Starting - Chevrolet - Tahoe :: 2001 - Clicking Noise Right Before When Engine Trying To Catch
I have a 2001 Chevy Tahoe, and for the past couple of years, I have been having an incredibly frustrating issue with my car. When I go to turn the key, it sounds as if it is about to turn on (ie the engine is about to turn over and it sounds normal) then right before it catches, it will start clicking, the noise sounds like the battery is dead. When it first started happening, I called AAA, however by the time they reached me, the car had started again. Now when it occurs, I wait 10-15 minutes and it will start- every time. I have had it in to 4-5 different car repair shops, however no one can seem to figure out what it is. I have had the battery replaced, and several other things altered, etc, however nothing seems to fix the problem. I am not sure where to go from here, I was informed to check the fuel pump and/or filter yesterday- it happened twice on me yesterday as well.
View 3 RepliesSanta Fe (DM - 2013+) :: 2016 - Hard Starting / Taking 3 To 4 Seconds Of Cranking Before It Will Fire
On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
Dodge - Van - Ram - Sensors :: 2001 - When Starting It Will Crank But Will Not Fire
My father inlaw has a dodge van that is having problems starting. When starting it will crank, but will not fire. We have discovered that if you remove the 20 amp Oxygen Sensor relay, under the hood, and jump it directly to the battery, while starting if will start. The fuse appears to be good. Can the O2 sensor relay prevent the van from starting, but run after initially bypassing after starting? What it might be?
View 4 RepliesSanta FE SM (2001-06) :: 2.7 Engine Won't Start / No Fire To Coils
I just replaced the motor in a 2002 Sante Fe 2.7 due to timing belt breaking, this motor will not start, it turns over, but I am getting no fire to the coils. Crank sensor replaced waiting on the cam sensor, anything else it could be?
View 2 RepliesSanta FE SM (2001-06) :: No Power When Pulled Into Gas Station / Cranks But No Fire
Here is what happened. Pulled into gas station and car just died. Tried to restart and no fire. Cranks but no fire. Flat bed trip home and started to diagnose. Thought it was a bad fuel pump so I pulled and tested with a direct power and functions fine. Checked all fuses and relays, all seemed fine. checked for power at pump and nothing. Reset cut off switch and still nothing. Thought maybe ECM relay in the under hood fuse box was bad I borrowed the one out of a friends car. Nothing. Thinking ECM was bad put theirs in my car and got power to pump. So I put their car back together thinking mine was the ECM, then theirs won't start. The ECM relay i took from there car and put in mine blew when i tried to start my car. Got another ECM for my car and put in. Still no power at the pump. Here is the info about the car. 2001 Santa fe 2.4L auto. 80,000 miles. Timing belt, tensioner and all Idler wheels changed along with water pump at 71,000 miles. This car has been very reliable up till this point. No check engine light came on at any time..
View 8 RepliesSanta FE SM (2001-06) :: Burned Out Plug Wire - Number 4 Cylinder Misfire
I've had the plug wire for my #4 cylinder burn out twice in the last 6 months. The car started running like crap and threw a CEL, the code was for a number #4 cylinder misfire. When I pulled the wire it has obvious signs of being burned out, like white powder and burn spots near the base of the wire where it goes over the plug. The plug and coil both look normal. No issues with the other cylinders. What could cause it?
This is on my '05 Santa Fe, 2.7l, FWD auto, with 180k miles
Passat (B5) :: Engine Shaking Like It Needs To Catch A Second Before Starting Fully
When I start my 2001 passat 1.8T 155,000+, my car shakes like it feels like it needs to catch a second before starting fully, and when it does fully start it gives a good kick but then stops, just curious of what it could be and what it could run me, but its not the battery I know that?
View 3 RepliesAccent MC (2006-11) :: When Turned The Ignition On It Sounded Like Starting But Didn't Catch
I have a 2008 Accent, automatic, with 167,000 mostly city kilometers on it. 3 times, yesterday and today, when I turned the ignition on it sounded like it was going to start but didn't catch. When I tried again the second time it started. At first, I thought I just didn't turn the key to the right long enough but with it happening 3 times, I am not so sure.
I called my mechanic and he thought it might be the fuel pump. He suggested I turn it to the right then back 2 times, then start it the third time. I have spent a lot on it lately, new tires in April, transmission fluid, also had to replace the tie rod on one front wheel and bearings on the other. If it is the fuel pump, what happens if I don't replace it soon?
Santa FE SM (2001-06) :: Hard Starting After Refueling
When I get gas in my '04 Sante fe it can be very hard to get it restarted. It acts as though its flooded.
View 9 RepliesSanta FE SM (2001-06) :: Revving / Stalling And Not Starting
I drive a 2004 Hyundai Santa Fe V6 2.7L with a whopping 274,3xx miles on it. I've had it for about 6 years and it has been a great car for the most part. The water pump was replaced a couple years ago and the battery was replaced a year ago.
It started having issues a few months ago. It started out having difficulty starting, and shortly after it would start it would rev up as if you were accelerating even if my foot was on the brake. I took it to the shop and they checked the head gaskets, battery, transmission, alternator (I think?). Came up with the idea that it may be the air intake valve. It's the thing that controls how much the blade opens when you press on the accelerator. Well they took it out and said it was the dirtiest one they had ever seen. They cleaned it, because no one in our area had a replacement, and my car seemed to be acting better. It would still rev occasionally and would have trouble starting but not nearly as often as before.
Fast forward to now (a month later) and my car is revving higher and for longer than it ever has and has started stalling, and not starting more frequently. It usually stalls after it has been revving when it cant release or go forward (ex. when applying the brake or while in park.)
What the heck is wrong with this thing?? No one seems to be able to figure it out and it it so frustrating, not to mention dangerous! It stalled in the middle of me making a turn today so I was literally sitting in the middle of oncoming traffic with a dead car.
Santa FE SM (2001-06) :: 2004 3.5L - Whine Occurred On Starting The Car
Drove the vehicle today (current at 156k miles) about 40 miles then came back home. Left again to run an errand. After coming out of the store and starting the car, a very pronounced 'whine' occurred. It kept whining for about 2 miles and with 3 blocks left to go, the whine suddenly stopped. No CEL appeared and the radiator temp was normal, oil level was fine and the pwr steering fluid in the reservoir was at the max level. I suspected it might be the p/s pump but, if so, why did the noise cease?
View 1 RepliesSanta FE SM (2001-06) :: Hard Time Starting After Gasing Up
My 2005 Santa Fe needs a purge valve.
View 3 RepliesSanta FE SM (2001-06) :: High RPMs In Park And When Starting
Earlier this week, noticed that my car was surging on its own; basically, if I came to a stop, I could still feel the engine, like it wanted to just take off. And if I would have taken my foot off the pedal, it would have done just that. Also, I knew the car had gas, but sometimes, when starting the car it would not start at all. I would have to wait about 5 minutes or so and add major gas to it with the pedal and then finally it would engage. And then the last thing was that when I would get to my destination and put it in Park, the RPMs would go up to about 1500 or so, maybe a bit higher and then stay there and go back down to about 1000, without me pressing on the gas pedal at all. So anyway, thought it was the throttle position sensor, so I had my Dad install a new one on the car. It was a pretty easy process and thought that took care of the problem.
The surging part basically stopped, so the new TPS took care of that, but then it still had problems with starting. Took it to a car repair place the next day and they changed out the spark plugs, said that they were causing a misfire in the engine. Also changed ignition wires and a new gasket. So after they were done, drove away and all seemed to be fine, but then went to the dentist and Parked and then the RPMs went up again. Tried to start it immediately afterwards and it wouldn't start again. Tried a few minutes later, added gas with the pedal and it did start. Took it back to the car repair place, they drove it around, inspected everything and everything checked out fine. (Yeah, of course!) Ok, so just thought maybe the repairs were taking a bit to take effect. But later in the day, wouldn't start again.
So next morning, took it to the Hyundai dealer. They looked at everything for about 2 hrs, and said that there was a vacuum hose that was leaking, so they put on a new clamp but everything else checked out okay. Ok, so now it starts fine every time, but today it did that high RPM thing again when I put it into Park. It doesn't do it every time, but the RPM will just go up randomly then go back down and go back to normal. Should I clean the IAC with some type of carb cleaner to get out any carbon deposits? Or could it be a bad MAF sensor? Not sure what the symptoms are of that. Everything else seems to be okay now except for the random high RPMs when in Park and sometimes at startup too.
It's a 2 WD, V6 engine.
Santa FE SM (2001-06) :: When Starting Steering Wheel Is Locked
First I have to say my Santa Fe is my pride and joy, never have I enjoyed a vehicle so much but today I encountered a problem. I went out to start my car, steering wheel is locked, key in ignition won't unlock, can't turn steering wheel to unlock.
View 2 RepliesSanta FE SM (2001-06) :: 2004 Not Starting After Putting Fuel In
My santa fe has been great but recently after putting fuel in, it does not seem to want to start.turns over and runs for a couple seconds then dies out. Have to keep accelerator pushed down for it to keep running. after that it seems to run and crank ok. Why it keeps dying out after fueling?
View 4 RepliesSanta FE SM (2001-06) :: 2003 - Ignition Key Rotating Freely Without Starting The Car
The key in my 2003 Hyundai Santa Fe is rotating freely without starting the car. The Accessories are always on and I had to disconnect the battery to prevent drainage. I removed the lock cylinder and found a small camshaft like part that seems to be loose and broken, one piece of it seems to be broken in the switch. Is there anywhere I can get this camshaft like part? I searched but can only find either the lock cylinder or the switch. See the attached pic for the part I am talking about.
View 3 RepliesSanta FE SM (2001-06) :: 2004 2.4 Petrol Engine Starting Rattle
I have a 2.4 Petrol, 16 valve engine in my Santa Fe which produces a rattle on startup when cold. When warm it starts normally. Oil and filter change makes no difference. Timing belt changed 40K ago. No other effects felt with regard to power or noise once initial noise/rattle has stopped after 2 to 4 seconds.
View 4 RepliesSanta FE SM (2001-06) :: Ticking Noise Coming From The Front When Starting
I Have a ticking noise coming from the front when I first start up the vehicle and only lasts for 5-10 secs maybe 15 secs tops.. I assume I think its from the engine..
View 15 RepliesSanta FE SM (2001-06) :: 3.5L 4WD Not Starting / Replaced Crank Position Sensor
We bought a 2006 Hyundai Sante Fe with the 3.5L and 4 wheel drive about two months ago, it has 94,000 miles on it. It was purchased from a dealership, and they had to work on it for a month before we took it from them because of some lights that were on, resulting in some sensors being replaced. We had it about a month when we took it to the grocery store, when we came back out I started it and it made a terrible noise, but was running, I immediately turned it off. Upon further inspection, the main serpentine belt had snapped, causing some damage to the secondary belt. We towed it home and I began to fix the belts.
When I pulled off the passenger side wheel and access cover, I noticed the remains of the belt were stuck behind the harmonic balancer, I tugged on it with about 5 pounds of force, and the entire pulley fell off of the harmonic balancer. I'm not sure if the belt stacked up behind and pushed it off, or if it just went bad, but the rubber between the portion that connects to the crank and the pulley was ripped, and missing in some spots. I replaced the harmonic balancer, and both belts, good to go, everything is running fine.
About a week later, the TCS etc. lights came on, but no check engine. I researched it a bit and came up with three possibilities:
1. Fuse
2. Tone wheel cracked/broken
3. Crankshaft position sensor
I checked the fuses and nothing was burnt, I never lifted the truck up to check the tone wheels.