Touareg :: Squeak Coming From Under The Vehicle - Need A New Transfer Case
Took it in for the 10K service and squeak that started coming from under the treg. The said it needs a new transfer case.
View 12 RepliesMazda :: 2006 - Horrible Noises From Transfer Case
I own a 2006 mazdaspeed 6 with 90k+ miles, 2 weeks ago I had a 90k service done at the dealership. On the 14th of May, the 90k service was done (which includes the changing the transfer case fluid/oil). Car was not driven every day, but on the 23rd of May the car made horrible noises on the way home from work. I called a flat bed/tow truck, and have tried to lock in the problem. The sound seems to be coming from the transfer case.The question is could they have done something wrong or was it just the transfer case’s time to go up?
View 19 RepliesSilverado 4WD :: 2006 - Transfer Case Shifting Malfunction - Can't Speed Up In 2wd
80K miles on this truck. pushbutton 4wd controls. Operates normally in Auto 4wd, 4Hi, and 4Lo, and 4wd functions as it should. By that I mean that the front wheel driveline is engaged in 4Hi & 4Lo, and engages under hard acceleration or rear-wheel slip in 4wd Auto. Here's the problem: when I push the 2Hi button, it shifts into 2wd as it should whether moving or stationary. However, when I take the rig up to road speed in 2wd, it operates fine for a minute or two, but after I've slowed or stopped, it won't move, and acts as if the transfer case has shifted into neutral. At times, it will move forward, but not in reverse for a short time before going neutral. Push the 4wd Auto button, and it goes back to working as it should in that mode. Transfer case is full of clean oil, wiring harness at transfer case (including ground) has been disassembled and inspected carefully. No codes nor "Service 4wd" messages are displayed. There is no clunking or grinding, and the actuator motor sounds as if it is working when the buttons are pushed with ignition on and engine not running. I have been unable to locate any fuse or fuses which might be associated with the transfer case or 4wd system.I'm stumped.
View 13 RepliesFord F-150 - 1997-2003 :: Howl Going On - Noise From Transfer Case Area
I've got sort of a howl going on, was thinking rear end, but when i jacked up the wheels and spun the driveshaft the noise seemed to come from the transfer case area. I haven't had a chance to check the fluid yet, could it be a bearing in the t-case? Its only when i'm on the gas if i let off its gone. 2001 f150 super crew 4x4
View 4 RepliesFord F-150 (2004-2008) :: Transfer Case Noise When Tries To Engage Once In A While As Driving
I have a problem transfer case 2006 f-150 , it tries to engage once in a while as I am driving and makes a terrible noise . I pulled the vacuum lines off at the hubs on each front hub and it stopped trying to engage. What the problem could be ?
View 1 RepliesFord F-150 (2009-2014) :: Slipping / Snapping Noise Coming From Transfer Case Area When Accelerate Fast
I bought a 2010 f150 from the company I work for.... It had a blown front diff, when I bought it, I just put a complete front diff assembly and front drive shaft on it. Thought I was golden, but when I accelerate fast there is a slipping/ snapping noise which sounds like it's coming from transfer case area... Accelerate slow and steady up to highway speeds it doesn't happen. This problem only happens in four wheel drive.... what this could be!???
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Clicking Noise Coming Just Forward Of Chain Section Of Transfer Case
I bought a 2000 Ex PSD 4x4 in september. I have refreshed the suspension in the last 4 months; leafs, shocks, etc. I developed a vibration over 50mph after I installed the suspension and have been chasing it since.
I have replaced the U Joints, professionally balanced and lubed driveshaft twice, adjusted driveshaft angle to less than 1*, replaced the flanges for the TC output and the driveshaft companion flange. I have not touched the diff, but there is no decernable play in the pinion or leaks. Also, I removed the rear housing of the TC and replaced the output needle bearing and seal 2 weeks ago.
The output of the TC still has 1/4" play and a clicking noise coming just forward of the chain section of the TC. I assume the play is coming from other bearings on the main shaft in the TC.
I am about to purchase a remanufactured TC, but before I do, I need a reality check. Is it possible there is damage to the output bearing of the Transmission or something else?
I don't want to buy a TC to put in and experience a TC failure again in a short time. It doesn't make sense to me that there would still be so much play after changing the output shaft needle bearing of the TC if the TC main shaft is supported not just from the TC bearings but the output of the transmission unless there was possible play in the output of the transmission.
Touareg :: Whistling Noise From Side Mirrors At Over 40mph?
My car has a bad whistle sound from the sidemirrors if I travel at over 40mph, I heard someone else had the same problem and the dealer fixed it but putting something on the mirror.... is there a TSB on this? I'm going to the dealership next week and i would like to see if he can fix it. List of things I have.
- Sometimes when i enter my car and start, my seats don't move back to the previous setting....... I had to hit "1" to get it to move back. it fails 3 out of 10 tries.
- Wind noise from the side mirrors, especially when over 40mph..... whistling sound.
- dash vibration when the weather is cold.... Not sure about this one.
- See if the dealer will turn off my DRL for me.
Dodge - Ram :: 1998 - Transfer Case Will Not Shift
I purchased a 98 dodge ram 4x4 v8 with automatic transmission. When I purchased it the guy told me there was an issue with the transfer case. From what he told me he got stuck and the transfer case is the result. I was told there is a fork in the transfer case that is probably bent? Does this sound correct? It is currently in 2wd. Do I have to remove the transfer case to replace the fork? What is it like to remove the transfer case? Drop the tranny?
View 16 RepliesFord Excursion :: 4x4 - Transfer Case Does Not Engage
Looking at another Ex but the owner says the transfer case does not engage. Says it can be locked into 4X4 by crawling under it and engaging it manually by removing a motor [Servo motor ?] Does this mean I would need a new transfer case or just the servo motor ? I know mine did the same thing last winter. It would go into 4X4 and then pop out.
View 10 RepliesFord - Explorer :: Transfer Case Sensors Name?
I just replaced the transfer case BW 4405. And I noticed that the 2 sensors (front drive shaft and rear drive shaft) are bad. What is the name of these two sensors? I'm looking for a brand new ones...
View 13 RepliesSonata NF (2006-10) :: Noise While Accelerating Under 40mph
I have a 2009 sonata with 33k miles, the last few days i hear a rattle noise while accelerating, the noise disappears while driving at more than 40mph...
View 6 RepliesSuburban :: Transfer Case Fuse Keeps Blowing Constantly
My '99 Suburban 350 with the autotrac 4wd is having electrical problems. The transfer case fuse always blows. I thought it may be the transfer case shift motor, so I took it out and tried and the fuse still blew. I tested the pins on the fuse, and sure enough they are shorted together, but only when the car turns on.
View 14 RepliesFord Aerostar :: 1991 - How To Check ATF In Transfer Case
Where/how to check the ATF in the transfer case? I found the lower drain bolt,but I don't see anything up higher that looks like a fill hole.
'91 Aerostar 4.0L AWD
Ford Excursion :: 2003 - Transfer Case Not Engaging
2003 ex 6.0 limited....300000 miles ...Automatic.Merry Christmas to all.My Transfer case will not shift into 4wd . Dash light for 4wd high and low works .I get no power to transfer case 2pin connector when key turned on.Also fuses 19,27,31,33,34,45,111 are all good when checked with meter.I also swapped 2 relays in engine compartment and no change.4 WD Switch on dash has power on Green/red wire I think it is for dash light and not for operation.
View 13 RepliesFord Excursion :: New Transfer Case Now Tranny Runs Hot?
Swapped out my transfer case since mine was detonated and now my tranny is running hotter? Drove in town for about 10-15 minutes and noticed my temps climbing and once it got to 180 it felt like it was slipping when moving from a full stop. i went home and parked it. Checked my fluid level and it looked a little low so topped it off while running and went through gears to make sure it was good. Drove again and it still went up to 180 in 10-15 minutes in town driving. Before we swapped the transfer case it was driving fine and went on a road trip 6 hour drive and felt fine. I bought the excursion and it supposedly had a new tranny in it.
View 14 RepliesFord Aerostar :: 1992 - Model Of Transfer Case?
So long story short I have a 92 Aerostar AWD which I'm pretty sure had the transfer case recall done (97V204000 1992 FORD AEROSTAR Recalls) it has the aluminum driveshaft but a couple of years ago the transfer case cracked and I replaced it with a "New OEM" transfer case off eBay. Fast forward to the present and my van has a strong vibration at 60+ my transmission guy says it all looks good so the vibration has to be from one of the driveshafts. My thought is that I may have got a transfer case without the recall done on it and its warped my driveshaft. I don't really know thats possible or what I could do about it if that was the case.
View 8 RepliesFord - Explorer :: 2003 - Transfer Case Diagram
I bought a new to me 03 explorer 4.6 tow package XLT 136000mi. Rebuilt aamco trans with 10k on it. Been checking it over before i put it on the road.. No 4x4 but the button lites work and i got into low range once. (Had a hell of a time getting back to high but eventually it did). Question is if there is 12v at the brown wire on the TC the case should be fully locked? I figure when i check it if there is not 12v at the brown wire in 4x4 high i could apply 12v directly with a jumper wire to see if the case locks to 4x4. Am I correct?
View 2 RepliesFord Transmission :: Transfer Case Noises When Shifted Into 4WD
About 9 months ago heard a strange noise when shifted into 4 wd , sounded like driving over those grooves on the side of the highway to keep people awake.
Had to pull over to stop , as it would not go back into 2wd with the noise still going.
Then it stopped , after shutting truck off and restarting.
Then earlier this year after trying to do it again in 4wd had bad clunking noise and was hard to get back in 2wd , I can here the shift motor engaging and the dash reads in 4wd, seems its not engaging fully in 4wd and not going back to 2wd, its a very bad clunking noise, shakes the whole truck.