Ford 6.0L Power Stroke Diesel :: Engine Light On And Code P2285 - Injector Control Pressure Sensor Circuit Low
Engine light came on yesterday and started missing on take offs. Giving code p2285 Injector Control Pressure Sensor Circuit Low. I've done the research and understand the problem. It's the weekend and shops closed until Monday. Is it safe to drive in the mean time? Is there any risk of doing damage? What's the risk of it quitting or failing start in the short term, today?
View 2 RepliesChevy - Silverado :: 1999 - Getting Code PO405 / PO404 EGR Sensor Low Cut?
Ok here is my problem i have a 99 Chevy Silverado LS 1500 5.3L. and i am having problems with egr codes coming up. I have been getting the P0405 EGR Sensor low circuit, i was told that my EGR was bad so i replaced it. ran fine for around 1-2 months and than the code came back on, talked with the guys where i bought it and they said that it could of been a faulty EGR so they replaced it. K so thats 2. 1-2 months down the road again same thing code pops up, talked with them replaced it again, number 3 so it did it again this time when i talked to them again they talked me in on getting the one better than the one i was using before and to buy a gasket with a screen. so thats #4. now today the code pops up again. This time codes P0405 came up and also P0404. oh and i should mention that i replaced the wiring plug also.
View 12 RepliesSilverado :: New Engine Won't Start - Crankshaft Position Sensor Is Out Of Circuit
I have a 2001 Chevy Silverado 4.3L that I recently put a new engine in. The new engine will turn over but will not start. I am not getting any spark for some reason. The OBD2 code that keeps coming up says that the crankshaft position sensor is out of circuit. I have put in a new CKP sensor and new electrical connector, new spark plugs and wires, new distributor rotor and new ignition coil and still get the same OBD2 code and it won't start.
View 2 RepliesSilverado :: Check Engine Light Came On - Mass Air Flow Sensor
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 RepliesSierra :: Fuel Tank Pressure Sensor - Code P0453
I have the code P0453 set and believe I need to replace the fuel tank pressure sensor. I have the part and want to know if this part can be replaced without removing the fuel tank. There is a video on youtube that shows replacing the part by lowering the tank with a transmission jack after the straps have been removed. Replacing the sensor by touch and feel maybe using mirrors to see what you are doing? It might be possible to cut a hole in the bed and patch it later but that seems pretty time consuming too.
View 1 RepliesFord 6.0L Power Stroke Diesel :: Code P0470 Pointing At The Exhaust Pressure Sensor
I have a 2004 6.0 with 75000 miles on it. My truck is throwing a P0470 code pointing at the exhaust pressure sensor. my question is do I need this sensor or can i bypass it? When I look up the part it only shows 2005 and up.
View 6 RepliesSilverado :: 2001 - Service Engine Light On For A Long Time - P0446 Code
I have a 2001 1500 with the 5.3V8 motor (ext. cab sb 4x4 LT). I was my dads and had the service engine light on for a long time for the P0446 code. I replaced the vent valve and the purge valve and light keeps coming back on. Usually can go for a day or so and then it comes back on and I get the same P0446 code.
View 3 RepliesSilverado :: 2003 2500HD - Code P1516 TAC Module / Reduced Engine Power
My truck is an 2003 2500hd with the 6l engine and 89k miles. From time to time I'm getting message "reduced engine power". Usually at the morning after 10-15 minutes after starting. I have to pull over, shut it off, wait few seconds then restart it. The ses light goes off usually by end of the day ( or after few hours ). When scanned by chevy tech showing code P1516 Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance. I have new battery with new main cable. TAC Module was cleaned.
View 14 RepliesSilverado :: Engine Power Randomly Reduce During Driving - P1516 Code Returned
Truck is a 2003 1500HD Silverado with the 6.0L 364V8. Last winter I started getting the P1516 code and reduced engine power randomly during driving. After dealing with it for about a month I did some research and discovered in most cases it was either the wiring/plug or the TAC module itself. After going over the connections I couldn't see any visible breaks..etc but I decided to go ahead and change out the connector and about 6inches of the wiring.
After replacement the code hadn't come back until today, probably atleast 9months ago was the last time it did it. Today the code came on four times during a 10minute drive. Before it would come on once during the drive, i'd clear it with my scan gauge, and it would not do it again the entire day. I checked all my connections once again and everything is intact and there is no visible breaks and the connector is clean. I'm starting to think that it was just a coincidence that this problem quit when I replaced the connector, and was wondering if colder weather could have weight on this issue?
After poking around the posts on here and other sites I found that many ended up replacing the TAC module which is on the throttle body. After looking at mine the only way I can see replacing that is just buying a new throttle body with the TAC on it, can't seem to find just the TAC part by itself anywhere. So if I were to order a new throttle body how hard is it to remove/install? and do I have to do a relearn process or is it plug and play?
Ford Super Duty (1999-2016) :: 2006 F350 Not Starting - Code P2285 - Injector Control Pressure Sensor Circuit Low
I have a 2006 f-350 6.0 and i went to fill up my truck with diesel. After that the truck did not start. Currently has the code p2285 - injector control pressure sensor circuit low. I tried disconnecting sensor, still no start.
I have the torque pro app and another 6.0 that I use for comparison. Check power at ficm 48 volt, flp 11.5v, FVP 11.5v. Hpop while cranking shows 1400 psi. removed oil filter and see low pressure oil ok, fills up reservoir. ipr at crank about 65%. fuel filter full of fuel.
Replaced the dummy plug on passenger side because originally hpop was very low psi 12. after replacement it went up to 1400 on cranking. What should I be looking at next, should I be removing ipr? should i be looking at crank sensor or cam sensor? Just installed 2 new batteries also because my dad kept cranking the truck until it died.
Checked to make sure fuel cut off relay not triggered, Ok. The truck has been having long cranks before it died. Also right now the injector cycling is 10 seconds long while on my other 6.0 it is about 4.
Toyota - T100 :: Check Engine Light On Due To Faulty Emission Evap Control Pressure Sensor
Engine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 RepliesChevrolet - Silverado :: 2005 - No Oil Pressure?
I am sure some of us have heard and read the no oil pressure situation. i had it happen to me and I replaced the oil pump and pick up tube all new oe gaskets with the replacement. i still have the same problem. No oil pressure and the tick sound.
View 3 RepliesVolvo :: Check Engine Light Due To O2 Sensor Is Bad - OBD Code P0455?
2004 XC90 T6. Local Volvo dealer (Bangkok at the time) said my check engine light was due to the O2 sensors going bad. I changed out the one under the car, then my wife threw out (accident) the other so I didn't change the one accessible from the hood. The check engine light went away so I figured that was that.
Fast forward a year later, I buy an Autel Maxiscan MS509 and now I'm getting check engine code P0455 which is probably the O2 sensors I didn't replace. Other than deductive reasoning, is there some way to look at the data on my OBD reader to confirm which O2 sensor is bad?
Santa FE SM (2001-06) :: P0103 Engine Light Code For MAF Sensor
I have an 2004 Santa Fe and im having some Mass Air Flow Sensor problems but I dont know what's wrong. My engine light came on for the second time after awhile. And I got it checked for the code and of course it was my sensor again. The first time I just giggled it around and the light went off. I did the same thing today with giggling it again went off. So I feel like it might be a loose connection but I really hope it isn't failing because im pretty sure that's uber expensive to fix.
View 2 RepliesGTI 337/20th Anniversary :: Code PO322 - Engine Speed Sensor
I drive an 05 Gli n my car has been shutting off on me took it for a diagnostic n the code po322 came up engine speed sensor. So my question is. Is their a DIY on replacing the sensor I'm picking it up tomorrow. To be honest I don't even know where the sensor is located...
View 8 RepliesSilverado :: 1998 - Pertaining To Steering Stabilizer Sensor
I've read some past posts pertaining to the steering stabilizer sensor and from what I've gathered I would say that I have the same problem. I got under the dash to see where the sensor is and could not find it. Someone said that you could disengage the electrical plug on the steering pump and that would rememdy the situation until you could replace the sensor with a new one. I could not find an electrical connection on the PS pump either. Would this suggest that I do not have a sensor to start with?
View 12 RepliesSilverado :: Fuel Pressure Range For 1999 5.3L
What the fuel pressure range should be for a 1999 5.3L?
View 10 RepliesPassat (B5) :: P0171 Engine Code - Mass Airflow Sensor Failed?
I've been getting this error code recently ("Fuel Trim,Bank1 System too Lean"). I have a Scanguage, which let me get the error code, and I used it to reset the message - it came back about a week later. I took it to a local repair shop after the second time, but as I'd already cleared the message, he couldn't do anything. It came back about a week later, and this time I took the vehicle in as soon as the yellow light showed up (without connecting the Scanguage).
The mechanic said that he found both P0171 and P0172, and that the problem was a loose vacuum hose AND a failing Mass Airlow Sensor. They reattached the hose and cleaned the sensor, but said that the latter fix may not last - the light came back on two days later. I took it in again (this time, checking the codes, and found only P0171) and he said this confirms the problem with the sensor and he'll have to replace it ($280 for the part, plus labor, less a discount on the labor equivalent to the labor he put in to clean the sensor.)
Lexus RX 2004-09 :: Check Engine And VSC Lights Come On - O2 Sensor Code P0157
went to have an oil change. Standard procedure. Wife drives the 330 away and the check engine and VSC lights come on. I figure it's the maintenance indicator needing reset, but no..... the reset didn't work. Went back to my local mechanic who changed the oil to run codes and see what the problem is. Code P0157 = bad O2 sensor.
Now, I questioned him as to why these lights would come on DIRECTLY after they changed my oil. Is there any correlation there? NO, he says. No reason why these lights would come on immediately after the oil change and we've never seen these two lights come on at the same time before.
I've read every post and thread I can, but it seems like every issue is different. Some times it's a loose gas cap or gas cap that needs replacing. I have to drive 60 miles to the dealer some time soon to have a recall performed, but until then should I worry about this O2 sensor and these lights staying on?