Lexus RX 2004-09 :: 07 - Serpentine Belt Tensioner Pulley Making Noise
My tensioner pulley is making noise.I replaced the rear idler pulley (can't get to the front one), but still have the noise. Mention a DIY for replacing the tensioner pulley bearing. A part number for the bearing?
View 2 RepliesPrius (2004-09) :: Noise From Belt Tensioner Bearing?
During the 120000km (75000mi) service my Toyota local service said I have a noisy Prius and that the sound is from the belt tensioner bearing.
As I bought it used and always heard the same sound. I've made a video ....
Camry :: Engine Noise - Bad Serpentine Belt Tensioner Is Seized On
After finally identifying a bad serpentine belt tensioner for being the the culprit for my engine noises, my mechanic said that the 'thru-bolt' is siezed. Since the replacement job was at my budget limit he said he doesnt want to get into it in fear that he has to brake the bolt and drill it out (requiring 2-3x more labor cost according to him).
If this is the case, and the 'thru-bolt' is seized, is this in any way something I can make a an effort to tackle? I have a jack and jack stands, and plenty of time.
Lexus RX 2004-09 :: Chirping Noise Coming From Belt Tensioner Or Idler Pulley
So from reading around a lot, it seems like the chirping is from the belt tensioner or idler pulley. That said, I've not been able to find anything definitive. I tried to do the water bottle squirt test (from Gates' youtube video) and either I did it wrong or the chirp did not go away implying the issue is not the belt. While I was looking in, I could see the tensioner shaking some.
If my tensioner should not be moving, do I just need the pulley or the pulley and the mount?
- Pulley [URL] ....
- Pulley and mount [URL] ....
Also, if the above items will fix the chirp, which brand would be best?
2007 RX 350, 113K.
Chirping gets worse as it heats up. Seems to happen independent of ambient temperature. Purchased a year ago so unsure of the history of part changes.
Golf IV R32 :: Loud Clicking / Ticking Noise Coming From Timing Belt - Tensioner Looks Off
I recently had a good amount of work done to my Mk4 R32. Last night on my drive home from the stealership I ended up with a passenger headlight out and a very loud clicking/ticking noise which seems to be coming from the Serpentine belt area. After closer inspection it looks like the tensioner lines are't lined up which means my belt and tensioner need to be replaced? I'm not sure, but I have a video and this picture.
View 7 RepliesHonda - Pilot :: While Driving Clicking Noise - Replace Timing Belt Tensioner?
Six months ago my 2005 Honda Pilot got a new timing belt that was incorrectly calibrated. When the Honda Dealer test drove the car, they damaged the values. They fixed the valve damage and gave me a discount on the timing belt. I considered selling the car, but decided to keep it.
Now it's six months later. When driving I hear a "clicking noise". The dealer says that the timing belt tensioner needs to be replaced and that it would be dangerous to drive it at high speed as it is now. The clicking is caused by a worn ??? tensioner.
They claim that the incorrectly calibrated timing belt could not have caused this problem with the tensioner.
Ford Aerostar :: 1997 - Squeaking Noise When Turning - Serpentine Belt Tensioner?
I have a problem with my 1997 aerostar. There is a squeaking noise that gets more significant when I turn. I am pretty sure this is the drive belt as the power steering fluid is fine. Should I attempt to replace the belt tensioner and if so is it just the pulley that needs replacing or the whole tensioner. I am by no means a mechanic but can figure most things out.
View 5 RepliesSuzuki - Aerio :: 2005 - Vibration / Tensioner Pulley Making A Lot Of Noise
i just recently went to a mechanic check out my wife's car cause it was vibrating really bad, and a pulley was making a lot of noise... they told me that the alternator bearings were shot, and i needed 4 motor mounts, long story short i changed the alternator.... it wasn't the problem... had them check it again, they said power steering.... i didn't want to waist a couple hours of work again, i checked it myself like i should have done in the first place... and found out it was the tensioner pulley.... so can i get any pointers on how to change the tensioner pulley, cause i tried and i lacked about 1/4" of space to get the bolt out... do i need to drop the engine or raise it? if so how.. 2005 suzuki aerio 2.3L .....
View 6 RepliesCamry 2012+ :: Repetitive Squeaking Noise From The Front - Belt Tensioner Has Constant Wobble?
I have a 2012 Camry LE 4 cylinder non-hybrid at 31,000 miles. I was changing the oil yesterday and noticed a repetitive squeaking noise from the front passenger side of the engine. Upon looking closer, the belt tensioner has a constant wobble. Maybe around 1 cm of deflection with the belt. The AC condenser was running. Is this normal? Do I need to replace the tensioner? If so, what the torque spec is for the main tensioner bolt (pivot bolt)?
View 1 RepliesFord Super Duty (1999-2016) :: 2006 - Serpentine Belt - How To Route The Belt Around Tensioner Pulley
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
Santa Fe (CM - 2007-12) :: Brakes Are Making Squeak Noise After Lubrication
I did lube my brakes 2 weeks ago (2nd I am doing it) and since then for the first couple of kms, the brakes are making a squeak noise. I think I put a little too much grease. Could it be the reason why its making noise ?
View 10 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Replaced Idler / Tensioner / Belt But Still Getting Whipping Noise?
Ok I have a 2002 f250 7.3 4x4. The belt starting to shred and make a whiping sound at highway speed. So I replaced the idler, tensioner and belt. That was not the problem it still making noise so next I changed water pump. Still not it so I changed a/c clutch, bearing, and pulley. And It still not fixed. Right now the back of the belt is turning black on the wrighting like a pully is locking up. Also the front edge of the belt is starting to wear. I only have 255,000 miles on the truck and has been well maintained.
View 14 RepliesCamry :: 2007 V6 Tensioner Replacement - Cricket Noise With One Of The Pulleys
2007 camry V6 ... I have a few questions regarding tensioner replacement. i wanted to know whats normal cost for that job? I am experiencing a "cricket" noise with one of the pulleys. I had the belt replaced but problem is still there. toyota is recommending to replace the tensioner assembly quoted for 1200. is that a bit high? low?
I have reviewed pervious post with related problems but my "cricket" is on when it has a load on or not... with a/c on or off.. Any online for 2007 manuals? the online link under the stickys does not work, it dispalys a message "site has been hacked".
Malibu :: Belt Tensioner Rattle
I replaced the belt tensioner. Today, after much prodding, I noticed the tensioner is rattling which is weird considering is only a year and some months old. The question is what can cause the tensioner to rattle? The belt is fine, is not cracked and it sits fine on the pulleys.
View 4 RepliesPassat (B6) :: How To Tighten The Belt Tensioner Up
I needed to tighten the belt tensioner up, but couldn't find a DIY. So reaching out to see if this is normal? If not how do I tighten it up?
Here lately the car has been idling funny, kinda sounds like it has a cam or something, once I accelerate it smooths out fine. I thought it was a loose clamp on my intake to the turbo but once I got that clamped down correctly it still was idling this way.
Taurus :: 1999 - New Belt Run Out - Old One Making Noise
My brother and i had replaced the idler pulley and the tensioner pulley oh his 1999 taurus wagon with a 3.0l and after we changed them we put a new belt on it and after about 10 mins of running it started to runoff the alternator pulley put the old pulleys back on and it runs fine except a noisy squeal so we put the new ones back on again and same problem except after about 35 mins it ran off again is there something we are missing this is getting expensive replacing serpentine belts. Like i said with the old pulleys it runs fine just very noisy new ones runs quiet just blows out serp. belts
View 5 RepliesGolf IV / Jetta IV :: Timing Belt Tensioner Came Out?
First off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 RepliesPontiac - G6 :: Belt Tensioner Bounce At Idle?
I've replaced the serpentine belt on a 06 Pontiac G6 (6cyl) and I noticed at idle the tensioner has a slight bounce to it... Is that normal? It goes away when you hit the gas. Apparently the tensioner was replaced less than a year ago
I attached a short video. [URL] ....
Sonata NF (2006-10) :: How To Replace Serpentine Belt Tensioner On 3.3 V6
How to replace the belt tensioner. It's not putting out enough tension when the engine is cold. So, the belt makes chirping noise for couple of minutes idling when cold with AC on.
I had the AC inspected and everything checks out according to my mechanic.
He believes that the issue is with the tensioner since I had recently had replaced the serpentine belt.