Ford - F150 :: Occasional Vibration When In Gear - Scraping / Squeaking Sound
Vehicle: 1998 F150, 158k mi. MT (M5OD), 4.9l I-6.
Description of problem: About 2 weeks/500 miles ago, truck developed a scraping/squeaking sound. I thought maybe something was rubbing on the driveshaft, but inspection revealed no likely candidate, nor disturbed metal on the shaft.
Over the course of the next 500 miles, it's gotten worse, so that current symptoms exhibit themselves (to one degree or another) 80% of the time. The symptoms are:
- Worst on first drive of day, on first mile.
- Sound produced somewhere between scrape and squeak.
- Vibration noticed throughout cab and through steering wheel ONLY when foot off clutch...smooth as soon as clutch depressed.
- Giving it a little gas (at constant speed) usually smooths out symptoms somewhat.
- Recently had bed loaded to gross. Vibrations went away, to return once bed empty.
- MT fluid found to be full, in good condition, and with 15k mi since change.
So, what's up? Given that a load in the bed improves things, I was thinking U-joints: but the driveshaft spins in neutral, too, so why would pressing the clutch change anything? I also thought about tired clutch bearings, but everything I've read says pressing the clutch makes things worse, not better.
Is it worth examining the tranny-to-engine bolts?
Ford - Focus :: 2001 - Squeaking / Scraping Noise Happens Sometimes While Driving Maybe 20 MPH
2001 Ford Focus ZTS manual. Squeaking/scraping is the best that I can describe it, happens sometimes while driving maybe 20 mph. Also makes a rapid clicking noise when starting from a stop, groaning noise with engine on/off while turning wheel from same area. I did pads/rotors last year. I had play in the wheel, axle nut was loose, tightened and went away. I can't find any problems. It can make some noises under heavy braking and it was making noise from moderate braking, I'm guessing that's my cheap rotors.
View 2 RepliesLexus LS 2007+ :: Fluttering Squeaking Noise When Apply Brakes On And Off While In Park
When I apply the brakes on and off while in park, I hear a "fluttering squeaking" noise. I examined the brake pads and calipers, and everything seems to be fine. I greased up all the brake hardware and no luck.
Also, I have a popping noise while making turns while I am not braking. I really doubt there is any connection with the brakes? I recently went testing in a parking lot, and while slightly turning from left to right I noticed the popping constantly. Keep in mind no brakes were applied.
Last year the dealer replaced the brake actuator and all arms were replaced. BTW, I am past my extended 100K warranty!!
Civic - Honda :: Squeaking And Scraping Sounds When Drive At Any Speed
My Honda Civic DX (1997) is over 200k. Over the past six months, it's been to the repair shop multiple times including each of the brake pads, shoes were replaced. Nowadays, it's making a squeaking and scraping noise as the vehicle is moving at any speed. The squeak comes and next the scraping. The sound is becoming more pronounced, it seems, daily. What the problem is coming from?
View 1 RepliesF Series :: 1998 - Squeaking Noise In First Gear At Low Speed
I have a 1998 F-150 and I have a squeaking noise and I can only hear it when I am in in first gear at low speed and when I'm in reverse backing up and goes away when I press the clutch pedal. I'm thinking its either my U-Joints or Throwout bearing.
View 3 RepliesSilverado :: No DRL Or Front Park Lights
Today I noticed I have no DRL or front park lights. The rear is fine and all the turn signals work. Bulbs are good, front park fuse has 12v on both sides. Only bought this truck a few weeks ago and I am pretty sure they worked then. Hand brake cables aren't adjusted good, the pedal goes to the floor and the park brake just barely grabs. I haven't checked the switch on that system yet but I thought the parks would still work just not the drl's.
Both side are gone,any thoughts?I also notice that the interior fuse box has an opening for another plug that looks the same as the door wiring plug on the fuse diagram it says body/12 way/brown with body being on top and the rest following under it. Is this supposed to have a plug in there?all the pins are in the fuse box for another plug,wouldn't think they would have the pins sticking out if nothing went in it, would be easy to short on something.
Silverado :: 2007 - Rear Park Assist Not Beeping?
My girlfriend has an 07 1500 new body style LTZ. It has the rear park assist and was working just fine before. Now when you put it in reverse the system makes the single beep. Then as you back up the lights in the back window on the passenger side all seem to work. The only problem is it doesn't beep anymore. As you get closer the beeps get more should get more and more frequent the closer you get to something. I tried turning it on and off, but no luck.
View 6 RepliesSonata NF (2006-10) :: Slight Engine Rattling Noise At Idle RPM In Gear Or Park
I have a high milage (210K) '07 2.4L which has a slight engine rattling noise at idle RPM at cold and operating temps, in gear or park. It is a fairly constant noise at idle but does vary a little. Otherwise, engine/tranny operate beautifully with no obvious problems.
I am concerned this could be a timing chain/tensioner related issue although I also wonder if it may be some other component. I have not been able to determine the source or location of the sound.
Silverado :: 2013 - Tranny Overheat In Park - Temp Went From 120 To 145 Degrees
I have less than 7k miles on my new Silverado W/T. I haven't hauled anything heavy in it since I bought it, and have been using it just back and forth to work. Pretty light duty. I was parked the other night in a parking lot idling and listening to the radio when I noticed the transmission temp jumped up to 189 degrees! I also noticed the water gauge was a bit past it's mid-range temp. I immediately cranked up the heater core to try to cool things down and it worked for the main radiator water temp..but the tranny sender quickly went to 200 degrees so I shut the whole mess down.
Just before I did that, the transmission idiot light popped on. I left it there for several hours in 20 degree weather and came back to start the truck and head home..the tranny on start-up was still @ 70 degrees. I got up on the hiway and things came down to about 100 degrees at a legal speed on the hiway. Engine water temp was normal too. Drove for about 45 minutes that way. I tried sitting in my driveway a day or so later in park, and the tranny temp went from 120 degrees to 145 degrees in 35 degree weather fairly quickly.
Ford Ranger / B-Series :: 2004 - Slipping In Park Position With Clunk Noise As If Popping Out Of Gear
So my new/old 2004 has another issue. Parked at the grocery store tonight on a very slight incline backwards. Put the Ranger in park (automatic shift) and before I could fully engage the parking brake it began to roll back with a clunk, clunk, clunk as if popping out of gear.
Need less to say I moved to another spot that was more level. Just an hour before I parked the same way on a steeper incline and did not get this. Now I need to watch this carefully until resolved. How to remedy this issue.
Silverado :: 1993 Z71 4x4 - 2nd Gear Lost
A friend has a 1993 4x4 Z71 automatic that has lost 2nd gear. He has drained the fluid and it does not smell burnt and color is fine. He does notice what seems like dust in it but it has no texture when try to feel the dust. The fluid did seem to have some sludge like gunk in bottom of container He drained it into.
View 1 RepliesC/K :: 88 K2500 Silverado - Gear Ratio From Factory
What the gear ratio is from factory?
View 8 RepliesPrius (Gen 2) :: Slight Noise Like Scraping When Turning Right
I have been noticing a slight noise when turning left and I cannot recall if this is normal or not. Typically I always play music when driving. It's very faint and sounds like scraping. Seems to come and go depending on the temp....that is when warmer I do not hear it. I got less than 1000 miles left on the warranty and would like to get opinions if it necessary to take into the shop. Btw, the shop wants $125 to walk in the door...hence the hesitation.
Prius 2006 99200 miles. Never had an issue.
Passat (B6) :: Scraping Noise Coming From The Front End
I have a scraping noise which sounds like it is coming from the front end but only around 10 to 20 mph. It can only be heard when driving down a quiet street, next to a building (mcdonald's drive through) or in my parking garage at work. Always makes the noise, it sounds like it something was scraping on one of the rotors.
Purchased car in August with 26,000 miles from a non VW dealer --- first mistake. Two days after signing papers showed signs of valve body issue. Took it to VW dealer near work and after two days they finally got OK to replace valve body and all is good. About 5K to 6K miles later started hearing the noise. At 36,000 the tranny started shifting hard and having problems up shifting occasionally, would rev up really high and then finally go into gear. Took 3 service visits for the same dealer to be able reproduce it and then they finally figure out they left out 2 liters (their calculation) of fluid when doing the valve body, so it got driven 10,000 miles while 2 liters low. They basically acted like they were doing me a favor by adding the fluid they left out in the first place and said only time will tell if there is any damage.
Took it back to the same dealer again for the scraping noise. Supposedly 3 people drove the car and never heard the noise. CEL came on yesterday and I decided to try a new dealer and have them look into the noise while it was there. Did a ride along with the service writer and tech. Writer is pretty sure he heard the noise and tech wants it back after the holidays to road test more and try driving in some quiet areas.
It has been determined that the car does not make the noise if there is no weight on the front end. I have jacked it up and spun the wheels and first dealer claims they had it on the lift in drive and could not hear. New dealer is thinking bearing noise that is only heard when bearing has weight on the front wheels or something to do with the CV axles or something in the tranny. If it is the tranny well we know who's fault that is.
Golf/GTI VI :: Rotational Scraping Noise From Front End
25k miles, recently started getting this noise from the front end when going ~15mpg or less. Decreases and increases with wheel speed and loudest when coasting to a stop sign. Sounds like a scraping disc brake, however brake pressure doesn't affect the noise. Started happening after last service when they rotated the tires. Haven't had the chance to inspect anything yet.
View 7 RepliesElantra MD (2010-15) :: Scraping Noise At Low Speeds
Recently my car has been making a noise from the front and rear wheels (sounds like metal scraping against something). It is more pronounced on the driver side and there is a definitive roar at highway speeds. I have had the tires rotated, balanced and tire pressure checked numerous times and still no fix. It has 37K miles on it.
View 11 RepliesSilverado :: 1996 Will Not Shift Out Of First Gear - 4l60e Transmission
I have a 1996 Silverado and it will not shift out of first gear. I have had the pickup for about 6 months and when I got it, it would shift if I accelerated to about 30 and let off but then I went though some mud and got stuck, I kept shifting from reverse to forward and I got out of the mud and it would not come out of first but reverse works fine and it will not shift manually at all the pickup has a 4l60e transmission.
View 5 RepliesSilverado :: 98 Chevy Truck With 4L60E Has No Second Gear - Shift From 1st Into 3rd
I have a 98 Chevy truck with a 4L60E. It has no second gear. I was sitting in park for about 10 minutes with the engine running, then put it in drive and it never shifted into second. It felt like it went straight to 3rd. I played with it manually until I figured out I had reverse, 1st, 3rd, 4th and torque converter lockup, just no second gear. My acceleration rate was medium and when I reach about 27-28 mph it would shift from 1st into 3rd. It has 230K on it so I rebuilt it with all the typical parts - frictions, steels, band, sun shell etc., still no second. I then pulled the pan back off and replaced the spacer plate and put in a shift kit. While I had it down I put a corvette servo in and did an air check. It worked fine. I could feel the band tighten.
Both the 1-2 and 2-3 solenoids checked good at 23 ohms. I swapped their positions to see if it would make a difference. I also checked to make sure the 1-2 accumulator piston wasn't stuck in its bore, the spring was new from the shift kit. It was fine. Put it back together...still no second gear. When I originally pulled the pan off for the rebuild, the pan was free of any debris and was very clean. I then drove it a couple of miles to a local transmission shop. They put their scan tool on it and drove it around the block. There were no codes and the ECM was calling for second gear. It doesn't sound mechanical since almost all the parts have been replaced, rebuilt or inspected that affect the 1-2 shift. It sounds electrical. Is there anything I have missed?
Chevy - Silverado :: 1996 Won't Shift Into High Gear
My dad's 1996 Chevy Silverado will not shift into hi gear. The truck starts up fine and he can drive it but for some reason it won't shift into hi gear. Him and I are clueless as to why it won't. He has a 1996 Chevy Silverado, 6.5 liter V-8 automatic transmission, and its a diesel. We really want to fix the truck ourselves so we are trying to avoid taking it to a shop.
View 2 Replies