Sonata NF (2006-10) :: Squeaking Near Serpentine Belt
I've been hearing a slight squeaking near the belt area. It's not continuous. Does it for a second then stops for a second and continues.
I hear it a lot more when I put the heat on through the top window (defroster). Never noticed it until it started getting cold. You think it might just be the belt? Or what?
Santa Fe (CM - 2007-12) :: Serpentine Belt Replaced Still Squeaking And Slipping?
Long story short is, I replaced my 2007 Santa Fe's serpentine belt and it still squeals for some time after we start the vehicle (then stops) ... but more importantly I *think* its still slipping if we're driving during rain or on very wet roads.
Long story long is ... the problem appeared as loss of power steering and air conditioning when driving during rain. Took it to the dealer and they suggested to replace the serpentine belt, replace the shroud (plastic) that covers the belt, and replace the timing belt. As we have 36k miles on it, no one I talked to understood the timing belt suggestion. I see though perhaps its just because the car is 4 years old? The shroud the dealer claimed was cracked and may be letting water in on to the belt. However, they completely removed it and did not replace it so I was not able to inspect this myself (wife took the car in for the appointment).
I bought the new belt and put it on. The squeaking was gone but as soon as I hit rain again, the slipping was back as bad as before (and we'd lose power steering / air conditioning same as before). I had a 1.5 hour drive in rain where the belt was slipping almost nonstop; constant back and forth between catching and slipping.
When the replacement shroud came in I thought that might solve the problem - keeping moisture off the belt. However with that in place I'm afraid there is still some slippage as I've noticed some dashboard lights come on during brief heavy rain. Also the initial squeaking is back when we start the car.
Sonata NF (2006-10) :: How To Replace Serpentine Belt Tensioner On 3.3 V6
How to replace the belt tensioner. It's not putting out enough tension when the engine is cold. So, the belt makes chirping noise for couple of minutes idling when cold with AC on.
I had the AC inspected and everything checks out according to my mechanic.
He believes that the issue is with the tensioner since I had recently had replaced the serpentine belt.
Hyundai - Sonata :: 2006 V6 - Noise Coming From The Serpentine Belt
Is it time to replace? There is a noise coming from the belt and when I listen with the hood up my best guess is that it's the tensioner. I'm not sure if it is easy to replace or if that is even the problem. The belt looks fine. It allows me to twist it barely less than halfway so to me it does not seem loose. But in the rain last week got the battery light and lost power steering, power brakes, etc, then it went back to normal and hasn't failed again since. The car has 131,000 miles.
Is there a way to check the tensioner? It's pretty tight in there. Or am I wrong as to what the problem is? The sound is a rubbing/slight clicking sound that is in time with the engine and you can hear it if you listen inside the car when the engine is on. The belt also seems to wander around on the tensioner just a little. One day it was about a mm in too much, a few days later, a few mm out, in relation to the pulley.
Sonata NF (2006-10) :: Noise On Cold Startup Coming From Serpentine Belt
I have a '06 sonata 3.3 v6. Let me first describe what was happening to the car before the noise started. When I first started the car and put the ac, the first time turning the steering wheel in either direction the steering wheel would tighten up and the battery indicator light would come on and the fasten seatbelt light would flash even though I had the belt fastened. It would only happen the first time I would make a turn and after that I could turn with no problem. So in recap, it would only happen on the first turn and only when the ac was on. Now when I start the car up there is a noise coming form the pulley/belt area. I wouldn't classify it as a squeaking noise more like a grinding. I've looked at the belt and it seems to be fine. After I start to drive the car the noise goes away. If I start the car again after a drive within about 2 hours the noise doesn't happen when I start it. What this noise could be? and also could the noise and the steering wheel tightening when the ac is on be connected?
View 1 RepliesGolf V R32 :: Squeaking Sound - Serpentine Belt?
So this car has only 50k miles. It was really cold in the sierra (around 20F) and the car started making a squeaking sound. I assumed it was just belt warming up, but when I opened the hood later, I saw shredded plastic. No CEL's! Seems to run smooth.
Where this came from? Is it part of the serpentine belt system?
Prius (Gen 2) :: How Often Serpentine Belt Should Be Replaced
I am very concerned regarding how often my serpentine belt needs to be replaced. First time it was replaced at 104k, second time dealer replaced it at 126k, third time at 153k. Today I went for oil change (173k) and the dealer told me that it has little cracks and recommend replacing it. Is it normal? Could it be something else is affecting it?
View 11 RepliesFord Ranger / B-Series :: 1998 - Serpentine Belt Squeaking
So i have a 1998 4.0 ohv ranger and have been fighting belt squeak shortly after i got it. I've replaced the belt twice and the tensioner twice when i put a GATES belt on it stopped for like month. But its still squeaking. If i put a wrench on the tensioner and turn it the squeak stops. So i need to find a way to tighten the tensioner could i somehow jam it, our hook up a turn buckle bolt to manually tighten it, or use a different ford tensioner. I really need to do something cause this squeak is just down right annoying.
View 2 RepliesPassat (B5) :: Serpentine And Timing Belt Needs To Be Replaced Simultaneously
Today I had my 2004 1.8T Passat in the shop for a few minor things. The car has only 89,000 KM's (NOT MILES~ I live in Canada) on it. They told me that my serpentine belt was needing to be replaced (which I knew) and they recommended that I to my timing belt at the same time. They told me that you can buy a kit that has the timing belt, tensioner and water pump in it. Anywhere I have read it has said to change your timing belt at 120,000 KMs.
View 2 RepliesPrius (2004-09) :: Serpentine Belt Just Replaced And Car Dies
I took my Prius II to the dealer to get my key fob reprogrammed. While doing that they did a routine check and noticed that my serpentine belt was quite worn. I had them replace it.
View 2 RepliesLexus SC430 :: Serpentine Belt - Creaking / Squeaking After Cold Starts
What a Serpentine Belt is? (how much is it for that part alone and to install at the dealership?)
Dealership told me why during the cold mornings after I start the car up, it is creaking and squeaking........
They told me it needs to be replaced?......
Chrysler - Towncountry :: Won't Go Past Second Gear After Serpentine Belt Replaced
My wife's town and country had its serpentine belt replaced. Now it won't go past second gear and is running 3.5 rpms at 40 mph. What do I do?
View 3 RepliesFord - Taurus :: Serpentine Belt Squeaking And White Smoke Coming From Engine
I noticed my serpentine belt started squeaking about 3 days ago. And yesterday as I was driving to work I heard a clicking sound coming from the left side of the hood, then my car started to gradually shut down and white smoke was coming from the engine. When I got to the stoplight it completely turned off, but I was able to turn it back on again to turn into the parking lot before it shut off again. When I checked it there were no visible leaks, my reservoir for my coolant was still full, and my meter never went up indicating that my car was over heating. I'm not sure what's wrong with it, but after it sits for awhile it is able to turn back on again for a while.
View 3 RepliesFord Aerostar :: 1997 - Squeaking Noise When Turning - Serpentine Belt Tensioner?
I have a problem with my 1997 aerostar. There is a squeaking noise that gets more significant when I turn. I am pretty sure this is the drive belt as the power steering fluid is fine. Should I attempt to replace the belt tensioner and if so is it just the pulley that needs replacing or the whole tensioner. I am by no means a mechanic but can figure most things out.
View 5 RepliesHonda - Odyssey :: 2006 - Serpentine Belt Breaking The Timing Belt
Serpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 RepliesSonata NF (2006-10) :: Whining / Slight Squeaking Noise Coming From Drive Belt
I have a 2006 sonata gls 3.3l v6. There is a whining/slight squeaking noise coming from the drive belt when i turn the car on. When the noise started it would only occur when turning with the AC or Heat on. It then escalated to whenever i started the car and would go away after driving for a while. Now the noise continues even after a drive sometimes..
I've been told by a mechanic friend that the belt looks ok. So my plan is to take the passenger side tire off and the splash guard on that side to get at the tensioner for the belt. Once I have the belt off i plan on turning the various pulleys that the serpentine belt goes on to see if i can figure out which one is making the noise. How to pinpoint where the noise is coming from?
Here's a link to a youtube video I put up with the noise my car is making ............ YouTube
Ford Super Duty (1999-2016) :: 2006 - Serpentine Belt - How To Route The Belt Around Tensioner Pulley
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
Sonata I45 (LF 2015+) :: Temperature Light Suddenly Came On - Broken Serpentine Belt
I am driving a 2015 Sonata with 20,000km (13,000 miles) and the temperature light suddenly came on. I stopped and checked things and could find nothing wrong (oil and coolant OK). I was close to home (less than 1 mile) so drove until light came on again then stopped until it cooled a bit and then home. I thought it must have been the sensor because engine definitely did not appear to be hot.
Once in the garage, I inspected things a little closer and noticed a destroyed serpentine belt--ripped to shreds. Not sure what caused it, but that was the problem. I was afraid of a coolant leak which would have been more serious.
Azera TG (2006-11) :: Serpentine Belt - Crank Pulley Failure
Ever hear of a crank pulley failure? Mine did and took out the serpentine belt. I have 63,000 miles on the 07 and it was a big shock to see the pulley in two parts.
View 5 Replies