
Just curious as to whether this can be done without a press or any special tools? I have an impact gun and all the sockets one could need, but I don't have a hub puller or bearing press or anything like that.
I've done a bunch of searches but can't seem to really find the answers I'm looking for...
Tiguan :: Steering Making Grinding / Rubbing Noise At Low Speeds
The steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 RepliesSonata NF (2006-10) :: Grinding And Banging Noise When Driving At Low Speeds
A few days ago, my Sonata 2006 LX started making weird noises when driving at low speeds. The noise comes from the front driver's side area, they are not affected by steering or going over bumps. Usually get less intense when I accelerate or brake. At speeds around 5 mph, the noise is grinding and pretty loud. At higher speeds, it's more like banging and it's frequency increases with the speed. There was no effect other than the noise, but the last day at higher speeds, I can feel with the steering wheel a little vibration sometimes from the banging.
I've been having tough times renting a car during the weekend and I still drive on short distances, but I'm afraid it could be a safety issue or that I can be making things much worse to repair. The noises got worse since the beginning, but I don't think they are getting any worse anymore.
Hyundai - Elantra :: Grinding Noise When Accelerating And Sometimes At Lower Speeds
My 2007 Hyundai Elantra SE (Automatic, 69,400 miles) makes a grinding noise when I start to accelerate from 40 mph. I sometimes hear a noise that sounds like an airplane wheel being activated when I'm driving at lower speeds driving around town. Could this be the transmission? Who should I take the car to?
View 7 RepliesFord Excursion :: 2001 - Grinding At Slower Speeds And While Turning
I have a 2001 excursion limo with 108,000 its a v-10 2 wheel drive with stock wheels and tires. I believe both my front hub bearings are going out, I am hearing some grinding at slower speeds and while turning, but seems to be ok at highway speeds...Anyway I think I am going to replace both front hub bearing assemblies.
View 12 RepliesSubaru - Outback :: Grinding / Rattling Noise When Shifting And Cruising At Low Speeds
Three days ago my Outback started making this grinding/rattling (hard to describe) noise when shifting and cruising at low speeds. Is this the clutch or the transmission? No trouble shifting though. I got rear-ended by a big Lexus SUV last week, but wouldn't think that would have anything to do with it. Just damaged the bumper a little.
View 1 RepliesFord - Explorer :: 2002 - Rear-end Is Slightly Grinding At Low Speeds Mainly When Turn Right
It is a 2002 Explorer xlt 4x4 4.6l v8 with 139k miles. It runs like a top and is in great condition. However I have a few questions:
Most importantly is it feels and sounds like the rear-end is slightly grinding at low speeds mainly when I turn right. If I give it a bit of gas when turning it doesn't seem to do it. I have tried running a vin decoder to figure out if I have limited slip or not so I can drain the rear diff and inspect it, but I haven't found what it has as far as gears go.
Number two. The keyless entry and remote worked when I bought the car and then about two days later it just stopped working. I bought a new battery for the remote and put it in and it still doesn't work.
Also the interior lights will stay on after you start the car until I hit about 15mph, and also stay on for about 5min after I shut the car off. I am not sure what may cause this. I have owned tons of older ford's but am relatively new to anything newer than 2000.
And I know pics or it didn't happen, so there is one of the door sticker, one of the rear axle, and one of the car ...
Camry :: 2003 XLE L4 - Grinding Type Noise When Turn Steering At Low To Intermediate Speeds
I have a 2003 Camry XLE L4, and there is a grinding type noise when I turn the steering wheel at low to intermediate speeds, and when I go over a bump. I can also produce the noise when the car is parked and I bounce the driver's side up and down by placing my hands on the left fender. The struts, steering rack, and CV axels are all new. Also when the car is cold, turning the steering wheel produces a squeak (a different noise) from just behind the steering wheel.
View 11 RepliesYaris/Scion & Vitz :: 2004 Echo - Grinding Noise While Turning At Low Speeds
I have a 2004 Echo with the 5 speed manual. Everything is factory original on this car except the tires. (159,000 km). While turning hard to the right at low speeds or pulling away from a stop and turning right, I get a harsh grinding/scraping noise and it seems to be coming from the drivers front wheel. If it was a CV joint, or wheel bearing, wouldn't it make noise all the time?
View 3 RepliesExplorer :: 2002 - Grinding Noises When Making Turns From A Stop Or At Slow Speeds
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 RepliesElantra XD (2001-06) :: Loud Grinding Noise Coming From Front Of Car When Decelerating At Low Speeds
Having problem with my car (2001 Elantra GT) - over the last month or so it's been occasionally making a very loud (not but consistent) grinding noise coming from the front of the car when decelerating at low speeds. The noise sounds like gears slipping over each other but cuts in and out. It's pretty loud and not a nice noise to hear! Sometimes it makes the noise when I brake firmy but not until I reach lower speeds... mostly it's just when coming to a stop, but it did it once last week when I was pulling very slowly out of a parking spot and not even braking.
As it's become more frequent (going form maybe once a week to several times every car journey) I have started to feel something in the brake pedal also, like there's something kicking it from behind. I took it to a mechanic and had to pay a ton of money to get a broken front left ABS ring replaced (it also had the front right ring replaced in May), and within 2 minutes of driving away from the place the noise was back. Before I spend even more money that I don't have on taking it back for extra diagnosis.
I'm told that this is almost certainly the ABS system that has a fault even though the ABS light never shows except when I start the car, and I've taken the fuses out of the ABS in order to confirm that it is. I haven't heard the noise after a few days of driving with ABS unplugged so I think we can be reasonably sure here. Is there anything that I can check myself or test (I'm not very handy when it comes to cars) or can you tell from this information what it's likely to be? Other things that I've noticed with the car which may or may not be relevant are:
- the warning lights for brakes, ABS and TCS are all lit with the fuses for ABS1 and ABS2 taken out. I take it this is normal for all 3 to illuminate with the fuses out?
- since unplugging the ABS I've noticed a slight metallic squeal from the brakes as if the brakes are worn down. Didn't notice this before I unplugged ABS though it may have been there, not sure.
- sometimes when going over a speed bump or just a minor imperfection in the road I hear a clunk in the front of the car and feel something move in the underside of the car. Happens mostly at lower speeds also, but not if I go over the bump really slowly.
- in the fuse box when I took out the ABS fuses I noticed there was a bit of minor melting/brown burn marks on the top of the connections marked (iirc) ECO3 and ECO4 on the diagram (large white connectors). Is this anything to be concerned about?
- sometimes when I have air coming into the car through the air vents it will become significantly warmer for a few minutes, then slowly go back to normal. Can't think of any circumstance that links the times when this happens (eg. speed, weather etc).
- the oil pan has a leak which is on the list of things to fix when the car works properly.
Civic - Honda :: 2004 - Clicking / Grinding Sound At Higher Speeds When Let Off The Accelerator
As the title states, I've having a problem with my civic. It makes this clicking/grinding noise during 4 separate occasions:
1) turning to the right
2) going in reverse
3) applying the brakes <30 MPH
4) engine braking- I hear a grinding at higher speeds when I let off the accelerator.
2004 Honda Civic EX, 5 sp MT, 1.7 L, ~172k miles. I'm not a mechanic, but do almost all my maintenance at our hobby shop on base.
I first noticed this noise only when applying brakes approaching a stop sign. I checked my pads and rotors and they looked good. The noise is coming from the front drivers side of the car. Pulled the pads off and they appeared to be wearing differently (only slightly). Regardless, I replaced the pads and rotors. The problem persisted. I checked the wheels for play to see if it was a wheel bearing, but there is no play.
Then, I noticed the sound when going in reverse and turning to the right. All information I found pointed to a faulty CV axle. From the outside, the boots were normal. No tears, no grease. It didn't make any specific noise when turned, but oh well. I replaced both of them today. Replaced the transmission fluid with genuine Honda. Pulled out of the parking lot of the hobby shop and the noise persisted.
Ball joints appear to be fine, wheel bearings appear to be fine. The guys at the shop suggested maybe it was the caliper not engaging correctly; perhaps air in the lines. Tomorrow I'm going to bleed the brake lines and see if that works. Otherwise, when else would cause this noise? Video attached....
There are 3 parts to the video. 1 is the last few seconds of me slowing down from an on ramp. I click the turn signal apply the brakes and you hear the noise. The next section is again slowing down at a stop sign. The last section is backing up out of a parking spot.
Chevrolet - Tahoe :: 2004 - Grinding When Turning Right / Braking - Shaking At Highway Speeds?
I drive a 2004 chevy Tahoe and have had this problem for about 8 months. It started out very faint and occasional, but has now escalated to loud and consistent. So it ONLY happens when turning right. I've tried to replicate it when turning left and had no success. It happens when I am turning fairly hard at a decent speed. ex. Pulling into my driveway. I've already checked the wheel bearings and Ball joints.
Another thing is that the ABS light is on sometimes when i start the car and comes on every time i turn the steering wheel all the way to the right. It also has a problem where it will shake almost uncontrollably when driving at 65+MPH after hitting a bump or sometimes just randomly on a smooth surface. We just got new tires and balanced them. It did the same with the previous set we had. I know I'm asking for a lot, but where to start?
Celica :: Vibration When Accelerating At Different Speeds
Car shakes real bad when it turns over and then at different speeds. 25-30 it'll shake more, along with 45-50 and around 70 mph.
Mechanic friend says motor mounts which would make since cause the one thats visible has cracks in the rubber.
But the shop my father takes the car into says it needs a new drive shaft.