Santa Fe (CM - 2007-12) :: Front Tire / Wheel Noise
My wife has a 2010 Santa Fe with AWD and 40,000 miles on it, and my daughter has a 2008 AWD with 38,000. I don’t drive my wife’s car much but after taking it on a trip I noticed that the front wheels/tires seemed louder than normal, exactly like a bad wheel bearing or when you are running snow tires. I had the tires balanced and inspected and took the car to the dealer sure that there was a front wheel bearing going out but they said it was fine. A week later I was driving my daughter’s 2008, same noise. Tires on both cars are fairly new and don’t appear to have any problems. So, is this common to these cars and considered normal?
View 2 RepliesSanta Fe (CM - 2007-12) :: Clunk Noise From Front Left Tire Area
I got a few clunk noise from front left tire area. I think it happens when I turn my steering wheel to left almost max.
And then, turning back to straight(to right). then, "Clunk"!
Today I got the clunk when I made U-turn on a street. A month ago, I heard it when I parked with fully turned front tires.
Santa Fe (CM - 2007-12) :: Tire Wear - Bobbling / Shuddering Front End
I just bought a used 2007 Santa Fe Limited. It has 78,000 miles on it. I have gone bumper to bumper looking for problems and am pretty happy about the condition. HOWEVER, I have noticed a shuddering/bobbling, fairly faint, when going over slightly rough roads a low speeds. The tires are shot. But they are all exactly the same ... meaning the same wear more so on the outside. I believe they were rotated properly, but something is wearing the outside prematurely. Is the shuddering/bobbling the culprit? What is the most common issue for the Shuddering/bobbling at low speeds on slightly rough roads?
Next, I want a quiet ride. Handling is not a concern. Should I go with a slightly wider tire or slightly taller tire? Lastly, I need new mats. I want them to be the same as what came with the car. Do I have to go to the dealer or are there some vendors with better deals on factory mats.
Civic - Honda :: 2007 - Popping Clicking Noise From Front End While Turning
ok I have a 07 civic with 80k, which I bought used, it seems when i turn the wheel more so to the left at slow speeds like parking or pulling out etc I hear a popping and or clicking noise from the front end it doesnt always happen, but happens enough I took it to my dealer to have everthing checked before a rd trip they told me the boots and all are fine but the joins could be binding, but that its safe to drive and doesnt need to be replaced.
View 7 RepliesSanta Fe (CM - 2007-12) :: Noise From Rear Tire Area
A month I have heard this noise.
View My Video .....
I took this video while I shake rear seat area.
Santa Fe (CM - 2007-12) :: Chirping Noise Coming From Left Rear Tire
I have a 2011 Sante Fe AWD 3.5L with 22K on it. The last few days I have been hearing this chirping noise coming from the left rear tire when I am stopped. When I am driving with windows closed or open I do not hear it, but when I pull into my driveway or a parking spot I hear it occasionally. Today, since I am looking out for it I get home, get out of the car and go to the left rear wheel well and sure enough it sounds like a chirping noise. Does not sound like it is mechanical and when I look under the car all seems OK. I put my ear right up to the top of the wheel near the well and I hear it. Sometimes it does not happen..
I suspect the Tire Pressure Monitoring System.....
Ford - F150 :: 2007 - Front End Noise Like Tire Is Rubbing Something?
I have 2007 F-150. I left for Iraq for two weeks and one of my kids borrowed my truck. When I got back, I drove the truck and have noise like the tire is rubbing something. I can't find anything hitting the tire. When you turn left, it makes the noise, when you turn right, it doesn't. If you drive straight and hit a bump it sounds like it rubs loader as you bounce. I had a mechanic look at it and he says that he couldn't see anything. I've had the front end aligned and it still makes the noise. I'm at a loss for an answer. The truck handles fine it is just very annoying and I want it stopped!
View 7 RepliesSanta Fe (CM - 2007-12) :: Front End Knocking Noise
I have a 2009 AWD Santa Fe with a little over 43K miles. Over the past few months it's developed a knocking noise that is most audible from the front drivers side area. The knocking speeds up or slows according to the car's speed, and appears somewhat louder when the steering wheel is turned. My initial suspicion from my surfing here is either a CV joint or wheel bearing.
I took it to the dealer that sold it to me and am getting increasingly frustrated with their work. The first irritation was yesterday when the service advisor called to say the problem was corroded rear rotors and brake pads; both wear items not covered under warranty. Though skeptical (since I was hearing the noise coming from up front, not from the back) I authorized the $300+ for turning the rotors, replacing brake pads and flushing the brake system.
When I showed up to retrieve the car I was told it'd been test driven and the problem was fixed. I asked the tech specifically whether he'd checked the CV joints and he assured me he had and they were fine. Upon driving away it was immediately obvious the knock was still there. Back to the dealer. I had the tech drive it with me in the passenger seat. He acknowledged he could now heard the knocking, but claimed he previously couldn't hear it over the horrible loud squealing from my rusted rotors; nor had he heard it on his alleged post-fix test drive. The problem with that is I've never heard this claimed horrible loud squealing, nor has my girlfriend, nor have any other regular passengers.
Back at the dealership the situation escalated when the service advisor, in defense of his tech, also claimed the horrible squealing rotors had drowned out any other noises. The problem with that is he admitted he'd not come along on any of the previous claimed test rides, and claimed to have heard the horrible squealing rotors only while the car was in the shop and/or up on the lift while the tech was turning a rear wheel by hand. Err, if the car was not driven any for distance or speed, of course you wouldn't have heard any knocking up front.
Yesterday evening I got a call from the shop advising the problem had now been diagnosed as a bad wheel bearing, front driver's side. I was assured it'd be fixed and ready this afternoon. All well and good. I showed up this afternoon and the service advisor stated the car was just getting buttoned up and we're going to test drive it. Fine, I'd like to come along on the test drive I said. He agreed, asked me to sit in the waiting room. In a few short minutes though - not long enough IMO - he came back out to advise the tech had just test driven the car (without me?!) and the knock is still there.
As of this writing I have no info from them as to what it might be. I left the car with them and asked the service advisor to have the tech(s) double check the CV joints. He got huffy with me and declared that if if the tech said he'd check them, there's no need to do so again. At this point I'm not sure whether I can trust this dealers' service department. I don't think the service advisor is being honest with me - I think he's been caught in a minor fib re: test riding and is compounding the situation by sticking with it.
Santa Fe (CM - 2007-12) :: Noise In Interior Right Front
Sounds like a servo maybe opening a door or flap. Comes on every few minutes. Can make it activate by turning the passenger side temp control.
View 4 RepliesSanta Fe (CM - 2007-12) :: Grinding Noise Come From Front Right Wheel
I have a 2010 Santa fe ( since new) 28k miles - I'm getting a grinding noise that seems to come from the front right wheel - noticeable only when doing a right hand turn or going around a roundabout.
So, Is this likely (from my terrible description) to be a wheel bearing problem....
Santa Fe (CM - 2007-12) :: Knocking Noise From Top Of Front Windshield
My new SANTA FE has merely covered 10000 km. The vehicle is running fine except a very irritating loud knocking noise from top of front windshield area. The noise is generated as soon as vehicle goes over a minor irregularity on road or even if you make a sharp right or left turn.
View 24 RepliesSanta Fe (CM - 2007-12) :: Tiny Grinding Noise Coming From The Front End
I have a 2007 SF Ltd. About 6 months ago I noticed a tiny grinding noise coming from the front end. I took it to the place that installed the brakes and rotors and had them look at it. The said that they didn't see anything but the cleaned up the rotors and oiled the slide pins. That didn't seem to sold the problem, so I took it to the shop that does all my inspections and such. They mentioned that they didn't see anything and that if if was only first thing in the morning, it might be some very minor rust that is building and being worn off. Lately, the grinding noise has gotten much more consistent and loud. Both places said the pads looked almost new and other than the turning of the rotors, they looked fine. If it isn't the pads or the rotors, what could be causing the grinding noise? A friend of mine had the same issue but his dealer told him that his vehicle "just had noisy brakes". That doesn't see to be an acceptable answer.
View 3 RepliesSanta Fe (CM - 2007-12) :: Driveshaft Clunk Noise In The Front Of Vehicle
Got a 2007 Santa Fe CM (Europe) with 160k km. I'm currently trying to figure out how to fix the clunk noise in the front of the vehicle. I am aware about the TSB 12-DS-002 where they recommend changing the drive shaft washer, but since that's a lot of work I want to make sure that this is really the problem.
The noise is not always there. Sometimes you can hear the clunk when decelerating, but not always. You can also sometimes hear a clunk when going from D to R. It sounds like a driveshaft has some play, and a change in the direction of the force causes it to slam into the other side. However, you can't feel it, so there is definitely not a lot of force behind it. You can only hear it.
However, I asked some guys to shift between R and D while I'm outside so that I can figure out where the sound comes from. However, murphy's law, it didn't made any clunk. And after shifting between R and D for like 20 times I felt bad for my transmission and stopped it.
The clunk is not always there, just sometimes. It doesn't really make sense to me, if its really play in a driveshaft it should be always there? Also the clunk started at about 155k km, now I got 160k.
Is there any further diagnostics I could do?
Santa Fe (CM - 2007-12) :: 2010 - Noise From Front Right Wheel When Starting Out
Well, even though I love my 2010 SF SE I have had a few issues. I've had my power steering pump replaced twice and now I'm hearing a clunky/creaky noise coming from the right from wheel. I"m thinking it is a sticky caliper. It happens most frequently when I am just starting out from having the car parked for a while. When I put my foot on the brake and then release it I get the noise. It seems to go away after I have been driving a while.
Can't say I ever had this much trouble with my previous generation SF. Nothing major but annoying none the less. BTW I have just under 30k miles.
Santa Fe (CM - 2007-12) :: Creaking Noise From Front End When Turning The Wheel
My parents have a 2007 hyundai santa fe AWD and recently there is this creaking noise from the front end when you have the car in reverse and you're foot on the brake and turn on the wheel, I had someone in the car and I stood outside it sounds like its coming from the center of the wheel near the hub it has that sound like a rusty door hinge, is there a problem with front wheel bearings on these cars we had the two rear ones replaced under warranty because of a humming thrumming noise and now there is a humming thrumming noise again but hard to tell if front or rear and the tires are in good condition no cupping.
Is there an easy way to check the hubs on these cars besides the normal move the tire up and down for play. By the way the car has 105000 kms on it...
Santa Fe (CM - 2007-12) :: Odd Clicking Noise On Front Driver Side Wheel
Truck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 RepliesSanta Fe (CM - 2007-12) :: Whining Noise Coming From Under Floor Area Towards The Front
I just bought a 2006 (mk2) Santa Fe 2.2 CDX manual.Overall I'm pleased with the car but I have noticed over the past week of ownership a whining noise coming from under the floor area towards the front (I think). The noise only occurs around the 20mph mark ( no other speed) and is there whether I'm in gear or just coasting.The car has done 43000 (so not high mileage) has a full service history and only one owner prior to me. It does have a tow bar (which I wanted) just I case this may be relevant.
View 4 RepliesSanta Fe (CM - 2007-12) :: Light Whining / Strained Noise From Front End While Driving From 0 - 20 MPH
I bought a 2011 Hyundai Santa Fe with 30k miles about 3 weeks ago. It is the 2.4 Cyl, non AWD version.
I noticed this noise while driving from ~0-20 MPH. A light whining, strained noise from the front end.
I brought it to my Hyundai dealership and they took a ride with me, and acknowledged they noticed a noise too. They changed power steering fluid once. Still heard the noise, so brought it back for 2nd time, they changed power steering reservoir, still heard the noise and brought it back for a 3rd time.
They now say there is nothing wrong with the car. Between 2nd and 3rd time, when pre heating my car on a couple of cold days, I noticed there's an even worse noise while parked in the drive way. I told them about this. Is this noise normal?
Here is a video : IMG 0662 - YouTube
Santa Fe (CM - 2007-12) :: 2011 V6 - P0447 And P0455 Codes Popping Up On Reader
I have the 2011 Santa Fe V6 and it has the P0447 & P0455 codes popping up on my reader. I checked the pins to make sure that there is voltage getting to the solenoid, (about 11volts at the 2 pins) and it seems good. No fuel lines broken, or cap messed up, etc.
View 6 Replies