Santa Fe (CM - 2007-12) :: Signal Lights Stop Flashing
I am having an issue with the turn signals on my 2010 Santa Fe. When changing lanes to the right and moving the turn signal lever up slightly, the turn signals activate normally. However, when releasing the lever, the signal lights stop flashing (as they should), but the flasher clicks at a rapid rate and won't stop. I have to jiggle the turn signal lever to get it to stop clicking. I have checked all lights and the bulbs are fine.
View 5 RepliesSanta Fe (CM - 2007-12) :: Turn Signal Has Not Been Working
2007 Santa Fe. Recently my turn signal has not been working. It seems to act finicky and not want to work every time I need it too. I noticed that this happened once every blue moon in the winter time when I purchased the vehicle new back in '07. However it has been occurring more frequently as of the past 3 days.
I have checked the fuse and it is fine. My hazard signals work when my turn signal works if that is any additional indication of what might be going on. What can be done to remedy the situation?
Santa Fe (CM - 2007-12) :: Turn Signal Relay Replacement?
I've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
Santa Fe (CM - 2007-12) :: Fast Blinker Going On With The Left Turn Signal
My wife's '07 has that fast-blink thing going on with the left turn signal. The thing is, none of the bulbs are out. It does appear that the front ones are dimmer than the ones on the right (which work fine).
View 8 RepliesSanta Fe (CM - 2007-12) :: Right Turn Signal And Bulbs On Steady All The Time
I'm trying to figure out what has failed on my 2008 Santa Fe.
After stopping at a gas station today, my right turn signal came on and stayed on. By this I mean that the right turn arrow on the dash is illuminated and both the front and rear right turn signal bulbs are illuminated. They are all on steady, not flashing. Moving the turn signal stalk/switch does nothing. They all stay on when the car is turned off and the key removed. I have to disconnect the battery to get them to shut off. I tried pulling the turn signal, hazard and cluster fuses in the dash, but they had no effect. The switch for headlamps/park lights has no effect on the right side bulbs.
The left turn signal works normally.
Also, it may be related to having unplugged the battery a couple of times, but now the CD player shows "initializing" and I can't use it. The am/fm stereo works normally.
Santa Fe (CM - 2007-12) :: 2008 - Turn Signal Relay Location
I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
Pontiac - Grandam :: 2002 - Turn Signal Noise Will Not Stop
The turn signal noise in the hazard light terminal will not shut off. Should the terminal be replaced or is it some other electrical issue? 2002 Grand Am
View 4 RepliesSanta Fe (CM - 2007-12) :: Turn Signal Light Bulbs Flash Rapidly Both In Front And Rear
My 2007 Hyundai Santa Fe right hand turn signal light bulbs flash rapidly both in the front and rear, the left hand side is normal. I am trying to locate the turn signal flasher module but without any luck, looked under the dash in the fuse box and under the hood in the relay box. Is it in the relay box...
View 7 RepliesFord Wiring/Electrical :: 1972 F250 - Signal Stop Blinking When Put The Left Turn Signal On And Apply Brakes
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 RepliesSanta Fe (DM - 2013+) :: Driver Side HID Headlight Turn Off After Putting Turn Signal On
I was on the way home tonight and I noticed the driver side HID headlight turn off after putting my turn signal on.
I have LED DRL fog lights installed and they're wired with no relay and plugged into the Engine Compartment fuse box. The installer connected them on the left side (where the wires come in, from the two black components by the air filter).
Could this wiring setup be interfering with the HID's?
Santa Fe (CM - 2007-12) :: Humming Noise On Decelerating From 20mph Down To A Stop Or From A Stop Up To 20mph
Started hearing a weird humming noise (not the usual hyundai hum in the front passenger side) coming from the front when decelerating from approximately 20mph down to a stop or from a stop up to 20mph. Went to a shop and ruled out wheel bearings, brakes, rotation, alignment, etc. Noise stopped.
Couple weeks later noticed physical resistance and upon accelerating to about 40mph it felt like I had a flat tire. That bumping, vibrating, shuddering feeling. No flat tire. Physical resistance, not power. Came and went in severity depending on terrain and speed. Brought it to a 2nd shop because the first was closed. The guy found codes that indicated the anti-lock brake system had failed. Said it should be covered under warranty and I should go to dealer.
Dealer replaced a brake switch (which has been recalled and was replaced before) and an inhibitor switch. They assessed the brakes too.
Car drives fine for a week and suddenly the brakes are screeching and we can't reverse out of a parking spot like the car is stuck on a snow mound but isnt. Rock it- in and out of forward and reverse to get out. We test it putting it in reverse again and car slams to a stop. When the car was pulled up on the tow truck we noticed only the rear driver tire didn't spin-locked up.
Dealer says no computer codes and that they just had to "adjust" the brake switch they had replaced. Drove home fine. Next day and for these next few days-something is still wrong. Physical resistance, not power. Cracking/popping noises when braking.
Santa Fe (DM - 2013+) :: LED Turn Signal Resistor Install
I could not find a picture of the 2013+ SFS headlight harness connector. I'm trying to wire a 6 ohm resistor across the turn signal as my LED upgrade is causing the fast flash problem(I expected this). The only place I can tap into that circuit is probably the headlight harness, preferably through the connector. I tried to measure the voltage on the connector, but the contact is too small and narrow for the probe to make physical contact. I even tried to put a cutout paper clip into those tiny holes, but still no dice. The wire colors are different between driver and passenger side, and the Sonata forum was indicating it is the top right corner for the positive lead of the turn signal. Which wire is the + & - for the turn signal.
View 14 RepliesSanta FE SM (2001-06) :: Turn Signal Malfunction When Headlights Are On
2004 Santa Fe 2.7L
When the headlights are on the left turn signal stays on(but does not blink). The right turn signal functions ok. With the headlights off both signals function normally. The headlights work correctly.
This issue happened once a year ago but just started reoccurring two days ago.
Passat (B5) :: Turn Signal Relay Work Sometimes For A Few Clicks But Then Stop Working
The turn signal lights in my brother's 2000 passat are staying lit when he turns the signals on. They work sometimes, for a few clicks, but then stop working.
1. is it the turn signal relay. It sounds like its in the middle of the dash.
2. how do you get to that relay?
Have to remove the HVAC controls? if so, how the heck do you do it?
[URL] ....
Ford 6.7L Power Stroke Diesel :: Turn Signal Won't Stop Automatically After Turning?
All of a sudden, my turn signal won't stop automatically after making a turn. I read that the multi function lever needed to be replaced. I did, and nothing changed... what is wrong since its not the lever assembly itself?
View 6 RepliesFord Super Duty (1999-2016) :: 2004 F350 - No Stop / Turn Signal?
2004 F350 6.0 Diesel 2WD, Question is my trailor lights running lights work fine also the electric brake, but i have no stop or right or left turn signals the truck signals are all working perfect. The truck came with factory wiring i have checked it at the plug on the bumper with meter to make sure it was not the trailor. Looked for blown fuses and cant find anything what am i missing it should have seperate fuses for trailor lights ??
View 14 RepliesSanta Fe (DM - 2013+) :: Turn Signal Light On The Passenger Side And Mirror Staying On?
I noticed the turn signal light on the passenger side and mirror staying on. Wether it's started or off. Locked or unlocked. Don't know what the issues could be. Front one not on though
At the dealer now. I have 600 miles on it so I'm assuming it will be warranty covered.
Ford Ranger / B-Series :: 1998 - Turn Signal Flashes Intermittently Then Stop - Indicator Flasher SF631 Location?
So with 172,000 miles my truck has started a new trick. When I turn on the turn signals theyll flash or interrupt normally for a few times then stop. After I turn the signal lever off and back on again they start to flash again only to stop after several times. This happens to both the left and right hand sides. The emergency flashers seem to work alright. Is this a function of the indicator flasher SF631? If so, were exactly is it located?
View 5 RepliesSanta Fe (CM - 2007-12) :: Sensors In Gas Pedal Sending Bad Signal To Throttle Which Burned Out The Actuator
My wife's 07 Santa Fe goes into limp mode while she's on the freeway. Had it towed to a mechanic. They report codes were: 0101, 0102, 1295, 2105, 2106, 2173. They said the sensors in the gas pedal were sending bad signal to throttle which burned out the actuator. So they wanted to replace throttle body and gas pedal sensors. They wanted $895.
Didn't seem right, so towed it to dealer. They said the first mechs were just guessing. Only the throttle body needs replacing. They wanted $960 total.
I bought a used throttle body off another 07 SF with similar vin number to avoid needing the ecm to be reprogrammed. Cost $225.
Couldn't find procedure for replacement in my pdf shop manual. Seems like this should be simple though. Anything special I need to know? Am I on the right track?