Prius (2004-09) :: Freon Leak At Schrader Valve
I had my a/c recharged in April and it was blowing hot again by July. I brought it back in today and they told me that it is leaking out of the Schrader valve on the low pressure side. They told me that they would have to replace the entire line which would cost a few hundred just in parts. Why can't they just replace the valve. The tried calling auto stores for a special part, but could not find one. How to seal or repair just the leaking Schrader valve and not the entire line?
View 8 RepliesFord A/C :: 2006 F250 - High Side Service Port Schrader Valve Leaking
I have a 2006 F-250 6.0 diesel. The high side service port schrader valve is leaking. Currently there is a charge on the system but its low. I planned on evac-ing the system, replace the cores and refill until i came across this valve remove/replacement tool from MasterCool. The only problem i have is not knowing whether or not this tool fits the valve cores I have. I see already that the high side is quite a large core. I cant even find a core removal tool at local auto parts stores to fit. What size my valve cores are or if the following would fit both high and low sides?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Tool For Replacement Of Injector Cup?
Rebuilding my 7.3 and I'm in need of the removal and install tool for the injector sleeves/cups for the 7.3 Powerstroke Diesel.
I'll pay all shipping charges and a small fee if required. I hate purchasing a tool I'll never need again, rather better not need.
Saturn :: New EVAP Purge Valve And Clicking Noise
I have a 2001 saturn l200 2.2... Well I put the new EVAP Purge Valve in last night.. Today I start the car and started to clicking so I unplug the new EVAP Purge Valve and it stop clicking and i plug it back in and started clicking..
View 6 RepliesSaturn - Vue :: VT25E CVT Transmission - Belt Replacement On Variator
How to put the belt on the variator, 2004 Vue VT25E CVT Transmission??
View 3 RepliesCamry :: 2002 V6 - PVC Valve Replacement On 1MZ Engine
I have the 2002 V6 camry and I want to replace the PVC valve. I read through the FYI/stickies, and I can see exactly how to do it on the 4 cylinder engine, are there any instructions for the 6 cylinder engine, I just want to make sure I do the right thing?
View 14 RepliesSonata NF (2006-10) :: PCV Valve Location And Replacement
Changed my oil today and check the air filter. I noticed that there is oil on the air filter, so I'm thinking the PCV valve is bad (car has 136,000 miles). I want to check it but I'm not sure where it's located. Where it's located (pictures would be great) and how involved it is to replace?
View 4 RepliesPrius (2004-09) :: CEL For P1121 / Valve Replacement?
I have a 2004 toyota Prius with 185k miles on it and recently got the CEL for P1121. I checked both coolants and turns out that the engine coolant was completely out. I immediately filled it up and the CEL went off for a couple days. It has come back and is on constantly, I checked the coolant and the coolant is at the correct level.
View 19 RepliesSaturn - S-series :: Maintenance And Repair - Ignition Lock Replacement
Do I need to do anything other than disconnect the battery to disable the airbags on this car so I can replace the ignition lock?
View 30 RepliesCamry :: Valve Cover Gasket Replacement On 2006 V6
So I'll be taking on a project to replace the valve cover gasket on my 2002 Camry V6. There's a bit of leakage through the gasket. And while I'm at it, I'll replace the spark plugs as well. I'm looking for a write up on this project. did a lot of searching but couldn't find anything.
View 14 RepliesCorolla / Matrix 2009-13 :: PCV Valve Rattling After Replacement
I replaced the PCV valve (with OEM). The old one looked dirty, but still rattled when I shake it. However, now with the engine at idle, I can hear a metallic clicking coming from the area of the new PCV valve. It's difficult to verify, because it's behind the intake manifold, but since I just replaced the PCV valve, what else could it be? The clicking also seems to sync up with the engine cycling..
My corolla has been burning 2 quarts of oil every 5000 miles since 80k miles. It's at 100k now. I guess worst case is there's a broken valve seal and I'm getting high pressure in the crank case. I also heard it could be a vacuum leak. I'm going to try and check the vacuum pressure, but is there anything else that I should be looking for?
I rigged a gauge from a brake bleeder pump into a tee in the vacuum booster line and it ran pretty steady at 20Hg. Accelerated a little and it hit 25Hg and came back down. It flutters a little at around 1 Hg, but I'm wondering if my vacuum rig is a bit leaky itself.
Here's a recording of the clicking: [URL] ....
Santa FE SM (2001-06) :: Valve Cover Gasket Replacement
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 RepliesAccent MC (2006-11) :: Purge Control Valve Replacement In GLS
My 06 accent GLS has become difficult to start only after refueling, which I'm guessing is related to a bad purge control valve from what I've read. Where exactly is the valve located, and is this something that someone with relatively little automotive repair experience could do on their own? I think I've located it on the backside of the engine near the air intake.
View 2 RepliesInfiniti - G35 :: 2006 - Valve Cover And Gaskets Replacement
I have a 2006 Infiniti G35 base sedan. The dealer noticed oil on the engine and said that I needed to replace both valve covers and gaskets -- My question: Why is it necessary to replace the valve covers and not just the gaskets?
View 6 RepliesAvalon 2005-12 :: Valve Cover Gasket Replacement
A few days ago I noticed some oil leaking from the left (front) valve cover area and I suspect it's the gasket. Fortunately, I didn't see any leaks from the back cover. It seemed like an easy job to replace the gasket, but as I started to disconnect the wiring, e.g., cam sensor, spark plugs, etc., I can't seem to find a way to remove the black plastic wiring harness 'housing' out of the way.
View 1 RepliesGolf IV / Jetta IV :: Heater Control Valve Replacement
Replacing a heater control valve for a 2004 Jetta? My car's vents only blow hot, and I checked the cables and saw that the control arm was disconnected. I tried to put the cylinder piece back in and had some luck, but I can't get it to sit tightly in there and it keeps falling out. Also, it still wont change the temperature coming out of the vents. I assume that something broke on the inside piece that the cylinder connected to.
[URL] ......
Here is an example of what mine kind of looks like, but mine is way more loose.
Ford Aerostar :: Replacement Of Proportioning Combo Valve?
cant drive 96aero cause cant find a proportioning combo valve.
View 5 RepliesFord Ranger / B-Series :: 2.8L V6 Valve Stem Replacement?
I have a 1984 ranger with the 2.8L and I am doing the valve stem oil seals.
I have instructions from the ranger station. And I have access to mitchell1 and chilton online.
Also I read somewhere about better settings to use for valve lash? The truck has about 80,000 miles on it.
Prius (Gen 2) :: 2004 - Red Triangle After Coolant Control Valve Replacement
2004 Prius, 98K miles ... I recently replaced the coolant control valve (received code P1121) and added coolant. Trouble codes were cleared. I am now getting the red triangle intermittently. When I drive the car, after a few minutes, the red triangle comes on. I can shut off the car, and turn it back on, and the red triangle comes back after a few minutes. The car seems to drive normally.
View 3 Replies