Santa Fe (CM - 2007-12) :: Cruise Control Not Working - Brake Light Fuse Blown
I have to press Cancel before I can get my cruise control to work. I had a problem about a year ago where my cruise control wasn't working, and found out that a blown brake light fuse was the problem. Now I turn my CC on and the "Cruise" light comes on, I then press the set button, and nothing. I then press the cancel button and then the set button and then the "Set" light comes on.
View 2 RepliesSanta Fe (CM - 2007-12) :: AC Blowing Fuse And Check Engine Light Code P0441
Have 2 problems that are giving me major problems.....especially with 100 degree heat in Dallas.
1. Ac stopped blowing cold last night out of blue. Still blows just not cold. Replaced bad fuse and drove for 5 minutes. Blew again. Checked out the control/ circuit board but looks ok. Really cant afford dealer.
2. Check engine light problem for months. Gas gauge wasn't working. Replaced fuel sending units and it fixed that but still light. Code says p441. Dealer said need solenoid valve. Replaced both the solenoid valve and the purge control valve. Still check engine light.
Camry :: 2009 - Rear Brake Light Blew Out - No Warning On Dashboard
I have a 2009 Camry LE. My right rear brake light blew out, but no warning light seems to pop up on the dashboard. I only realized the brake light went out when someone pointed it out to me. How can you tell that the brake light blew out? (I checked the manual but didn't find anything)...
View 4 RepliesSanta Fe (CM - 2007-12) :: Moisture In Brake Light
Have a 2012 Santa Fe, I originally bought brand new off the lot and now Ive noticed moisture in the brake light. Is something of this nature typically covered under warranty?
View 4 RepliesSanta Fe (CM - 2007-12) :: Right Brake Light Does Not Work All The Time
I have a 2007 Santa Fe 3.3L v6 and the right brake light doesn't work all the time. When the vehicle is parked ignition on motor off the light works. Yet when driving I have been told my right brake light is out. I read that the turn signal switch assembly could be the problem.
View 4 RepliesFord F-150 (2004-2008) :: Alternator And Fuse 23 Blew - 13 Diagnostic Error Codes
Within three days the alternator and fuse #23 blew. After replacing these and the fuel filter (because of stalling during acceleration), I took it for a diagnostic check at O'Reileys because the stalling while accelerating worsened, it wasn't shifting correctly and the O/D light began flashing on the shifter. It hit on these 13 error codes:
P7055
P0446
P0750
P0443
P0743
P0135
P0141
P0155
P0161
P2195
P2197
P0423
P1747
I have researched each code (definitions, what to examine/test, and the locaton of each part). My question is that with this many hits is it most likely a problem with the PCM, or should I just proceed with checking each connection, wiring and solenoid individually? The EGR Valve tested fine and the alternator is pushing 14.6 v...
Ford Wiring/Electrical :: 1990 F150 - Turn Signal Fuse Blew?
I have a 1990 f-150 that periodically (and rapidly) blows the fuse for the turn signals. The brake/tail lights continue to work, but just the turn signals quits. Looking for a schematic of those systems?
View 1 RepliesFord F-150 (2009-2014) :: Installing HIDs Headlight Fuse Blew - Now Battery Reads 11.9V?
In an attempt to install HIDs on my 2013 f150 screw 4x4 I hated them and I broke my truck. I blew a fuse for the left headlight which I replaced.
My battery now reads 11.9v, I have no dash or radio lights and my truck won't even attempt to start. I can't exit park either. My door locks inside the vehicle work but my remote is useless. My headlights and dome lights work but that's it light wise.
Is my battery just too low and needs to be "reset"? If not my battery does it sound like a main relay or the body control module or similar?
Santa Fe (CM - 2007-12) :: Air Conditioner Fuse Keeps Blowing
I have a 07' hyundai santa fe and recently I had a 10 amp fuse blow labeled A/CON and so I replaced it and it worked for about 2-3 weeks and it blew again, and so I'm getting more fuses Monday to see if it keeps working, but from what I read online it looks like the field coil is the culprit, I tried to read the ohms from the relay and got .5 kohms (which I see its supposed to be 3-4ohms) but i have a crappy multimeter and I'm not sure if that's right anyway.
View 8 RepliesSanta Fe (CM - 2007-12) :: 2010 - BCM 1 Fuse Keeps Blowing
My 2010 Sante Fe started blowing the BCM 1 fuse.The vehicle will not even crank over. Its at the dealer for the 3rd time time this week. 1st time thought it was a faulty fuse, 2nd time replaced the drivers door lock actuator.
View 1 RepliesSanta Fe (CM - 2007-12) :: Horn Fuse Burned In Hood Relay Box
Just noticed I have no more horn... I had car alarm issues for a while and the alarm would sound all day in the parking garage while I was at work (was keeping the car unlocked at home...) Finally fixed the hood pin.
Going back to the horn, the horn fuse was burned in the hood relay box, and when I replaced it and tried the horn again, it burned again... Where to start? Do I go for new relays, new horns, new wiring or all of the above...
Santa FE SM (2001-06) :: Blown ECU Fuse And Engine Light On
A few years back, we had the unfortunate luck of have the Crank Position Sensor fail in our 2004 Sante Fe. The sensor failed again 2 years later. Most recently, it broke down again, and acted the same as it did when the CPS went....upon deceleration and braking, it lost power and began to chug before it finally shut off. This time, the ECU 20 amp fuse blew, and the engine light came on.
It had been raining heavily the day prior, so we thought that the ECU or harness got wet. It sat for a few days, and when we started it with the new fuse, it ran just fine, with the exception of the engine light remaining on. Wife drove it to work tonight, and the fuse popped again. Given that the engine light is on, could the failure be due to an emissions control sensor or it's wiring shorting out?
Toyota - Camry :: No Brake Light - Fuse Spark And Blown
I have a 1996 camry and the break light don't come on non of them. I change the switch under the break pedal and it didn't work. I change the fuse but when I did so it spark and blew the fuse. Is there a reason for this? where should i go next with this issue.
View 1 RepliesFord Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Right Brake Light Out - Fuse Diagram?
I was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 RepliesElectrical-wiring - Brakes - Suzuki - Grandvitara :: 2001 - Brake Light Fuse Keeps Blowing
I'm having brake light issues with a 2001 Suzuki Grand Vitara. The brake light fuse keeps blowing. The last time driven with me following the driver side brake light was dimmer than the passenger side. At one stop the driver side brake light pulsed brighter for a split second then went back to dim. A few stops later it became as bright as the passenger side and stayed that way for the rest of the trip. The driver put in a breaker fuse and it was in during the observed trip. I'm not sure of the brake light visual symptoms without the breaker fuse in other than that the fuse keeps blowing which prevents the vehicle from being shifted out of park. What the problem could be? Bad ground?
View 4 RepliesCamry :: 2007 - Installing Remote Starter / Parking Light Fuse Or Wire
Im currently installing a remote starter on my 07 camry and it wants me to tie into the "parking light" fuse or wire. It is a Bulldog system, on the website it describes it as "Black (-) wire" located at "BodyECU in vehicle fuse box 26 pin plug pin 23" The fuse box cover does not identify fuses by number and i do not see anything that looks to be parking light related.
View 1 RepliesSanta Fe (CM - 2007-12) :: Hand Brake Not Releasing / Crunching Sound?
I've got a 2011 santer fe auto with a foot hand brake. i park the car on my drive which is on a slight incline, when i put it in reverse and then release the hand brake there is a crunching sound and the rear offside wheel locks. It eventually releases after a number of revolutions but it sounds very mechanical clunky.
View 5 RepliesSanta Fe (CM - 2007-12) :: Large Puddle Of Brake Fluid On Ground
Wife came home and said that her brake peddle went to the floor once. Truck is in the garage with a large leak of brake fluid on the ground. I ordered a new MC but not sure this is the issue. There is fluid on only the right side of the booster, all associated brake hoses and lines going into the ABS module. The module also has lots of brake fluid all over it. Looks like there has been a leak for a while. Only one flare nut coming from the MC was some what loose (I gave it about a quarter turn and it's tight now.
Booster has some rust on the front of it near the center of the MC bolt locations. Before I put this new MC on I want to be sure this is the issue. Do the ABS modules tend to leak OUT when they are failing? I see that's a common issue with the Hyundai but I don't see anything about fluid leaks externally.
The truck has about 180k miles on it. I was thinking of cleaning everything up the best I can adding some fluid and running it to see where the leak is coming from...