Passat (B7) :: 2012 - CEL With P0106 And P0106 PD Codes?
I am having a problem right now with the check engine light on and P0106 and P0106 PD codes scanned. I bought this 2012 Volkswagen Passat 2.5 S from Hertz Car Sales for less than a month.
When I drove the car back from work on a Tuesday night, January 13, my car was doing fine at first and was suddenly reducing power with check engine light coming out. It was highly congested with massive traffic and cars on the 101 freeway towards Downtown.
I was luckily and safely able to drive the car back to my house. I could not take it to anywhere since it was already 7:30 at night. I decided to let the car sit for a few days until the weekend comes.
However, when I decided to take the car to an auto shop today, the car would not crank and start. Now, I have both check engine light and EPC+Battery light.
Ford Escape / Hybrid :: Check Engine Light Only Comes On After Motor Is At Higher Rev - Codes P0304 And P0316
A couple of weeks ago I got a check engine light. Pulling the codes I saw that it was a p0304 and sometimes a p0316. The first time this happened I check the spark plug cables and one was loose (cycylinder 4). Then last week my fuel pump died. since then I have gotten the two codes on a somewhat continous basis. I replaced the plugs (needed to anyway) and the problem did not go away.
The odd thing is that the check engine light does not come on at idle. IT only comes on after the motor is at a higher rev. The replaced plugs looked pretty normal, but the cylinder 4 plug had some carbon deposits. I am currently running injector cleaner in the gas. I may go ahead and replace the plug wires since the current ones are high mileage and it is not an expensive fix.
Sonata NF (2006-10) :: ESC And Check Engine Light Came On - Stop Lamp Switch Malfunction
I have a 2006 Sonata. My check engine light came on and also my ESC light. My car does not accelerate. It takes literally about 40 seconds to get up to 20 miles an hour. I called the hyundai 800 number and they said there is a recall for a "stop lamp switch malfunction".
View 3 RepliesSonata NF (2006-10) :: Check Engine Light With 8 Different Codes Just Came On
The light just came on in my 06 Sonata 3.3L, showing many codes... P0171B, P0172B, P2187, P2188, P0174B, P0175B, P2189, and P2190. All of these just came on at once, within the last hour. Everything that is stated is regarding Too Lean or Too Rich on Bank's 1 & 2. Where to start on this...
View 9 RepliesSonata NF (2006-10) :: P0885 And P0890 Codes Set Check Engine Light On
Car keeps tripping P0885 P0890 codes and sets engine light on. I've tried swapping ATN relay and cleaning connector in TCM and Relay box. It's intermittent comes on at least every other day. Shifts fine when engine light reset. But when the P0885 comes up it goes into limp mode. Just bought this car We bought an after market warranty but shop say they won't cover Engine light codes or intermittent.
View 5 RepliesSonata NF (2006-10) :: Check Engine Light With Codes P0160 / P2273 And P0158
I just picked up my 'new'/used 2006 sonata! unfortunately, about 11 months in now, i have a check engine light and some codes; a local store told me what the codes were (i haven't got a code reader yet) and as i was researching them it sounds like either a bad O2 sensor or just the wiring going to it.?.? Codes are P0160, P2273, P0158. How can i tell what is actually bad? I am 'ok' at 'fixing'; just trying to save from an expensive garage repair if at all possible.
View 4 RepliesSonata NF (2006-10) :: Throttle Body Cleaning Due To Rough Idle Occasionally / Code P0106
Trying to clean the throttle body on my 09 sonata 2.4L due to rough idle occasionally (throwing P0106, replaced MAF sensor still same problem), one quick question, is it okay to force the valve open (with connector disconnected of course), and is "re-learning" necessary and what's the proper way to do it?
View 2 RepliesSonata NF (2006-10) :: P0304 Code Popping Up
The code p0304 pop up last week, I have 50800 miles on my car, I unplug the spark plug and the ignition coil from the cylinder 4 and when i start the car I can there is a spark so the wire the spark plug and the ignition coil is good... I changed the fuel injecter with the one from cylinder 3 I cleared the code and it came back?
View 4 RepliesSonata NF (2006-10) :: Malfunction Indicator Light (MIL) Does Not Work?
I am trying to diagnosis a new issue on my 2006 V6 Sonata . I plugged in my code scanner which gave back MIL Status as ON, but there was no Check Engine - Malfunction Indicator Light (MIL) lit up on the instrument cluster. It also showed that the EVAP, CAT and O2S was "Not Ready". When I checked the codes, I had P0031, P0037, P0051 and P0057, all of which are tied to Low Heater Circuits in the O2 sensors. When I checked the cables under the hood, the lower O2 sensor cable closest to the firewall was stuck onto exhaust pipe. It easily pulled free but I tried clearing the codes but the same 4 codes remained. I checked the resistance across the heater control and ground circuit, all 4 O2 sensors were around 10 ohms.
There seems to be several issues:
1) Why doesn't the instrument cluster register the MIL status as ON and display this Check Engine Light?
2) Why are the EVAP, CAT and O2 "Not Ready", I've heard that these are sometimes tied to disconnecting the battery. I've put almost 3K miles on the vehicle since the battery change.
3) OBD Codes P0031, P0037, P0051, P0057, I would expect all O2 sensors to fail at once, is there a fuse or other control that needs to be replaced or reset?
I am trying to get everything ready for emissions testing on this recently purchased 06 Sonata and I am thinking these issues will cause it to fail.
Sonata NF (2006-10) :: Surging And Cutting Out Once Warmed Up - P0304 Code
I was on my drive in to work Wednesday and the car once warmed up started surging and cutting out. I got it to work and home again and hooked up my code reader and came up with P0304 meaning misfire in number 4 cylinder.
View 2 RepliesGolf IV / Jetta IV :: Codes P0238 And P0106 - Car Is Not Boosting
My car is not boosting. I had two codes p0238 and p0106...
View 9 RepliesSonata I45 (YF - 2011+) :: 2011 - Engine Code P0106
I just replaced my OEM battery with a duralast from autozone. The battery had 138,000 miles. Shortly after, the check engine light came on and code says P0106. Map Sensor. Seems like to much of coincidence that this happened. Have read that disconnecting battery cables for 3 hours may do the trick.
View 8 RepliesSonata NF (2006-10) :: Oil Pressure Light At Idle And CEL With Codes P0011 / P0051
I recently bought a 08 Sonata V6, with 94K mileage. The oil pressure light comes on when the engine is idle (around 700-800 rpm). The seller told me that this problem started a few months ago, but the car has not been used much since then. He also said that he has changed the oil after that, but the problem still persists.
The engine light has shown up more recently, like in a week or two. I took the car to a mechanic and he could not guess what the problem might be. But he gave me the error codes: P0011, and P0051. There are no other obvious symptoms (e.g. oil leakage, low oil level, unusual sound from the engine).
I could not find any thread regarding both of these issues (Oil Pressure, and the error codes) together. Any connection between these two?
So far, I have realized that the oil pressure can be due to a bad sensor, and P0011 has something to do with CVVT, and Oil Control Valve (OCV). But I would like to make sure I don't just waste money by replacing the sensor and OCV.
Sonata I45 (YF - 2011+) :: CEL Came On - DTC P0106 For Map Sensor
Installed hid and relay kit yesterday...after reconnecting the battery the check engine light came on the dtc that was pulled was p0106 for the MAP sensor... i had it cleared and it keeps coming back... The car still runs fine just seems as if it idling low...
View 8 RepliesElantra HD (2006-10) :: Engine Malfunction Light Decode
My engine malfunction light has come on.
View 7 RepliesJeep - Wrangler :: 2006 - Getting Check Engine Light - Electrical Malfunction?
I am having a “Check Engine” light problem on a stock 06, 4 cylinder Jeep Wrangler with manual transmission. A local highly regarded independent mechanic has had it in his shop 3 or 4 times for more than a day each time. On the first visit he replaced a purge solenoid valve and reset the light. It stayed off for more than 400 miles and then relit. He went over it and checked the wires and connections and reset the light. Again it stayed off for some time and then relit. He has checked the Jeep site.
After the last visit he suggested I drive it and see if it would reset itself as it had been doing in the past. It did reset itself twice but it only stayed off for 10 miles the first time and 2 the second. The code indicates an electrical problem and he is now planning to drop the fuel tank and check the wires and sensors there. The next step may be an ECM transplant. This is only an emission system problem and the mechanic says it is OK to drive. We do not have emission inspections here. How important is it to fix the problem?
Accent LC (2000-05) :: CEL Fault Codes P0304 And P0441
Car - 2004 Accent auto.- 1.6l - 97K miles
After battling a few months to get my check engine light - fault code P0304 to go off I finally remedied the problem with 3 bottles/fill ups of STP Gas treatment. This was about 1500miles ago. I go to DMV Inspection station and sat for an hour then wait anther 20minutes for the test to end and was given the big fat rejection sticker, she failed because the check engine light came on with fault codes P0304 & P0441.
Now what the heck happened here? Just bad luck and coincidence or did their test set it off? Anyway the P0441 code is new and researched it is the Evaporative Emission Control System Purge Valve. Okay where is it, the HMA manual is not specific? In relation to the intake manifold where is it? Easy fix? And will this solve my P0304 code?
Nissan - Sentra :: Check Engine Light Came On With P0304 Cylinder 4 Misfire Code
(This is a continuation of a previous thread: [URL] ..... )
I have a 2005 Nissan Sentra with 75,000 miles on it. Several months ago (see above link) the check engine light came on with a P0304 cylinder 4 misfire code. The only symptom appears to be a rough idle/shaking every 3rd or 4th start for the first 10-15 seconds, but runs smoothly afterwards. My mechanic replaced all my spark plugs (I had new plugs put it at 50,000 miles for the same issue) of which the one from cylinder 4 was worn down much more than the rest. The problem persisted so they replaced my fuel pump and fuel filter and switched the spark coils from cylinder 4 to a different cylinder, but the code still read cylinder 4 so it wasn't the coil. That was back in October.
I took my car back in last week for the same problem and without starting my car (because the problem is worst on the first start) they pushed my car into the bay and did a smoke test, no leaks in the fuel lines. Then they checked the cylinder and said that there was "excess" fuel in the cylinder and replaced the fuel injector. Then after ~3 days the check engine came back on with the same P0304 misfire code. Previous repairs/diagnostics rule out spark plugs, coils, fuel pressure, and injectors.
Elantra XD (2001-06) :: Misfire - Consistently Getting Codes P0301 And P0304
I would like to find out why my car is misfiring before throwing parts at it. I have a basic level of mechanics and have checked a few things before posting here, which may or may not have ruled out some possibilities.
The problem: I have been consistently getting P0301 and P0304 but only happens sometimes, while other times there is no check engine light. I first checked the ignition coil, right side of it, that controls cylinders 1 and 4. Did resistance test, measured for voltage, and checked the wires for continuity to the connector, with everything coming out good. I know a few must have had issues with the cheap pigtail connector like me so I went and changed that but still got the misfire codes. I then put in an older known to be good working coil but no change.
After that, I removed spark plugs 1 and 4 and put them where 2 and 3 go but still got the same codes P0301 and P0304.
A friend who is a mechanic for Nissan checked the spark and wires, saying they were fine. He then checked the injectors and noticed that injector 1 didn't increase in ticking sound when RPM increased. He said I should replace injectors 1 and 4 to see if that changes anything or switch injectors 1 and 4 with 2 and 3 to see if the codes at least change. I removed them all, got two of them from junkyard just in case, made my own tool where I pumped straight fuel injector cleaner through each of them with pumped air, and put the two from junkyard on cylinders 1 and 4. I still got the same codes so then I switched injectors 1 and 4 with 2 and 3, which didn't change the codes.
I was told by another local mechanic shop that it's definitely the coil but I knew it wasn't.
Other info: I am not sure it would matter when dealing with a misfire but I borrowed a code scanner and saw that the Long Term Fuel Trim was -7%. I researched that and it means that the car is running rich and the computer is being told that it needs to run lean. I am not sure that this would make only two of the cylinders misfire and the freeze data shows that same negative LTFT for when the P0301 happened. I also know that there is an air leak at the gasket where the front cat connects to the flex pipe/rear cat. I have also gotten a rear downstream 02 sensor code once within the past month but it hasn't come back.
Would the LTFT being lean have anything to do with the misfires? Would the gasket between the two cats cause the 02 sensor to get a faulty reading? If so, would the downstream 02 sensor be able to adjust to a lean fuel mix? What else should I check?