Tiguan :: 2009 - Cylinder Misfire After Coil Pack Swap?
I recently did a coil pack swap to determine if that was the cause for a cylinder 1 misfire. Left to right on my 2009 se tiguan, I changed 1 to 2, 2 to 1, 3 to 4 and 4 to 3. I recently ran into the cylinder misfire again, this time on cylinder 4. The problem is, I do not know which coil fires which cylinder. I've looked around quite a bit and can't seem to find it.
View 6 RepliesTiguan :: 2010 - Random / Multiple Cylinder Misfire Detected - MIL On
My buddy has a 2010 tiguan and hes having a misfire issue. It has a hesitation and the interior lights seem to dim with the hesitation. Heres the codes that pulled up with vagcom.
4 Faults Found:
000768 - Random/Multiple Cylinder Misfire Detected
P0300 - 000 - - MIL ON
Freeze Frame:
Fault Status: 11100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 148426 km
[Code] ....
What it might be?
Ford F-150 (2009-2014) :: 5.4L Engine - Cylinder 3 Misfire
I've been chasing this misfire for about two months now. I have changed all eight plugs, changed the coil and even change head gaskets. After all of that I'm still getting a misfire on cyl3 code. I've inspected the resistance from the fuel injectors, they are all about 12ohms. What else do I need to check before I sell this thing off?
Background: It has just under 130k miles and I have had zero problems until it got cold this season. Once the mornings hit about 20F degrees I had a check engine light come on. Maybe a little bit of a shake at first but after it warms up it drives excellent. It has never sounded like there is a misfire, it has always ran smooth.
Ford F-150 (2009-2014) :: 2010 - Seems Like Driving Over Rumble Strips - Cylinder Misfire?
My 2010 F150 randomly feels like I'm driving over the rumble strips as well as a small jerk like there is a cylinder misfire. If keep it at constant speed it still happens, but under cruise control it stops. Even when load increases like going up a hill.
View 14 RepliesFord F-150 (2004-2008) :: Cylinder 7 Misfire / Cylinder 6 Has Oil On Plug
06 F150 fx4 has cly 7 miss fire cly 6 has oil on plug .Check engine light comes on only if you step into the gas, The oil was low. If you drive normal the check engine light does not come on, but you can fill the miss when in gear. Change the plugs an coil add oil still no change.
View 4 RepliesTiguan :: 2012 VW (43k) CEL Came On / Engine Sputtering / Misfire
A few days ago, my CEL came on when I got to work, I assumed it was a misfire because when I got off work it was off. Now, I just got to work and my CEL came on when I left my house. I have been noticing engine sputtering/wastegate when I'm around 2-3k rpm, hovering around 20-35mph, after that I don't notice it. I bought the car used at 39k miles, the 40k service, nor an oil change has been done since last september. (not sure if that's a factor). I've skimmed the forums and head it could possibly be the spark plugs/coil plugs/ or turbo.
View 6 RepliesTiguan :: Random Misfire On 2009 TSI / 2WD - Oil Leak
I have a 2009 TSI/2WD with 68k miles on it which we bought brand new. The car has been relatively trouble free for all these years and my wife loves the car.
Middle of the last December my wife calls me and tells me the "Check Engine" light came on while she was driving.I told her if there is no unusual noises or any warning lights blinking drive the car home and I'll take a look at it when I get home.She said everything looks normal and nothing unusual.
Long story short,I came home scanned it with VAG-COM,found random misfire codes and spotted the oil leak on the garage floor and saw where it was coming from.Yeah you guessed it right, it was the Crank Shaft seal.
I went ahead and replaced it with new one from the dealer and a new PCV breather too.Started the car after I finish No leak,No check engine and everything was fine.
Until two weeks ago again the check engine light came on.went ahead scanned again and this time it was P0300,P0302(RANDOM AND CYL.#2). There was no visible misfire that I could feel so I cleared the MIL.I also did swap the coils to make sure it wasn't coil related and again it stayed the same as before.Spark plugs have been replaced 3 months ago,so that's not it either.
After couple of days of my wife driving it,I noticed that the MIL always comes on when she starts the car after it was driven and the engine was hot or warmed up, so after a lot of searching and reading online forums,I came to conclusion that it must be the valves and it's"DE CARB" time.
Tiguan :: Misfire Occurs At Highway Speed Under Acceleration
Misfire occurs at highway speed under acceleration, the service writer stated "we have to do a coil swap" meaning they just swap them from around, and this is the SECOND time they have done this, according to them this is how VW wants them to address this, now I understand factory procedures cuz I work for a Porsche dealer, but wouldn't you think second time around you would replace those things.
View 9 RepliesTiguan :: 2012 2.0 TDi Misfire And Sputters Then Stalls On Startup
I have recently purchased a 2012 facelift Tiguan diesel and it has a running fault. When starting the engine, 50% of the time it starts fine, 50% of the time it starts with a "misfire" and sputters for a short while (5-6 seconds) then stalls. If you Rev it a bit while it is sputtering then it clears the sputter and doesn't stall. It doesn't matter if it's hot or cold. Once it's running fine then the misfire never returns until you shut off the engine and then try to restart. The start stop also fails to cut in and I'm wondering if this could be linked. It had a new battery and alternator fitted a few months ago but a non start stop battery was fitted. This has now been changed for the correct battery but both problems still persist.
View 2 RepliesTiguan :: Lack Of Power Under WOL - Replace Cylinder 4 Coil Pack?
So, we have a CEL and we're experiencing the lack of power under WOL. Feels like the fuel is being shut off. Did a little research and I guess the computer sees the issue and will cut fuel if it recognizes an issue? Could be the reason its showing the "Fuel level too low"?
Vagcom shows as follows:
2 Faults Found:
000772 - Cylinder 4
P0304 - 000 - Misfire Detected - Intermittent - MIL ON
Freeze Frame:
Fault Status: 10100000
[Code] ....
My plan is to replace cylinder 4 coil pack and all the plugs.
Tiguan :: Random Cylinder Misfires On All Cylinders With Rough Idle
I have 11 tiguan 2.0T. When I start it up is runs rough below 1200 rpm. The check engine light starts flashing. The codes are all 4 cylinders for random cylinder misfire. When I go drive it around the roughness calms down but doesn't go away and the idle will start jumping up and down. It goes to 1500 back to 800. Then 1700 back to 800. It had even hit 2400 once. I have changed the pcv about 2 months ago. I checked it and it looks fine. One place said maf. I cleaned it and no change. Running out of options.
View 2 RepliesPrius (Gen 2) :: Misfire On Cylinder 1
Its not the spark plugs or the coil. What else?
View 3 RepliesPassat (B6) :: Misfire In Cylinder 4
So i got a CEL that said that cylinder #4 is being lazy. How do i figure out which is cylinder #4? Do I count them from left to right or what?
View 2 RepliesRepair :: CEL / VSA Came On Again - Cylinder 3 Misfire?
My Honda's check engine light and VSA light were on. The diagnosis was cylinder 3 misfire, an apparent Honda problem and one that I've had fixed once before on this same car at the dealership where I bought the car. This time the tech said I needed the pistons replaced and that the damaged pistons had also damaged the cylinders so they needed to be repaired (not replaced), and that I needed new spark plugs. My car has been in the dealer repair shop since July 16 (3 weeks today). I've had cars in the shop before and know just a little about cars. Three weeks seems like a LONG time. My question is: Is this normal or not (I am a woman and I'm not sure the tech/dealership is being honest with me. They assure me that this repair can take a long time).
View 17 RepliesTiguan :: CEL P301 And P130A Misfire Codes - How To Remove Coils
I am going to change the plugs to start trying to fix this. How do i remove the coils from the plugs. I cannot get the connector off and do not want to break it.
View 7 RepliesTiguan :: Running Rough During A Cold Start / Random Cylinder Misfires
I've got a 2009 Tiguan with 65k miles on it. A few weeks ago I noticed some issues with running rough during a cold start. I only noticed because the engine would vibrate considerably more than usually for the first few minutes of operation, and would idle at around 1050-1100rpm instead of the usual 750rpm. After warm up, things were fine. Suddenly the issue got bad real fast - wife was out and the MIL light came on, EPC light came on, and the car was running extremely rough. We managed to drive it home (2 miles) doing under 20 the whole time on side streets. Once I hooked it up to my OBD reader, I was seeing cylinder misfire codes on all four cylinders.. P0300, P0301..P0304, all five codes simultaneously.
Since the car was due for an oil change and hit 65k miles recently, I decided to throw new plugs in there to see if that would work. It did, at first.. A day or two it ran completely fine, no rough starts, no misfires, I thought I had solved the problem. The old plugs had some deposits on them and were original, so I thought I was in the clear. Two days later, same thing happened again.. EPC light, barely running and misfires on all four cylinders..
I read up some online and decided to order new ignition coils. Took a few days, but I got four new coils and threw them in. Again, problem solved it seemed. No more EPC light, misfire codes didn't come back and no more rough starts. I drove a good 40 miles with no problems at various speeds, but started noticing some misfires during acceleration (slightly rough acceleration, almost feels like a back and forth rocking motion, very slight). Sure enough, after a cold start I'm seeing the engine run a bit rough again with misfires. This time, only P0304 (misfire on cylinder 4) is thrown, and it only shows up as a "pending code" (engine light flashes for a few moments during start, but does not stay on).
I checked my connections, swapped the plugs and coils in what I thought were cylinders 3 and 4 (closer to the driver side), nothing. I swapped what I think are cylinder 1 and 2 (passenger side) just to be sure, but still nothing. At this point I'm pretty lost. I know enough to be dangerous with a carbureted engine, but am lacking in knowledge when it comes to a fuel injected turbo charged VW engine. It seems to be cylinder 4 misfiring consistently at this point according to the OBD reader.
Also of note.. I had some misfire problems last year, and had my intake manifold replaced as part of a recall (also had carbon deposits removed at the same time). Can a carbon build up occur this fast? Can it be the injectors?
Camry :: 2003 V6 XLE - Misfire On Cylinder 5
I recently purchased a 03 Camry XLE V6 love the car, but the engine has been giving me trouble. Since owning the car in January it has been in the shop 3 times for a cylinder misfire on 5. They jave replaced the ignition coil, spark plug, and fuel injector and still would misfire, it might be a few weeks later, but it would still misfire. It is currently in the shop for the something, they have checked the fuel, electrical system, and compression tested the cylinder and all has comeback good.
View 2 RepliesF Series :: Cylinder 1 Misfire Only At Startup
Normally a misfire i put a new coil on that cylinder fixed.. new coil and plug still a miss.. only at startup .. smoothens out in 25 seconds..
View 5 RepliesLS / MKZ :: 2003 Lincoln V8 Misfire On Cylinder 7
I have an 03 Lincoln LS V8 136000 miles. Just bought it in mid June and it was throwing P0420 and 430. I changed out the Coils and plugs and that seemed to do the trick. Before I was getting about 18.5 mpg and after it went up to 22 mpg. Well this lasted for about 250 miles (about a week). Now I have developed a really bad miss on #7,and a sometime flashing CEL, changed out the coil, no change. My question could this be a fuel problem? I did have one thing strange thing happen before I did the coils and plugs. I was just pulling on to the on ramp stepped on the pedal and it was like some one turned the car off nothing let off the gas and it was still idling tried again nothing, pulled off to the side. turned it off and restarted and it was fine??? Plus the fact it seems now that I my have to do the solenoid in the tranny grabbing during shifts.
View 4 Replies