Santa Fe (CM - 2007-12) :: 2010 - Remote Start Key Fob Not Responding
Recently my 2010 Santa Fe's remote start key fob is not acknowledging a response for any function on it and there is no blue light activating behind rear view mirror. I figure it has to be something fairly simple since it worked just fine last week. I have two remotes and when buttons are pushed I'm getting bright blue lights on both key fobs so I doubt if both batteries are bad, the factory key fob for door locks still works fine. I've read other posts and I'm aware that there is not many fans of the remote start feature. Its been -30 here in MB for far too long and I need this feature to work for me.
View 2 RepliesLexus GX 2010+ :: GX460 Will Not Start And Clicks - No Lights Indication
I bought my car and have had nothing but issues. I think I have driven the loaner rx almost as much as I have had my GX 460. Vibration issues, suspension issues, loose bolt issues, etc... Now for the double secret bonus I am on vacation and so is my GX. Went out tonight to pick up dinner after driving 3 1/2 hours and nothing but grinding clicks. Called roadside and they came. Not the battery. This is the second time it has happened. No lights are indicated.
View 14 RepliesSanta Fe (CM - 2007-12) :: 2010 Takes A While To Start With Ignition Switch
I have a peculiar problem with my 2010 Santa-Fe 3.5L
Every now and again, and more often recently, when I try to start the car with the ignition switch, it cranks well, but doesn't, or takes a while to start. If, after trying to start it with no success, I give it a few seconds, I usually get it going, but not always instantly like it used to.
However, If I try to start it with the remote, it starts instantly, every time. What could be the cause?
Santa Fe (CM - 2007-12) :: 2010 V6 Can't Start / Clicking Noise With Dimming Lights
Our 2010 Santa Fe SE V6 just developed a problem where when we turned the key, the car wouldn't start, and there was a loud clicking sound during start attempt. Battery tested 100% OK.
This often points to a starter problem, but a telling symptom was than the headlights would dim, almost going out, along with the dash lights and most any other lamp. If it was just the starter, unless dead short, this associated dimming would not happen. I also put a volt meter on the battery and watched battery voltage during cranking attempt, and the voltage showed minimal drop, so once again the battery was not the problem.
Traced the problem to the ground strap from the battery which terminates to the driver side front wheel well. Two bolts hold the strap to the wheel well, and they are oxide coated and the contact point on the wheel well is painted. This means all the current returning to the battery is essentially passing through the bolt threads and cap where the oxide has been scratched enough to be conductive.
I sanded underside of the bolt heads to remove oxide, sanded the ground strap itself which seemed to have some sort of clear coating, and sanded the paint away from the wheel well where the strap makes contact. I didn't have star washers, but if I did they would have been a good addition.
Car now starts with no problem.
I am concerned with the possibility of corrosion under the strap where I sanded away the paint, but will monitor this. I think the contact between the strap and fender wall is tight enough with the two screws to seal out moisture and oxygen.
I am also going to locate and check any other chassis to engine ground straps so I don't have any new problems in the future.
Santa Fe (CM - 2007-12) :: Random Setting Gets Erased Every Time When Call Is Taken
I have 3000 songs in folders on a USB stick. I understand how to get random play both within the folder, and for the entire USB. (Pushing and holding the button) What my frustration is is that everytime i take a phone call, or everytime i turn off the car, the random setting gets erased and it is back to sequential play. Is there a way to get this to a default permanent setting of "all random".
View 3 RepliesSanta Fe (CM - 2007-12) :: 2009 - Rough Idle / Random Stalling
I am happy to own a Hyundai Santa Fe (2009) 2.7l which originally originated in the US. It is a really nice car, however, it recently over time developed the problem, which causes some pain - firstly it started with rough idle (pulsating), now it began to stall from time to time when decelerating.
[URL].....
I tried to plug a OBD reader and here's what I get (well, that's a "pending" fault, but still might be useful).
I tried to browse around the internet. I believe it is unlikely that 2 oxygen sensors fail at the same time. It could possibly be caused by vacuum leaks or faulty MAF. Is it a common fault among Santa Fe?
Santa Fe (CM - 2007-12) :: 2008 - Random Stalling After 15 Minutes Of Driving
Our santa fe 2008 diesel randomly stalls. Most of the time the stall happens after at least 15mins of driving but I am not sure if its just a coincidence. It only happens when the car is stopped. When it happens, i put the car in park, turn off AC, then turn the car back on. It starts right up but is a bit rumbling like it will stall again. When i press the accelerator there is no response.
If I turn on the AC or turn the wheels, it dies. If i put it in drive or reverse it also dies. That happens around 3-5 times, then after that, everything is good again. Accelerator responds normally, car doesn't stall. Its driving me crazy! Whats worse is sometimes it doesn't occur for 1month! Then all of a sudden it stalls again. Bought the car 2nd hand and since january it died around 8-10 times.
I brought it to a reputable mechanic and they checked the fuel system. Replaced the fuel filter, fuel sensor. They even tried a different pump and sanction valve and it still didn't fix it. They kinda concluded that its not in the fuel system already, but they are at a loss. Its very hard to trigger since we don't know what really causes the stalling. All we know is that it only occurred when the car is stopped.
Santa Fe (CM - 2007-12) :: Codes P0154 And P0300 - O2 Sensor / Random Misfire
My 07 3.3 SF is throwing P0154 and P0300 codes. Autozone said the P0154 is Bank 2 pre-cat O2 sensor. But exactly which one? The P0300 is random misfire. Could they be related?
View 7 RepliesSanta Fe (CM - 2007-12) :: 2010 - Engine Hiccups / Quick Hesitation
I've got a 2010 Hyundai Santa Fe with the 2.4L engine. Funny thing happened on the highway. Driving along with the cruise on, the engine 'hiccups'. Almost like a quick hesitation or someone lightly tapping the brakes.
Got it home and ran the usual tests. Computer showed no trouble codes. Checked the oil. Checked the air filter. All normal.
Turned the car on and tested it in park. Gave it some gas, and took the engine up to 3k RPMs...after a few seconds, it did the hiccup thing again. I watched the RPMs dropped from 3k to 2.5k, and then rebounded to 3k. We could also hear a slight and single 'knock' each time the RPM's would drop. I noticed the A/C was on, so I turned it off, and the problem went away. Turned the A/C back on, and the problem came back. I did that about 5 times to confirm it, and every time the problem occurred, the A/C had to be on.
Now, of course the car has 61.5k miles, and we're the second owners, so bye bye warranty. The car was in for repairs at the dealership when the head control unit for the A/C had issues. Of course now we ask them if the problem is related to their repair will they cover the costs, and they say the best they can do is ask Hyundai to cut down the expenses (even though the repair was done within the last 10k miles)?!
My guess is the compressor has kicked the bucket. Of course, I'm not sure if maybe it's the idle motor not operating like it should or if the car even HAS an idle motor to work with the RPMs when the A/C is on.
Santa Fe (CM - 2007-12) :: 2010 - RPMs Drop Low After Engine Turns Over
I have a 2010 Santa Fa GLS. 88K miles. This issue started in the last 6 months, once the engine turns over the RPM drop low and starts to putter as if it is not getting enough fuel. If push down the gas when starting it works. Once it passes the first 2 -3 seconds everything is fine. No issue idling or driving. What this could be? It's not an issue with Starter, Battery, my best guess would be a sensor, leaky fuel injector.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2010 - Engine Jerks When Driving Slowly
I bought a 2010 Hyundai Santa Fe 3.5L and noticed the engine would jerk really bad. It felt like the engine was going to jump out of the vehicle. I notice it does it when I turn it on in the morning and when I am driving slowly out my lane way the engine jerks. I have dealt with this problem since last year and they have already replaced the transmission which has done nothing. I took it back to the dealership and the service manager told me that he has already had 4 of the same vehicles come in with the same problem and they realized that they had to re-set the computer in the engine so that the transmission computer and the engine computer are on the same page that they talk to each other so to speak. Since they re-set the computer we have had the vehicle back a week today and this morning the car jerked again. I am tired of constantly taking this vehicle in and being told they have a solution and then it is not fixed. How am I supposed to sell a vehicle to someone when it feels like you are being lifted out of your seat because of the JERKING!!!!!
View 14 RepliesSanta Fe (CM - 2007-12) :: ESP Off And ABS Lights At Engine Start
As appear on the attached video , sometimes the ESP off and ABS lights again at Engine start , and after the switch on checkup. Is that normal , or indicate upcoming issue?
[URL] .....
Santa Fe (CM - 2007-12) :: Engine Turns Over But Will Not Start
Like the title says, the engine turns over but it doesn't start. Sequence is something like this:
Turn key to on.
Wait until all the lights and gongs have stopped.
Turn to start for 3 to 4 seconds.
No start.
Turn everything off and repeat 1 to 3 times.
It starts.
Santa Fe (CM - 2007-12) :: Headlights Dim / Flicker When Bakes Depressed - Random Stalling While Driving
Had the following problems with my 2009 Santa Fe: Audio system would randomly reset when playing MP3 from USB drive, Headlights would dim/flicker when bakes depressed, LED lights on dash would flicker, random stalling while driving. Finally just died and would not start. The Hazard lights would not work only a bit of buzzing from the relay. Checked Battery, connectors, etc. All looked good. Measured voltage at fusebox (inside) and found it dropped from 12v to 4v when I put the hazard switch on. Showed there was a connection problem of some kind.
Finally used a jumper cable from the battery negative terminal to an ground point inside the cabin. Bingo that fixed all the problems, car started, lights were good, hazards worked. As a permanent fix I ran a wire from where the negative terminal of the battery connects to the frame, then drilled a hole in the firewall and ran the wire into the cabin. Connected the wire to a ground point in the cabin. Used a heavy gauge stranded wire. you can try this out with lamp cord as a temporary fix, but I'd use something heavier for a permanent fix. All problems have gone. No flickering, no stalling... This may be a problem on other models from what I've read in some forums (unexplained stalling - check the grounding in the cabin..).
Santa Fe (CM - 2007-12) :: Doors Will Not Lock With Power Button - AC Turns On By Itself At Random Times
I have a 2007 SF SE that seems to be having multiple electrical problems. In summary, the following are happening irregularly:
1) rear passenger door will not lock with the power lock button
2) front driver door will not lock with the power lock button
3) A/C turns on by itself at random times
4) Power gas latch release will not work
As I said before, these problems happen randomly and all the things listed above will work on occasions. I have not taken any steps to troubleshoot other than looked at the relays in the engine bay which seemed to be fine.
I know that some other posts mentioned the lock actuators for the lock problems. However, I think there might be an electrical problem since all the problems seem to be related. The car is not under warranty anymore.
Santa Fe (CM - 2007-12) :: Map / Dome Light Not Working When Door Opened - Random Alarm
I have a 2012 Santa Fe and the front map light fixture was where my issue started. I believe from what I read that the diode had gone bad because the map lights would work if the light button was pressed, but not if the door button was pressed. At that point, the only issue I had was the light now working when the door opened. So, I ordered a replacement part and tried to install it today. It was harder to get the old one out than last time, but it came out no worse for wear and I unplugged the old map light fixture. I plugged in the new one and it did not work at all. I checked the wire and it looked fine, the prongs and they were fine and tried it again... nothing.
Now, the back seat dome light and trunk dome light don't work either. (with the new map light plugged in or not) Old one back in and still nothing. Checked the manual for the fuse that is supposed to control those lights and it is fine. I got frustrated because it made no sense and gave up for the night. (no light is even plugged in where the map light goes for now) I come in the house and now every hour or two (when I lock the car) the alarm sounds for no reason. The alarm button won't shut it off either, I have to hit unlock and it stops. (3 times in the last 5 hours now) So, I have decided to leave it unlocked for now. So far, so good. BUT, I need to lock my car when I am out without the alarm sounding and I need my dome lights working. Everything else with / in the car seems to be normal.
Santa Fe (CM - 2007-12) :: 2010 - Loud Whirring Sound After Engine Turned Off
I turned off the engine and I get a whirring sound, quite loud, that seems to be coming from the top of the engine around where the injectors are.
View 51 RepliesSanta Fe (CM - 2007-12) :: Engine Start Up Noise For About 10 Seconds Or So
I recently purchased a 2011 Santa Fe SE with the 3.5 V6 Engine. When I start it up for the first time in the morning or after its been sitting for a few hours, the engine sounds likes it's insides are rattling for about 10 seconds or so... I believe the lifters are probably pumping up and it's a valve train noise... but is this normal? I don't like this sound. the previous owner used Mobil 1 synthetic oil and that is what is in there now. Is this a good choice for this engine? Is there an oil filter with a check valve that can be used to hold pressure to the valve train on start up? Is this cartridge type oil filter all that is used on these engines?
View 18 RepliesSanta Fe (CM - 2007-12) :: Engine Does Not Always Start In Only Warm Weather
I have a Santa Fe 2007, when the weather gets warmer it doesn't always start first time, once and a while I have to try two to three times...
View 4 Replies