Santa Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Santa Fe (CM - 2007-12) :: ESC Light On And Tachometer Would Drop To 0 While Driving
For a few months now I've been having strange electric issues with my 2009 Santa Fe GL.
At first, we had the cruise light randomly come on (not actually engaging cruise, just indicating the system is on), the ESC light would be on, and the tachometer would drop to 0 while driving, although the engine was clearly running. We had the cruise control switch replaced and that appeared to have fixed the ESC and tachometer issue.
Unfortunately, the cruise light would still come on so the brake switch was replaced a few weeks back - that did not fix the cruise light issue. Now, over the weekend two very disturbing things started happening:
1) Cruise will now randomly turn off when engaged
2) The car thinks it's in manual transmission mode, even when it's not. When in drive (D), the car will no longer switch out of first gear. In order to switch gears, I must switch to manual drive mode and change gears by using (+).
Camry :: Speedometer / Tachometer Intermittently Going Out With ABS Light On - ECU Malfunction?
I have a 2005 Camry with 110,000 miles on it. Bought Toyota because I thought they were supposed to last and be such good cars...speedometer, tachometer intermittently going out along with ABS light coming on...took it to dealer, they said it was the combo meter and oh by the way the water pump needs to be replaced. Then get a call that it isn't the combo meter but the ECU that needs to be replaced and that the part is $1982.00. I have serviced the car religiously at the dealer and am very disappointed to have such problems in a car that is only 5 years old and has been taken care of...
View 1 RepliesSanta Fe (CM - 2007-12) :: A/C Malfunction - Blowing Hot Air
However, selecting Mode setting to the floor on the climate control build (as I read) does not seem to turn off the AC from running to off with outside air only. Also, the OFF button does stop everything but once the fan speed is turned up its cold air blowing.
I read through the entire section in the owners manual and there is nothing mentioning it will run if AC is not selected nor any other over ride procedure. I am thinking this is a unique SF Limited issue and solutions for other models don't hold true for me. With the temperature much hotter its not difficult to feel the difference blowing out the vents.
Santa Fe (CM - 2007-12) :: Windshield Ejector Malfunction
When I pull the wipers lever backwards, washer fluid supply in tank lowers, but there don`t come liquid out for the jets.
The rear jets don`t spray liquid . The auto sweeping function works OK (7 times).
The only way to spray a little of liquid is pulling the lever many times at once.
I deduct that the fluid is going or evaporating somewhere, The pump makes the noise that`s working...as always.
Someone told me that ejectors are clogged, but I used a pin to clean them and some liquid spits out.
Santa Fe (CM - 2007-12) :: Malfunction Indicator Light Blinking
Month ago the malfunction indicator turned on. On checking it was found that wires over the engine were eaten by rats. Reconnection of wires solved the problem.
Today the malfunction indicator light is blinking. Could it be the same wires going loose?
Santa Fe (CM - 2007-12) :: 2010 - Malfunction Indicator Lamp Stays On After New Battery
Yesterday I changed battery after that its seems malfunction indicator lamp stays on, i checked with hyundai service center they told to reset the program then diagnose the problem, then only come to know the issue or not issue they asked 20rial, i m wondering just changed the battery got some issue.
View 4 RepliesSanta Fe (CM - 2007-12) :: Backup Power Malfunction - C/D Changer Kept Shuffling - Clock Had Reset
Recently my santa fe has been acting up. One time I got in and nothing came on, no light, door noise, nothing. I closed, then opened my door and everything turned back on, clock reset itself and the cd changer kept shuffling through the cds. Another time this happens before I got in the car. I opened my door to hear the cd changer shuffling and the clock had reset. This has happened 4 time in the pasted 3 weeks.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2009 A/C Malfunction Blowing Hot Air Randomly - Control Not Working Properly?
My wife drives a 2009 Hyundai Santa Fe Limited which we bought new back in 09. she has put roughly 140,000 miles in that time span. We have religiously followed all required maintenance routines; this is the first major issue we have EVER had with our Santa Fe. The issue we are having involves the AC unit. Instead of blowing ice cold air, the air vents are blowing hot air as if the heater is on. I have check all major AC components and everything is working properly. I believe we are having a controls issue.
At one point, all vents would only blow hot air. The other day, the passenger side vents started blowing ice cold air while the driver side still blew hot air. The driver's side has not blown cold air since this issue started about a week ago. We do have dual climate control; I have tried every possible combination of controls to see if it's a particular switch or button; however, I have not had much luck.
Santa FE SM (2001-06) :: Speedometer / Tachometer And Gas Gauges Not Working
We have an intermittent (now more regular) issue on our 2005 SF of the instrument cluster (tachometer, speedometer, gas gauge, temp gauge) sitting at zero - no motion whatsoever. In the summer months, the gauges came on after a while of AC being on, which I thought odd. But it just happened here in October (and the temp is just around 5C/41F) so a temp issue is unlikely. No OBD codes that we know of, all the fuses are fine, and while we did have a PCSV issue earlier this year, it did not seem to affect this particular issue with the gauges.
Threads such as the one below seem to say that it is the speedometer that is wacky... 01 Santa Fe Speedometer Not Working! , and the general solution to the problem/issue is to replace the vehicle speed sensor (VSS) and associated gear mechanism. And on a different thread, Input Output Speed Sensors , it was suggested that the problem could be addressed by changing the input and output sensors.
Ford Super Duty (1999-2016) :: 2008 F250 - Average Cam Phaser Life Expectancy?
I drive a 2008 5.4L F-250. How long do the average cam phasers last. I run full synthetic at 5K intervals and run WIX filters.
View 2 RepliesSanta Fe (CM - 2007-12) :: 2008 - No Response To Key
The other day, I had occasion to try to start my '08 Ltd, and there was no starter response to the key. Everything lit up and didn't dim when turning the key. Jiggled the key a few times, no change. Jiggled the shift lever a few times, no change. Turned the key a few more times, and it started. Yes, the vehicle was definitely in Park at the time.
This one has an automatic, so I'm assuming it was either a shift interlock switch (aka Neutral Safety Switch) or possibly the ignition switch itself, but as noted, neither responded to my ham handed approach to solving the problem. First time, it took about half a dozen start attempts. The second time, only three.
Haven't had the problem since then, but then again, I haven't been cycling the ignition as much as I was that day (probably 20 start stop cycles). Now I'm just wondering where and when it will bite me again. Some of the places I take this vehicle to the boonies in the Rocky Mountains would cost me dearly in tow charges.
Encountered this on an earlier CM model? I don't recall ever seeing this mentioned here over the years.
Santa Fe (CM - 2007-12) :: 2008 - Hum Noise From Driveline
Have 2008 Santa fe with a driveline hum noise. Originally thought is was a wheel bearing so I replaced what I thought was the suspect ones (1 in front and 1 in the back). Noise still there! Carrier bearing on the drive shaft? Front axle shaft? I'm at a lose.
View 7 RepliesSanta Fe (CM - 2007-12) :: 2008 - Misfires On All 6 Cylinders
Just replaced all 6 plugs after getting p0300-p0306 codes. Still getting all codes, always starting with p0305. Was told coil was bad cause the shop only was getting p0305, but I have all misfire codes. We have over 95k on it, have owned since 2008. Its the 2.7 in it.
View 11 RepliesSanta Fe (CM - 2007-12) :: 2008 2.7 - Misfire On Cylinder 3
Motor missing has 61k. Code reader says # 3 misfire. got new plugs. 2 people say its probably the coil on #3. Its center in the back. Need step by step to replace the coil for #3 and plugs while I've got it apart and where is the best place to get a coil?
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 2.7l Misfire / Flashing CEL
2008 GLS AWD, 2.7L w/ 66500mi. This happened on my way home from work this AM. Vehicle cold started normally, but I noticed a stumble as I idled out of my parking spot after a 12hr shift. All gauge indications looked OK. A few hundred yards down the road (and deep in the hood no less) I can feel an intermittent vibration/stumble and now I get the *FLASHING* (misfire) check engine light.
5am Sat morning and I'm already on the highway for my ~35mi ride home. The vehicle behaved OK, but you could feel a definite power loss, indicative of not firing on all 6. I hated to, but I had to drive it the whole ~35miles with the flashing CEL. I couldn't smell rich exhaust, nor did I notice any black smoke, etc.
Now I'm SOL. I have no warranty since I'm a subsequent owner (3rd owner of vehicle). Of course I lent out my generic code reader 2yrs ago and never got it back. My garage is currently upside down, tools packed away..etc. We just had a baby a few weeks ago and moved to a new house. Perfect timing.
Santa Fe (CM - 2007-12) :: 2008 Vehicle Pulling Towards Right
When driving I seem to be constantly applying pressure to the left side of my steering wheel to keep the vehicle from moving to the right. I've had the car aligned made sure my tire pressures were correct and had my mechanic check the undercarriage to make sure ball joints tie rod ends etc. are all in good working order. Despite all this the vehicle seems to want to wander right and I'm constantly putting pressure on the left side of the steering wheel.
View 4 RepliesSanta Fe (CM - 2007-12) :: 2008 - Both Low Beam Headlights Out
I have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 RepliesSanta Fe (CM - 2007-12) :: 2008 GLS Stalling On Highway
I was driving home on the highway doing about 60 mph in rush hour traffic the other night when it completely stalled out. When I started the car as I left work I noticed the engine noise was louder than normal but was in a hurry to get home. I was driving and noticed a change in the way the car was riding almost like a hiccup. I pressed the gas pedal to the floor and the car continued to decrease speed. I jumped off the highway on the next exit and the car slowed as I pulled on the shoulder and stopped.
As I stopped and put the car into park the battery, oil and check engine light came on. My headlights were still on as was the radio but the car would not restart. It was dark, raining and about 35 degrees outside. The local highway assistance showed up about 20 minutes later and gave me a battery jump. The jump lasted for about one mile down the road again and then died. The motorist assistance employee said that my belts were not turning so he thought it was my alternator.
My car was towed and kept in the shop for 3 days, no error codes, started right up and no problem they can find with alternator, tensioner, belts, or battery. The week prior I had my entire fuel system replaced as my gas gauge had stopped reading. The shop checked my fuel pump and did not find any errors. I don't know what else to look at and the shop is out of options...they have driven it repeatedly and cannot find anything. I have read on many threads about the crankshaft position sensor. Could this be the issue?