Santa Fe (CM - 2007-12) :: Air Conditioner Fuse Keeps Blowing
I have a 07' hyundai santa fe and recently I had a 10 amp fuse blow labeled A/CON and so I replaced it and it worked for about 2-3 weeks and it blew again, and so I'm getting more fuses Monday to see if it keeps working, but from what I read online it looks like the field coil is the culprit, I tried to read the ohms from the relay and got .5 kohms (which I see its supposed to be 3-4ohms) but i have a crappy multimeter and I'm not sure if that's right anyway.
View 8 RepliesSanta Fe (CM - 2007-12) :: AC Blowing Fuse And Check Engine Light Code P0441
Have 2 problems that are giving me major problems.....especially with 100 degree heat in Dallas.
1. Ac stopped blowing cold last night out of blue. Still blows just not cold. Replaced bad fuse and drove for 5 minutes. Blew again. Checked out the control/ circuit board but looks ok. Really cant afford dealer.
2. Check engine light problem for months. Gas gauge wasn't working. Replaced fuel sending units and it fixed that but still light. Code says p441. Dealer said need solenoid valve. Replaced both the solenoid valve and the purge control valve. Still check engine light.
Santa FE SM (2001-06) :: 2004 - ECU Fuse Under The Hood Keeps Blowing When Ignition Turned On
I have a 2004 Hyundai Sante Fe 2.4L that keeps blowing the ECU fuse under the hood when the ignition is turned on. We have replace the fuel pump and the inertia switch. I have tested the relay, ignition failure sensor, both coils and O2 sensor wiring.
View 10 RepliesToyota :: 2007 - 40 AMP Fuse Keeps Blowing Out
2007 FJ Cruiser, 4WD, 65K Miles. I replaced the 120 AMP Fuse. Starts, everything seems to work, but the 40 AMP Fuse (ABS Motor) is blown. New fuses blow as soon as I place them in. Brakes pedal has little resistance and can barely stop the vehicle at slow speeds.
What will stop the 40 amp ABS fuse from blowing?
Prius (2010-12) :: Fog Light Fuse Keeps Blowing Out?
I've had the PC Shop fog light kit for about a year now along with a 35w HID kit. Was working fine for about a year and they stopped working. I checked the 20A fuse and it was blown. Replaced it, and immediately blows again as soon as I turn on the fog lights. Tried again with 15A, 25A and 30A, same thing. Perhaps coincidence, but the kit initially stopped working after a rainy day but I've driven my car through rain and snow in the past without issues. The HID ballasts are mounted 2ft off the ground and are waterproof.
View 1 RepliesPrius (2010-12) :: 2011 - Fuse 29 Keep Blowing
I have a 2011 Prius 3 and it keeps blowing fuse 29, its the fuse for the dome lights and then the dome lights don't work and the traction control light stays on. Why this fuse keeps blowing?
View 19 RepliesFord - Focus :: 2007 Keep Blowing 10amp Fuse
My 2007 Focus wagon keep blowing (#30) 10amp fuse. It is connected to the tail lights (when the lights are on), the license plate light, and dashboard lights. I think it is related to moisture as it is worse (keeps blowing the fuse) after a rain. I've checked the taillights and there isn't any moisture there (although when I first found this, both taillight housings were pretty melted). Where to look for the short? Some other discussion groups listed different harnesses, but which one...I have the sinking feeling this is going to be impossible to find (or REALLY expensive)
View 1 RepliesLexus RX 2010-15 :: No Volume Controls / AMP1 Fuse Keeps Blowing
I have no volume or voice command button. Also the amp1 fuse keeps blowing right away. Would a blown amp keep the voice command button from working?
View 5 RepliesPrius (2010-12) :: 2014 - Power Outlet Fuse Keeps Blowing
I have owned my Prius three, not III, for just over 2 years now. The first year I had no issue but now, when charging my iPhone 6, the fuse blows every 2-4 weeks. (My phone is the ONLY thing I ever plug in there). I finally tried replacing the 15amp fuse with a 20amp (I know, that's a no no). But I still blew the 20amp fuse now.
View 16 RepliesPrius (2004-09) :: 2007 - Signals Weren't Working / Gauge Fuse Blowing?
We bought this car a month ago, 2007 US touring model. It had a 15A fuse in the Gauge position (spec calls for 10A there) when we bought it. As of last week it is blowing a lot.
What we've noticed:
- First time it happened I noticed my signals weren't working. After 5 minutes of driving I pulled over and turned the car off and on. At that point the Combination Meter went blank. After getting home I found the fuse blown. Replaced it with a 10A fuse, and that blew right away when starting the car. Replaced it with a 15A fuse and it worked for a few trips.
- While I was away for a week, my wife replaced the fuse 3 times while it blew away from home. (she estimates every third trip) She has found it seems to happen when putting the car in reverse.
- Today the car is working fine, and I can't replicate the problem.
Ford - Explorer :: 2007 - Horn Fuse Keeps Blowing - Ground Cable Origin?
My father is having electrical issues and I'm hoping this is the cause. Where this ground cable originates from?
He replaced the battery last week after vehicle would not start. Noticed he blew a radio fuse but nothing else until yesterday. Major issues of all instruments, ac, windows, etc going out. Unable to start vehicle without jump.Had a error code B1676. So today we switched the battery, all is good (for now) except for horn fuse that keeps blowing.
It's a 2007 ford explorer 2wd v6
Prius (2010-12) :: Tail / License And Rear Turn Signal Lights Not Working - Fuse Blowing
This issue came on suddenly. I unplugged the license plate lights- fuse still blew. I don't know where the wire harness is for this group of wires going to these lights to check for frayed or melted wires. I don't see any damage any where. I am severely limited for funds for a mechanic so I need to try and figure this out first myself. Looking for pictures of how I can traces the wires through the car?
View 1 RepliesSanta Fe (CM - 2007-12) :: The Brake Light Fuse Blew Out
I have a Santa Fe 2001 and I towed a trailer today. It was fine at first but when we were trying to position the trailer at the destination the brake light fuse blew which meant the gear stick would not move. Figured out how to start the car again and used the shift lock release to move into drive to get the car off the road. I had to keep pushing that shift lock release button in to change the gears. I had the RACV guy come and change the blown fuse for me, and brake lights are fine now and the car starts, however the gear stick is still playing up. It went ok from park to drive, but then on the way back to park it got stuck at Neutral. Then had to use release again. Checked the fuse and brake lights, all is good there. What could be causing the gear stick to get stuck now? RACV guy couldn't understand why, he said replacing the fuse usually solves the problem.
View 1 RepliesSanta Fe (CM - 2007-12) :: Horn Fuse Burned In Hood Relay Box
Just noticed I have no more horn... I had car alarm issues for a while and the alarm would sound all day in the parking garage while I was at work (was keeping the car unlocked at home...) Finally fixed the hood pin.
Going back to the horn, the horn fuse was burned in the hood relay box, and when I replaced it and tried the horn again, it burned again... Where to start? Do I go for new relays, new horns, new wiring or all of the above...
Santa Fe (CM - 2007-12) :: A/C Malfunction - Blowing Hot Air
However, selecting Mode setting to the floor on the climate control build (as I read) does not seem to turn off the AC from running to off with outside air only. Also, the OFF button does stop everything but once the fan speed is turned up its cold air blowing.
I read through the entire section in the owners manual and there is nothing mentioning it will run if AC is not selected nor any other over ride procedure. I am thinking this is a unique SF Limited issue and solutions for other models don't hold true for me. With the temperature much hotter its not difficult to feel the difference blowing out the vents.
Santa Fe (CM - 2007-12) :: Cruise Control Not Working - Brake Light Fuse Blown
I have to press Cancel before I can get my cruise control to work. I had a problem about a year ago where my cruise control wasn't working, and found out that a blown brake light fuse was the problem. Now I turn my CC on and the "Cruise" light comes on, I then press the set button, and nothing. I then press the cancel button and then the set button and then the "Set" light comes on.
View 2 RepliesSanta Fe (CM - 2007-12) :: AC Blowing Mild Cold Air
I have a 2007 3.3 with 42K miles on it and the AC just started passing air that's not quite as cold as it used to be. When its at idle I would say its a mild cold and then when driving its the same mild cold but with more force. Understandably today is really the first hot, humid day of many to come so I was wondering is there any good indication that its just low freon with a leak or the compressor is going or is there any adjustment to the belt in case its just slipping? I did it drive it for quite awhile and it never improved. I would hate to drive it more and ask for a bigger problem.
View 2 RepliesSanta Fe (CM - 2007-12) :: AC / Heater - Blower Stopped Blowing Air
My 2009 Santa Fe GLS a/c, heater, etc. blower has stopped blowing air. I have checked the fuses, did the push test on the air adjustment button but nothing has worked. Sometimes it's like I can feel a VERY SMALL amount of air blowing out the vents.
View 3 RepliesSanta Fe (CM - 2007-12) :: Heater Blowing Luke Warm Air
I have a SF 2009 Limited. Since I bought it 2 years ago, I noticed the heater blows luke warm air. Not hot. It takes 20min for the cabin to reach 22degC when it's only 0 outside.
It was like that when brand new.
It has the auto temp control, so it might be playing tricks on me but I don't think so.
I am tempted to find the pipe feeding the heater radiator and insulate the pipes. Maybe the heater only gets warm liquid.
What else can I do?