Subaru - Forester :: 2006 - Dragging Noise While Coming To Stop?
I have a 2006 Subaru Forester with 115K miles. It's been well-maintained and well-loved.
For the past few months, the brakes have been inconsistently making a dragging/grinding noise when coming to a stop at low speeds (<5mph). It sounds to be coming from the front half of the car - I can feel it vibrating a little near the driver side. We've taken the car in to be looked at three times - each time, the mechanics think they've heard the noise and report there is absolutely nothing wrong with the brake pads or rotors. Twice they reported a shim was out of alignment. After the last shim adjustment, the noise got a little better - instead of grinding, it's more of a dragging sound now. Because the noise is inconsistent, I haven't been able to crack the formula of the conditions that produce it, other than that it only happens as I'm coming to a stop at very low speeds.
Is there something besides the brakes we should be having inspected? Does this sound safe to drive?
IS F (2008-2014) :: Grinding Noise Coming From Front Brakes When Slowly Coming To A Stop Below 5 Mph
Just got a 2013 IS-F. Loving this car, but discovered an annoying issue. Grinding noise coming from front brakes when slowly coming to a stop below 5 mph. Is this normal?
View 9 RepliesSubaru - Forester :: 2006 - Road Noise Coming From Both Driver And Passenger Sides
I have considerable road noise coming from both the driver and from passenger sides; have done a little research and found this to be a persistent problem with most Subaru models with frame-less doors.
View 2 RepliesNissan - Altima :: 2006 Making Dragging Sound When Brakes Applied
My car sounds like it's dragging something but when I look under it there's nothing there. The sound it makes is comparable to the sound a snow plow makes as its plowing the road. The sound is constant but gets worse when I brake. What could be the cause?
View 10 RepliesElantra XD (2001-06) :: Rear Brakes Making Noise While Coming To Last 10 Mph To Stop
Any fix for the rear brake noise I am getting on a 2001 Elantra. I pulled the drums off and inspected the drums and shoes all looks fine. Then I adjusted the brakes cleaned everything and still get noise. It occurs as the vehicle is coming to a stop last 10mph to stop.
View 13 RepliesElantra XD (2001-06) :: Brakes Making A Grinding Noise And Thump Sound Coming From Passenger Side Front
So, last week I got my transmission replaced and they also had to replace the CV axle because it was damaged beyond repair when the Transmission self-distructed. They drove it after all the repairs and said it was driving fine, just that it had a belt squeak.
On my way home (30 min drive) about 10 minutes in, still in the city, my brakes start making a grinding noise and sort of a thump thump thump when I brake which sounds like its coming from the passenger side front, it makes me really nervous. It doesn't sound like any brake grindy noise Ive ever heard before and it wasn't making any brake noises before it broke down. (On a side note: it also made a weird noise maybe the first 3 times I drove it after getting it back and I turned the wheel hard to back out of a parking space, that used to be when I heard the belt squeak but I haven't made it squeak since I got the car back.)
Everyone I talked to said it sounded like it needed new pads so tonight I bought new brake pads and rotors for the front and got everything taken apart. The rotors didn't look bad at all, just some light surface scratches, nothing deep, no warping I could see, and the brake pads look almost brand new. I did notice that the inside brake pad on the passenger side was missing its little metal plate that is usually between the caliper and the pad, so I went ahead and replaced all of the brake pads hoping this lost metal plate was the issue.
I also turned the rotor by hand on each side while the brake pads were off and the only difference I could notice was when turning the passenger side one it made a little more noise almost like it was loose.
I got everything put back together and drove around the neighborhood with my boyfriend in the car to listen, the grinding noise was gone and it seemed to brake really well (never got above 30 mph.) However, on my way to return the rotors to advanced auto (45-50 mph) it started making the thump thump thump noise but without the grinding, still on the passenger side. I can feel it in the gas pedal and now it not only happens when I'm braking, but also any time I let my foot off the gas pedal. The only time I dont feel/hear it is when I'm accelerating.
Subaru - Forester :: 2006 - Hard To Shift At Speeds Of Between 15 - 25 MPH
I have a regular mechanic that I use, except for a recent plug change. The car now feels like it is shifting awkwardly, and at speeds of between 15-25 MPH, it's as if it has a hard time choosing a gear. Can improperly installed plugs have an impact on this sort of thing?
View 1 RepliesFord F-150 (2009-2014) :: 2012 - Brakes Dragging - Noise / Hum At Slower Speeds
I have a 2012 F-150 4x4 super crew all factory with 54,000 mi. I've noticed a new noise/hum at slower speeds, more frequent now. The noise doesn't sound like its from the front or back specifically. I pulled the front wheels this evening and the front rotors seem pretty tight, how easily should they turn with vehicle off for about 30 min? I started it and pushed and released the brake and quickly tried to turn them, very tight, after a minute or two they relaxed a little, another 5 min they seemed tighter? I sharpie mark on both inside and outside of the rotor and turned it past the pads and they are both squeezing equally ruling out binding of the slider bolts.
View 3 RepliesFord Super Duty (1999-2016) :: Grinding Noise At Slow Speeds - Clunk When Coming To A Stop?
Every once in a while, while driving my 06 350 SRW at slow speeds, I hear a grinding noise coming from the left side of the truck. It is almost like a winding grinding noise if that makes sense. It will grind slow to a stop, and then I hear a clunk.
This is a very intermittent problem. The tires are completely shot on the truck, and I thought that would be it, but considering it is intermittent and the clunk I hear as I come to a stop I figured it could be it.
Subaru - Forester :: 2002 - Making Noise While Driving?
my girlfriend has a 2002 forester and it is making a very loud noise while driving, sounds like a helicopter coming from the front/right. when you let off the accelerator it changes pitch and sounds like more towards the middle...checked for axle play or anything rubbing and things look ok...very confused, i'm a former VW tech and i've never heard this noise before
View 7 RepliesSonata NF (2006-10) :: Noise Like Grinding Sound When Brakes Applied To Stop
I noticed yesterday a sound, like a grinding sound, *sometimes* as I apply the brakes to stop. I'm at 68k. The noise only happens when the brakes are applied so I suspect there is an issue with my brakes again.
Some BACKGROUND info: At around 60k (or 8 months ago roughly), the front pads were replaced after the brakes were squealing and a pulsating brake pedal when stopping. The pads were replaced by a dealer. In addition, both front/rear rotors were turned at the same time. Rear pads had 40% at the time and were not replaced.
Some weeks later the pulsation came back and I went back again and they machined them again. For this current issue I was thinking about taking the car to someplace local (not a dealer) and getting a free brake evaluation of what is going on.
I'm also concerned that all this machining the dealer did to eliminate the pulsation may have decreased the life of the rotors and perhaps they need replacement now.
Explorer :: 2002 - Grinding Noises When Making Turns From A Stop Or At Slow Speeds
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 RepliesSubaru - Forester :: 2003 - Transfer Clutch Assembly Making Noise
I have a 10 year old 2003 Subaru Forester in "very good" condition....except that the transfer clutch assembly is starting to make noise and the repair shop (at the dealer) says, housing has to be replaced also. The car has 130K miles and has had all its regular maintenance for 10 years. The only major mechanical problem we've had are the head gaskets (which on this year's model were NOT part of the recall). Those were fixed 2 years ago. Some of what I see in the online chatter about transfer clutches suggests that this is a slippery slope and the next thing you know there's the "next thing" that needs to be worked on. We were hoping that the 2014 Forester would get really good mileage (this one got 30 when it was younger) but we hear it will only be 32 mpg so we're inclined to "keep waiting" if this car can be kept happy. Is a transfer clutch repair a big deal?
View 7 RepliesSubaru - Forester :: 2011 - Grinding Noise When Try To Engage 2nd Gear In Cold
I have a brand new (2 months old) 2011 Subaru Forester 2.5x that has a 4 cyl engine and a 5 speed manual transmission. This past week it's been cold here in New Hampshire and in the morning when I first drive the car, I have trouble shifting from 1st to second gear. When I shift from 1st to 2nd, I hear/feel some grinding noise as I try to engage 2nd gear. This only seems to happen when the car has been sitting around in the cold for a long period of time. Our garage has been cold (34 deg this AM) for the past week and when I drive out of our driveway and on our street I encounter this problem.
Normally, this problem only happens the first time you shift out of first and into 2nd. However, the other day, when it was very cold (5 degrees out) it happened several times as I drove down the street. After it happened the first time that morning, I stopped the car and drove from a dead stop, shifting from 1st to 2nd. I had problems 3 or 4 times trying to shift to 2nd. I ended up double clutching the car to avoid making the grinding sound. I took the car to the dealer. The couldn't repeat it but I didn't expect it to, because the car was warmed up and it was warmer during the day (low 30's by the time I got to the dealer that afternoon). The mechanic changed the transmission oil and checked the magnet in the pan to see if there were any metal pieces. He did not find any metal pieces. That was two days ago.
Unfortunately, every morning since then the car has had the same problem. Once the transmission has been warmed up it runs flawlessly and I have no problems shifting. I've made sure I am fully depressing the clutch for each shift. The past few days I've been taking the car out on an early morning test run and like clockwork, it has problems on the first shift into second, and it usually works fine after that. I have an appointment next week to leave the car with the dealer overnight. They will test drive it to see if they can reproduce the problem. What might be wrong? I have a workaround solution to avoid grinding the gears. I simply double clutch shift into 2nd for the first few times that I shift after the car has been sitting in the cold for a while. However, this is less than ideal for a brand new car.
Chevrolet - Tahoe :: Brakes Making Grinding Sound When Come To A Stop
I have fairly new brakes on my 97 Chevy Tahoe with 202,000+ miles. For the last several months when I come to a stop, sometimes the brakes make a grinding sound (or 'boy-yoi-yong' sound- it's hard to tell) and the brake pedal feels like it 'slips' although the brakes do always stop the car. The brake don't always do this but it happens at least once or twice a day. Sometimes the problems is very mild, other times it's very noticeable. have it checked by two mechanics and they can't get the brakes to misbehave so they can't find the problem. All they did was flush the brake fluid twice and tell me it MIGHT be the master cylinder or the ABS system. My husband got laid off from his job and I am disabled. We can't afford to start fixing everything the mechanics THINK might be wrong with the brakes.
View 3 RepliesFord F-150 - 1997-2003 :: Intermittent Grinding / Dragging Noise Coming From Pulley
1997 4.6L.. Have an intermittent grinding / dragging noise coming from the pulley (?timing) area that I'm trying to pin down. Both the alternator and tensioner were replaced prior to the noise starting. The ac compressor and the power steering pump are original. The fan clutch was replaced about 4 years ago and the water pump 8 years ago. Timing chain / guides / tensioner are all original.
I don't notice any of the common ps pump indicators (whine increase when steering) but noticed the fluid level was down slightly and that the pulley seems to have some inward - outward play with the belt off. I also don't have any other engine symptoms like rough idle or any codes being triggered. How to isolate the culprit?
Subaru - Forester :: 2001 - Making Whining Noise / Louder And Slightly Higher-pitched As Accelerate
My car is making a sort of whining noise; it sounds like some sort of tire noise, but I checked the tires and don't see anything that could be problematic. My husband checked to see if anything was rubbing, and doesn't find anything. The car is quiet when it is not moving, and the noise gets somewhat louder and slightly higher-pitched as I accelerate. It almost seems like the noise changed on a different road surface, but again, I don't see anything different with the tires. The car has about 140-150,000 on it. The noise has only been noticeable for a couple of weeks. No other problems, no change in steering or handling. No incident that I can think of that could have been a catalyst.
View 4 RepliesFord Brakes/Suspension :: Front Brakes Are Dragging / Does Not Stop The Truck Just Gets Hot
First it was the RH now after replacing the rotors, calipers and new shoes. The LH is now doing it. It doesn't stop the truck just gets hot, the wheel, and u can smell it. The truck is a 97 f150 ext cab 2wd short box, had since new and has over 200,000 miles and going strange until now. I want to get 300000.0 before I let her go. Had to replace a rear axle brake line years ago, and do not think the lines were bleed right, the brakes never work just right.
View 4 RepliesTiguan :: Steering Making Grinding / Rubbing Noise At Low Speeds
The steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 Replies