Santa Fe (CM - 2007-12) :: Loud Click Noise Coming From Front End Of Vehicle When Apply Brakes
I get this loud click noise coming from the front end of my vehicle when I apply the brakes. It seems to happen much more often than not, especially at low speeds. I can only describe it as some sort of loud clicky clanky sound, it's also a single sound, it doesn't go on and on and it only happens when I apply the brakes.
View 2 RepliesLexus ES 2013+ :: Faint High Pitched Noise In The Cabin When Apply Brakes
I have been driving my new ES 300h for a few days and have noticed that often when I apply the brakes, there is a faint high pitched noise in the cabin. It's not a brake noise of any sort, its clearly some electronic component. I was just wondering if this is a normal part of the regenerative braking system or not, as it is definitely quite audible and takes away from the otherwise very quiet ride of the vehicle.
View 7 RepliesLexus GX 2004-09 :: Brakes Squeaking Noise Under Dash Area
Ok this just started and it has to do with brakes in a way----the Noise is the sound of when you are deflating a balloon (the squeaking sound). Its under the dash area and I can make it do it if I press on the brake pedal and let off it will make the squealing sound. Some times it will do it on its own just driving along without even hitting the breaks, but when it DOES start doing it I can make it do the noise constantly pushing the brake pedal down and then letting off!!!
View 10 RepliesFord - F150 :: 2007 - Pronounced Vibration When Apply The Brakes
I have a 2007 F150 FX-2 which i bought new. I have about 60,000 miles on it, and every 8,000-10,000 miles i develop a pronounced vibration when i apply the brakes. When i first had this problem, at about 10,000 miles on the odometer, the dealership replaced the pads and turned the rotors, but the problem resurfaced before another 5,000 miles had passed. About 10,000 miles later the problem resurfaced, the dealership said they replaced the rotors.
The problem resurfaced again at about 37,000 miles, but the dealership claimed that since I was out of warranty. Being handy, I replaced the rotors myself, but now, about 15,000 miles later, I'm experiencing this issue again. Is this just a common problem i will have to live with? I don't tow anything, and i rarely load the bed with anything. Maybe a trip to the hardware store once a quarter and i load a motorcycle into the bed two or three times a year.
Lexus LS 2007+ :: Right Headlight Fluttering When Going Down The Road
I noticed that driving my LS last weekend that the right headlight was fluttering going down the road. It did not go off but it looked like a loose connection. When I arrived at the golf course, someone told me that he noticed that the right headlight was out. Now I got home and I have checked the headlight and nothing seams to be a problem. Both low beam and high beams go off and on with no problem. My question is : is the headlight bulb going out or do I have a connection problem? I hate to take off the tire and inner wheel cover to change the bulb unless I need to. Second question: If I have to change the bulb what is the best brand to use?
View 14 RepliesAvalon 2005-12 :: 2007 Downshift Immediately And Jerks When Apply Brakes
I have a 2007 Avalon and really enjoy the car. The only fault I can find is the weird shifting. It seems like every time that I apply the brakes, the car will downshift immediately and the whole car will jerk left/right due to the sudden downshift. Sometimes it will shift back up and cause the car to jerk a little but will be smooth after. Some times I apply the brakes and it does nothing.
I also get the occasional hard shift but the bigger issue here is the downshift while braking. It kind of ruins the driving experience on an otherwise great car as one tends to use the brakes often. It's especially annoying while going down a hill and applying the brakes. I have watched the tachometer before and noticed it jumps up to 3k or so from a normal 1500 or so RPM's. It may not be downshifting per say, but it's definitely doing something.
Santa Fe (CM - 2007-12) :: 2009 - Loud Squeal Sound When Apply The Brakes
I just installed new brake pads in my 2WD 2009 Santa Fe. I bought the cheapest AutoZone pads. Now I have a loud squeal sound when I apply the brakes. If I apply a hard brake the squeal goes away. Until I apply the brakes again. Now, after install...I have been researching and noticed that the stock pads are ceramic. I did apply (Not once but twice) break grease on the pads. What the problem might be? Oh yeah, I did see that after 2007, oiling the caliper springs is required and might be the problem too. But I do not know where the spring in question is and how to oil it.
View 4 RepliesLexus GS 2006-11 :: Brakes Making Loud Squeaking Noise When Go Into Reverse And Back Up Slowly
I just got a 2009 lexus gs 350 everything is perfect except when i go into reverse and back up slowly the brakes make a loud squeaking noise!! Its really annoying and embarrassing. I got the rotors resurfaced and nothing.
View 3 RepliesGolf V R32 :: Humming Noise That Goes Away When Apply The Brakes
My AM radio has terrible reception. There is humming noise that goes away when I apply the brakes. I will bring it to the dealer, but I know what they will say, "cannot duplicate problem" or "radio operation found to be normal".
View 14 RepliesSanta Fe (CM - 2007-12) :: Steering Wheel Will Shimmy When Apply Brakes At High Speeds
I have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
Nissan - Versa :: 2007 - Buck / Shaky When Driving At Speeds Above 40 Mph And Apply Brakes
I have recently noticed that if I am driving at speeds above 40 mph and apply the brakes, the car (including the steering wheel) seems to buck/shake. I've learned to ease off the gas and let the speed drop before applying the brakes-- this seems to work, but I'm concerned about what is going on. This is an '07 Nissan Versa...
View 7 RepliesLexus RC 2015+ :: Squealing Sound When In Reverse And Apply The Brakes
Not sure if this is a normal characteristics of our Fsport brakes, but when I am in reverse and I apply the brakes I hear a squealing sound. Is that normal? By the way my car just hit 20k miles
View 9 RepliesPassat (B5) :: Constant Noise Just When Apply Brakes In Reverse
I have a dry metal on metal squawk noise when I reverse, I have taken it to a VW dealer, and they say "there is nothing wrong", or that they "cannot find anything". The noise is not constant, just when I apply the brakes in reverse.
View 2 RepliesGolf/GTI VI :: Knocking Noise When Car Started And Apply Brakes
It happens quite often, when i start the car, and apply brakes, then there is some sort of knocking sound coming from the rear. It sounds like someone knocking on the door... But the sound will disappear after a while. The car drives fine, could it be the brakes?
View 2 RepliesLexus RX 2010-15 :: Clicking Sound When Apply Brakes In Reverse At Low Speed
Having this problem on ride, clicking noise when you apply brakes in reverse? ( I had this problem as well on my previous toyota ) it's annoying that I have to hear this sound again. My car is 6 mo old and I just put 5000km so far on my ride, I guess i can let the dealer handle it ?
View 14 RepliesCamry :: Loud Popping Noise When Put Car Into Reverse And Accelerate Then Apply Brakes
I have a 2010 Toyota Camry SE with just under 51,000 miles on it. Every time I put the car into reverse and accelerate to apprx. 2-4 MPH then apply the brakes, I hear a loud popping noise, and it sounds like it is coming from the passenger front wheel. Slight noise from the drivers front as well. This doesn't happen in Drive, only in reverse at a low rate of speed. My father and I have taken the front wheels off and tested it, seems to be a motor mount, curious if this seems rational or common in a newer car.
View 11 RepliesPrius (2010-12) :: When Apply Brakes High Pitched Whirring Noise?
I have had my certified 2010 Prius II, not two because it is a 2010 and 2010 used uppercase roman numerals for model designation, with 82000 miles about 3 months and sometimes when I apply the brakes I hear a high pitched whirring noise. I think the closest thing to compare it to would be a skill saw but not that loud.
View 2 RepliesSanta FE SM (2001-06) :: Faint High-pitched Noise When Apply Brakes
So I've started hearing a faint high-pitched noise when I apply my brakes. It's not EVERY time I apply the brakes, and it's not nearly as loud and annoying as the noise I hear other vehicles make when they need their brakes checked, but it's noticeable.
Also: There's a (possibly related) scratching/rattling noise that just started. I can only hear it with the windows down and it's not very loud. But it happens intermittently when the vehicle is moving or when it's braking, and it makes an almost sputtering sound when I slow to a stop. It will abruptly go silent before I'm fully stopped. Sometimes it cuts in and out, similar to when you've got a short in a speaker wire and the sound cuts in and out.
I'll be getting this checked out. Is this a "drop everything and go to the mechanic" issue, do you think, or more of a "get it looked at when you can"? I should note I haven't had any problems with the car actually braking (yet). It seems to function fine other than the new noises.
Ford Excursion :: 2000 - Popping Noise Coming From Rear End When Apply The Brakes
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 Replies